Jason Jung
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Jason Jung has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Marcel A. Verheijen
Eindhoven University of Technology, 5600 MB Eindhoven, The Netherlands
4 shared publications - Erik P. A. M. Bakkers
Department of Applied Physics, Eindhoven University of Technology, Eindhoven, The Netherlands
3 shared publications - Sander G. Schellingerhout
Department of Applied Physics Eindhoven University of Technology Groene Loper 19 5612AP Eindhoven The Netherlands
3 shared publications - Orson A. H. van der Molen
University of Basel, Basel, Switzerland
2 shared publications - Sergey M. Frolov
Department of Physics and Astronomy, University of Pittsburgh, Pittsburgh, PA, USA
2 shared publications - An-Hsi Chen
Oak Ridge National Laboratory
1 shared publication
Latest Publications
- 13 February 2023
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 7 (2) , 023401
Single-crystalline PbTe film growth through reorientation
Heteroepitaxy enables the engineering of novel properties, which do not exist in a single material. Two principal growth modes are identified for material combinations with a large lattice mismatch, Volmer-Weber, and Stranski-Krastanov. Both lead to the formation of three-dimensional islands, hampering the growth of flat defect-free thin films. This limits the number of viable material combinations. Here, we report a distinct growth mode found in molecular beam epitaxy of PbTe on InP initiated by pregrowth surface treatments. Early nucleation forms islands analogous to the Volmer-Weber growth mode, but film closure exhibits a flat surface with atomic terracing. Remarkably, despite multiple distinct crystal orientations found in the initial islands, the final film is single crystalline. This is possible due to a reorientation process occurring during island coalescence, facilitating high quality heteroepitaxy despite the large lattice mismatch, difference in crystal structures, and diverging thermal expansion coefficients of PbTe and InP. This growth mode offers a new strategy for the heteroepitaxy of dissimilar materials and expands the realm of possible material combinations.
- 13 February 2023
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 7 (2) , 023401
Single-crystalline PbTe film growth through reorientation
Heteroepitaxy enables the engineering of novel properties, which do not exist in a single material. Two principal growth modes are identified for material combinations with a large lattice mismatch, Volmer-Weber, and Stranski-Krastanov. Both lead to the formation of three-dimensional islands, hampering the growth of flat defect-free thin films. This limits the number of viable material combinations. Here, we report a distinct growth mode found in molecular beam epitaxy of PbTe on InP initiated by pregrowth surface treatments. Early nucleation forms islands analogous to the Volmer-Weber growth mode, but film closure exhibits a flat surface with atomic terracing. Remarkably, despite multiple distinct crystal orientations found in the initial islands, the final film is single crystalline. This is possible due to a reorientation process occurring during island coalescence, facilitating high quality heteroepitaxy despite the large lattice mismatch, difference in crystal structures, and diverging thermal expansion coefficients of PbTe and InP. This growth mode offers a new strategy for the heteroepitaxy of dissimilar materials and expands the realm of possible material combinations.
- Open Access
- 17 October 2022
- Published by Wiley in Advanced Functional Materials
- Vol. 32 (51)
Selective Area Growth of PbTe Nanowire Networks on InP
Hybrid semiconductor–superconductor nanowires are promising candidates as quantum information processing devices. The need for scalability and complex designs calls for the development of selective area growth techniques. Here, the growth of large scale lead telluride (PbTe) networks is introduced by molecular beam epitaxy. The group IV‐VI lead‐salt semiconductor is an attractive material choice due to its large dielectric constant, strong spin‐orbit coupling, and high carrier mobility. A crystal re‐orientation process during the initial growth stages leads to single crystalline nanowire networks despite a large lattice mismatch, different crystal structure, and diverging thermal expansion coefficient to the indium phosphide (InP) substrate. The high quality of the resulting material is confirmed by Hall bar measurements, indicating mobilities up to 5600 cm2 (Vs)−1, and Aharonov–Bohm experiments, indicating a low‐temperature phase coherence length exceeding 21 µm. Together, these properties show the high potential of the system as a basis for topological networks.
- 17 October 2022
- Published by Wiley in Advanced Functional Materials
- Vol. 32 (51)
Open AccessSelective Area Growth of PbTe Nanowire Networks on InP
Hybrid semiconductor–superconductor nanowires are promising candidates as quantum information processing devices. The need for scalability and complex designs calls for the development of selective area growth techniques. Here, the growth of large scale lead telluride (PbTe) networks is introduced by molecular beam epitaxy. The group IV‐VI lead‐salt semiconductor is an attractive material choice due to its large dielectric constant, strong spin‐orbit coupling, and high carrier mobility. A crystal re‐orientation process during the initial growth stages leads to single crystalline nanowire networks despite a large lattice mismatch, different crystal structure, and diverging thermal expansion coefficient to the indium phosphide (InP) substrate. The high quality of the resulting material is confirmed by Hall bar measurements, indicating mobilities up to 5600 cm2 (Vs)−1, and Aharonov–Bohm experiments, indicating a low‐temperature phase coherence length exceeding 21 µm. Together, these properties show the high potential of the system as a basis for topological networks.
- Open Access
- 22 February 2022
- Published by IOP Publishing in Materials for Quantum Technology
- Vol. 2 (1) , 015001
Growth of PbTe nanowires by molecular beam epitaxy
Advances in quantum technology may come from the discovery of new materials systems that improve the performance or allow for new functionality in electronic devices. Lead telluride (PbTe) is a member of the group IV–VI materials family that has significant untapped potential for exploration. Due to its high electron mobility, strong spin–orbit coupling and ultrahigh dielectric constant it can host few-electron quantum dots and ballistic quantum wires with opportunities for control of electron spins and other quantum degrees of freedom. Here, we report the fabrication of PbTe nanowires by molecular beam epitaxy. We achieve defect-free single crystalline PbTe with large aspect ratios up to 50 suitable for quantum devices. Furthermore, by fabricating a single nanowire field effect transistor, we attain bipolar transport, extract the bandgap and observe Fabry–Pérot oscillations of conductance, a signature of quasiballistic transmission.
- 22 February 2022
- Published by IOP Publishing in Materials for Quantum Technology
- Vol. 2 (1) , 015001
Open AccessGrowth of PbTe nanowires by molecular beam epitaxy
Advances in quantum technology may come from the discovery of new materials systems that improve the performance or allow for new functionality in electronic devices. Lead telluride (PbTe) is a member of the group IV–VI materials family that has significant untapped potential for exploration. Due to its high electron mobility, strong spin–orbit coupling and ultrahigh dielectric constant it can host few-electron quantum dots and ballistic quantum wires with opportunities for control of electron spins and other quantum degrees of freedom. Here, we report the fabrication of PbTe nanowires by molecular beam epitaxy. We achieve defect-free single crystalline PbTe with large aspect ratios up to 50 suitable for quantum devices. Furthermore, by fabricating a single nanowire field effect transistor, we attain bipolar transport, extract the bandgap and observe Fabry–Pérot oscillations of conductance, a signature of quasiballistic transmission.
- Open Access
- 4 July 2021
- Published by Wiley in Advanced Functional Materials
- Vol. 31 (38) , 2103062
Universal Platform for Scalable Semiconductor‐Superconductor Nanowire Networks
Semiconductor‐superconductor hybrids are commonly used in research on topological quantum computation. Traditionally, top‐down approaches involving dry or wet etching are used to define the device geometry. These often aggressive processes risk causing damage to material surfaces, giving rise to scattering sites particularly problematic for quantum applications. Here, a method that maintains the flexibility and scalability of selective area grown nanowire networks while omitting the necessity of etching to create hybrid segments is proposed. Instead, it takes advantage of directional growth methods and uses bottom‐up grown indium phosphide (InP) structures as shadowing objects to obtain selective metal deposition. The ability to lithographically define the position and area of these objects and to grow a predefined height ensures precise control of the shadowed region. The approach by growing indium antimonide nanowire networks with well‐defined aluminium and lead (Pb) islands is demonstrated. Cross‐section cuts of the nanowires reveal a sharp, oxide‐free interface between semiconductor and superconductor. By growing InP structures on both sides of in‐plane nanowires, a combination of platinum and Pb can independently be shadow deposited, enabling a scalable and reproducible in situ device fabrication. The semiconductor‐superconductor nanostructures resulting from this approach are at the forefront of material development for Majorana based experiments.
- 4 July 2021
- Published by Wiley in Advanced Functional Materials
- Vol. 31 (38) , 2103062
Open AccessUniversal Platform for Scalable Semiconductor‐Superconductor Nanowire Networks
Semiconductor‐superconductor hybrids are commonly used in research on topological quantum computation. Traditionally, top‐down approaches involving dry or wet etching are used to define the device geometry. These often aggressive processes risk causing damage to material surfaces, giving rise to scattering sites particularly problematic for quantum applications. Here, a method that maintains the flexibility and scalability of selective area grown nanowire networks while omitting the necessity of etching to create hybrid segments is proposed. Instead, it takes advantage of directional growth methods and uses bottom‐up grown indium phosphide (InP) structures as shadowing objects to obtain selective metal deposition. The ability to lithographically define the position and area of these objects and to grow a predefined height ensures precise control of the shadowed region. The approach by growing indium antimonide nanowire networks with well‐defined aluminium and lead (Pb) islands is demonstrated. Cross‐section cuts of the nanowires reveal a sharp, oxide‐free interface between semiconductor and superconductor. By growing InP structures on both sides of in‐plane nanowires, a combination of platinum and Pb can independently be shadow deposited, enabling a scalable and reproducible in situ device fabrication. The semiconductor‐superconductor nanostructures resulting from this approach are at the forefront of material development for Majorana based experiments.
- Top Cited Papers
- 30 April 2021
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 372 (6541) , 508-511
Parity-preserving and magnetic field–resilient superconductivity in InSb nanowires with Sn shells
Move aside, aluminum: Some of the most promising schemes for quantum information processing involve superconductors. In addition to the established superconducting qubits, topological qubits may one day be realized in semiconductor-superconductor heterostructures. The superconductor most widely used in this context is aluminum, in which processes that cause decoherence are suppressed. Pendharkar et al. go beyond this paradigm to show that superconducting tin can be used in place of aluminum (see the Perspective by Fatemi and Devoret). The authors grew nanowires of indium antimonide, which is a semiconductor, and coated them with a thin layer of tin without using cumbersome epitaxial growth techniques. This process creates a well-defined, “hard” superconducting gap in the nanowires, which is a prerequisite for using them as the basis for a potential topological qubit. Science , this issue p. 508 ; see also p. 464
- 30 April 2021
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 372 (6541) , 508-511
Top Cited PapersParity-preserving and magnetic field–resilient superconductivity in InSb nanowires with Sn shells
Move aside, aluminum: Some of the most promising schemes for quantum information processing involve superconductors. In addition to the established superconducting qubits, topological qubits may one day be realized in semiconductor-superconductor heterostructures. The superconductor most widely used in this context is aluminum, in which processes that cause decoherence are suppressed. Pendharkar et al. go beyond this paradigm to show that superconducting tin can be used in place of aluminum (see the Perspective by Fatemi and Devoret). The authors grew nanowires of indium antimonide, which is a semiconductor, and coated them with a thin layer of tin without using cumbersome epitaxial growth techniques. This process creates a well-defined, “hard” superconducting gap in the nanowires, which is a prerequisite for using them as the basis for a potential topological qubit. Science , this issue p. 508 ; see also p. 464