Tianying Niu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Tianying Niu has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Chuanyu Du
School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, China
1 shared publication - Na Wang
School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, China
1 shared publication - Qingcai Chen
School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, China
1 shared publication - Wanli Song
Northeastern University
1 shared publication - Zhiguo Lu
School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, China
1 shared publication
Latest Publications
- Open Access
Wear and Friction Characteristics of 65Mn Steel for Spike-Tooth Harrow
The friction and wear characteristics of spike-tooth material (65Mn steel) of Spike-Tooth Harrow in a two-stage peanut harvester were studied in this paper. The friction and wear tests of pin and disc on 65 manganese steel were carried out on the tribometer, then the wear loss and the friction coefficient were studied. The wear loss of the pin was acquired by calculating the mass of the pin before and after the experiment using an electronic balance. According to the actual working environment of peanut spring-finger, four variable parameters are set up: load, speed, soil moisture and soil type. The friction and wear characteristics of pins were studied under different loads, speeds and different soil environments. After wearing, the worn surface of the material was observed by scanning microscope and the wear mechanism was studied. The experimental results show that the wear of the pin increases with the increase of load and decreases with the increase of rotational speed in the same rotation number. Especially in the case of the sandy soil with 20% in moisture, a maximum wear loss of the pin is achieved.
Open AccessWear and Friction Characteristics of 65Mn Steel for Spike-Tooth Harrow
The friction and wear characteristics of spike-tooth material (65Mn steel) of Spike-Tooth Harrow in a two-stage peanut harvester were studied in this paper. The friction and wear tests of pin and disc on 65 manganese steel were carried out on the tribometer, then the wear loss and the friction coefficient were studied. The wear loss of the pin was acquired by calculating the mass of the pin before and after the experiment using an electronic balance. According to the actual working environment of peanut spring-finger, four variable parameters are set up: load, speed, soil moisture and soil type. The friction and wear characteristics of pins were studied under different loads, speeds and different soil environments. After wearing, the worn surface of the material was observed by scanning microscope and the wear mechanism was studied. The experimental results show that the wear of the pin increases with the increase of load and decreases with the increase of rotational speed in the same rotation number. Especially in the case of the sandy soil with 20% in moisture, a maximum wear loss of the pin is achieved.