Ivana Zrinski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ivana Zrinski has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Andrei Ionut Mardare
Institute of Chemical Technology of Inorganic Materials Johannes Kepler University Linz Linz Austria
5 shared publications - Achim Walter Hassel
Institute of Chemical Technology of Inorganic Materials, Johannes Kepler University (JKU) Linz, Altenberger Strasse 69, 4040 Linz, Austria
4 shared publications - Janez Zavašnik
Jozef Stefan Institute, Slovenia
2 shared publications Achim Walter Hassel
Institute of Chemical Technology of Inorganic Materials, Johannes Kepler University Linz, Austria
1 shared publication- Alexey Minenkov
Christian Doppler Laboratory for Nanoscale Phase Transformations, Center for Surface and Nanoanalytics, Johannes Kepler University Linz, Altenberger Str. 69, 4040 Linz, Austria
1 shared publication - Cezarina Cela Mardare
Institute of Chemical Technology of Inorganic Materials, Johannes Kepler University Linz, Altenberger Str. 69, 4040 Linz, Austria
1 shared publication
Latest Publications
- Open Access
Electrolyte Influence on Properties of Ultra-Thin Anodic Memristors on Titanium
Titanium anodic memristors were prepared in phosphate buffer (PB) and citrate buffer (CB) electrolytes. Studying their I-U sweeps, the memristors presented self-rectifying and volatile behaviors. Transmission electron microscopic analysis revealed crystalline protrusions inside a semi-crystalline Ti oxide. Grounded in this, a hybrid interfacial memristive switching mechanism relaying on partial filaments was proposed. Moreover, both analyzed memristor types demonstrated multilevel switching capabilities. The memristors anodized in the PB and CB showed high-to-low resistance ratios of 4 × 104 and 1.6 × 102, respectively. The observed (more than two order of magnitude) ratio improvement of the PB memristors suggests their better performance, in spite of their modestly high resistive state instabilities, attributed to the thermal stress caused by consecutive switching. The endurance and retention of both the PB and CB memristors was measured over up to 106 cycles, indicating very good lifetimes. Phosphate incorporation into the anodic oxide was confirmed by photoelectron spectroscopy analysis and was related to the improved memristive behavior of the PB sample. The presence of phosphate inside the memristively active layer modifies the availability of free O species (vacancies and ions) in the oxide. Taking all this into consideration, Ti anodic memristors anodized in PB are emphasized as candidates for neuromorphic computing.
Open AccessElectrolyte Influence on Properties of Ultra-Thin Anodic Memristors on Titanium
Titanium anodic memristors were prepared in phosphate buffer (PB) and citrate buffer (CB) electrolytes. Studying their I-U sweeps, the memristors presented self-rectifying and volatile behaviors. Transmission electron microscopic analysis revealed crystalline protrusions inside a semi-crystalline Ti oxide. Grounded in this, a hybrid interfacial memristive switching mechanism relaying on partial filaments was proposed. Moreover, both analyzed memristor types demonstrated multilevel switching capabilities. The memristors anodized in the PB and CB showed high-to-low resistance ratios of 4 × 104 and 1.6 × 102, respectively. The observed (more than two order of magnitude) ratio improvement of the PB memristors suggests their better performance, in spite of their modestly high resistive state instabilities, attributed to the thermal stress caused by consecutive switching. The endurance and retention of both the PB and CB memristors was measured over up to 106 cycles, indicating very good lifetimes. Phosphate incorporation into the anodic oxide was confirmed by photoelectron spectroscopy analysis and was related to the improved memristive behavior of the PB sample. The presence of phosphate inside the memristively active layer modifies the availability of free O species (vacancies and ions) in the oxide. Taking all this into consideration, Ti anodic memristors anodized in PB are emphasized as candidates for neuromorphic computing.
- Open Access
- 10 April 2023
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 13 (5) , 805-815
Anodic HfO2 crossbar arrays for hydroxide-based memristive sensing in liquids
The development of miniaturized and portable sensing devices is crucial to meeting the high processing capacity demands of contemporary computing systems. Hence, the conceptualization of memristive sensors for hydroxide-containing liquids is proposed in this study. Metal-insulator-metal (MIM) structures were formed on electrochemically anodized Hf thin films with Pt patterned as top electrodes. These MIM memristive structures were integrated into a crossbar array, allowing the investigation of a high number of potential memristor sensors. The MIM structures have demonstrated sensing possibilities in the detection of the hydroxyl ion in D-glucose, used as a standard solution. The sensing method was based on the resistive state ratio extracted from I-U sweeps measurements. Analytical characterization of the memristor sensor was done based on the resistive state ratio in relation to different concentrations of a standard solution drop cast directly on the surface of the device. Linearity was found for D-glucose concentrations ranging from 10 mM to 80 mM with a reasonable corresponding correlation factor (R2=0.96809). Additionally, D-glucose incorporation in anodic oxide was studied by XPS to investigate its effect on conductive filaments formation. A carbon bonded by a single covalent bond to oxygen (O-C-O) was detected, confirming the proposed sensing mechanism defined by the glucose penetrating the oxide/electrode interface.
- 10 April 2023
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 13 (5) , 805-815
Open AccessAnodic HfO2 crossbar arrays for hydroxide-based memristive sensing in liquids
The development of miniaturized and portable sensing devices is crucial to meeting the high processing capacity demands of contemporary computing systems. Hence, the conceptualization of memristive sensors for hydroxide-containing liquids is proposed in this study. Metal-insulator-metal (MIM) structures were formed on electrochemically anodized Hf thin films with Pt patterned as top electrodes. These MIM memristive structures were integrated into a crossbar array, allowing the investigation of a high number of potential memristor sensors. The MIM structures have demonstrated sensing possibilities in the detection of the hydroxyl ion in D-glucose, used as a standard solution. The sensing method was based on the resistive state ratio extracted from I-U sweeps measurements. Analytical characterization of the memristor sensor was done based on the resistive state ratio in relation to different concentrations of a standard solution drop cast directly on the surface of the device. Linearity was found for D-glucose concentrations ranging from 10 mM to 80 mM with a reasonable corresponding correlation factor (R2=0.96809). Additionally, D-glucose incorporation in anodic oxide was studied by XPS to investigate its effect on conductive filaments formation. A carbon bonded by a single covalent bond to oxygen (O-C-O) was detected, confirming the proposed sensing mechanism defined by the glucose penetrating the oxide/electrode interface.
- Open Access
- 9 November 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (22) , 3944
Threshold Switching in Forming-Free Anodic Memristors Grown on Hf–Nb Combinatorial Thin-Film Alloys
The development of novel materials with coexisting volatile threshold and non-volatile memristive switching is crucial for neuromorphic applications. Hence, the aim of this work was to investigate the memristive properties of oxides in a Hf–Nb thin-film combinatorial system deposited by sputtering on Si substrates. The active layer was grown anodically on each Hf–Nb alloy from the library, whereas Pt electrodes were deposited as the top electrodes. The devices grown on Hf-45 at.% Nb alloys showed improved memristive performances reaching resistive state ratios up to a few orders of magnitude and achieving multi-level switching behavior while consuming low power in comparison with memristors grown on pure metals. The coexistence of threshold and resistive switching is dependent upon the current compliance regime applied during memristive studies. Such behaviors were explained by the structure of the mixed oxides investigated by TEM and XPS. The mixed oxides, with HfO2 crystallites embedded in quasi amorphous and stoichiometrically non-uniform Nb oxide regions, were found to be favorable for the formation of conductive filaments as a necessary step toward memristive behavior. Finally, metal–insulator–metal structures grown on the respective alloys can be considered as relevant candidates for the future fabrication of anodic high-density in-memory computing systems for neuromorphic applications.
- 9 November 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (22) , 3944
Open AccessThreshold Switching in Forming-Free Anodic Memristors Grown on Hf–Nb Combinatorial Thin-Film Alloys
The development of novel materials with coexisting volatile threshold and non-volatile memristive switching is crucial for neuromorphic applications. Hence, the aim of this work was to investigate the memristive properties of oxides in a Hf–Nb thin-film combinatorial system deposited by sputtering on Si substrates. The active layer was grown anodically on each Hf–Nb alloy from the library, whereas Pt electrodes were deposited as the top electrodes. The devices grown on Hf-45 at.% Nb alloys showed improved memristive performances reaching resistive state ratios up to a few orders of magnitude and achieving multi-level switching behavior while consuming low power in comparison with memristors grown on pure metals. The coexistence of threshold and resistive switching is dependent upon the current compliance regime applied during memristive studies. Such behaviors were explained by the structure of the mixed oxides investigated by TEM and XPS. The mixed oxides, with HfO2 crystallites embedded in quasi amorphous and stoichiometrically non-uniform Nb oxide regions, were found to be favorable for the formation of conductive filaments as a necessary step toward memristive behavior. Finally, metal–insulator–metal structures grown on the respective alloys can be considered as relevant candidates for the future fabrication of anodic high-density in-memory computing systems for neuromorphic applications.
- Open Access
- 28 February 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (5) , 813
Impact of Electrolyte Incorporation in Anodized Niobium on Its Resistive Switching
The aim of this study was to develop memristors based on Nb2O5 grown by a simple and inexpensive electrochemical anodization process. It was confirmed that the electrolyte selection plays a crucial role in resistive switching due to electrolyte species incorporation in oxide, thus influencing the formation of conductive filaments. Anodic memristors grown in phosphate buffer showed improved electrical characteristics, while those formed in citrated buffer exhibited excellent memory capabilities. The chemical composition of oxides was successfully determined using HAXPES, while their phase composition and crystal structure with conductive filaments was assessed by TEM at the nanoscale. Overall, understanding the switching mechanism leads towards a wide range of possible applications for Nb memristors either as selector devices or nonvolatile memories.
- 28 February 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (5) , 813
Open AccessImpact of Electrolyte Incorporation in Anodized Niobium on Its Resistive Switching
The aim of this study was to develop memristors based on Nb2O5 grown by a simple and inexpensive electrochemical anodization process. It was confirmed that the electrolyte selection plays a crucial role in resistive switching due to electrolyte species incorporation in oxide, thus influencing the formation of conductive filaments. Anodic memristors grown in phosphate buffer showed improved electrical characteristics, while those formed in citrated buffer exhibited excellent memory capabilities. The chemical composition of oxides was successfully determined using HAXPES, while their phase composition and crystal structure with conductive filaments was assessed by TEM at the nanoscale. Overall, understanding the switching mechanism leads towards a wide range of possible applications for Nb memristors either as selector devices or nonvolatile memories.
- Open Access
- 8 March 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (3) , 666
Electrolyte-Dependent Modification of Resistive Switching in Anodic Hafnia
Anodic HfO2 memristors grown in phosphate, borate, or citrate electrolytes and formed on sputtered Hf with Pt top electrodes are characterized at fundamental and device levels. The incorporation of electrolyte species deep into anodic memristors concomitant with HfO2 crystalline structure conservation is demonstrated by elemental analysis and atomic scale imaging. Upon electroforming, retention and endurance tests are performed on memristors. The use of borate results in the weakest memristive performance while the citrate demonstrates clear superior memristive properties with multilevel switching capabilities and high read/write cycling in the range of 106. Low temperature heating applied to memristors shows a direct influence on their behavior mainly due to surface release of water. Citrate-based memristors show remarkable properties independent on device operation temperatures up to 100 °C. The switching dynamic of anodic HfO2 memristors is discussed by analyzing high resolution transmission electron microscope images. Full and partial conductive filaments are visualized, and apart from their modeling, a concurrency of filaments is additionally observed. This is responsible for the multilevel switching mechanism in HfO2 and is related to device failure mechanisms.
- 8 March 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (3) , 666
Open AccessElectrolyte-Dependent Modification of Resistive Switching in Anodic Hafnia
Anodic HfO2 memristors grown in phosphate, borate, or citrate electrolytes and formed on sputtered Hf with Pt top electrodes are characterized at fundamental and device levels. The incorporation of electrolyte species deep into anodic memristors concomitant with HfO2 crystalline structure conservation is demonstrated by elemental analysis and atomic scale imaging. Upon electroforming, retention and endurance tests are performed on memristors. The use of borate results in the weakest memristive performance while the citrate demonstrates clear superior memristive properties with multilevel switching capabilities and high read/write cycling in the range of 106. Low temperature heating applied to memristors shows a direct influence on their behavior mainly due to surface release of water. Citrate-based memristors show remarkable properties independent on device operation temperatures up to 100 °C. The switching dynamic of anodic HfO2 memristors is discussed by analyzing high resolution transmission electron microscope images. Full and partial conductive filaments are visualized, and apart from their modeling, a concurrency of filaments is additionally observed. This is responsible for the multilevel switching mechanism in HfO2 and is related to device failure mechanisms.