Tiago Monteiro Vieira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tiago Monteiro Vieira has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Margarida Moldão-Martins
LEAF—Linking Landscape, Environment, Agriculture and Food Research Center, Instituto Superior de Agronomia, Universidade de Lisboa, 1349-017 Lisboa, Portugal
3 shared publications - Sara Cristina Cunha
CBQF—Centro de Biotecnologia e Química Fina—Laboratório Associado, Escola Superior de Biotecnologia, Universidade Católica Portuguesa, Rua Diogo Botelho 1327, 4169-005 Porto, Portugal
3 shared publications - Susana Casal
LAQV/REQUIMTE, Laboratory of Bromatology and Hydrology, Faculty of Pharmacy, University of Porto, Porto, Portugal
3 shared publications - Vítor Delgado Alves
LEAF—Linking Landscape, Environment, Agriculture and Food Research Center, Instituto Superior de Agronomia, Universidade de Lisboa, 1349-017 Lisboa, Portugal
3 shared publications - Domingos P. F. Almeida
Instituto Superior de Agronomia, Universidade de Lisboa, Tapada da Ajuda, 1349-017 Lisboa, Portugal
2 shared publications - Joana Freitas Fundo
Universidade Católica Portuguesa/Porto
2 shared publications
Latest Publications
- Open Access
- 9 January 2026
- Published by Elsevier in Applied Food Research
- Vol. 6 (1)
Packaging atmosphere and confinement as key factors in shelf-life extension of live clams
- 9 January 2026
- Published by Elsevier in Applied Food Research
- Vol. 6 (1)
Open AccessPackaging atmosphere and confinement as key factors in shelf-life extension of live clams
- 25 August 2024
- Published by Elsevier in Surfaces and Interfaces
- Vol. 53
Electropsun non-woven luminescent two-dye pH sensors: Effect of morphology on the sensing performance
- 25 August 2024
- Published by Elsevier in Surfaces and Interfaces
- Vol. 53
Electropsun non-woven luminescent two-dye pH sensors: Effect of morphology on the sensing performance
- Open Access
Application of an Eco-Friendly Antifungal Active Package to Extend the Shelf Life of Fresh Red Raspberry (Rubus idaeus L. cv. ‘Kweli’)
The main objective of this study was to extend the shelf life of fresh red raspberry (Rubus idaeus. L. cv. ‘Kweli’) by using active film-pads inside commercial compostable packages. The pads were produced with chitosan (Ch) with the incorporation of green tea (GTE) and rosemary (RSME) ethanolic extracts as natural antifungal agents. Pads were placed on the bottom of commercial fruit trays underneath the fruits, and the trays were heat-sealed with a polyacid lactic (PLA) film. Preservation studies were carried out over 14 days of storage at refrigeration temperature (4 °C). Raspberry samples were periodically analyzed throughout storage, in terms of quality attributes (fungal decay, weight loss, firmness, surface color, pH, total soluble solids), total phenolic content and antioxidant activity. Gas composition inside the packages was also analyzed over time. From the packaging systems tested, the ones with active film-pads Ch + GTE and Ch + RSME were highly effective in reducing fungal growth and decay of raspberry during storage, showing only around 13% and 5% of spoiled fruits after 14 days, respectively, in contrast with the packages without pads (around 80% of spoiled fruits detected). In addition, fruits preserved using packages with Ch + RSME active film-pads showed lower mass loss (5.6%), decreased firmness (3.7%) and reduced antioxidant activity (around 9% and 15% for DPPH and FRAP methods, respectively). This sustainable packaging presents a potential strategy for the preservation of raspberries and other highly perishable small fruits.
Open AccessApplication of an Eco-Friendly Antifungal Active Package to Extend the Shelf Life of Fresh Red Raspberry (Rubus idaeus L. cv. ‘Kweli’)
The main objective of this study was to extend the shelf life of fresh red raspberry (Rubus idaeus. L. cv. ‘Kweli’) by using active film-pads inside commercial compostable packages. The pads were produced with chitosan (Ch) with the incorporation of green tea (GTE) and rosemary (RSME) ethanolic extracts as natural antifungal agents. Pads were placed on the bottom of commercial fruit trays underneath the fruits, and the trays were heat-sealed with a polyacid lactic (PLA) film. Preservation studies were carried out over 14 days of storage at refrigeration temperature (4 °C). Raspberry samples were periodically analyzed throughout storage, in terms of quality attributes (fungal decay, weight loss, firmness, surface color, pH, total soluble solids), total phenolic content and antioxidant activity. Gas composition inside the packages was also analyzed over time. From the packaging systems tested, the ones with active film-pads Ch + GTE and Ch + RSME were highly effective in reducing fungal growth and decay of raspberry during storage, showing only around 13% and 5% of spoiled fruits after 14 days, respectively, in contrast with the packages without pads (around 80% of spoiled fruits detected). In addition, fruits preserved using packages with Ch + RSME active film-pads showed lower mass loss (5.6%), decreased firmness (3.7%) and reduced antioxidant activity (around 9% and 15% for DPPH and FRAP methods, respectively). This sustainable packaging presents a potential strategy for the preservation of raspberries and other highly perishable small fruits.
- 1 November 2021
- Published by Elsevier in Separation and Purification Technology
- Vol. 274
Ionic liquid-based semi-interpenetrating polymer network (sIPN) membranes for CO2 separation
- 1 November 2021
- Published by Elsevier in Separation and Purification Technology
- Vol. 274
Ionic liquid-based semi-interpenetrating polymer network (sIPN) membranes for CO2 separation
- Open Access
Design of Chitosan and Alginate Emulsion-Based Formulations for the Production of Monolayer Crosslinked Edible Films and Coatings
This study aimed to develop edible monolayer emulsion-based barriers with polysaccharides as film-forming components (chitosan and sodium alginate), soy lecithin as a surfactant and olive oil as a hydrophobic barrier. Monolayer barriers in the form of films were prepared by casting filmogenic emulsions composed of 2% w/v chitosan (dissolved in lactic acid 1% v/v) or 1% w/v sodium alginate, with different lipid contents (25, 50 and 100% w/w biopolymer basis) and different surfactant concentrations (5, 10 and 25% w/w, lipid basis). Glycerol was used as a plasticizer (25 % w/w, biopolymer basis). After the emulsion drying process, the obtained stand-alone films were sprayed with a crosslinking solution, achieving an optimized crosslinker content of 3.2 mgCa2+/cm2 alginate film and 4 mg tripolyphosphate/cm2 chitosan film. The effect of oil and lecithin contents, as well the presence of crosslinking agents, on the film’s water vapour permeability (WVP), water vapour sorption capacity, mechanical properties and colour parameters, was evaluated. The results have shown that the lowest WVP values were obtained with formulations containing 25% lipid and 25% surfactant for chitosan films, and 100% lipid and 25% surfactant for alginate films. The application of the crosslinking agents decreased even further the WVP, especially for chitosan films (by 30%). Crosslinking also increased films’ resistance to deformation under tensile tests. Overall, the films developed present a good potential as polysaccharide-based barriers with increased resistance to water, which envisages the use of the designed formulations to produce either edible/biodegradable films or edible coatings.
Open AccessDesign of Chitosan and Alginate Emulsion-Based Formulations for the Production of Monolayer Crosslinked Edible Films and Coatings
This study aimed to develop edible monolayer emulsion-based barriers with polysaccharides as film-forming components (chitosan and sodium alginate), soy lecithin as a surfactant and olive oil as a hydrophobic barrier. Monolayer barriers in the form of films were prepared by casting filmogenic emulsions composed of 2% w/v chitosan (dissolved in lactic acid 1% v/v) or 1% w/v sodium alginate, with different lipid contents (25, 50 and 100% w/w biopolymer basis) and different surfactant concentrations (5, 10 and 25% w/w, lipid basis). Glycerol was used as a plasticizer (25 % w/w, biopolymer basis). After the emulsion drying process, the obtained stand-alone films were sprayed with a crosslinking solution, achieving an optimized crosslinker content of 3.2 mgCa2+/cm2 alginate film and 4 mg tripolyphosphate/cm2 chitosan film. The effect of oil and lecithin contents, as well the presence of crosslinking agents, on the film’s water vapour permeability (WVP), water vapour sorption capacity, mechanical properties and colour parameters, was evaluated. The results have shown that the lowest WVP values were obtained with formulations containing 25% lipid and 25% surfactant for chitosan films, and 100% lipid and 25% surfactant for alginate films. The application of the crosslinking agents decreased even further the WVP, especially for chitosan films (by 30%). Crosslinking also increased films’ resistance to deformation under tensile tests. Overall, the films developed present a good potential as polysaccharide-based barriers with increased resistance to water, which envisages the use of the designed formulations to produce either edible/biodegradable films or edible coatings.
- Open Access
Composite Coatings of Chitosan and Alginate Emulsions with Olive Oil to Enhance Postharvest Quality and Shelf Life of Fresh Figs (Ficus carica L. cv. ‘Pingo De Mel’)
Fresh figs are very appreciated and have been associated with health benefits. However, these fruits are highly perishable. In this study, edible coatings were studied envisaging their positive effect in enhancing figs’ shelf-life. Fig fruits cv. ‘Pingo de mel’ were harvested at commercial ripening stage and single emulsion-based coatings, composed of chitosan + olive oil and alginate + olive oil, were applied. After coatings application by dipping each fruit in the emulsion-based solutions at 4 °C and drying, the coated fruits were sprayed with crosslinking solutions (6% tripolyphosphate and 1% calcium chloride for chitosan and alginate-based coatings, respectively). Then, were maintained at 4 °C and analyzed after 1, 7, 14 and 19 days of storage. After each time interval, fruits were further maintained at 25 °C for 2 days. The results have shown that coatings were effective on delaying fungal decay and postharvest ripening indicators (respiration rate, mass loss, softening and total soluble solids/titratable acidity ratio). The results foresee a fruits’ shelf life between 14 and 19 days under refrigeration at 4 °C that may be followed up to 2 days at ambient temperature, higher than that estimated for uncoated fruits (less than 14 days at 4 °C plus to 2 days at ambient temperature).
Open AccessComposite Coatings of Chitosan and Alginate Emulsions with Olive Oil to Enhance Postharvest Quality and Shelf Life of Fresh Figs (Ficus carica L. cv. ‘Pingo De Mel’)
Fresh figs are very appreciated and have been associated with health benefits. However, these fruits are highly perishable. In this study, edible coatings were studied envisaging their positive effect in enhancing figs’ shelf-life. Fig fruits cv. ‘Pingo de mel’ were harvested at commercial ripening stage and single emulsion-based coatings, composed of chitosan + olive oil and alginate + olive oil, were applied. After coatings application by dipping each fruit in the emulsion-based solutions at 4 °C and drying, the coated fruits were sprayed with crosslinking solutions (6% tripolyphosphate and 1% calcium chloride for chitosan and alginate-based coatings, respectively). Then, were maintained at 4 °C and analyzed after 1, 7, 14 and 19 days of storage. After each time interval, fruits were further maintained at 25 °C for 2 days. The results have shown that coatings were effective on delaying fungal decay and postharvest ripening indicators (respiration rate, mass loss, softening and total soluble solids/titratable acidity ratio). The results foresee a fruits’ shelf life between 14 and 19 days under refrigeration at 4 °C that may be followed up to 2 days at ambient temperature, higher than that estimated for uncoated fruits (less than 14 days at 4 °C plus to 2 days at ambient temperature).
- 1 July 2014
- Published by Elsevier in Food Research International
- Vol. 61, 56-60
Ochratoxin A in commercial soluble coffee and coffee substitutes
- 1 July 2014
- Published by Elsevier in Food Research International
- Vol. 61, 56-60
Ochratoxin A in commercial soluble coffee and coffee substitutes