Hussein Ahmad Qulatein
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hussein Ahmad Qulatein has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Cristian Ferreiro
Department of Chemical Engineering, Faculty of Science and Technology, University of the Basque Country UPV/EHU, Barrio Sarriena s/n, 48940 Leioa, Spain
2 shared publications - Jose María Lomas
Department of Environmental and Chemical Engineering, Faculty of Engineering of Vitoria-Gasteiz, University of the Basque Country UPV/EHU, 01006 Vitoria-Gasteiz, Spain
2 shared publications - José Ignacio Lombraña
Department of Chemical Engineering, Faculty of Science and Technology, University of the Basque Country (UPV/EHU), P.O. Box 644, 48080 Bilbao, Spain
2 shared publications - Natalia Villota
Department of Environmental and Chemical Engineering, Faculty of Engineering Vitoria-Gasteiz, University of the Basque Country UPV/EHU, Nieves Cano 12, 01006 Vitoria-Gasteiz, Spain
2 shared publications - Pedram Fatehi
Chemical Engineering Department Lakehead University Thunder Bay Ontario Canada
2 shared publications - Luis Miguel Camarero
Department of Chemical and Environmental Engineering, Faculty of Engineering of Vitoria-Gasteiz, University of the Basque Country UPV/EHU, Nieves Cano 12, 01006 Vitoria-Gasteiz, Spain
1 shared publication
Latest Publications
- Open Access
Carboxyalkylated Lignin as a Sustainable Dispersant for Coal Water Slurry
Coal water slurry (CWS) has been considered a cleaner and sustainable alternative to coal. However, the challenging suspension of coal particles in CWS has created a major obstacle to its use in industry. This study presents a novel approach to enhance the stability and rheological properties of coal water slurry (CWS) through the utilization of carboxyalkylated lignin (CL) as a dispersant. The generated CL samples had high water solubility of around 9 g/L and a charge density of around 2 mmol/g. All CLs were able to stabilize the coal suspension, and their performance decreased due to the increase in the alkyl chain length of carboxyalkylated lignin. Carboxymethylated lignin (CL-1) improved the stability of the coal suspensions with the lowest instability index of less than 0.6. The addition of CLs reduced the contact angle of the coal surface from 45.3° to 34.6°, and the increase in the alkyl chain length hampered its effect on contact angle changes. The zeta potential measurements confirmed that the adsorption of CL enhanced the electrostatic repulsion between coal particles in suspensions, and the zeta potential decreased with the increased alkyl chain length of CLs due to increased steric hindrance. The rheology results indicated that CLs demonstrated shear thinning behavior. This innovative method showcases the affinity of carboxyalkylated lignin to improve the performance of CWS, offering an environmentally friendly alternative for producing a cleaner product, i.e., sustainable coal water slurry, with improved suspension stability.
Open AccessCarboxyalkylated Lignin as a Sustainable Dispersant for Coal Water Slurry
Coal water slurry (CWS) has been considered a cleaner and sustainable alternative to coal. However, the challenging suspension of coal particles in CWS has created a major obstacle to its use in industry. This study presents a novel approach to enhance the stability and rheological properties of coal water slurry (CWS) through the utilization of carboxyalkylated lignin (CL) as a dispersant. The generated CL samples had high water solubility of around 9 g/L and a charge density of around 2 mmol/g. All CLs were able to stabilize the coal suspension, and their performance decreased due to the increase in the alkyl chain length of carboxyalkylated lignin. Carboxymethylated lignin (CL-1) improved the stability of the coal suspensions with the lowest instability index of less than 0.6. The addition of CLs reduced the contact angle of the coal surface from 45.3° to 34.6°, and the increase in the alkyl chain length hampered its effect on contact angle changes. The zeta potential measurements confirmed that the adsorption of CL enhanced the electrostatic repulsion between coal particles in suspensions, and the zeta potential decreased with the increased alkyl chain length of CLs due to increased steric hindrance. The rheology results indicated that CLs demonstrated shear thinning behavior. This innovative method showcases the affinity of carboxyalkylated lignin to improve the performance of CWS, offering an environmentally friendly alternative for producing a cleaner product, i.e., sustainable coal water slurry, with improved suspension stability.
- Open Access
Turbidity Changes during Carbamazepine Oxidation by Photo-Fenton
The objective of this study is to evaluate the turbidity generated during the Fenton photo-reaction applied to the oxidation of waters containing carbamazepine as a function of factors such as pH, H2O2 concentration and catalyst dosage. The results let establish the degradation pathways and the main decomposition byproducts. It is found that the pH affects the turbidity of the water. Working between pH = 2.0 and 2.5, the turbidity is under 1 NTU due to the fact that iron, added as a catalyst, is in the form of a ferrous ion. Operating at pH values above 3.0, the iron species in their oxidized state (mainly ferric hydroxide in suspension) would cause turbidity. The contribution of these ferric species is a function of the concentration of iron added to the process, verifying that the turbidity increases linearly according to a ratio of 0.616 NTU L/mg Fe. Performing with oxidant concentrations at (H2O2) = 2.0 mM, the turbidity undergoes a strong increase until reaching values around 98 NTU in the steady state. High turbidity levels can be originated by the formation of coordination complexes, consisting of the union of three molecules containing substituted carboxylic groups (BaQD), which act as ligands towards an iron atom with Fe3+ oxidation state.
Open AccessTurbidity Changes during Carbamazepine Oxidation by Photo-Fenton
The objective of this study is to evaluate the turbidity generated during the Fenton photo-reaction applied to the oxidation of waters containing carbamazepine as a function of factors such as pH, H2O2 concentration and catalyst dosage. The results let establish the degradation pathways and the main decomposition byproducts. It is found that the pH affects the turbidity of the water. Working between pH = 2.0 and 2.5, the turbidity is under 1 NTU due to the fact that iron, added as a catalyst, is in the form of a ferrous ion. Operating at pH values above 3.0, the iron species in their oxidized state (mainly ferric hydroxide in suspension) would cause turbidity. The contribution of these ferric species is a function of the concentration of iron added to the process, verifying that the turbidity increases linearly according to a ratio of 0.616 NTU L/mg Fe. Performing with oxidant concentrations at (H2O2) = 2.0 mM, the turbidity undergoes a strong increase until reaching values around 98 NTU in the steady state. High turbidity levels can be originated by the formation of coordination complexes, consisting of the union of three molecules containing substituted carboxylic groups (BaQD), which act as ligands towards an iron atom with Fe3+ oxidation state.
- Open Access
Colour Changes during the Carbamazepine Oxidation by Photo-Fenton
The oxidation of aqueous solutions of carbamazepine is conducted using the Fenton reagent, combined with the photolytic action of a 150 W medium pressure UV lamp, operating at T = 40 °C. The effect of acidity is analysed at an interval pH = 2.0–5.0, verifying that operating at pH = 5.0 promotes colour formation (Colour = 0.15 AU). The effect of iron is studied, finding that the colour of the water increases in a linear way, Colour = 0.05 + 0.0075 [Fe]0. The oxidising action of hydrogen peroxide is tested, confirming that when operating with [H2O2]0 = 2.0 mM, the maximum colour is generated (Colourmax = 0.381 AU). The tint would be generated by the degradation of by-products of carbamazepine, which have chromophoric groups in their internal structure, such as oxo and dioxocarbazepines, which would produce tint along the first minutes of oxidation, while the formation of acridones would slowly induce colour in the water.
Open AccessColour Changes during the Carbamazepine Oxidation by Photo-Fenton
The oxidation of aqueous solutions of carbamazepine is conducted using the Fenton reagent, combined with the photolytic action of a 150 W medium pressure UV lamp, operating at T = 40 °C. The effect of acidity is analysed at an interval pH = 2.0–5.0, verifying that operating at pH = 5.0 promotes colour formation (Colour = 0.15 AU). The effect of iron is studied, finding that the colour of the water increases in a linear way, Colour = 0.05 + 0.0075 [Fe]0. The oxidising action of hydrogen peroxide is tested, confirming that when operating with [H2O2]0 = 2.0 mM, the maximum colour is generated (Colourmax = 0.381 AU). The tint would be generated by the degradation of by-products of carbamazepine, which have chromophoric groups in their internal structure, such as oxo and dioxocarbazepines, which would produce tint along the first minutes of oxidation, while the formation of acridones would slowly induce colour in the water.