JAJouni Ahopelto

Jouni Ahopelto

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jouni Ahopelto has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Critical dimensions variability-aware design of optomechanical nano beams

    by O R Ranjbar-Naeini, G Conte, L Mercadé, O M E Ylivaara, J Ahopelto, Cm Sotomayor-Torres

    Subwavelength geometrical dimension, which often originates from fabrication-induced dimensional deviations variability, can strongly influence the performance of phononic–photonic crystal optomechanical (OM) nanobeams. Here, we present a suitable variability-aware design framework for OM nanobeams by combining extraction of critical dimension variations from scanning electron microscopy images and finite-element modeling. We extracted the impact of deterministic geometrical deviations on the unit cell of the phononic and photonic crystals to identify the most critical fabrication-sensitive parameters. We extended the study to the full cavity, where SEM-informed digital-twin models are used to quantify the influence of systematic dimensional variations on the optical and mechanical resonance frequencies, the optical quality factor, the effective mode volume, and the total OM coupling rate. The results indicate that biased dimensional deviations of ±10 nm exert a minor effect on the overall device performance, whereas larger deviations have a stronger impact on the photonic, phononic, and OM response.

  • Open Access

    Quasi-isotropy of nanocrystalline silicon film: An inelastic light scattering study

    by Yani Chen, Oili M. E. Ylivaara, Manjunath Balagopalan, Omid R. Ranjbar-Naeini, Gloria Conte, Tapani Makkonen, Jouni Ahopelto, Clivia M. Sotomayor Torres

    Nanocrystalline silicon thin membranes exhibit high potential in micro-electro-mechanical systems and in optoelectronic and optomechanical applications due to the distinct microstructure, which enables enhanced nonlinear dynamics, broader operational bandwidth, and tunable mechanical and thermal properties compared to single-crystalline silicon. This work presents a comprehensive investigation of the structural characteristics of nanocrystalline silicon using angle-resolved polarized Raman spectroscopy. Our analysis reveals a striking transition from the strong anisotropy of crystalline Si(100) to a quasi-isotropic behavior in nanocrystalline silicon. Inelastic light scattering provides an efficient nondestructive method to characterize the crystallographic texture of nanocrystalline semiconductor films, offering valuable guidance for their optimization in advanced electronic, flexible, and optomechanical devices.


  • Open Access

    Thermal Properties of Nanocrystalline Silicon Nanobeams

    by Jeremie Maire, Emigdio Chávez‐Ángel, Guillermo Arregui, Martin F. Colombano, Nestor E. Capuj, Amadeu Griol, Alejandro Martínez, Daniel Navarro‐Urrios, Jouni Ahopelto, Clivia M. Sotomayor‐Torres

    Controlling thermal energy transfer at the nanoscale and thermal properties has become critically important in many applications since it often limits device performance. In this study, the effects on thermal conductivity arising from the nanoscale structure of free‐standing nanocrystalline silicon films and the increasing surface‐to‐volume ratio when fabricated into suspended optomechanical nanobeams are studied. Thermal transport and elucidate the relative impact of different grain size distributions and geometrical dimensions on thermal conductivity are characterized. A micro time‐domain thermoreflectance method to study free‐standing nanocrystalline silicon films and find a drastic reduction in the thermal conductivity, down to values below 10 W m–1 K–1 is used, with a stronger decrease for smaller grains. In optomechanical nanostructures, this effect is smaller than in membranes due to the competition of surface scattering in decreasing thermal conductivity. Finally, a novel versatile contactless characterization technique that can be adapted to any structure supporting a thermally shifted optical resonance is introduced. The thermal conductivity data agrees quantitatively with the thermoreflectance measurements. This study opens the way to a more generalized thermal characterization of optomechanical cavities and to create hot‐spots with engineered shapes at the desired position in the structures as a means to study thermal transport in coupled photon‐phonon structures.


  • Open Access

    Thermal properties of nanocrystalline silicon nanobeams

    by Jeremie Maire, Emigdio Chavez-Angel, Guillermo Arregui, Martin F. Colombano, Nestor E. Capuj, Amadeu Griol, Alejandro Martinez, Daniel Navarro-Urrios, Jouni Ahopelto, Clivia M. Sotomayor-Torres

    Controlling thermal energy transfer at the nanoscale has become critically important in many applications and thermal properties since it often limits device performance. In this work, we study the effects on thermal conductivity arising from the nanoscale structure of free-standing nanocrystalline silicon films and the increasing surface-to-volume ratio when fabricated into suspended optomechanical nanobeams. We characterize thermal transport in structures with different grain sizes and elucidate the relative impact of grain size and geometrical dimensions on thermal conductivity. We use a micro-time-domain thermoreflectance method to study the impact of the grain size distribution, from 10 to 400 nm, on the thermal conductivity in free-standing nanocrystalline silicon films considering surface phonon and grain boundary scattering. We find a drastic reduction in the thermal conductivity, down to values of 10 W.m^{-1}.K^{-1} and below, which is just a fraction of the conductivity of single crystalline silicon. Decreasing the grain size further decreases the thermal conductivity. We also observe that this effect is smaller in OM nanostructures than in membranes due to the competition of surface scattering in decreasing thermal conductivity. Finally, we introduce a novel versatile contactless characterization technique that can be adapted to any structure supporting a thermally shifted optical resonance and use it to evaluate the thermal conductivity. This method can be used with optical resonances exhibiting different mode profiles and the data is shown to agrees quantitatively with the thermoreflectance measurements. This work opens the way to a more generalized thermal characterization of optomechanical cavities and to create hot-spots with engineered shapes at desired position in the structures as a means to study thermal transport in coupled photon-phonon structures.

  • Open Access

    Nano-thermoelectric infrared bolometers

    by Aapo Varpula, Kirsi Tappura, Jonna Tiira, Kestutis Grigoras, Olli-Pekka Kilpi, Kuura Sovanto, Jouni Ahopelto, Mika Prunnila

    Infrared (IR) radiation detectors are used in numerous applications from thermal imaging to spectroscopic gas sensing. Obtaining high speed and sensitivity, low-power operation, and cost-effectiveness with a single technology remains to be a challenge in the field of IR sensors. By combining nano-thermoelectric transduction and nanomembrane photonic absorbers, we demonstrate uncooled IR bolometer technology that is material-compatible with large-scale CMOS fabrication and provides fast and high sensitivity response to long-wavelength IR (LWIR) around 10 µm. The fast operation speed stems from the low heat capacity metal layer grid absorber connecting the sub-100 nm-thick n- and p-type Si nano-thermoelectric support beams, which convert the radiation induced temperature rise into voltage. The nano-thermoelectric transducer-support approach benefits from enhanced phonon surface scattering in the beams, leading to reduction in thermal conductivity, which enhances the sensitivity. We demonstrate different size nano-thermoelectric bolometric photodetector pixels with LWIR responsitivities, specific detectivities, and time constants in the ranges 179 V/W–2930 V/W, 1.5 × 107 cm Hz1/2/W–3.1 × 108 cm Hz1/2/W, and 66 µs–3600 µs, respectively. We benchmark the technology against different LWIR detector solutions and show how nano-thermoelectric detector technology can reach the fundamental sensitivity limits posed by phonon and photon thermal fluctuation noise.


  • High-performance infrared thermoelectric bolometers based on nanomembranes

    by Aapo Varpula, Kirsi Tappura, Jonna Tiira, Kestutis Grigoras, Kai Viherkanto, Jouni Ahopelto, Mika Prunnila

    The state-of-the-art infrared (IR) photodetectors are either thermal detectors (bolometers) or quantum detectors (photovoltaic and photoconductive detectors). Compared to quantum IR photodetectors, IR bolometers are slower and less sensitive but in turn, they offer lower cost without need for cooling and exotic materials (e.g. HgCdTe). Phonon/photon engineered materials offer interesting routes for enhancing room-temperature IR bolometers. We have recently demonstrated experimentally a nano-thermoelectric bolometer for long-wave IR detection. The technology utilizes efficient thermoelectric transducers based on silicon nanomembranes, which have an enhanced thermoelectric figure of merit arising from the low thermal conductivity stemming from the nano-scale thickness. For the absorption of the IR radiation the nano-thermoelectric bolometer utilizes a nanomembrane based quarter-wave resistive absorber, which is also known as the Salisbury screen. The use of nanomembranes in both the thermoelectric transducer and the absorber results in a very small thermal mass, and thereby high speed for the detector. In this article, we present an analytical model for quarter-wave resistive absorbers (i.e. Salisbury screens). It can be applied both in radio frequency (RF) and optical applications. The results of the analytical model are compared with the ones obtained with the transfer-matrix method using the optical material data available in the literature. We present also a device model of the nano-thermoelectric IR detector and estimate the full performance of this technology.


  • Open Access

    Conversion between surface acoustic waves and guided modes of a quasi-periodic structured nanobeam

    by Alexander V Korovin, Yan Pennec, Matteo Stocchi, Davide Mencarelli, Luca Pierantoni, Tapani Makkonen, Jouni Ahopelto, Bahram Djafari Rouhani

    The generation of acoustic waves in structured nanobeams containing optomechanic cavities is a topic of current interest. In this paper, we theoretically study the efficient conversion of surface acoustic waves (SAW) generated on a substrate by an RF electric signal into the acoustic waves of a nanobeam. First, we demonstrate the possibility of converting the SAW generated on a silicon substrate with a thin piezoelectric AlN layer into the guided mechanical modes of a straight nanobeam with a maximum efficiency of −22.6 dB. This can be achieved by using a set of inter-digitated transducers with radial fingers, which provide SAW focusing towards the nanobeam entrance. We analyse the nature of the modes created inside the nanobeam and the conversion efficiency of the SAW into the different modes. Then, we study the interaction of these waves with a one-dimensional phononic crystal nanobeam containing a cavity. The latter is constituted by an array of holes and stubs and has been proven in our recent works to be very efficient for optomechanic applications. We calculate the transmission properties of the cavity modes and discuss the efficiency of generating the cavity modes from the initial SAW.


  • Electrical transport through ordered self-assembled protein monolayer measured by constant force conductive atomic force microscopy

    by Jani M. Kivioja, Katri Kurppa, Markku Kainlauri, Markus B. Linder, Jouni Ahopelto

    This paper addresses some of the challenges met in electrical characterization of biomolecules, namely, the control of the orientation of molecules and the control of the force exerted on these soft molecules. We investigate the transport properties of small proteins called hydrophobins using conductive atomic force microscopy. The proteins have a property that they form a well ordered monolayer in which the orientation of the molecules is known. We introduce an active compensation for the electrostatic force induced by the bias voltage, which often hamper the measurements. Results suggest that the electrical transport through the hydrophobins protein monolayer occurs mainly via tunneling.


  • Open Access

    Flexible stamp for nanoimprint lithography

    by T. Nielsen, R.H. Pedersen, O. Hansen, T. Haatainen, A. Tolkki, J. Ahopelto, A. Kristensen

    The design, fabrication and performance of a flexible silicon stamp for homogenous large area nanoimprint lithography (NIL) are presented. The flexible stamp is fabricated by bulk semiconductor micro machining of a 4-inch silicon wafer and consists of thick anchor like imprint areas connected by membranes. The bending stiffness difference between the imprint areas and the membranes ensures that the deformation of the stamp during the imprint process mainly takes place in the membranes, leaving the imprint structures unaffected. By this design the strong demand to the parallelism between stamp and substrate in the imprint situation is decoupled from the pressing tool and the wafer quality. The stamp consist of 1562 imprint areas (1 mm /spl times/ 1 mm) containing the patterns to be replicated. The imprinted patterns are characterized with respect to the imprint depth and the polymer residual layer thickness. It is found that within a 50 mm diameter the polymer residual layer thickness is 18.8 nm with a standard deviation of 6.6 nm.


  • Gate bias symmetry dependency of electron mobility and prospect of velocity modulation in double-gate silicon-on-insulator transistors

    by M. Prunnila, J. Ahopelto, K. Henttinen, F. Gamiz

    We report on detailed room-temperature transport properties of a 17nm thick double-gate silicon-on-insulator (DGSOI) transistor. We find that when the electron gas is transferred between the top and the bottom of the silicon-on-insulator (SOI) layer by changing the gate bias symmetry (i.e., applying the gate biases in a push–pull fashion), while keeping the carrier density constant the maximum mobility occurs when the electron gas symmetrically occupies the whole SOI slab. The observed mobility behavior is the fingerprint of volume inversion∕accumulation. This gate bias symmetry dependency of the mobility suggests that DGSOI devices intrinsically can be operated in a velocity modulation transistor (VMT) mode. In the experimental gate bias window, the maximum velocity∕mobility modulation is ∼40% . The VMT transconductance exceeds conventional single-gate transconductance when electron density is above ∼5.3×1016m−2 . Improvements of the observed VMT operation in thin DGSOI devices are discussed.