Roman Rössler
Research Subjects
Roman Rössler has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Andreas Viertauer
RHI Magnesita GmbH, Vienna, Austria
1 shared publication - Christoph Truschner
Voestalpine Stahl GmbH
1 shared publication - Christoph Walkner
Chair of General and Analytical Chemistry, Montanuniversität Leoben, Franz Josef-Straße 18, 8700 Leoben, Austria
1 shared publication - Elizaveta Cheremisina
Institute of Multidisciplinary Research for Advanced Materials, Tohoku University
1 shared publication - Gernot Heine
Faculty of Physics, University of Vienna, Boltzmanngasse 5, A-1090 Wien, Austria
1 shared publication - Johannes David Pedarnig
Johannes Kepler University Linz
1 shared publication
Latest Publications
- Open Access
Investigating the Origin of Non-Metallic Inclusions in Ti-Stabilized ULC Steels Using Different Tracing Techniques
Since steel cleanness comes to the fore of steel producers worldwide, it is necessary to understand the formation mechanism and modification of non-metallic inclusions (NMIs) in more detail. One central point is the identification of the source of especially interfering NMIs to prevent their evolution in the future. The present study applies two approaches to determine the source of NMIs in Ti-stabilized ultra-low carbon (ULC) steels—the active and the passive tracing. Both approaches are applied to an industrial experiment. The active tracing technique is focused on investigating the clogging layer formation in submerged entry nozzles and, hence, the origin of alumina particles. This method adds rare earth elements (REEs) directly to the melt to mark pre-existing deoxidation products at a certain point of the steelmaking process. The main concern of the passive method, the so-called REE fingerprint, is the determination of the source of mesoscopic NMIs. For the REE fingerprint, the pre-existing concentration of REEs in different potential sources and the investigated NMIs are measured by using an inductively coupled plasma mass spectrometer (ICP-MS). The resulting patterns are compared after normalizing the contents to chondrites, and the NMIs’ origins are identified. Concerning the EDS analysis and the resulting patterns from the REE fingerprint, the mold slag and, respectively, the casting powder were the sources of the investigated NMIs.
Open AccessInvestigating the Origin of Non-Metallic Inclusions in Ti-Stabilized ULC Steels Using Different Tracing Techniques
Since steel cleanness comes to the fore of steel producers worldwide, it is necessary to understand the formation mechanism and modification of non-metallic inclusions (NMIs) in more detail. One central point is the identification of the source of especially interfering NMIs to prevent their evolution in the future. The present study applies two approaches to determine the source of NMIs in Ti-stabilized ultra-low carbon (ULC) steels—the active and the passive tracing. Both approaches are applied to an industrial experiment. The active tracing technique is focused on investigating the clogging layer formation in submerged entry nozzles and, hence, the origin of alumina particles. This method adds rare earth elements (REEs) directly to the melt to mark pre-existing deoxidation products at a certain point of the steelmaking process. The main concern of the passive method, the so-called REE fingerprint, is the determination of the source of mesoscopic NMIs. For the REE fingerprint, the pre-existing concentration of REEs in different potential sources and the investigated NMIs are measured by using an inductively coupled plasma mass spectrometer (ICP-MS). The resulting patterns are compared after normalizing the contents to chondrites, and the NMIs’ origins are identified. Concerning the EDS analysis and the resulting patterns from the REE fingerprint, the mold slag and, respectively, the casting powder were the sources of the investigated NMIs.
- 13 August 2021
- Published by Springer Nature in Metallurgical and Materials Transactions B
- Vol. 52 (5) , 2939-2950
Evaluation of Dissolution Rate and Behavior of MgO Carriers for Primary and Secondary Metallurgical Slags
- 13 August 2021
- Published by Springer Nature in Metallurgical and Materials Transactions B
- Vol. 52 (5) , 2939-2950
Evaluation of Dissolution Rate and Behavior of MgO Carriers for Primary and Secondary Metallurgical Slags
- Open Access
- 9 March 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (3) , 675
Anisotropy of the In-Plane and Out-of-Plane Resistivity and the Hall Effect in the Normal State of Vicinal-Grown YBa2Cu3O7−δ Thin Films
The resistivity and the Hall effect in the copper-oxide high-temperature superconductor YBaCuO (YBCO) are remarkably anisotropic. Using a thin film of YBCO grown on an off-axis cut SrTiO substrate allows one to investigate these anisotropic transport properties in a planar and well-defined sample geometry employing a homogeneous current density. In the normal state, the Hall voltage probed parallel to the copper-oxide layers is positive and strongly temperature dependent, whereas the out-of-plane Hall voltage is negative and almost temperature independent. The results confirm previous measurements on single crystals by an entirely different measurement method and demonstrate that vicinal thin films might be also useful for investigations of other layered nanomaterials.- 9 March 2021
- Published by MDPI AG in Nanomaterials
- Vol. 11 (3) , 675
Open AccessAnisotropy of the In-Plane and Out-of-Plane Resistivity and the Hall Effect in the Normal State of Vicinal-Grown YBa2Cu3O7−δ Thin Films
The resistivity and the Hall effect in the copper-oxide high-temperature superconductor YBaCuO (YBCO) are remarkably anisotropic. Using a thin film of YBCO grown on an off-axis cut SrTiO substrate allows one to investigate these anisotropic transport properties in a planar and well-defined sample geometry employing a homogeneous current density. In the normal state, the Hall voltage probed parallel to the copper-oxide layers is positive and strongly temperature dependent, whereas the out-of-plane Hall voltage is negative and almost temperature independent. The results confirm previous measurements on single crystals by an entirely different measurement method and demonstrate that vicinal thin films might be also useful for investigations of other layered nanomaterials.