Linning Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Linning Wang has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Yongjin Wang
GaN Optoelectronic Integration International Cooperation Joint Laboratory of Jiangsu Province, Nanjing University of Posts and Telecommunications, Nanjing, China
4 shared publications Kang Fu
Nanjing University of Posts and Telecommunications
2 shared publicationsPengzhan Liu
2 shared publicationsBolun Jia
Nanjing University of Posts and Telecommunications
1 shared publicationChengwei Wang
Nanjing Tech University
1 shared publicationDemao Ye
China State Shipbuilding Corporation Limited
1 shared publication
Latest Publications
- 16 April 2024
- Published by Optica Publishing Group in Optics Letters
- Vol. 49 (9) , 2229-2232
Optical wireless communication using a flexible and waterproof perovskite color converter
In this Letter, the CH3NH3PbBr3 nanocrystals (NCs) are embedded into the interstices of the fluorine (polyvinyl fluoride/polyvinylidene fluoride, PVF/PVDF) matrix on polyethylene terephthalate (PET) substrate to introduce new advantages, such as being flexible and waterproof, while maintaining the high optical performance of perovskites. The sample’s photoluminescence (PL) spectra under 325 nm laser is a green emission peaked at 537 nm with full width at half maximum (FWHM) of about 21.2 nm and a fast PL decay time. As a color converter, it shows high optical absorption and can transform light from solar-blind ultraviolet to a blue region into a green region in air, water, and bending conditions. While excited by a 270 nm ultraviolet light-emitting diode (LED), the system’s observed −3 dB bandwidth with the color converter is near 4.4 MHz in air and water conditions with well-eye diagrams at a data rate of 30 Mbps. Finally, we demonstrate an audio transmission application with an ultraviolet light source, a color conversion layer, and a low-cost silicon-based photodetector.
- 16 April 2024
- Published by Optica Publishing Group in Optics Letters
- Vol. 49 (9) , 2229-2232
Optical wireless communication using a flexible and waterproof perovskite color converter
In this Letter, the CH3NH3PbBr3 nanocrystals (NCs) are embedded into the interstices of the fluorine (polyvinyl fluoride/polyvinylidene fluoride, PVF/PVDF) matrix on polyethylene terephthalate (PET) substrate to introduce new advantages, such as being flexible and waterproof, while maintaining the high optical performance of perovskites. The sample’s photoluminescence (PL) spectra under 325 nm laser is a green emission peaked at 537 nm with full width at half maximum (FWHM) of about 21.2 nm and a fast PL decay time. As a color converter, it shows high optical absorption and can transform light from solar-blind ultraviolet to a blue region into a green region in air, water, and bending conditions. While excited by a 270 nm ultraviolet light-emitting diode (LED), the system’s observed −3 dB bandwidth with the color converter is near 4.4 MHz in air and water conditions with well-eye diagrams at a data rate of 30 Mbps. Finally, we demonstrate an audio transmission application with an ultraviolet light source, a color conversion layer, and a low-cost silicon-based photodetector.
- 27 February 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (6) , 9330-9338
Full-duplex underwater wireless blue light communication
Owing to its relatively low absorption loss and high data transmission rate, wireless blue light communication is becoming an increasingly attractive technology for underwater applications. Here, we demonstrate an underwater optical wireless communication (UOWC) system that communicates using blue light-emitting diodes (LEDs) with a dominant wavelength of 455 nm. Under the on-off keying modulation scheme, the waterproof UOWC system achieves a bidirectional communication rate of 4 Mbps based on the transmission control protocol (TCP) and exhibits real-time full-duplex video communication with a transmission distance of 12 m in a swimming pool, offering great potential for practical use in real-world scenarios, such as carried around or attached to an autonomous vehicle.
- 27 February 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (6) , 9330-9338
Full-duplex underwater wireless blue light communication
Owing to its relatively low absorption loss and high data transmission rate, wireless blue light communication is becoming an increasingly attractive technology for underwater applications. Here, we demonstrate an underwater optical wireless communication (UOWC) system that communicates using blue light-emitting diodes (LEDs) with a dominant wavelength of 455 nm. Under the on-off keying modulation scheme, the waterproof UOWC system achieves a bidirectional communication rate of 4 Mbps based on the transmission control protocol (TCP) and exhibits real-time full-duplex video communication with a transmission distance of 12 m in a swimming pool, offering great potential for practical use in real-world scenarios, such as carried around or attached to an autonomous vehicle.
- 28 July 2021
- Published by Optica Publishing Group in Optics Express
- Vol. 29 (16) , 25922-25944
Single-photon detection for MIMO underwater wireless optical communication enabled by arrayed LEDs and SiPMs
Underwater wireless optical communication (UWOC) is a promising technology that can be a candidate to improve the communication capacity and speed in aquatic media. The aim of this study is to examine the performance of a silicon photomultiplier (SiPM) array-based multiple-input multiple-output (MIMO) UWOC system. A SiPM is a modern solid-state photodetector with extremely high sensitivity up to the single-photon level or a photon-counting ability, which helps in detecting extremely weak light signals after long-distance underwater channel attenuation. We clarify the basic characteristics and photon-counting detection mode of a SiPM. In particular, the photocount of a SiPM is approximated by a Gaussian distribution, and theoretical analysis shows that only 13.3 photons need to be detected during “1” symbol period to achieve a bit error rate of 10−3 in an ambient light environment. Moreover, a SiPM also has a better analog mode detection ability than an avalanche photodiode (APD) and realizes 2 Mbps analog communication owing to its unique array structure and high photon detection efficiency. Furthermore, MIMO, i.e., spatial diversity, is applied as an effective method to relax the link alignment, improve the system performance, and alleviate the effect of optical turbulence. In our experiment, with a photon-counting 6×3 MIMO scheme, an energy per bit of 7.38×10−9 J/bit is achieved at a scintillation index of 4.66×10−3 in a 10 m water tank with 1 Mbps on-off-keying (OOK) modulation. To the best of our knowledge, this is the first study on a MIMO-UWOC system based on the photon-counting mode of a SiPM array. This UWOC system combines the advantages of SiPMs and the MIMO scheme and has the potential to realize long-distance UWOC under optical turbulence.
- 28 July 2021
- Published by Optica Publishing Group in Optics Express
- Vol. 29 (16) , 25922-25944
Single-photon detection for MIMO underwater wireless optical communication enabled by arrayed LEDs and SiPMs
Underwater wireless optical communication (UWOC) is a promising technology that can be a candidate to improve the communication capacity and speed in aquatic media. The aim of this study is to examine the performance of a silicon photomultiplier (SiPM) array-based multiple-input multiple-output (MIMO) UWOC system. A SiPM is a modern solid-state photodetector with extremely high sensitivity up to the single-photon level or a photon-counting ability, which helps in detecting extremely weak light signals after long-distance underwater channel attenuation. We clarify the basic characteristics and photon-counting detection mode of a SiPM. In particular, the photocount of a SiPM is approximated by a Gaussian distribution, and theoretical analysis shows that only 13.3 photons need to be detected during “1” symbol period to achieve a bit error rate of 10−3 in an ambient light environment. Moreover, a SiPM also has a better analog mode detection ability than an avalanche photodiode (APD) and realizes 2 Mbps analog communication owing to its unique array structure and high photon detection efficiency. Furthermore, MIMO, i.e., spatial diversity, is applied as an effective method to relax the link alignment, improve the system performance, and alleviate the effect of optical turbulence. In our experiment, with a photon-counting 6×3 MIMO scheme, an energy per bit of 7.38×10−9 J/bit is achieved at a scintillation index of 4.66×10−3 in a 10 m water tank with 1 Mbps on-off-keying (OOK) modulation. To the best of our knowledge, this is the first study on a MIMO-UWOC system based on the photon-counting mode of a SiPM array. This UWOC system combines the advantages of SiPMs and the MIMO scheme and has the potential to realize long-distance UWOC under optical turbulence.
- 21 April 2021
- Published by Optica Publishing Group in Optics Letters
- Vol. 46 (9) , 2075-2078
Simultaneous transmission, detection, and energy harvesting
Due to the electro-optic property of InGaN multiple quantum wells, a III-nitride diode can provide light transmission, photo detection, and energy harvesting under different bias conditions. Made of III-nitride diodes arrayed in a single chip, the combination allows the diodes to transmit, detect, and harvest visible light at the same time. Here, we monolithically integrate a III-nitride transmitter, receiver, and energy harvester using a compatible foundry process. By adopting a bottom S i O 2 / T i O 2 distributed Bragg reflector, we present a III-nitride diode with a peak external quantum efficiency of 50.65% at a forward voltage of 2.6 V for light emission, a power conversion efficiency of 6.68% for energy harvesting, and a peak external quantum efficiency of 50.9% at a wavelength of 388 nm for photon detection. The energy harvester generates electricity from ambient light to directly turn the transmitter on. By integrating a circuit, the electrical signals generated by the receiver pulse the emitted light to relay information. The multifunctioning system can continuously operate without an external power supply. Our work opens up a promising approach to develop multicomponent systems with new interactive functions and multitasking devices, due to III-nitride diode arrays that can simultaneously transmit, detect, and harvest light.
- 21 April 2021
- Published by Optica Publishing Group in Optics Letters
- Vol. 46 (9) , 2075-2078
Simultaneous transmission, detection, and energy harvesting
Due to the electro-optic property of InGaN multiple quantum wells, a III-nitride diode can provide light transmission, photo detection, and energy harvesting under different bias conditions. Made of III-nitride diodes arrayed in a single chip, the combination allows the diodes to transmit, detect, and harvest visible light at the same time. Here, we monolithically integrate a III-nitride transmitter, receiver, and energy harvester using a compatible foundry process. By adopting a bottom S i O 2 / T i O 2 distributed Bragg reflector, we present a III-nitride diode with a peak external quantum efficiency of 50.65% at a forward voltage of 2.6 V for light emission, a power conversion efficiency of 6.68% for energy harvesting, and a peak external quantum efficiency of 50.9% at a wavelength of 388 nm for photon detection. The energy harvester generates electricity from ambient light to directly turn the transmitter on. By integrating a circuit, the electrical signals generated by the receiver pulse the emitted light to relay information. The multifunctioning system can continuously operate without an external power supply. Our work opens up a promising approach to develop multicomponent systems with new interactive functions and multitasking devices, due to III-nitride diode arrays that can simultaneously transmit, detect, and harvest light.