Naichuan Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Naichuan Yu has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Yingwu Yao
School of Chemical Engineering and Technology, Hebei University of Technology, Tianjin, People’s Republic of China
4 shared publications Hanfei Cao
3 shared publicationsJingyu Wei
School of Biological and Environmental Engineering, Tianjin Vocational Institute, Tianjin, People’s Republic of China
3 shared publicationsJunsheng Wu
3 shared publicationsKun Shen
3 shared publicationsZhensheng Gu
School of Biological and Environmental Engineering, Tianjin Vocational Institute, Tianjin, People’s Republic of China
3 shared publications
Latest Publications
- 19 February 2024
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 31 (13) , 20207-20221
Electrocatalysis coupled heterogeneous electro-Fenton like treatment of coal gasification wastewater using tourmaline as catalyst: process parameters and response surface
Coal gasification technology is essential for realizing clean and efficient conversion of coal, as well as for reducing carbon emissions. However, coal gasification technology is accompanied by a large amount of coal gasification wastewater that is biodegradable. In this work, tourmaline was applied as a catalyst in electro-Fenton like process for treating coal gasification wastewater. The optimal applied parameters of coal gasification wastewater were investigated as follows: current density of 90 mA cm−2, tourmaline dosage of 8 g L−1, electrode gap of 1 cm, and temperature at 25 °C; the COD removal ratio reached 91.24% after 240-min treatment. In addition, the current density and tourmaline dosage were further optimized by response surface method. The result was about current density with 82.4 mA cm−2 and catalyst with 7.57 g L−1; the predicted COD removal efficiency was 86.91%. Under the optimal parameters the actual COD removal efficiency was 88.25% a little high than the predicted value. To explore the reusability of tourmaline as Fenton reaction catalyst, five cycles of experiments were carried out. The result demonstrated that tourmaline could be used as catalyst for treating coal gasification wastewater by electro-Fenton like process.
- 19 February 2024
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 31 (13) , 20207-20221
Electrocatalysis coupled heterogeneous electro-Fenton like treatment of coal gasification wastewater using tourmaline as catalyst: process parameters and response surface
Coal gasification technology is essential for realizing clean and efficient conversion of coal, as well as for reducing carbon emissions. However, coal gasification technology is accompanied by a large amount of coal gasification wastewater that is biodegradable. In this work, tourmaline was applied as a catalyst in electro-Fenton like process for treating coal gasification wastewater. The optimal applied parameters of coal gasification wastewater were investigated as follows: current density of 90 mA cm−2, tourmaline dosage of 8 g L−1, electrode gap of 1 cm, and temperature at 25 °C; the COD removal ratio reached 91.24% after 240-min treatment. In addition, the current density and tourmaline dosage were further optimized by response surface method. The result was about current density with 82.4 mA cm−2 and catalyst with 7.57 g L−1; the predicted COD removal efficiency was 86.91%. Under the optimal parameters the actual COD removal efficiency was 88.25% a little high than the predicted value. To explore the reusability of tourmaline as Fenton reaction catalyst, five cycles of experiments were carried out. The result demonstrated that tourmaline could be used as catalyst for treating coal gasification wastewater by electro-Fenton like process.
- 4 November 2023
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 28 (7) , 2011-2020
Comparison of Ti/PbO2 electrode and Ti/RuO2-IrO2 electrode on their electrochemical performance
- 4 November 2023
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 28 (7) , 2011-2020
Comparison of Ti/PbO2 electrode and Ti/RuO2-IrO2 electrode on their electrochemical performance
- Open Access
- 22 March 2022
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (33) , 50237
Correction to: Heterogeneous Ti/PbO2-electro-Fenton degradation of aromatic methane dyes using industrial pyrite waste slag as catalyst
- 22 March 2022
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (33) , 50237
Open AccessCorrection to: Heterogeneous Ti/PbO2-electro-Fenton degradation of aromatic methane dyes using industrial pyrite waste slag as catalyst
- 28 February 2022
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (33) , 50218-50236
Heterogeneous Ti/PbO2-electro-Fenton degradation of aromatic methane dyes using industrial pyrite waste slag as catalyst
It is imperative to search the eco-friendly and cost-effective technologies for degrading contaminants. Coupling the effect of Ti/PbO2 at the anode with heterogeneous electro-Fenton was an efficient method. Industrial pyrite waste slag characterized by a variety of methods had catalytic performance and stable performance to activate hydrogen peroxide (H2O2) into hydroxyl radical (∙OH). Meanwhile, the processing conditions, the malachite green wastewater concentration, the current density, the pH range, and the dosage of industrial pyrite waste slag were emphatically optimized. Herein, the total organic carbon (TOC) removal efficiency reached 97.70%, the mineralization current efficiency (MCE) was 0.392%, and the energy consumption (EC) was 1.942 kWh/m3 after 240 min. Heterogeneous Ti/PbO2-electro-Fenton using industrial pyrite waste slag as catalyst was an environmentally friendly technology and provided a recycling method with traditional wastes. Finally, catalytic mechanisms and possible pathways were represented according to the results of quantum chemistry calculations and gas chromatography-mass spectrometry (GCMS).
- 28 February 2022
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (33) , 50218-50236
Heterogeneous Ti/PbO2-electro-Fenton degradation of aromatic methane dyes using industrial pyrite waste slag as catalyst
It is imperative to search the eco-friendly and cost-effective technologies for degrading contaminants. Coupling the effect of Ti/PbO2 at the anode with heterogeneous electro-Fenton was an efficient method. Industrial pyrite waste slag characterized by a variety of methods had catalytic performance and stable performance to activate hydrogen peroxide (H2O2) into hydroxyl radical (∙OH). Meanwhile, the processing conditions, the malachite green wastewater concentration, the current density, the pH range, and the dosage of industrial pyrite waste slag were emphatically optimized. Herein, the total organic carbon (TOC) removal efficiency reached 97.70%, the mineralization current efficiency (MCE) was 0.392%, and the energy consumption (EC) was 1.942 kWh/m3 after 240 min. Heterogeneous Ti/PbO2-electro-Fenton using industrial pyrite waste slag as catalyst was an environmentally friendly technology and provided a recycling method with traditional wastes. Finally, catalytic mechanisms and possible pathways were represented according to the results of quantum chemistry calculations and gas chromatography-mass spectrometry (GCMS).
- 1 February 2022
- Published by Elsevier in Chemosphere
- Vol. 289, 133014
Electrocatalysis degradation of coal tar wastewater using a novel hydrophobic benzalacetone modified lead dioxide electrode
- 1 February 2022
- Published by Elsevier in Chemosphere
- Vol. 289, 133014
Electrocatalysis degradation of coal tar wastewater using a novel hydrophobic benzalacetone modified lead dioxide electrode
- 27 January 2016
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 163 (5) , D179-D184
Preparation and Electrocatalytic Property of PbO2-CeO2Nanocomposite Electrodes by Pulse Reverse Electrodeposition Methods
PbO2-CeO2 nanocomposite electrodes were prepared by pulse reverse electrodeposition in the lead nitrate solution containing CeO2 nanoparticles. The effect of pulse reverse electrodeposition parameters, such as reverse pulse frequency, reverse peak current density and reverse duty cycle, on the content of CeO2 nanoparticles in the PbO2-CeO2 nanocomposite electrodes was investigated. The SEM and XRD tests show that PbO2-CeO2 nanocomposite electrodes possess finer grain size than PbO2-CeO2 nanocomposite electrodes (P) by pulse electrodeposition and PbO2-CeO2 nanocomposite electrodes (D) by direct current electrodeposition. The service life of PbO2-CeO2 nanocomposite electrodes can reach 285 h, which is 1.3 times longer than that of PbO2-CeO2 electrodes (P), and 2.3 times longer than that of PbO2-CeO2 electrodes (D). The electrochemical measurements show that PbO2-CeO2 nanocomposite electrodes possess highest oxygen evolution overpotential and largest electrochemical active surface area among these electrodes. The electrocatalytic property of PbO2-CeO2 nanocomposite electrodes was examined for the electrochemical degradation of methylene blue (MB). The bulk electrolysis shows that PbO2-CeO2 nanocomposite electrodes exhibit the highest COD removal efficiency and lowest energy consumption, which can be ascribed to the highest oxygen evolution overpotential, largest electrochemical active surface area and highest CeO2 content.
- 27 January 2016
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 163 (5) , D179-D184
Preparation and Electrocatalytic Property of PbO2-CeO2Nanocomposite Electrodes by Pulse Reverse Electrodeposition Methods
PbO2-CeO2 nanocomposite electrodes were prepared by pulse reverse electrodeposition in the lead nitrate solution containing CeO2 nanoparticles. The effect of pulse reverse electrodeposition parameters, such as reverse pulse frequency, reverse peak current density and reverse duty cycle, on the content of CeO2 nanoparticles in the PbO2-CeO2 nanocomposite electrodes was investigated. The SEM and XRD tests show that PbO2-CeO2 nanocomposite electrodes possess finer grain size than PbO2-CeO2 nanocomposite electrodes (P) by pulse electrodeposition and PbO2-CeO2 nanocomposite electrodes (D) by direct current electrodeposition. The service life of PbO2-CeO2 nanocomposite electrodes can reach 285 h, which is 1.3 times longer than that of PbO2-CeO2 electrodes (P), and 2.3 times longer than that of PbO2-CeO2 electrodes (D). The electrochemical measurements show that PbO2-CeO2 nanocomposite electrodes possess highest oxygen evolution overpotential and largest electrochemical active surface area among these electrodes. The electrocatalytic property of PbO2-CeO2 nanocomposite electrodes was examined for the electrochemical degradation of methylene blue (MB). The bulk electrolysis shows that PbO2-CeO2 nanocomposite electrodes exhibit the highest COD removal efficiency and lowest energy consumption, which can be ascribed to the highest oxygen evolution overpotential, largest electrochemical active surface area and highest CeO2 content.
- 9 October 2015
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 20 (2) , 353-359
Comparison of electrocatalytic characterization of Ti/Sb-SnO2 and Ti/F-PbO2 electrodes
- 9 October 2015
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 20 (2) , 353-359
Comparison of electrocatalytic characterization of Ti/Sb-SnO2 and Ti/F-PbO2 electrodes