Eduard Latõšov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Eduard Latõšov has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Anna Volkova
Department of Energy Technology , Tallinn University of Technology , Ehitajate Tee 5 , Tallinn , Estonia
4 shared publications - Andres Siirde
Department of Energy Technology, Tallinn University of Technology, 19086 Tallinn, Estonia
2 shared publications Anna Volkova
2 shared publications- Jarek Kurnitski
Department of Civil Engineering and Architecture, Tallinn University of Technology, 19086 Tallinn, Estonia
2 shared publications Andres Siirde
Tallinn University of Technology , Ehitajate tee 5, Tallinn , 19086 , Estonia
1 shared publication- Jelena Ziemele
Riga Technical University
1 shared publication
Latest Publications
- Open Access
- 1 August 2022
- Published by Elsevier in Energy Reports
- Vol. 8, 9493-9505
Transition towards university campus carbon neutrality by connecting to city district heating network
- 1 August 2022
- Published by Elsevier in Energy Reports
- Vol. 8, 9493-9505
Open AccessTransition towards university campus carbon neutrality by connecting to city district heating network
- Open Access
- 27 April 2022
- Published by Elsevier in Smart Energy
- Vol. 6
CO2 emission intensity of the Estonian DH sector
- 27 April 2022
- Published by Elsevier in Smart Energy
- Vol. 6
Open AccessCO2 emission intensity of the Estonian DH sector
- Open Access
- 1 January 2020
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 24 (1) , 171-184
Heat Storage Combined with Biomass CHP under the National Support Policy. A Case Study of Estonia
In spite of the progressions in heat storage systems for combined heat and power’ (CHP) plants performance, these innovations have not been implemented in CHP-based district heating (DH) systems in some of the countries where DH systems are still being developed. An examination of environmental and economic advantages that can be gained as a result of heat storage installation into the DH system are necessary to effectively popularise heat storage as a DH system-improvement technology. A real large-scale biomass CHP-based DH system is investigated in this case study. Scenarios for two kinds of support policies (feed-in premium for electricity generated by biomass CHP and energy-efficient biomass CHP) were analysed by changing the extent of the heat storage. The goal of this study was to assess the impact of the biomass CHP policy support instruments on the viability of integrating heat storage. Calculations demonstrate that fitting of heat storage combined with biomass CHP is less viable when all power generated by biomass CHP is subsidised.
- 1 January 2020
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 24 (1) , 171-184
Open AccessHeat Storage Combined with Biomass CHP under the National Support Policy. A Case Study of Estonia
In spite of the progressions in heat storage systems for combined heat and power’ (CHP) plants performance, these innovations have not been implemented in CHP-based district heating (DH) systems in some of the countries where DH systems are still being developed. An examination of environmental and economic advantages that can be gained as a result of heat storage installation into the DH system are necessary to effectively popularise heat storage as a DH system-improvement technology. A real large-scale biomass CHP-based DH system is investigated in this case study. Scenarios for two kinds of support policies (feed-in premium for electricity generated by biomass CHP and energy-efficient biomass CHP) were analysed by changing the extent of the heat storage. The goal of this study was to assess the impact of the biomass CHP policy support instruments on the viability of integrating heat storage. Calculations demonstrate that fitting of heat storage combined with biomass CHP is less viable when all power generated by biomass CHP is subsidised.
- Open Access
- 1 March 2019
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 23 (1) , 1-13
The Impact of Parallel Energy Consumption on the District Heating Networks
The aim of this study is to evaluate and compare the impacts of heat recovery ventilation (HRV) and exhaust air heat pump (EAHP)-based solutions used in renovated buildings, which make it possible to reach performance class C in district heating (DH) area CO2 emissions, primary energy consumption and total energy costs for consumers. Evaluation is based on the methodology presented in the previous research paper [1]. Calculation results show that the use of EAHP has a negative impact on DH sustainability (heat losses in the DH network, DH heat price, reduced consumption of DH heat) and CO2 emissions related to energy delivery (heat and electricity) to consumers in the DH area. Positive aspects of the EAHP use include the fact that almost the same primary energy consumption level can be achieved with lesser (up to 7 %) annual costs (annual capital costs, DH heat costs and electricity costs) and lower initial investments (about 10 %). At the same time, every renovated building with EAHP will experience a negative impact on heat prices. In DH areas where almost all buildings are renovated with EAHP, cost savings are not as evident compared to buildings with HRV in DH areas where the use of parallel consumption solutions (EAHP) is minimized. It is reasonable to promote these renovation packages and solutions that benefit the building’s primary energy reduction, and also do not increase electric energy consumption (additional electric power generators are needed) and do not damage DH networks.
- 1 March 2019
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 23 (1) , 1-13
Open AccessThe Impact of Parallel Energy Consumption on the District Heating Networks
The aim of this study is to evaluate and compare the impacts of heat recovery ventilation (HRV) and exhaust air heat pump (EAHP)-based solutions used in renovated buildings, which make it possible to reach performance class C in district heating (DH) area CO2 emissions, primary energy consumption and total energy costs for consumers. Evaluation is based on the methodology presented in the previous research paper [1]. Calculation results show that the use of EAHP has a negative impact on DH sustainability (heat losses in the DH network, DH heat price, reduced consumption of DH heat) and CO2 emissions related to energy delivery (heat and electricity) to consumers in the DH area. Positive aspects of the EAHP use include the fact that almost the same primary energy consumption level can be achieved with lesser (up to 7 %) annual costs (annual capital costs, DH heat costs and electricity costs) and lower initial investments (about 10 %). At the same time, every renovated building with EAHP will experience a negative impact on heat prices. In DH areas where almost all buildings are renovated with EAHP, cost savings are not as evident compared to buildings with HRV in DH areas where the use of parallel consumption solutions (EAHP) is minimized. It is reasonable to promote these renovation packages and solutions that benefit the building’s primary energy reduction, and also do not increase electric energy consumption (additional electric power generators are needed) and do not damage DH networks.
- Open Access
- 1 May 2017
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 19 (1) , 5-14
Methodological Approach to Determining the Effect of Parallel Energy Consumption on District Heating System
District heating (DH) offers the most effective way to enhance the efficiency of primary energy use, increasing the share of renewable energy in energy consumption and decreasing the amount of CO2 emissions. According to Article 9 section 1 of the Directive 2010/31/EU of the European Parliament and of the Council of 19 May 2010 on the energy performance of buildings, the Member states of the European Union are obligated to draw up National Plans for increasing the number of nearly zero-energy buildings [1]. Article 2 section 2 of the same Directive states that the energy used in nearly zero-energy buildings should be created covered to a very significant extent by energy from renewable sources, including energy from renewable sources produced on-site or nearby. Thus, the heat distributed by DH systems and produced by manufacturing devices located in close vicinity of the building also have to be taken into account in determining the energy consumption of the building and the share of renewable energy used in the nearly zero-energy buildings. With regard to the spreading of nearly zero-energy and zero-energy houses, the feasibility of on-site energy (heat and/or electricity) production and consumption in DH areas energy (i.e. parallel consumption, when the consumer, connected to DH system, consumes energy for heat production from other sources besides the DH system as well) needs to be examined. In order to do that, it is necessary to implement a versatile methodological approach based on the principles discussed in this article.
- 1 May 2017
- Published by Walter de Gruyter GmbH in Environmental and Climate Technologies
- Vol. 19 (1) , 5-14
Open AccessMethodological Approach to Determining the Effect of Parallel Energy Consumption on District Heating System
District heating (DH) offers the most effective way to enhance the efficiency of primary energy use, increasing the share of renewable energy in energy consumption and decreasing the amount of CO2 emissions. According to Article 9 section 1 of the Directive 2010/31/EU of the European Parliament and of the Council of 19 May 2010 on the energy performance of buildings, the Member states of the European Union are obligated to draw up National Plans for increasing the number of nearly zero-energy buildings [1]. Article 2 section 2 of the same Directive states that the energy used in nearly zero-energy buildings should be created covered to a very significant extent by energy from renewable sources, including energy from renewable sources produced on-site or nearby. Thus, the heat distributed by DH systems and produced by manufacturing devices located in close vicinity of the building also have to be taken into account in determining the energy consumption of the building and the share of renewable energy used in the nearly zero-energy buildings. With regard to the spreading of nearly zero-energy and zero-energy houses, the feasibility of on-site energy (heat and/or electricity) production and consumption in DH areas energy (i.e. parallel consumption, when the consumer, connected to DH system, consumes energy for heat production from other sources besides the DH system as well) needs to be examined. In order to do that, it is necessary to implement a versatile methodological approach based on the principles discussed in this article.
- Open Access
- 1 September 2011
- Published by Taylor & Francis in Baltic Journal of Economics
- Vol. 11 (2) , 41-58
Implications for competitiveness of the Estonian carbon-intensive industry post-2013
From 2013 the total quantity of permitted CO2 emissions in the European Union will be decreasingly capped, putting pressure on their unit price. This in turn will influence carbon-intensive companies’ total costs and potentially affect profit margins. This article offers analysis of a small open country’s carbon-intensive firms’ variable cost sensitivity to CO2 prices at €15, €25 and €50 per tonne, using Estonia as a reference. The analysis reveals that firms using heavily carbon-intensive fuels (such as oil shale) could experience variable cost increase up to 100%. Although such fuel is primarily used in Estonia’s electricity generation, the biggest impact would hit the country’s mineral sector where carbon-intensive manufacturing faces on average a 20% variable cost change. Such companies could eventually move their activities outside the EU.
- 1 September 2011
- Published by Taylor & Francis in Baltic Journal of Economics
- Vol. 11 (2) , 41-58
Open AccessImplications for competitiveness of the Estonian carbon-intensive industry post-2013
From 2013 the total quantity of permitted CO2 emissions in the European Union will be decreasingly capped, putting pressure on their unit price. This in turn will influence carbon-intensive companies’ total costs and potentially affect profit margins. This article offers analysis of a small open country’s carbon-intensive firms’ variable cost sensitivity to CO2 prices at €15, €25 and €50 per tonne, using Estonia as a reference. The analysis reveals that firms using heavily carbon-intensive fuels (such as oil shale) could experience variable cost increase up to 100%. Although such fuel is primarily used in Estonia’s electricity generation, the biggest impact would hit the country’s mineral sector where carbon-intensive manufacturing faces on average a 20% variable cost change. Such companies could eventually move their activities outside the EU.