Xiaoyan Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Xiaoyan Wu has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
Mi Li
University of South China
3 shared publicationsXiaowen Zhang
3 shared publications- Tao Cai
University of South China
2 shared publications Yilong Hua
University of South China
2 shared publications- Chunqiao Xiao
School of Environmental Ecology and Biological Engineering, Wuhan Institute of Technology, Wuhan 430205, China
1 shared publication Chunxue Lv
University of South China, Hengyang, China
1 shared publication
Latest Publications
- 29 August 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (36) , 26774-26786
Regulating Pore Space Occupancy via Fe0 Content in Amino-Functionalized Silica for Stable Uranium Immobilization
Incorporating Fe0 into the porosity of silicon-based materials can overcome the shortcomings of nanozero-valent iron (nZVI), such as aggregation, passivation, and secondary release of reduction products. The mass transfer resistance due to iron oxidation expansion and consequent pore blockage during uranium reductive coprecipitation remains unclear. The present work employed amino-functionalized mesoporous silica (NH2–SGB) as the support to precisely regulate the spatial occupancy rate of Fe0 in the pores, and synthesized a series of Fe0@NH2–SGB (x-PV, x = 0.00, 0.33, 0.50, and 0.67) composites. Batch experiments and structural characterization results illustrated that Fe0@NH2–SGB (0.33-PV) achieved 97.0% U(VI) removal and an equilibrium immobilization capacity of 48.3 mg·g–1 from 10 mg·L–1 initial U(VI) solution at pH 5.0 with 0.2 g·L–1 added, and a Langmuir-fitted theoretical maximum adsorption capacity of 449.43 mg·g–1 at room temperature, which is better than that of 0.50-PV and 0.67-PV. The reserved redundant pore of Fe0@NH2–SGB (0.33-PV) can effectively accommodate the iron–uranium coprecipitation products, maintain the unobstructed mass transfer channels, and avoid the orifice blockage effect, resulting in an effective utilization rate of Fe0 to 98.2%, which exceeded that of 0.67-PV (46.7%), the uranium fixation product achieved a spatial fit of up to 89.1% pore volume and realized confined encapsulation in the pore. Mechanistic analysis revealed that the immobilization of U(VI) first took place on the surface of the sample via selective trapping by −NH2 groups. Subsequently, the Fe0 and Fe(II) in the pores efficiently reduced U(VI) to U(IV) and achieved stable self-sealing immobilization. Meanwhile, continuous 30-day static desorption tests and acid stress tests showed uranium leaching rates consistently below 0.5%, confirming the long-term stabilization effect of the confinement encapsulation strategy. It provides a novel material design strategy for the rational design of confined nanomaterials and the long-term immobilization of uranium in contaminated groundwater.
- 29 August 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (36) , 26774-26786
Regulating Pore Space Occupancy via Fe0 Content in Amino-Functionalized Silica for Stable Uranium Immobilization
Incorporating Fe0 into the porosity of silicon-based materials can overcome the shortcomings of nanozero-valent iron (nZVI), such as aggregation, passivation, and secondary release of reduction products. The mass transfer resistance due to iron oxidation expansion and consequent pore blockage during uranium reductive coprecipitation remains unclear. The present work employed amino-functionalized mesoporous silica (NH2–SGB) as the support to precisely regulate the spatial occupancy rate of Fe0 in the pores, and synthesized a series of Fe0@NH2–SGB (x-PV, x = 0.00, 0.33, 0.50, and 0.67) composites. Batch experiments and structural characterization results illustrated that Fe0@NH2–SGB (0.33-PV) achieved 97.0% U(VI) removal and an equilibrium immobilization capacity of 48.3 mg·g–1 from 10 mg·L–1 initial U(VI) solution at pH 5.0 with 0.2 g·L–1 added, and a Langmuir-fitted theoretical maximum adsorption capacity of 449.43 mg·g–1 at room temperature, which is better than that of 0.50-PV and 0.67-PV. The reserved redundant pore of Fe0@NH2–SGB (0.33-PV) can effectively accommodate the iron–uranium coprecipitation products, maintain the unobstructed mass transfer channels, and avoid the orifice blockage effect, resulting in an effective utilization rate of Fe0 to 98.2%, which exceeded that of 0.67-PV (46.7%), the uranium fixation product achieved a spatial fit of up to 89.1% pore volume and realized confined encapsulation in the pore. Mechanistic analysis revealed that the immobilization of U(VI) first took place on the surface of the sample via selective trapping by −NH2 groups. Subsequently, the Fe0 and Fe(II) in the pores efficiently reduced U(VI) to U(IV) and achieved stable self-sealing immobilization. Meanwhile, continuous 30-day static desorption tests and acid stress tests showed uranium leaching rates consistently below 0.5%, confirming the long-term stabilization effect of the confinement encapsulation strategy. It provides a novel material design strategy for the rational design of confined nanomaterials and the long-term immobilization of uranium in contaminated groundwater.
- 30 August 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 498
Separate or simultaneous treatment of nitrate and uranium in groundwater via bioremediation: Review and prospect
- 30 August 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 498
Separate or simultaneous treatment of nitrate and uranium in groundwater via bioremediation: Review and prospect
- Open Access
- 4 November 2022
- Published by Elsevier in Journal of Rare Earths
- Vol. 42 (1) , 181-190
Application of surfactant for improving leaching process of weathered crust elution-deposited rare earth ores
- 4 November 2022
- Published by Elsevier in Journal of Rare Earths
- Vol. 42 (1) , 181-190
Open AccessApplication of surfactant for improving leaching process of weathered crust elution-deposited rare earth ores
- Open Access
- 22 February 2022
- Published by Frontiers Media SA in Frontiers in Chemistry
- Vol. 10, 835959
Dual Effect of Acetic Acid Efficiently Enhances Sludge-Based Biochar to Recover Uranium From Aqueous Solution
Excess sludge (ES) treatment and that related to the uranium recovery from uranium-containing wastewater (UCW) are two hot topics in the field of environmental engineering. Sludge-based biochar (SBB) prepared from ES was used to recover uranium from UCW. Excellent effects were achieved when SBB was modified by acetic acid. Compared with SBB, acetic acid-modified SBB (ASBB) has shown three characteristics deserving interest: 1) high sorption efficiency, in which the sorption ratio of U(VI) was increased by as high as 35.0%; 2) fast sorption rate, as the equilibrium could be achieved within 5.0 min; 3) satisfied sorption/desorption behavior; as a matter of fact, the sorption rate of U(VI) could still be maintained at 93.0% during the test cycles. In addition, based on the test conditions and various characterization results, it emerged as a dual effect of acetic acid on the surface of SBB, i.e., to increase the porosity and add (−COOH) groups. It was revealed that U(VI) and −COO− combined in the surface aperture of ASBB via single-dentate coordination. Altogether, a new utilization mode for SBB is here proposed, as a means of efficient uranium sorption from UCW.
- 22 February 2022
- Published by Frontiers Media SA in Frontiers in Chemistry
- Vol. 10, 835959
Open AccessDual Effect of Acetic Acid Efficiently Enhances Sludge-Based Biochar to Recover Uranium From Aqueous Solution
Excess sludge (ES) treatment and that related to the uranium recovery from uranium-containing wastewater (UCW) are two hot topics in the field of environmental engineering. Sludge-based biochar (SBB) prepared from ES was used to recover uranium from UCW. Excellent effects were achieved when SBB was modified by acetic acid. Compared with SBB, acetic acid-modified SBB (ASBB) has shown three characteristics deserving interest: 1) high sorption efficiency, in which the sorption ratio of U(VI) was increased by as high as 35.0%; 2) fast sorption rate, as the equilibrium could be achieved within 5.0 min; 3) satisfied sorption/desorption behavior; as a matter of fact, the sorption rate of U(VI) could still be maintained at 93.0% during the test cycles. In addition, based on the test conditions and various characterization results, it emerged as a dual effect of acetic acid on the surface of SBB, i.e., to increase the porosity and add (−COOH) groups. It was revealed that U(VI) and −COO− combined in the surface aperture of ASBB via single-dentate coordination. Altogether, a new utilization mode for SBB is here proposed, as a means of efficient uranium sorption from UCW.
- 1 February 2017
- Published by Taylor & Francis in Preparative Biochemistry & Biotechnology
- Vol. 47 (6) , 562-569
Optimizations of particle size and pulp density for solubilization of rock phosphate by a microbial consortium from activated sludge
Microbial solubilization of rock phosphate is getting more and more attention recently. However, the microorganisms used in previous studies were mostly single or known species, and seldom studies focused on the mixed microorganisms or microbial consortia from natural environments. In this study, a microbial consortium taken from activated sludge was used to solubilize two different mid-low-grade rock phosphates. The results showed that the microbial consortium could effectively solubilize the rock phosphates in National Botanical Research Institute’s phosphate growth medium and released soluble phosphorus in the broth. The biomass increased gradually, whereas the pH decreased sharply during the solubilizing process. The maximum phosphorus solubilization was recorded at particle size of 150 µm. Higher or lower than this optimal particle size, the phosphorus solubilization decreased. The phosphorus solubilization gradually decreased with a larger pulp density from 1 to 5%, and the optimal pulp density was 1%. The solubilization level of microbial consortium varied with different rock phosphates. The results revealed that the soluble phosphorus released from high-silicon ore was higher than which from high-magnesium ore. A strong positive correlation between biomass and phosphorus solubilization in the broth was observed from regression analysis results, and the phosphorus solubilization also had a significant negative correlation with pH in the broth.
- 1 February 2017
- Published by Taylor & Francis in Preparative Biochemistry & Biotechnology
- Vol. 47 (6) , 562-569
Optimizations of particle size and pulp density for solubilization of rock phosphate by a microbial consortium from activated sludge
Microbial solubilization of rock phosphate is getting more and more attention recently. However, the microorganisms used in previous studies were mostly single or known species, and seldom studies focused on the mixed microorganisms or microbial consortia from natural environments. In this study, a microbial consortium taken from activated sludge was used to solubilize two different mid-low-grade rock phosphates. The results showed that the microbial consortium could effectively solubilize the rock phosphates in National Botanical Research Institute’s phosphate growth medium and released soluble phosphorus in the broth. The biomass increased gradually, whereas the pH decreased sharply during the solubilizing process. The maximum phosphorus solubilization was recorded at particle size of 150 µm. Higher or lower than this optimal particle size, the phosphorus solubilization decreased. The phosphorus solubilization gradually decreased with a larger pulp density from 1 to 5%, and the optimal pulp density was 1%. The solubilization level of microbial consortium varied with different rock phosphates. The results revealed that the soluble phosphorus released from high-silicon ore was higher than which from high-magnesium ore. A strong positive correlation between biomass and phosphorus solubilization in the broth was observed from regression analysis results, and the phosphorus solubilization also had a significant negative correlation with pH in the broth.