RBRafaella Mariana Fontes de Bragança

Rafaella Mariana Fontes de Bragança

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Rafaella Mariana Fontes de Bragança has a total of 18 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Assessing color mismatch in single-shade composite resins for enamel replacement

    by Rafaella Mariana Fontes de Bragança, Diana Leyva Del Rio, Luiz Alves Oliveira-Neto, William Michael Johnston


  • Open Access

    Reliability of the color measurement of resin composites using images obtained using a stereoscopic loupe

    by Alexsandra Santos Albuquerque, Rafaella Bragança, Oscar Emilio Pecho, André Luis Faria-E-Silva

    This study assessed the reliability of a color measurement method using images obtained from a charge-coupled device (CCD) camera and a stereoscopic loupe. Disc-shaped specimens were created using the composite Filtek Z350 XT (shades DA1, DA2, DA3, and DA4) (n = 3). CIELAB color coordinates of the specimens were measured using the spectrophotometer SP60 over white and black backgrounds. Images of the same specimens were taken using a CCD camera attached to a stereoscopic loupe. The color of the image was measured (red–green–blue [RGB]) using an image processing software and converted to CIELAB coordinates. For each color coordinate, data from images were adjusted using linear regressions predicting those values from SP60. The whiteness index for dentistry (WID) and translucency parameter (TP00) of the specimens as well as the color differences (ΔE00) among pairwise shades were calculated. Data were analyzed via repeated-measures analysis of variance and Tukey’s post hoc test (α = 0.05). Images obtained using the loupe tended to be darker and redder than the actual color. Data adjustment resulted in similar WID, ΔE00, and TP00 values to those observed for the spectrophotometer. Differences were observed only for the WID of shade DA3 and ΔE00 for comparing DA1 and DA3 over the black background. However, these differences were not clinically relevant. The use of adjusted data from images taken using a stereoscopic loupe is considered a feasible method for color measurement.


  • The role of interface distance and underlying substrate on the color adjustment potential of single‐shade composites

    by Gabriella Jesus Santos de Livi, Tauan Rosa Santana, Rafaella Mariana Fontes Bragança, Rosa Maria Viana de Bragança Garcez, André Luis Faria‐E‐Silva

    Objective: This study assessed how the distance from the composite interface and the underlying chromatic substrate affect the color adjustment potential (CAP) of two single‐shade composites.Materials and Methods: Cylinder‐shaped specimens were created using Vittra APS Unique (VU), Charisma Diamond One (DO), and a shaded (A3) composite. Some single‐shade specimens were surrounded by the A3 composite, forming dual specimens. Color measurements of simple specimens were taken against a gray background using a spectrophotometer. All specimens were positioned at a 45° angle in a viewing booth under illuminant D65, and images were captured with a DSLR camera against gray or A3 backgrounds. Image colors were measured using image processing software and converted to CIELAB coordinates. Color differences (ΔE00) between the single‐shade composites and the A3 composite were calculated. CAP was determined by comparing data from simple and dual specimens.Results: No clinically significant differences were observed between color measurements obtained from images and the spectrophotometer. CAP was higher for DO compared to VU and increased as the distance from the composite interface decreased and when specimens were positioned against an A3 background.Conclusion: The color adjustment potential increased with decreased distance from the composite interface and against a chromatic background.Clinical Significance: Achieving satisfactory color match in restorations using single‐shade composites is crucial, and selecting an appropriate underlying substrate is essential. The color adjustment gradually decreases from the restoration margins towards its center.


  • Open Access

    Prevalence of lectures about dental esthetics and female speakers in three Brazilian conferences

    by Karen Larissa Oliveira Conceição, Karla Danielly Alves Soares, Rafaella Mariana de Bragança, Marcos Britto Correa, Rafael Ratto Moraes, André Luis Faria-E-Silva

    This study analyzed the prevalence of lectures involving esthetics in the scientific program of Brazilian dental conferences and the gender distribution of speakers. All lectures presented in three dental conferences (Bahia, São Paulo, and Goiás states) held from 2016 to 2020 were evaluated. Three investigators individually divided the lectures according to the specialties recognized by the Brazilian Federal Council of Dentistry (FCD) based on their titles. The lectures were also classified as involving or not esthetics, and the speaker`s gender was recorded. Descriptive statistical analyses were performed, and Chi-square tests assessed possible associations between factors. The words most cited in the titles of the lectures were “esthetic” (13.6%), “dentistry” (9.9%), and “treatment” (8.1%). Oral diseases were barely mentioned in the titles (up to 1.3%). The highest number of lectures was observed for the specialty of Restorative Dentistry (22.3%), followed by Prosthodontics (18.5%). Approximately one-third of lectures involved some aesthetic aspect, but this percentage ranged from 71.9 to 78.6% for the two specialties with more lectures. Regarding the speaker`s gender, the inequity was higher for lectures involving esthetics (81.6% of males) than for topics unrelated to esthetics (66.7%). More male speakers than females were observed for all specialties. The highest gender gap was observed for Pediatric Dentistry with 62.4% male speakers, although only 10.6% of FCD registered specialists were men. In conclusion, the Brazilian dental conferences analyzed seemed to favor offering lectures dealing with esthetic topics and male speakers.


  • Open Access

    Background and surrounding colors affect the color blending of a single-shade composite

    by Mariana Silva Barros, Paula Fernanda Damasceno Silva, Márcia Luciana Carregosa Santana, Rafaella Mariana Fontes Bragança, André Luis Faria-E-Silva

    This study evaluated the background and effect of surrounding colors on the color blending of a single-shade composite used in a thin layer. Disc-shaped specimens (1.0 mm thickness) were built with the Vittra APS Unique composite surrounded (dual specimens) or not surrounded (simple specimens) by a control composite (shade A1, A2, or A3). Simple specimens were also built with only control composites. The specimen color was measured against white and black backgrounds with a spectrophotometer (CIELAB system). The whiteness index for dentistry (WID) was calculated for simple specimens. Differences (ΔE00) in color and translucency parameters (ΔTP00) between the simple/dual specimens and the controls were calculated. The translucency adjustment potential (TAP) and color adjustment potential (CAP) were estimated based on the ratios between data from simple and dual specimens. The Vittra APS Unique composite showed higher WID values than the controls. No differences between ΔTP00_SIMPLE and ΔTP00_DUAL were observed for any of the shades. The composite shade did not affect TAP values. The lowest values of ΔE00_SIMPLE and ΔE00_DUAL were observed for shade A1 regardless of the background color. For the white background, ΔE00_SIMPLE values did not differ from those of ΔE00_DUAL for all shades. Only A1 showed ΔE00_DUAL values lower than ΔE00_SIMPLE when the black background was used. The highest modulus of CAP (negative values for the white background) was observed when shade A1 surrounded the Vittra APS Unique composite. The color blending ability of the single-shade resin composite used in a thin layer was affected by both the surrounding shade and background color.


  • Open Access

    Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a thin layer

    by Mariana Silva Barros, Paula Fernanda Damasceno Silva, Márcia Luciana Carregosa Santana, Rafaella Mariana Fontes Bragança, André Luis Faria-E-Silva

    Barros MS, et al. Restor Dent Endod. 2022 Dec;48:e7. https://doi.org/10.5395/rde.2023.48.e7


  • Open Access

    Effect of surrounded shade and specimen`s thickness on color adjustment potential of a single-shade composite

    by Mariana Silva Barros, Paula Fernanda Damasceno Silva, Márcia Luciana Carregosa Santana, Rafaella Mariana Fontes de Bragança, André Luis Faria-E-Silva

    This study evaluated the effect of surrounded shade and specimens` thickness on the color adjustment potential (CAP) of a single-shade composite. The composite Vittra APS Unique was surrounded (dual specimens) or not (simple specimens) by a control composite (shade A1, A2, or A3). Simple specimens of the control composite were also confectioned. Opacity and whiteness index for dentistry (WID) were calculated for simple specimens. Color differences between the simple (ΔE*SIMPLE)/ dual specimens (ΔE*DUAL) and the controls were calculated. CAP was calculated based on the ratio between ΔE* SIMPLE and ΔE* DUAL. The tested composite presented lower opacity (53 to 62% vs. 80 to 93%) and higher WID (≈ 42 vs. 18 to 32) than controls. Irrespective of the specimens’ thickness (1.0/ 1.5 mm), the lowest values of ΔE* SIMPLE (11.1/ 10.8) and ΔE*DUAL (7.2/ 6.1) were observed using the surrounding shade A1. The shade A3 yielded higher ΔE*SIMPLE (16.4/ 17.1) and ΔE* DUAL (11.3/ 12.3) than the A2 (ΔE*SIMPLE = 13.4/ 14.6; and ΔE* DUAL = 9.7/ 10.3). The specimen`s thickness significantly affected the CAP (0.35 and 0.44 for 1.0 and 1.5 mm, respectively) only for shade A1, which had the highest CAP values. The shade A3 resulted in higher CAP values (0.31) than A2 (0.27) when 1.0-mm thick specimens were used, but similar values were observed for 1.5 thick specimens (≈ 0.29). In conclusion, both surrounding shade and specimen thickness can affect the CAP of a single-shade resin composite.


  • Open Access

    The effectiveness of the supplementary use of the XP-endo Finisher on bacteria content reduction: a systematic review and meta-analysis

    by Ludmila Smith de Jesus Oliveira, Rafaella Mariana Fontes de Bragança, Rafael Sarkis-Onofre, André Luis Faria-E-Silva

    Oliveira LS, et al. Restor Dent Endod. 2021 Jun;46(3):e37. https://doi.org/10.5395/rde.2021.46.e37


  • Open Access

    Color assessment of resin composite by using cellphone images compared with a spectrophotometer

    by Rafaella Mariana Fontes de Bragança, Rafael Ratto Moraes, André Luis Faria-E-Silva

    De Bragança RM, et al. Restor Dent Endod. 2021 Apr;46(2):e23. https://doi.org/10.5395/rde.2021.46.e23