Sophia K. Tushak
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sophia K. Tushak has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Jason R. Kerrigan
Center for Applied Biomechanics, Department of Mechanical and Aerospace Engineering, University of Virginia, Charlottesville, VA, USA
4 shared publicationsBengt Pipkorn
Autoliv Research, Vårgårda, Sweden
3 shared publicationsBronislaw D. Gepner
Center for Applied Biomechanics, University of Virginia, Charlottesville, USA
3 shared publicationsJason J. Hallman
Toyota Motor Engineering & Manufacturing North America, Inc., Saline, USA
3 shared publicationsJason L. Forman
Center for Applied Biomechanics, University of Virginia, Charlottesville, USA
3 shared publications- Jason R. Kerrigan
Center for Applied Biomechanics, University of Virginia, Charlottesville, VA, 22911, USA
2 shared publications
Latest Publications
- Open Access
Effect of Varying Child Restraint System Seatback Angle on Spinal Loading of 1.5 YO and 3 YO PIPER Human Body Models in Frontal Impacts
This computational study examined how variations in the seatback angle of two generic child restraint systems (CRSs) affect spinal loading in young occupants (1.5 YO and 3 YO) during frontal impacts, performed according to the specifications included in UNECE R129. CRS seatback angle dictates torso recline, which in turn influences head, chest, and spine kinematics and loading. While manufacturers typically recommend 30–45° for rear-facing CRSs and an upright position for forward-facing CRSs, little is known about the biomechanical implications of deviating from these guidelines. Using PIPER human body models representing a 1.5-year-old in a rear-facing CRS and a 3-year-old in a forward-facing CRS, simulations were performed under UN-R129 frontal impact conditions. The seatbacks were rotated 5° and 10° more upright or reclined relative to the nominal angle, with occupants restrained by a five-point harness and CRSs secured with ISOFIX, top tether, or three-point belt. The results showed that reclined configurations generally increased the predictions of spinal loading (forces and/or moments) given by the PIPER model, while nominal or more upright angles reduced loads, particularly in the lumbar spine of the 3-year-old model. Overall, the study highlights how computational tools can guide CRS design improvements to optimize spinal protection and enhance child safety beyond current regulatory requirements.
Open AccessEffect of Varying Child Restraint System Seatback Angle on Spinal Loading of 1.5 YO and 3 YO PIPER Human Body Models in Frontal Impacts
This computational study examined how variations in the seatback angle of two generic child restraint systems (CRSs) affect spinal loading in young occupants (1.5 YO and 3 YO) during frontal impacts, performed according to the specifications included in UNECE R129. CRS seatback angle dictates torso recline, which in turn influences head, chest, and spine kinematics and loading. While manufacturers typically recommend 30–45° for rear-facing CRSs and an upright position for forward-facing CRSs, little is known about the biomechanical implications of deviating from these guidelines. Using PIPER human body models representing a 1.5-year-old in a rear-facing CRS and a 3-year-old in a forward-facing CRS, simulations were performed under UN-R129 frontal impact conditions. The seatbacks were rotated 5° and 10° more upright or reclined relative to the nominal angle, with occupants restrained by a five-point harness and CRSs secured with ISOFIX, top tether, or three-point belt. The results showed that reclined configurations generally increased the predictions of spinal loading (forces and/or moments) given by the PIPER model, while nominal or more upright angles reduced loads, particularly in the lumbar spine of the 3-year-old model. Overall, the study highlights how computational tools can guide CRS design improvements to optimize spinal protection and enhance child safety beyond current regulatory requirements.
- 21 January 2023
- Published by Springer Nature in Annals of Biomedical Engineering
- Vol. 51 (6) , 1216-1225
Human Lumbar Spine Injury Risk in Dynamic Combined Compression and Flexion Loading
Anticipating changes to vehicle interiors with future automated driving systems, the automobile industry recently has focused attention on crash response in novel postures with increased seatback recline. Prior research found that this posture may result in greater risk of lumbar spine injury in the event of a frontal crash. This study developed a lumbar spine injury risk function (IRF) that estimated injury risk as a function of simultaneously applied compression force and flexion moment. Force and moment failure data from 40 compression–flexion tests were utilized in a Weibull survival model, including appropriate data censoring. A mechanics-based injury metric was formulated, where lumbar spine compression force and flexion moment were normalized by specimen geometry. Subject age was incorporated as a covariate to further improve model fit. A weighting factor was included to adjust the influence of force and moment, and parameter optimization yielded a value of 0.11. Thus, the normalized compression force component had a greater effect on injury risk than the normalized flexion moment component. Additionally, as force was nominally increased, less moment was required to produce injury for a given age and specimen geometry. The resulting IRF may be utilized to improve occupant safety in the future.
- 21 January 2023
- Published by Springer Nature in Annals of Biomedical Engineering
- Vol. 51 (6) , 1216-1225
Human Lumbar Spine Injury Risk in Dynamic Combined Compression and Flexion Loading
Anticipating changes to vehicle interiors with future automated driving systems, the automobile industry recently has focused attention on crash response in novel postures with increased seatback recline. Prior research found that this posture may result in greater risk of lumbar spine injury in the event of a frontal crash. This study developed a lumbar spine injury risk function (IRF) that estimated injury risk as a function of simultaneously applied compression force and flexion moment. Force and moment failure data from 40 compression–flexion tests were utilized in a Weibull survival model, including appropriate data censoring. A mechanics-based injury metric was formulated, where lumbar spine compression force and flexion moment were normalized by specimen geometry. Subject age was incorporated as a covariate to further improve model fit. A weighting factor was included to adjust the influence of force and moment, and parameter optimization yielded a value of 0.11. Thus, the normalized compression force component had a greater effect on injury risk than the normalized flexion moment component. Additionally, as force was nominally increased, less moment was required to produce injury for a given age and specimen geometry. The resulting IRF may be utilized to improve occupant safety in the future.
- Open Access
Human lumbar spine injury risk in dynamic combined compression and flexion loading
Anticipating changes to vehicle interiors with future automated driving systems, the automobile industry recently has focused attention on crash response in relaxed postures with increased seatback recline. Prior research found that this posture may result in greater risk of lumbar spine injury in the event of a frontal crash. This study developed a lumbar spine injury risk function that estimated injury risk as a function of simultaneously applied compression force and flexion moment. Force and moment failure data from 40 compression-flexion tests were utilized in a Weibull survival model, including appropriate data censoring. A mechanics-based injury metric was formulated, where lumbar spine compression force and flexion moment were normalized to specimen geometry. Subject age was incorporated as a covariate to further improve model fit. A weighting factor was included to adjust the influence of force and moment, and parameter optimization yielded a value of 0.11. Thus, the normalized compression force component had a greater effect on injury risk than the normalized flexion moment component. Additionally, as force was nominally increased, less moment was required to produce injury for a given age and specimen geometry. The resulting injury risk function can be utilized to improve occupant safety in the field.
Open AccessHuman lumbar spine injury risk in dynamic combined compression and flexion loading
Anticipating changes to vehicle interiors with future automated driving systems, the automobile industry recently has focused attention on crash response in relaxed postures with increased seatback recline. Prior research found that this posture may result in greater risk of lumbar spine injury in the event of a frontal crash. This study developed a lumbar spine injury risk function that estimated injury risk as a function of simultaneously applied compression force and flexion moment. Force and moment failure data from 40 compression-flexion tests were utilized in a Weibull survival model, including appropriate data censoring. A mechanics-based injury metric was formulated, where lumbar spine compression force and flexion moment were normalized to specimen geometry. Subject age was incorporated as a covariate to further improve model fit. A weighting factor was included to adjust the influence of force and moment, and parameter optimization yielded a value of 0.11. Thus, the normalized compression force component had a greater effect on injury risk than the normalized flexion moment component. Additionally, as force was nominally increased, less moment was required to produce injury for a given age and specimen geometry. The resulting injury risk function can be utilized to improve occupant safety in the field.
- 16 March 2022
- Published by Elsevier in Journal of Biomechanics
- Vol. 135, 111051
Failure tolerance of the human lumbar spine in dynamic combined compression and flexion loading
- 16 March 2022
- Published by Elsevier in Journal of Biomechanics
- Vol. 135, 111051
Failure tolerance of the human lumbar spine in dynamic combined compression and flexion loading
- Open Access
- 12 October 2020
- Published by Taylor & Francis in Traffic Injury Prevention
- Vol. 21 (sup1) , S90-S95
Comparison of injuries in multiple and single event crashes
Objective: Compare injuries for occupants in multiple event (ME) crashes where a less severe event preceded a more severe event to occupants in similar single event (SE) crashes. Methods: Occupants in ME crashes from NASS-CDS years 2000–2015 where the most severe event occurred subsequent to a less severe event were matched to occupants in SE crashes where the SE was similar to the most severe event in the ME crash. Occupants were matched based on occupant, vehicle, and crash characteristics and were compared across 21 detailed body regions using conditional logistic regression. Finite element (FE) simulations were performed with human surrogate models (detailed GHBMC and Hybrid III) and in both low- and high-speed conditions (n = 8 total simulations). At each speed, the crash simulations with both human body models reproduced a common multidirectional ME crash scenario, where the second impulse was more severe and similar to the SE impulse. Relative injury risk was assessed, and ME versus SE were computed and compared to those from the field data. Results: 1,663 ME occupants were matched to 3,217 SE occupants. ME occupants had higher MAIS2+ and MAIS3+ injury risk, and showed directionally higher injury risk in all but one body region. Eleven out of the 27 injury groups had higher injury risk in ME (false discovery rate (FDR)1.54). In FE simulations, ME displayed larger anterior and lateral displacement compared to SE. Head and thorax injury risk was increased in ME simulations by up to 5-fold. The detailed GHBMC and Hybrid III exhibited different kinematics and injury risk across all simulations, as did low- and high-speed conditions. Conclusions: The field data and FE simulations suggest that a first, less severe crash event results in occupants having greater injury risk when they are involved in a second, more severe crash event than if they were involved only in the second event. Several factors could cause this increase in injury risk, such as improper interaction with safety systems and airbags after the first event renders the occupant out-of-position.
- 12 October 2020
- Published by Taylor & Francis in Traffic Injury Prevention
- Vol. 21 (sup1) , S90-S95
Open AccessComparison of injuries in multiple and single event crashes
Objective: Compare injuries for occupants in multiple event (ME) crashes where a less severe event preceded a more severe event to occupants in similar single event (SE) crashes. Methods: Occupants in ME crashes from NASS-CDS years 2000–2015 where the most severe event occurred subsequent to a less severe event were matched to occupants in SE crashes where the SE was similar to the most severe event in the ME crash. Occupants were matched based on occupant, vehicle, and crash characteristics and were compared across 21 detailed body regions using conditional logistic regression. Finite element (FE) simulations were performed with human surrogate models (detailed GHBMC and Hybrid III) and in both low- and high-speed conditions (n = 8 total simulations). At each speed, the crash simulations with both human body models reproduced a common multidirectional ME crash scenario, where the second impulse was more severe and similar to the SE impulse. Relative injury risk was assessed, and ME versus SE were computed and compared to those from the field data. Results: 1,663 ME occupants were matched to 3,217 SE occupants. ME occupants had higher MAIS2+ and MAIS3+ injury risk, and showed directionally higher injury risk in all but one body region. Eleven out of the 27 injury groups had higher injury risk in ME (false discovery rate (FDR)1.54). In FE simulations, ME displayed larger anterior and lateral displacement compared to SE. Head and thorax injury risk was increased in ME simulations by up to 5-fold. The detailed GHBMC and Hybrid III exhibited different kinematics and injury risk across all simulations, as did low- and high-speed conditions. Conclusions: The field data and FE simulations suggest that a first, less severe crash event results in occupants having greater injury risk when they are involved in a second, more severe crash event than if they were involved only in the second event. Several factors could cause this increase in injury risk, such as improper interaction with safety systems and airbags after the first event renders the occupant out-of-position.