Tetyana Kalyn
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tetyana Kalyn has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Halyna Hrytsuliak
Ivano-Frankivsk National Technical University of Oil and Gas
5 shared publications - Andrew Kotsyubynsky
Ivano-Frankivsk National Technical University of Oil and Gas
3 shared publications - Diana Lynnyk
Ivano-Frankivsk National Technical University of Oil and Gas
3 shared publications - Ольга Фомічова
Ivano-Frankivsk National Technical University of Oil and Gas
3 shared publications - Andrii Hrytsanchuk
Ivano-Frankivsk National Technical University of Oil and Gas
1 shared publication - Anna Gamarnyk
Івано-Франківський національний медичний університет
1 shared publication
Latest Publications
- 15 August 2026
- Published by Springer Nature
- p. 373-384
Accumulation of Toxic Substances in Plants and Their Impact on Human Health
- 15 August 2026
- Published by Springer Nature
- p. 373-384
Accumulation of Toxic Substances in Plants and Their Impact on Human Health
- 15 August 2026
- Published by Springer Nature
- p. 411-425
Justifying the Choice of Technologies and Equipment to Reduce Dustiness in Grain Processing Enterprises
- 15 August 2026
- Published by Springer Nature
- p. 411-425
Justifying the Choice of Technologies and Equipment to Reduce Dustiness in Grain Processing Enterprises
- 3 July 2025
- Published by Springer Nature
- p. 617-625
Revitalization of Oil-Polluted Soils by Growing PhytoreMediation Plants
- 3 July 2025
- Published by Springer Nature
- p. 617-625
Revitalization of Oil-Polluted Soils by Growing PhytoreMediation Plants
- Open Access
- 1 June 2025
- Published by International Science Group in International Science Journal of Engineering & Agriculture
- Vol. 4 (3) , 66-80
Environmentally friendly corrosion inhibitors: a modern alternative to traditional methods of protecting metal structures
Metal corrosion is a serious technical and environmental problem that leads to significant economic losses and threatens the safety of infrastructure. Traditional methods of protecting metal structures are based on the use of chemical inhibitors, which are often toxic, poorly biodegradable and hazardous to human health and the environment. In response to these challenges, there is a growing interest in the development of “green” corrosion inhibitors - non-toxic, biodegradable and environmentally friendly substances derived from natural sources. This study examines the effectiveness of aqueous, alcoholic and water-alcohol plant extracts as an alternative to traditional corrosion inhibitors for the protection of 17GS steel in the NS4 model environment. Experimental studies have shown that the water-alcohol extract of Echinacea provides up to 69% protection of steel, the water extract of tea - up to 50%, while the effectiveness of eucalyptus oil was only 12%. The results obtained indicate a significant dependence of the protection efficiency on the type of plant material, extract concentration, exposure temperature, and duration of contact with the environment. Gravimetric analysis confirmed the formation of a dense protective adsorption-oligomeric film on the metal surface, which significantly reduces the corrosion rate and increases the polarization resistance of steel to 15 kΩ at a concentration of 40 ml/l. Microstructural analysis shows that the most effective compounds are those with aromatic structures and nitrogen-containing heterocycles that are able to form stable chemical bonds with the metal surface. A multivariate regression analysis of the dependence of steel corrosion resistance on exposure time, inhibitor concentration, and temperature was performed, which confirmed the significant impact of these factors on metal protection. The studies indicate that it is possible to optimize the composition of inhibitors by using combined herbal preparations and nanostructured additives to increase the duration and effectiveness of the protective effect. The results of this work open up new prospects for the development of environmentally friendly metal protection technologies that meet the concept of sustainable development and the principles of green chemistry. Further research should be focused on finding new sources of bioactive compounds, improving extraction methods, and in-depth study of the mechanisms of protective coatings formation.
- 1 June 2025
- Published by International Science Group in International Science Journal of Engineering & Agriculture
- Vol. 4 (3) , 66-80
Open AccessEnvironmentally friendly corrosion inhibitors: a modern alternative to traditional methods of protecting metal structures
Metal corrosion is a serious technical and environmental problem that leads to significant economic losses and threatens the safety of infrastructure. Traditional methods of protecting metal structures are based on the use of chemical inhibitors, which are often toxic, poorly biodegradable and hazardous to human health and the environment. In response to these challenges, there is a growing interest in the development of “green” corrosion inhibitors - non-toxic, biodegradable and environmentally friendly substances derived from natural sources. This study examines the effectiveness of aqueous, alcoholic and water-alcohol plant extracts as an alternative to traditional corrosion inhibitors for the protection of 17GS steel in the NS4 model environment. Experimental studies have shown that the water-alcohol extract of Echinacea provides up to 69% protection of steel, the water extract of tea - up to 50%, while the effectiveness of eucalyptus oil was only 12%. The results obtained indicate a significant dependence of the protection efficiency on the type of plant material, extract concentration, exposure temperature, and duration of contact with the environment. Gravimetric analysis confirmed the formation of a dense protective adsorption-oligomeric film on the metal surface, which significantly reduces the corrosion rate and increases the polarization resistance of steel to 15 kΩ at a concentration of 40 ml/l. Microstructural analysis shows that the most effective compounds are those with aromatic structures and nitrogen-containing heterocycles that are able to form stable chemical bonds with the metal surface. A multivariate regression analysis of the dependence of steel corrosion resistance on exposure time, inhibitor concentration, and temperature was performed, which confirmed the significant impact of these factors on metal protection. The studies indicate that it is possible to optimize the composition of inhibitors by using combined herbal preparations and nanostructured additives to increase the duration and effectiveness of the protective effect. The results of this work open up new prospects for the development of environmentally friendly metal protection technologies that meet the concept of sustainable development and the principles of green chemistry. Further research should be focused on finding new sources of bioactive compounds, improving extraction methods, and in-depth study of the mechanisms of protective coatings formation.
- Open Access
- 1 September 2020
- Published by Walter de Gruyter GmbH in Management Systems in Production Engineering
- Vol. 28 (3) , 141-147
INFLUENCE OF HYDRATE FORMATION AND CONCENTRATION OF SALTS ON THE CORROSION OF STEEL 20 PIPELINES
One of the ways to increase natural gas production is to conserve and/or intensify existing wells with their subsequent development. They are characterized by a high content of highly mineralized water, which leads to an increased risk of hydrate formation and internal corrosion. The issue of the formation of gas hydrates in industrial pipelines, which is a major problem for the exploitation of industrial gas pipelines, requires considerable attention to be made to exclude emergency situations. The main task of the study - to determine the effect of hydrates on the corrosion of the pipeline in order to prevent emergencies. A technique for studying the effect of hydration on the corrosion of pipelines has been developed. The combined analysis of the corrosion behavior of pipe material in aggressive media of chloride type was done. According to the results of corrosion-mechanical tests, regularities of joint action of mechanical stresses, concentration of chlorides and hydrate formation on the speed and localization of corrosion processes are established.
- 1 September 2020
- Published by Walter de Gruyter GmbH in Management Systems in Production Engineering
- Vol. 28 (3) , 141-147
Open AccessINFLUENCE OF HYDRATE FORMATION AND CONCENTRATION OF SALTS ON THE CORROSION OF STEEL 20 PIPELINES
One of the ways to increase natural gas production is to conserve and/or intensify existing wells with their subsequent development. They are characterized by a high content of highly mineralized water, which leads to an increased risk of hydrate formation and internal corrosion. The issue of the formation of gas hydrates in industrial pipelines, which is a major problem for the exploitation of industrial gas pipelines, requires considerable attention to be made to exclude emergency situations. The main task of the study - to determine the effect of hydrates on the corrosion of the pipeline in order to prevent emergencies. A technique for studying the effect of hydration on the corrosion of pipelines has been developed. The combined analysis of the corrosion behavior of pipe material in aggressive media of chloride type was done. According to the results of corrosion-mechanical tests, regularities of joint action of mechanical stresses, concentration of chlorides and hydrate formation on the speed and localization of corrosion processes are established.