SYShinji Yamada

Shinji Yamada

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shinji Yamada has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Depth‐Resolved Photoluminescence for Channeling Implantation of Mg or Mg/N Ions into GaN after Ultra‐High‐Pressure Annealing

    by Keita Kataoka, Tetsuo Narita, Kazuyoshi Tomita, Shinji Yamada, Tetsu Kachi

    P‐type doping profiles designed for a junction termination extension (JTE) in vertical GaN power devices fabricated by channeling ion implantation (I/I) of Mg or Mg/N ions into GaN and subsequent ultra‐high‐pressure annealing at 1300 °C are analyzed by depth‐resolved photoluminescence (PL) spectroscopy. PL spectra are acquired after low‐damage dry etching to different depths. The activated Mg acceptor concentration is quantified at each depth from the calibration curve using the PL intensity ratio between acceptor‐bound excitons (A 0 X A ) and free excitons (FX A ). Residual nonradiative recombination centers (NRCs) are also discussed on the basis of the PL intensity profiles. Most of the implanted Mg ions are substituted into Ga sites in both cases of Mg‐I/I and Mg/N‐I/I. By contrast, the concentration of residual NRCs near the mean implantation depth is substantially reduced in the Mg/N‐I/I case. The rapid substitution of Mg ions into Ga sites and the enhanced I/I defect recovery by sequential N‐I/I observed in the channeling I/I case are similar to those observed in the random I/I case reported previously. It is concluded that channeling Mg/N‐I/I is a suitable process for fabricating JTEs with deep p‐type profiles containing low I/I defect concentrations.


  • Rapid Mg substitution to Ga-sites and slow defect recovery revealed by depth-resolved photoluminescence in Mg/N-ion-implanted GaN

    by Keita Kataoka, Tetsuo Narita, Kazuyoshi Tomita, Shinji Yamada, Tetsu Kachi

    Toward p-type GaN formation by Mg ion implantation (I/I) applicable to devices, depth-resolved photoluminescence (PL) revealed key behaviors during activation annealing for precise profile control, such as Mg substitution into Ga-sites (MgGa) and recovery of I/I defects. Depth profiles of the MgGa acceptor concentration were measured for Mg-I/I and Mg/N-I/I samples after ultra-high-pressure annealing at 1300 °C for 1–60 min. The cycle of low-damage dry etching and PL measurement was repeated over the I/I depth, and the MgGa concentration was estimated at each depth based on the calibration curve for the PL intensity ratio between acceptor-bound excitons (A0XA) and free excitons (FXA). In the region deeper than the I/I peak of 0.3 μm, almost all of the Mg atoms rapidly substituted into Ga-sites during the short annealing process. By contrast, the Mg substitution ratios in the shallower region were low when the annealing process was short but were improved by the sequential N-I/I. The low substitution ratio can be explained by MgGa bonding with nitrogen vacancy (VN)-related defects, while the implanted N-ions can compensate them. The PL intensity near the mean implantation depth of Mg/N-I/I was gradually improved as the annealing duration was increased to 60 min, indicating a slow reduction of nonradiative recombination centers. Simultaneously, the green luminescence associated with the VN-related defects decreased in intensity with increasing annealing time. Therefore, the main effect of prolonging annealing is the enhancement of slow defect recovery rather than enhancement of the Mg substitution as a fast process.


  • A distinctive bound exciton line induced by electron-beam irradiation and subsequent annealing of an unintentionally doped GaN layer

    by Hiroko Iguchi, Keita Kataoka, Masahiro Horita, Tetsuo Narita, Shinji Yamada, Kazuyoshi Tomita, Tetsu Kachi, Jun Suda

    An undefined bound exciton line (UDX) with a photon energy 0.6 meV lower than the Si-donor bound exciton line was observed by photoluminescence in gallium nitride (GaN) layers annealed at 1100 °C after electron beam (EB) irradiation at an energy of 137–2000 keV. The UDX was not observed in samples not subjected to EB irradiation or annealing but was found in a sample annealed after EB irradiation at an energy of 137 keV, where only nitrogen atoms are displaced in GaN. The origin of the UDX was presumably formed by a thermal reaction of defects containing nitrogen-displacement-related defects.

  • Open Access

    Realization of low specific-contact-resistance on N-polar GaN surfaces using heavily-Ge-doped n-type GaN films deposited by low-temperature reactive sputtering technique

    by Shinji Yamada, Masanori Shirai, Hiroki Kobayashi, Manabu Arai, Tetsu Kachi, Jun Suda

    We developed a low-temperature ohmic contact formation process for N-polar GaN surfaces. Specific-contact-resistances of 9.4 × 10−5 and 2.0 × 10−5 Ω cm2 were obtained using Ti/Al metal stacks on heavily-germanium-doped GaN films, which were deposited at 500 °C and 600 °C using a radical-assisted reactive sputtering method, respectively. The electrode sintering temperature was as low as 475 °C. Carrier concentrations for the 500 °C and 600 °C samples were 2.6 × 1020 and 1.8 × 1020 cm−3, respectively. These results suggest that this method is highly effective in reducing the contact resistance of GaN devices with low thermal budgets.


  • Depth Analyses of Mg‐Acceptor and Si‐Donor Concentrations in GaN by Combining Stepwise Etching and Photoluminescence

    by Keita Kataoka, Tetsuo Narita, Kazuyoshi Tomita, Shinji Yamada, Tetsu Kachi

    The depth profiles of the Mg‐acceptor or Si‐donor concentration in GaN are visualized using stepwise etching and photoluminescence (PL) measurements. Low‐damage etching techniques are applied: multistep‐bias inductively coupled plasma reactive ion etching for p‐type GaN and electrochemical etching for n‐type GaN. To determine the concentration calibration curve, the PL intensity ratios of Mg‐neutral acceptor or Si‐neutral donor‐bound excitons to free excitons are plotted against Mg or Si atomic concentrations in etched GaN epitaxial layers having depth distributions of dopant concentrations, as estimated by secondary ion mass spectrometry. The quantitative accuracy of the calibration curve is ensured by the appropriate sample temperature and excitation density ranges for PL. The stepwise dry etching and the Mg acceptor quantification by PL using this calibration curve are applied to Mg‐ion‐implanted GaN after ultra‐high‐pressure annealing at 1300 °C for 1 min. The obtained depth profile of the Mg‐acceptor concentration is consistent with the Mg atomic concentration profile in the region deeper than the implantation peak, whereas the acceptor concentration in the shallow region is lower than the Mg atomic concentration. This analysis is useful for revealing the site substitution ratio of dopants in GaN materials partially involving inactive dopants.


  • Effects of the sequential implantation of Mg and N ions into GaN for p-type doping

    by Hideki Sakurai, Tetsuo Narita, Keita Kataoka, Kazufumi Hirukawa, Kensuke Sumida, Shinji Yamada, Kacper Sierakowski, Masahiro Horita, Nobuyuki Ikarashi, Michal Bockowski, et al.


  • Top Cited Papers

    Impact ionization coefficients and critical electric field in GaN

    by Takuya Maeda, Tetsuo Narita, Shinji Yamada, Tetsu Kachi, Tsunenobu Kimoto, Masahiro Horita, Jun Suda

    Avalanche multiplication characteristics in a reverse-biased homoepitaxial GaN p–n junction diode are experimentally investigated at 223–373 K by novel photomultiplication measurements utilizing above- and below-bandgap illumination. The device has a non-punch-through one-side abrupt p–-n+ junction structure, in which the depletion layer mainly extends to the p-type region. For above-bandgap illumination, the light is absorbed at the surface p+-layer, and the generated electrons diffuse and reach the depletion layer, resulting in an electron-injected photocurrent. On the other hand, for below-bandgap illumination, the light penetrates a GaN layer and is absorbed owing to the Franz–Keldysh effect in the high electric field region (near the p–n junction interface), resulting in a hole-induced photocurrent. The theoretical (non-multiplicated) photocurrents are calculated elaborately, and the electron- and hole-initiated multiplication factors are extracted as ratios of the experimental data to the calculated values. Through the mathematical analyses of the multiplication factors, the temperature dependences of the impact ionization coefficients of electrons and holes in GaN are extracted and formulated by the Okuto–Crowell model. The ideal breakdown voltage and the critical electric field for GaN p–n junctions of varying doping concentration are simulated using the obtained impact ionization coefficients, and their temperature dependence and conduction-type dependence were discussed. The simulated breakdown characteristics show good agreement with data reported previously, suggesting the high accuracy of the impact ionization coefficients obtained in this study.


  • Formation of highly vertical trenches with rounded corners via inductively coupled plasma reactive ion etching for vertical GaN power devices

    by Shinji Yamada, Hideki Sakurai, Yamato Osada, Kanji Furuta, Toshiyuki Nakamura, Ryuichiro Kamimura, Tetsuo Narita, Jun Suda, Tetsu Kachi

    A trench-gate metal-oxide-semiconductor field-effect transistor (T-MOSFET) has great potential for use in gallium nitride (GaN)-based vertical power switching devices owing to its high blocking voltage and high current capability. To form an optimal trench shape that has highly vertical sidewalls and rounded corners, we developed a dry-etching technique using inductively coupled plasma reactive ion etching (ICP-RIE). A highly vertical trench was obtained by including SiCl4 reactive gas mixed with Cl2 gas in the ICP-RIE process, where Si-related byproducts suppressed the etching of the sidewall and allowed selective etching in the vertical direction. We found that the optimization of the bias power was a key to suppress the formation of subtrenches and to avoid an isotropic etching mode. The optimal etching condition leads to natural formation of rounded corners at the trench bottom. In addition, a multistep-bias etching technique was applied to reduce etching-induced damage. Cross-sectional transmission electron microscopy images revealed that lattice distortion on the sidewall surface was eliminated by multistep-bias etching. Based on the rectification properties of the Schottky barrier diodes formed on the trench sidewalls, the Schottky barrier height was comparable to the not-etched surfaces. This indicates that the gap states caused by etching-induced damage can almost be eliminated in the multistep-bias process. The proposed technique is suitable for GaN-based vertical T-MOSFETs.


  • Depth profiling of surface damage in n-type GaN induced by inductively coupled plasma reactive ion etching using photo-electrochemical techniques

    by Shinji Yamada, Kentaro Takeda, Masachika Toguchi, Hideki Sakurai, Toshiyuki Nakamura, Jun Suda, Tetsu Kachi, Taketomo Sato


  • Reduction of plasma-induced damage in n-type GaN by multistep-bias etching in inductively coupled plasma reactive ion etching

    by Shinji Yamada, Masato Omori, Hideki Sakurai, Yamato Osada, Ryuichiro Kamimura, Tamotsu Hashizume, Jun Suda, Tetsu Kachi