Zhiqing Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhiqing Yang has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Hao Zhou
School of Electronic Information, Wuhan University, Wuhan, China
2 shared publications - Yingwei Tian
School of Electronic Information, Wuhan University, Wuhan, China
2 shared publications - Biyang Wen
School of Electronic Information, Wuhan University, Wuhan 430072, China
1 shared publication - Jianjiang Tang
East China Sea Forecast Center, State Oceanic Administration, Shanghai 200136, China
1 shared publication - Wei Shen
The School of Computer Science and Engineering, Nanjing University of Science and Technology, Nanjing 210094, China
1 shared publication - Weimin Huang
Faculty of Engineering and Applied Science, Memorial University of Newfoundland, St. John’s, NL A1B 3X5, Canada
1 shared publication
Latest Publications
- Open Access
- 26 October 2021
- Published by MDPI AG in Remote Sensing
- Vol. 13 (21) , 4305
Improving Ship Detection in Clutter-Edge and Multi-Target Scenarios for High-Frequency Radar
As one of the main sensors for continuous maritime measurements of sea state parameters, high-frequency surface wave radar (HFSWR) also plays an important role in ship detection and tracking. Compact HFSWR often suffers from missing targets, especially when the target appears near the Doppler region with heavy sea clutter or near another target in a multi-target scenario. To address this problem, an automatic ship detection method based on time–frequency (TF) analysis is presented in this paper. The TF target ridge areas are extracted in the TF image via the eigenvalues of the Hessian matrix, image edge detection, and local maximum search. Then, whether ship signals exist in the TF ridges or not is decided by a decision threshold that is calculated by fitting the probability distribution function (PDF) of sea clutter in the TF domain. The proposed TF method can separate TF ridges of similar Doppler frequency and performs constant false alarm rate (CFAR) detection for TF targets, which facilitates detecting these targets that are masked by sea clutter and other large targets. Experimental results show that the number of detected ships that match with the automatic identification system (AIS) records is four times more than that obtained by the conventional constant false alarm rate (CFAR) detectors and 1.3 times more than that by the state-of-the-art TF method in consideration of approximately the same number of detected targets.
- 26 October 2021
- Published by MDPI AG in Remote Sensing
- Vol. 13 (21) , 4305
Open AccessImproving Ship Detection in Clutter-Edge and Multi-Target Scenarios for High-Frequency Radar
As one of the main sensors for continuous maritime measurements of sea state parameters, high-frequency surface wave radar (HFSWR) also plays an important role in ship detection and tracking. Compact HFSWR often suffers from missing targets, especially when the target appears near the Doppler region with heavy sea clutter or near another target in a multi-target scenario. To address this problem, an automatic ship detection method based on time–frequency (TF) analysis is presented in this paper. The TF target ridge areas are extracted in the TF image via the eigenvalues of the Hessian matrix, image edge detection, and local maximum search. Then, whether ship signals exist in the TF ridges or not is decided by a decision threshold that is calculated by fitting the probability distribution function (PDF) of sea clutter in the TF domain. The proposed TF method can separate TF ridges of similar Doppler frequency and performs constant false alarm rate (CFAR) detection for TF targets, which facilitates detecting these targets that are masked by sea clutter and other large targets. Experimental results show that the number of detected ships that match with the automatic identification system (AIS) records is four times more than that obtained by the conventional constant false alarm rate (CFAR) detectors and 1.3 times more than that by the state-of-the-art TF method in consideration of approximately the same number of detected targets.
- Open Access
- 16 April 2021
- Published by MDPI AG in Remote Sensing
- Vol. 13 (8) , 1548
Joint Ship Detection Based on Time-Frequency Domain and CFAR Methods with HF Radar
Compact high-frequency surface wave radar (HFSWR) plays a critical role in ship surveillance. Due to the wide antenna beam-width and low spatial gain, traditional constant false alarm rate (CFAR) detectors often induce a low detection probability. To solve this problem, a joint detection algorithm based on time-frequency (TF) analysis and the CFAR method is proposed in this paper. After the TF ridge extraction, CFAR detection is performed to test each sample of the ridges, and a binary integration is run to determine whether the entire TF ridge is of a ship. To verify the effectiveness of the proposed algorithm, experimental data collected by the Ocean State Monitoring and Analyzing Radar, type SD (OSMAR-SD) were used, with the ship records from an automatic identification system (AIS) used as ground truth data. The processing results showed that the joint TF-CFAR method outperformed CFAR in detecting non-stationary and weak signals and those within the first-order sea clutters, whereas CFAR outperformed TF-CFAR in identifying multiple signals with similar frequencies. Notably, the intersection of the matched detection sets by TF-CFAR and CFAR alone was not immense, which takes up approximately 68% of the matched number by CFAR and 25% of that by TF-CFAR; however, the number in the union detection sets was much (>30%) greater than the result of either method. Therefore, joint detection with TF-CFAR and CFAR can further increase the detection probability and greatly improve detection performance under complicated situations, such as non-stationarity, low signal-to-noise ratio (SNR), and within the first-order sea clutters.
- 16 April 2021
- Published by MDPI AG in Remote Sensing
- Vol. 13 (8) , 1548
Open AccessJoint Ship Detection Based on Time-Frequency Domain and CFAR Methods with HF Radar
Compact high-frequency surface wave radar (HFSWR) plays a critical role in ship surveillance. Due to the wide antenna beam-width and low spatial gain, traditional constant false alarm rate (CFAR) detectors often induce a low detection probability. To solve this problem, a joint detection algorithm based on time-frequency (TF) analysis and the CFAR method is proposed in this paper. After the TF ridge extraction, CFAR detection is performed to test each sample of the ridges, and a binary integration is run to determine whether the entire TF ridge is of a ship. To verify the effectiveness of the proposed algorithm, experimental data collected by the Ocean State Monitoring and Analyzing Radar, type SD (OSMAR-SD) were used, with the ship records from an automatic identification system (AIS) used as ground truth data. The processing results showed that the joint TF-CFAR method outperformed CFAR in detecting non-stationary and weak signals and those within the first-order sea clutters, whereas CFAR outperformed TF-CFAR in identifying multiple signals with similar frequencies. Notably, the intersection of the matched detection sets by TF-CFAR and CFAR alone was not immense, which takes up approximately 68% of the matched number by CFAR and 25% of that by TF-CFAR; however, the number in the union detection sets was much (>30%) greater than the result of either method. Therefore, joint detection with TF-CFAR and CFAR can further increase the detection probability and greatly improve detection performance under complicated situations, such as non-stationarity, low signal-to-noise ratio (SNR), and within the first-order sea clutters.