Said Hussien Moustafa
Said Hussien Moustafa has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
M. El-Hagary
3 shared publicationsM. Emam-Ismail
2 shared publicationsA. Ali Gharieb
1 shared publicationE. R. Shaaban
Al-Azhar University - Assiut Branch
1 shared publicationE.R. Shaaban
1 shared publication- Essam Ramadan Shaaban
Physics Department, Faculty of Science, Al-Azhar University, Assiut 11751, Egypt
1 shared publication
Latest Publications
- Open Access
- 6 November 2025
- Published by Springer Nature in Applied Physics A
- Vol. 131 (12) , 1-19
Characterization of AgIn5S8/Ag3.4In0.6 nanocomposite thin films as promising materials for enhancing (AgIn5S8/Ag3.4In0.6)/p-Si heterojunctions
Nanocomposite thin films of AgIn 5 S 8 /Ag 3.4 In 0.6 were prepared and proportion controlled with different thicknesses by the thermal deposition technique and heat treated at 330 °C for 2 h. XRD patterns demonstrated that the prepared thin films crystallized in two cubic phases of AgIn 5 S 8 and Ag 3.4 In 0.6 . The EDX revealed data near stoichiometric composition with slightly excess S. The surface morphology by FE-SEM showed accumulated nanoparticles forming granules that increased in diameter with increasing film thickness and elongated at the highest thickness of 450 nm. The optical measurements of films revealed two optical direct transitions for each film, ranging from 1.67 to 1.53 and 2.89 to 2.57 eV, by increasing the film thickness from 225 to 450 nm. Other optical linear and nonlinear parameters were determined. Electrical investigation of the resistivity, conductivity, and heterojunction electrical parameters with a crystalline p-Si substrate showed a slight improvement in the fabricated device conductivity with increasing the film thickness. AgIn 5 S 8 /Ag 3.4 In 0.6 nanocrystalline thin films provide a novel and promising candidate for long-life photovoltaic devices and photoelectronic applications.
- 6 November 2025
- Published by Springer Nature in Applied Physics A
- Vol. 131 (12) , 1-19
Open AccessCharacterization of AgIn5S8/Ag3.4In0.6 nanocomposite thin films as promising materials for enhancing (AgIn5S8/Ag3.4In0.6)/p-Si heterojunctions
Nanocomposite thin films of AgIn 5 S 8 /Ag 3.4 In 0.6 were prepared and proportion controlled with different thicknesses by the thermal deposition technique and heat treated at 330 °C for 2 h. XRD patterns demonstrated that the prepared thin films crystallized in two cubic phases of AgIn 5 S 8 and Ag 3.4 In 0.6 . The EDX revealed data near stoichiometric composition with slightly excess S. The surface morphology by FE-SEM showed accumulated nanoparticles forming granules that increased in diameter with increasing film thickness and elongated at the highest thickness of 450 nm. The optical measurements of films revealed two optical direct transitions for each film, ranging from 1.67 to 1.53 and 2.89 to 2.57 eV, by increasing the film thickness from 225 to 450 nm. Other optical linear and nonlinear parameters were determined. Electrical investigation of the resistivity, conductivity, and heterojunction electrical parameters with a crystalline p-Si substrate showed a slight improvement in the fabricated device conductivity with increasing the film thickness. AgIn 5 S 8 /Ag 3.4 In 0.6 nanocrystalline thin films provide a novel and promising candidate for long-life photovoltaic devices and photoelectronic applications.
- 24 August 2024
- Published by Elsevier in Optical Materials
- Vol. 156
Tailoring the optoelectronic and spintronics properties of Cr-doped ZnS nanostructure thin films
- 24 August 2024
- Published by Elsevier in Optical Materials
- Vol. 156
Tailoring the optoelectronic and spintronics properties of Cr-doped ZnS nanostructure thin films
- 22 December 2021
- Published by Wiley in Physica Status Solidi (b)
- Vol. 259 (3)
Studying the Optical and Electrical Properties of CuGa0.5In0.5Se2 Chalcopyrite Due to Substrate Temperature and Gamma Irradiation
Thin films of chalcopyrite CuGa0.5In0.5Se2 (CGIS) with thickness ≈2000 Å are prepared by thermal evaporation method at different values of substrate temperature (Ts) 373, 473, and 573 K. Crystal structure and elemental chemical composition are examined by X‐ray diffraction and energy dispersive X‐ray analysis, respectively. The optical constants of the films in the spectral range 200 nm ≤ λ ≤ 2500 nm are calculated. It is found that the transmittance and band gap (Eg) decrease with increasing the substrate temperature (Ts) while Urbach energy increases with the increase of Ts. The Wemple–DiDomenico (WDD) model is used to calculate the oscillator parameters. Furthermore, the prepared films are irradiated with γ‐ray at different doses 2, 4, and 8 kGy. The results reveal that the optical band gap increases and Urbach energy decreases as γ‐doses increase. Finally, the substrate temperature and γ irradiation upon the electrical resistivity are studied. Consequently, it is found that the electrical resistivity decreases with the increase of both the substrate temperature and γ‐irradiation. In conclusion, the γ‐irradiation stimulates a change in optical parameters and electrical resistivity which can be utilized for industrial dosimetric purposes.
- 22 December 2021
- Published by Wiley in Physica Status Solidi (b)
- Vol. 259 (3)
Studying the Optical and Electrical Properties of CuGa0.5In0.5Se2 Chalcopyrite Due to Substrate Temperature and Gamma Irradiation
Thin films of chalcopyrite CuGa0.5In0.5Se2 (CGIS) with thickness ≈2000 Å are prepared by thermal evaporation method at different values of substrate temperature (Ts) 373, 473, and 573 K. Crystal structure and elemental chemical composition are examined by X‐ray diffraction and energy dispersive X‐ray analysis, respectively. The optical constants of the films in the spectral range 200 nm ≤ λ ≤ 2500 nm are calculated. It is found that the transmittance and band gap (Eg) decrease with increasing the substrate temperature (Ts) while Urbach energy increases with the increase of Ts. The Wemple–DiDomenico (WDD) model is used to calculate the oscillator parameters. Furthermore, the prepared films are irradiated with γ‐ray at different doses 2, 4, and 8 kGy. The results reveal that the optical band gap increases and Urbach energy decreases as γ‐doses increase. Finally, the substrate temperature and γ irradiation upon the electrical resistivity are studied. Consequently, it is found that the electrical resistivity decreases with the increase of both the substrate temperature and γ‐irradiation. In conclusion, the γ‐irradiation stimulates a change in optical parameters and electrical resistivity which can be utilized for industrial dosimetric purposes.
- Open Access
- 16 March 2021
- Published by Springer Nature in Research Square
Effect of Cu Incorporation on Optoelectronic Properties of e-Beam Evaporated ZnO thin Films by Ellipsometric Investigations
Electron beam deposition technique has been used to deposit a series of Zn1-xCuxO nanocrystalline thin film on silica substrate with a variety of Cu concentrations. The microstructural, surface morphology and spectroscopic ellipsometry (SE) were used to examine the physical properties of the deposited films. The nanocrystalline nature of the Zn1-xCuxO (0.0≤x≤0.20) thin film has been confirmed by surface morphology studies. The XRD spectrum of the Zn1-xCuxO nanocrystalline film showed a hexagonal wurtzite type structure, and no extra phase was detected. Our results show that as the Cu content increases, the direct optical energy gap Eg decreases without any sign of solubility limit up to x≤0.2. The decrease in Eg can be attributed to the sp-d exchange coupling. In addition, exploring the spectral behavior of the refractive index dispersion from SE of the Cu-doped ZnO shows that as the Cu dopant increments; the refractive index of the deposited film enhances. Further, understand the refractive index dispersion of the deposited film has been performed using a single oscillator model proposed by Wemple-DiDomenico (WDD). Our calculations show that as the Cu concentration increases, the values of oscillator energy Eo decreases however, the dispersion energy Ed increases. As a result, the variation of the optical energy band gap and the tunability of the dispersive oscillator parameters values Eo, Ed, n0, e0, M-1 and M-3 with the increase of the Cu doping level confirm that Cu doped ZnO films are a good candidate for optoelectronic device applications.
- 16 March 2021
- Published by Springer Nature in Research Square
Open AccessEffect of Cu Incorporation on Optoelectronic Properties of e-Beam Evaporated ZnO thin Films by Ellipsometric Investigations
Electron beam deposition technique has been used to deposit a series of Zn1-xCuxO nanocrystalline thin film on silica substrate with a variety of Cu concentrations. The microstructural, surface morphology and spectroscopic ellipsometry (SE) were used to examine the physical properties of the deposited films. The nanocrystalline nature of the Zn1-xCuxO (0.0≤x≤0.20) thin film has been confirmed by surface morphology studies. The XRD spectrum of the Zn1-xCuxO nanocrystalline film showed a hexagonal wurtzite type structure, and no extra phase was detected. Our results show that as the Cu content increases, the direct optical energy gap Eg decreases without any sign of solubility limit up to x≤0.2. The decrease in Eg can be attributed to the sp-d exchange coupling. In addition, exploring the spectral behavior of the refractive index dispersion from SE of the Cu-doped ZnO shows that as the Cu dopant increments; the refractive index of the deposited film enhances. Further, understand the refractive index dispersion of the deposited film has been performed using a single oscillator model proposed by Wemple-DiDomenico (WDD). Our calculations show that as the Cu concentration increases, the values of oscillator energy Eo decreases however, the dispersion energy Ed increases. As a result, the variation of the optical energy band gap and the tunability of the dispersive oscillator parameters values Eo, Ed, n0, e0, M-1 and M-3 with the increase of the Cu doping level confirm that Cu doped ZnO films are a good candidate for optoelectronic device applications.
- 1 May 1998
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 227-230, 1087-1091
DC electrical properties of amorphous carbon with different bonding hybridization
- 1 May 1998
- Published by Elsevier in Journal of Non-Crystalline Solids
- Vol. 227-230, 1087-1091
DC electrical properties of amorphous carbon with different bonding hybridization