Solihudin Solihudin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Solihudin Solihudin has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Diana Rakhmawaty Eddy
Universitas Padjadjaran
2 shared publications - Allyn Pramudya Sulaeman
Department of Chemistry, Padjadjaran University
1 shared publication - Arief Cahyanto
Department of Clinical Sciences, College of Dentistry, Ajman University, Ajman, United Arab Emirates
1 shared publication - Dian Nursyamsiah
Department of Chemistry, Faculty of Mathematics and Sciences, Universitas Padjadjaran, Jl. Raya Bandung-Sumedang km. 21 Jatinangor, Sumedang 45363, Indonesia
1 shared publication - Elin Karlina
Universitas Padjadjaran
1 shared publication Hersandy Dayu Kusuma
1 shared publication
Latest Publications
- Open Access
- 18 October 2025
- Published by Elsevier in Results in Materials
- Vol. 28
Valorization of tar-modified rice husk activated carbon for high-performance supercapacitor electrodes
- 18 October 2025
- Published by Elsevier in Results in Materials
- Vol. 28
Open AccessValorization of tar-modified rice husk activated carbon for high-performance supercapacitor electrodes
- Open Access
- 31 July 2022
- Published by Universitas Padjadjaran in Padjadjaran Journal of Dentistry
- Vol. 34 (2) , 168-173
Effect of 3-methacryloxypropyltrimethoxysilane on diametral tensile strength of rice husk silica-based dental composite
Introduction: Rice husk silica has been studied as a filler in dental composite, however, the mechanical properties of the resulting composites are below the commercial due to the poor surface modification between silica and resin matrix. 3-methacryloxyprpyltrimethoxysilane (MPTS) is one of the coupling agents that are effective to modify the silica surface. The purpose of this study to analyze the effect of MPTS on the diametral tensile strength (DTS) of the self-made composite using rice husk silica. Methods: The research type of this study was an experimental research laboratory. The samples (26 samples) were divided into two groups, namely the test group (using MPTS-modified silica) and the control group (using non-modified silica). The samples were cylindrical in shape with a diameter of 6.0 ± 0.1 mm and a height of 3.0 ± 0.1 mm according to ANSI/ADAS No. 27, 1993 and ISO 4049, 1988. The Fourier Transform Infrared (FTIR), HORIBA, was used to characterize the MPTS grafting on the silica surface. The DTS value is measured by Universal Testing Machine (UTM), Lloyd LRX Plus. Results: FTIR presents the additional peak of carboxyl and methacryloyl group at 1716, 1555, and 1410 cm-1 wavenumber, respectively in MPTS-modified silica. The DTS value of the test group was 43.40 ± 4.43 MPa and the control group was 25.80 ± 2.63 MPa. The test group was significantly higher than the control group (p-value = 0.001). Conclusion: The MPTS is effective to enhance the DTS value of rice husk silica-based composite.Keywords: Rice husk silica; dental composite; diametral tensile strength; 3-methacryloxypropyltrimethoxysilane.
- 31 July 2022
- Published by Universitas Padjadjaran in Padjadjaran Journal of Dentistry
- Vol. 34 (2) , 168-173
Open AccessEffect of 3-methacryloxypropyltrimethoxysilane on diametral tensile strength of rice husk silica-based dental composite
Introduction: Rice husk silica has been studied as a filler in dental composite, however, the mechanical properties of the resulting composites are below the commercial due to the poor surface modification between silica and resin matrix. 3-methacryloxyprpyltrimethoxysilane (MPTS) is one of the coupling agents that are effective to modify the silica surface. The purpose of this study to analyze the effect of MPTS on the diametral tensile strength (DTS) of the self-made composite using rice husk silica. Methods: The research type of this study was an experimental research laboratory. The samples (26 samples) were divided into two groups, namely the test group (using MPTS-modified silica) and the control group (using non-modified silica). The samples were cylindrical in shape with a diameter of 6.0 ± 0.1 mm and a height of 3.0 ± 0.1 mm according to ANSI/ADAS No. 27, 1993 and ISO 4049, 1988. The Fourier Transform Infrared (FTIR), HORIBA, was used to characterize the MPTS grafting on the silica surface. The DTS value is measured by Universal Testing Machine (UTM), Lloyd LRX Plus. Results: FTIR presents the additional peak of carboxyl and methacryloyl group at 1716, 1555, and 1410 cm-1 wavenumber, respectively in MPTS-modified silica. The DTS value of the test group was 43.40 ± 4.43 MPa and the control group was 25.80 ± 2.63 MPa. The test group was significantly higher than the control group (p-value = 0.001). Conclusion: The MPTS is effective to enhance the DTS value of rice husk silica-based composite.Keywords: Rice husk silica; dental composite; diametral tensile strength; 3-methacryloxypropyltrimethoxysilane.
- Open Access
- 16 April 2021
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 33 (5) , 963-968
Green Synthesis of Zero Valent Iron (ZVI) using Tea Leaves Extract and its Application as Fenton like Catalyst for Textile Dyes Removal
This study aims to develop an alternative method in the green synthesis of zero valent iron (ZVI) from tea leaves extract and its application as a Fenton catalyst for textile dyes removal. Tea leaves extract having high polyphenolic contents were used as reducing agents in this study and the ZVI obtained from them was characterized by UV-VIS, SEM-EDS, FTIR, PSA and XRD techniques. The synthesized zero valent iron (ZVI) was utilized as a Fenton like catalyst for textile dyes removal. The results showed that this system was highly efficient regarding the dyes removal of about 95.96% using 80 mg/L ZVI. Moreover, using 100 mg/L ZVI, the COD number reduced to 94.68%.
- 16 April 2021
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 33 (5) , 963-968
Open AccessGreen Synthesis of Zero Valent Iron (ZVI) using Tea Leaves Extract and its Application as Fenton like Catalyst for Textile Dyes Removal
This study aims to develop an alternative method in the green synthesis of zero valent iron (ZVI) from tea leaves extract and its application as a Fenton catalyst for textile dyes removal. Tea leaves extract having high polyphenolic contents were used as reducing agents in this study and the ZVI obtained from them was characterized by UV-VIS, SEM-EDS, FTIR, PSA and XRD techniques. The synthesized zero valent iron (ZVI) was utilized as a Fenton like catalyst for textile dyes removal. The results showed that this system was highly efficient regarding the dyes removal of about 95.96% using 80 mg/L ZVI. Moreover, using 100 mg/L ZVI, the COD number reduced to 94.68%.