XLXiaoFu Li

XiaoFu Li

*This is an algorithmically generated author record based on publicly available information.

XiaoFu Li has a total of 28 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Self-learning physical reservoir computer

    by Raf E Ul Shougat, XiaoFu Li, Edmon Perkins

    A self-learning physical reservoir computer is demonstrated using an adaptive oscillator. Whereas physical reservoir computing repurposes the dynamics of a physical system for computation through machine learning, adaptive oscillators can innately learn and store information in plastic dynamic states. The adaptive state(s) can be used directly as physical node(s), but these plastic states can also be used to self-learn the optimal reservoir parameters for more complex tasks requiring virtual nodes from the base oscillator. Both this self-learning property for reconfigurable computing and the morphable logic gate property of the adaptive oscillator make this an ideal candidate for a multipurpose neuromorphic processor.


  • Multiplex-free physical reservoir computing with an adaptive oscillator

    by Raf E Ul Shougat, XiaoFu Li, Edmon Perkins

    Nonlinear oscillators can often be used as physical reservoir computers, in which the oscillator's dynamics simultaneously performs computation and stores information. Typically, the dynamic states are multiplexed in time, and then machine learning is used to unlock this stored information into a usable form. This time multiplexing is used to create virtual nodes, which are often necessary to capture enough information to perform different tasks, but this multiplexing procedure requires a relatively high sampling rate. Adaptive oscillators, which are a subset of nonlinear oscillators, have plastic states that learn and store information through their dynamics in a human readable form, without the need for machine learning. Highlighting this ability, adaptive oscillators have been used as analog frequency analyzers, robotic controllers, and energy harvesters. Here, adaptive oscillators are considered as a physical reservoir computer without the cumbersome time multiplexing procedure. With this multiplex-free physical reservoir computer architecture, the fundamental logic gates can be simultaneously calculated through dynamics without modifying the base oscillator.


  • Open Access

    Chaos in a Pendulum Adaptive Frequency Oscillator Circuit Experiment

    by Xiaofu Li̇, Aubrey Beal, Robert Dean, Edmon Perki̇nS

    Adaptive oscillators can learn and encode information in dynamic, plastic states. The pendulum has recently been proposed as the base oscillator of an adaptive system. In a mechanical setup, the horizontally forced pendulum adaptive frequency oscillator seeks a resonance condition by modifying the length of the pendulum's rod. This system stores the external forcing frequency when the external amplitude is small, while it can store the resonance frequency, which is affected by the nonlinearity of the pendulum, when the external amplitude is large. Furthermore, for some frequency ranges, the pendulum adaptive frequency oscillator can exhibit chaotic motion when the amplitudes are large. This adaptive oscillator could be used as a smart vibratory energy harvester device, but this chaotic region could degrade its performance by using supplementary energy to modify the rod length. The pendulum adaptive frequency oscillator’s equations of motions are discussed, and a field-programmable analog array is used as an experimental realization of this system as an electronic circuit. Bifurcation diagrams are shown for both the numerical simulations and experiments, while period-3 motion is shown for the numerical simulations. As little work has been done on the stability of adaptive oscillators, the authors believe that this work is the first demonstration of chaos in an adaptive oscillator.


  • Field-programmable analog array (FPAA) based four-state adaptive oscillator for analog frequency analysis

    by XiaoFu Li, Raf E Ul Shougat, Tushar Mollik, Robert N. Dean, Aubrey N. Beal, Edmon Perkins

    Adaptive oscillators are a subset of nonlinear oscillators that can learn and encode information in dynamic states. By appending additional states onto a classical Hopf oscillator, a four-state adaptive oscillator is created that can learn both the frequency and amplitude of an external forcing frequency. Analog circuit implementations of nonlinear differential systems are usually achieved by using operational amplifier-based integrator networks, in which redesign procedures of the system topology is time consuming. Here, an analog implementation of a four-state adaptive oscillator is presented for the first time as a field-programmable analog array (FPAA) circuit. The FPAA diagram is described, and the hardware performance is presented. This simple FPAA-based oscillator can be used as an analog frequency analyzer, as its frequency state will evolve to match the external forcing frequency. Notably, this is done without any analog-to-digital conversion or pre-processing, making it an ideal frequency analyzer for low-power and low-memory applications.


  • Effect of Initial Grain Size on Growth Behavior of Intermetallic Compounds on (001)Cu During Aging

    by Chong Dong, Haoran Ma, Dan Zhang, Xiaofu Li, Jie Yu, Liuhong Yang, Haitao Ma

    Cu 6 Sn 5 is the main intermetallic compound between the Sn-based solder and Cu substrate. And the orientation of Cu 6 Sn 5 is one of the key factors affecting its electrical, thermal, and mechanical properties. Besides, under bump metallization may only contain one grain in a limit case due to the decrease of the solder joint. Therefore, the orientation-preferred Cu 6 Sn 5 on Cu single crystal attracts a great of attention from researchers in the electronic packaging industry. During the thermal aging process, the solid-solid reaction will take place in the solder joint and the intermetallic compounds will continue to grow, consequently affecting the performance of the joints. In this paper, the growth behavior of Cu 6 Sn 5 for the different kinds of as-soldered joints in the aging process was investigated. The as-soldered joints were reflowed at 300 °C for 1 s and 120 s, respectively, consequently resulting in the difference in the Cu 3 Sn layer thickness and Cu 6 Sn 5 grain size. Then, the solder joints were aged at 150 °C for a different time. The results suggest that in the aging process, the Cu 6 Sn 5 layer increases gradually and the Cu 3 Sn layer increases rapidly for the two kinds of solder joint. Moreover, the thinner the initial Cu 3 Sn layer is, the faster the Cu 3 Sn layer grows during aging. Besides, the morphology of Cu 6 Sn 5 grains gradually changed from roof to scallop and the preferred orientation of Cu 6 Sn 5 disappeared as the aging time increased. Besides, for the as-soldered joint reflowed at 300 °C for 1s, there are many voids at the reaction interface when the aging time is 20 d.

  • Effect of composition and size of Sn based solder on Cu3Sn growth in interfacial reaction

    by Min Shang, Dan Zhang, Xiaofu Li, Ying Guo, Haitao Ma, Siyu Shang

    The development of electronic packaging has brought about the miniaturization of integrated circuits, which requires that solder joints have a better reliability. The interconnection of electronic components mainly adopts soldering technology. Molten Sn reacts with Cu atoms in the substrate to form intermetallic compounds (IMCs), which is the substance of Sn/Cu soldering interconnection, including Cu 6 Sn 5 and Cu 3 Sn. IMC, strongly affects the reliability of solder joint as the basis of solder joint connection. Compared with Cu 6 Sn 5 , Cu 3 Sn has stronger deformation resistance and more stable service performance, it can withstand the higher temperature in the subsequent packaging process. In this paper, the effects of Sn based solder composition and size on the growth mechanism of interfacial intermetallic compound Cu 3 Sn phase were discussed by reflow soldering process, combined with corresponding characterization methods and simulation techniques.

  • The pendulum adaptive frequency oscillator

    by XiaoFu Li, Pawan Kallepalli, Tushar Mollik, Raf E Ul Shougat, Scott Kennedy, Sean Frabitore, Edmon Perkins


  • Dynamic effects on reservoir computing with a Hopf oscillator

    by Raf E Ul Shougat, XiaoFu Li, Edmon Perkins

    Limit cycle oscillators have the potential to be resourced as reservoir computers due to their rich dynamics. Here, a Hopf oscillator is used as a physical reservoir computer by discarding the delay line and time-multiplexing procedure. A parametric study is used to uncover computational limits imposed by the dynamics of the oscillator using parity and chaotic time-series prediction benchmark tasks. Resonance, frequency ratios from the Farey sequence, and Arnold tongues were found to strongly affect the computation ability of the reservoir. These results provide insights into fabricating physical reservoir computers from limit cycle systems.


  • An Information Theoretic Study of a Duffing Oscillator Array Reservoir Computer

    by Raf E Ul Shougat, XiaoFu Li, Tushar Mollik, Edmon Perkins

    Typically, nonlinearity is considered to be problematic and sometimes can lead to dire consequences. However, the nonlinearity in a Duffing oscillator array can enhance its ability to be used as a reservoir computer. Machine learning and artificial neural networks, inspired by the biological computing framework, have shown their immense potential, especially in the real-time temporal data processing. Here, the efficacy of a Duffing oscillator array is explored as a reservoir computer by using information theory. To do this, a reservoir computer model is studied numerically, which exploits the dynamics of the array. In this system, the complex dynamics stem from the Duffing term in each of the identical oscillators. The effects of various system parameters of the array on the information processing ability are discussed from the perspective of information theory. By varying these parameters, the information metric was found to be topologically mixed. Additionally, the importance of asynchrony in the oscillator array is also discussed in terms of the information metric. Since such nonlinear oscillators are used to model many different physical systems, this research provides insight into how physical nonlinear oscillatory systems can be used for dynamic computation, without significantly modifying or controlling the underlying dynamical system. To the authors' knowledge, this is the first use of Shannon's information rate for quantifying a reservoir computer of this kind, as well as the first comparison between synchronization phenomena and the computing ability of a reservoir.