Javier E. Chavarrio
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Javier E. Chavarrio has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- George Willis Huber
University of Wisconsin-Madison
6 shared publications - Edwing Grajales-González
Clean Energy Research Platform, Physical Sciences and Engineering (PSE) Division, King Abdullah University of Science and Technology (KAUST), Thuwal 23955-6900, Saudi Arabia
2 shared publications Erick Votava
2 shared publications- Manos Mavrikakis
Department of Chemical and Biological Engineering, University of Wisconsin-Madison, Madison, Wisconsin 53706, USA
2 shared publications - Manuel Monge Palacios
Clean Energy Research Platform, Physical Sciences and Engineering Division (PSE)
2 shared publications - Subram Mani Sarathy
Clean Energy Research Platform, Physical Sciences and Engineering (PSE) Division, King Abdullah University of Science and Technology (KAUST), Thuwal 23955-6900, Saudi Arabia
2 shared publications
Latest Publications
- Open Access
- 29 May 2026
- Published by Elsevier in SSRN Electronic Journal
Kinetic modelling of Ca(OH)2-mediated D-galactose isomerization to D-tagatose in model and real feedstocks
D-Tagatose is a rare low-calorie sweetener whose scalable production from dairy whey remains limited by incomplete mechanistic understanding of the isomerization of D-galactose, by stoichiometric amounts of Ca(OH)2. This work addresses the gap by establishing the first detailed kinetic framework for this system. Ab initio thermodynamic calculations predict an equilibrium conversion of approximately 30% at 25℃ (Keq = 0.39), consistent with the below 30% yields reported across conventional catalytic systems. 1H NMR analysis of the intermediate Ca-galactose gel reveals open-chain D-galactose coordinated to the calcium center, with D-tagatose forming only upon acidification. Initial rate analysis confirmed greater than first order reaction orders for all product pathways, attributed to mono- and bis-ligated Ca-galactose coordination complexes involving Ca(OH)+ and Ca2+ as competing Lewis acid species. A chemistry-informed power-law model incorporating both mechanistic pathways was globally fitted across 200-400 mM D-galactose feed (R2 = 0.996), with Ca(OH)+ dominating the experimental range. Extension to equimolar D-galactose/D-glucose mixed feeds through systematic model selection (AIC, BIC, F-tests) across sixteen candidates identified an optimal seven-parameter structure quantifying inhibition induced by D-glucose, with D-tagatose formation rate constants reduced to 38% of pure-feed values. Application to commercial whey hydrolysate at room temperature achieved 51% D-tagatose yield and 70% selectivity within 120 minutes. Above-equilibrium D-tagatose yields are attributed to the formation of the stable Ca-galactose coordination complexes, a pathway not observed in conventional single-pot isomerization.
- 29 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessKinetic modelling of Ca(OH)2-mediated D-galactose isomerization to D-tagatose in model and real feedstocks
D-Tagatose is a rare low-calorie sweetener whose scalable production from dairy whey remains limited by incomplete mechanistic understanding of the isomerization of D-galactose, by stoichiometric amounts of Ca(OH)2. This work addresses the gap by establishing the first detailed kinetic framework for this system. Ab initio thermodynamic calculations predict an equilibrium conversion of approximately 30% at 25℃ (Keq = 0.39), consistent with the below 30% yields reported across conventional catalytic systems. 1H NMR analysis of the intermediate Ca-galactose gel reveals open-chain D-galactose coordinated to the calcium center, with D-tagatose forming only upon acidification. Initial rate analysis confirmed greater than first order reaction orders for all product pathways, attributed to mono- and bis-ligated Ca-galactose coordination complexes involving Ca(OH)+ and Ca2+ as competing Lewis acid species. A chemistry-informed power-law model incorporating both mechanistic pathways was globally fitted across 200-400 mM D-galactose feed (R2 = 0.996), with Ca(OH)+ dominating the experimental range. Extension to equimolar D-galactose/D-glucose mixed feeds through systematic model selection (AIC, BIC, F-tests) across sixteen candidates identified an optimal seven-parameter structure quantifying inhibition induced by D-glucose, with D-tagatose formation rate constants reduced to 38% of pure-feed values. Application to commercial whey hydrolysate at room temperature achieved 51% D-tagatose yield and 70% selectivity within 120 minutes. Above-equilibrium D-tagatose yields are attributed to the formation of the stable Ca-galactose coordination complexes, a pathway not observed in conventional single-pot isomerization.
- 6 January 2026
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 386
Selective oxidation of 3-hydroxypropionic acid to malonic acid over Pd/C: Mechanistic and kinetic study
- 6 January 2026
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 386
Selective oxidation of 3-hydroxypropionic acid to malonic acid over Pd/C: Mechanistic and kinetic study
- 20 October 2025
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 383
Catalytic hydrogenation of HMF to BHMF over copper catalysts
- 20 October 2025
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 383
Catalytic hydrogenation of HMF to BHMF over copper catalysts
- Open Access
- 20 February 2025
- Published by Royal Society of Chemistry (RSC) in EES Catalysis
- Vol. 3 (3) , 459-474
Kinetic and process modeling of Guerbet coupling chemistry over Cu–Mg–Al mixed oxides
Kinetic modeling of Guerbet coupling chemistry over a CuMgAlOx catalyst is presented. Integration of the model in a process simulation enables assessing a recycling strategy to optimize the production of diesel fuel precursors.
- 20 February 2025
- Published by Royal Society of Chemistry (RSC) in EES Catalysis
- Vol. 3 (3) , 459-474
Open AccessKinetic and process modeling of Guerbet coupling chemistry over Cu–Mg–Al mixed oxides
Kinetic modeling of Guerbet coupling chemistry over a CuMgAlOx catalyst is presented. Integration of the model in a process simulation enables assessing a recycling strategy to optimize the production of diesel fuel precursors.
- 7 October 2024
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 9 (1) , 98-114
Advanced diesel from ethanol: a pathway to produce sustainable and high-quality drop-in biofuels
In this work, we develop a novel technology for the transformation of ethanol into diesel via Guerbet coupling and etherification.
- 7 October 2024
- Published by Royal Society of Chemistry (RSC) in Sustainable Energy & Fuels
- Vol. 9 (1) , 98-114
Advanced diesel from ethanol: a pathway to produce sustainable and high-quality drop-in biofuels
In this work, we develop a novel technology for the transformation of ethanol into diesel via Guerbet coupling and etherification.
- 17 July 2024
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 14 (15) , 11411-11424
Catalytic Reduction of Esters over Zirconia-Supported Metal Catalysts
- 17 July 2024
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 14 (15) , 11411-11424
Catalytic Reduction of Esters over Zirconia-Supported Metal Catalysts
- 1 January 2022
- Published by Elsevier in Combustion and Flame
- Vol. 235
Probing the gas-phase oxidation of ammonia: Addressing uncertainties with theoretical calculations
- 1 January 2022
- Published by Elsevier in Combustion and Flame
- Vol. 235
Probing the gas-phase oxidation of ammonia: Addressing uncertainties with theoretical calculations
- Open Access
- 9 April 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 125 (15) , 3177-3188
Early Chemistry of Nicotine Degradation in Heat-Not-Burn Smoking Devices and Conventional Cigarettes: Implications for Users and Second- and Third-Hand Smokers
Nicotine exposure results in health risks not only for smokers but also for second- and third-hand smokers. Unraveling nicotine’s degradation mechanism and the harmful chemicals that are produced under different conditions is vital to assess exposure risks. We performed a theoretical study to describe the early chemistry of nicotine degradation by investigating two important reactions that nicotine can undergo: hydrogen abstraction by hydroxyl radicals and unimolecular dissociation. The former contributes to the control of the degradation mechanism below 800 K due to a non-Arrhenius kinetics, which implies an enhancement of reactivity as temperature decreases. The latter becomes important at higher temperatures due to its larger activation energy. This change in the degradation mechanism is expected to affect the composition of vapors inhaled by smokers and room occupants. Conventional cigarettes, which operate at temperatures higher than 1000 K, are more prone to yield harmful pyridinyl radicals via nicotine dissociation, while nicotine in electronic cigarettes and vaporizers, with operating temperatures below 600 K, will be more likely degraded by hydroxyl radicals, resulting in a vapor with a different composition. Although low-temperature nicotine delivery devices have been claimed to be less harmful due to their nonburning operating conditions, the non-Arrhenius kinetics that we observed for the degradation mechanism below 873 K suggests that nicotine degradation may be more rapidly initiated as temperature is reduced, indicating that these devices may be more harmful than it is commonly assumed.
- 9 April 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 125 (15) , 3177-3188
Open AccessEarly Chemistry of Nicotine Degradation in Heat-Not-Burn Smoking Devices and Conventional Cigarettes: Implications for Users and Second- and Third-Hand Smokers
Nicotine exposure results in health risks not only for smokers but also for second- and third-hand smokers. Unraveling nicotine’s degradation mechanism and the harmful chemicals that are produced under different conditions is vital to assess exposure risks. We performed a theoretical study to describe the early chemistry of nicotine degradation by investigating two important reactions that nicotine can undergo: hydrogen abstraction by hydroxyl radicals and unimolecular dissociation. The former contributes to the control of the degradation mechanism below 800 K due to a non-Arrhenius kinetics, which implies an enhancement of reactivity as temperature decreases. The latter becomes important at higher temperatures due to its larger activation energy. This change in the degradation mechanism is expected to affect the composition of vapors inhaled by smokers and room occupants. Conventional cigarettes, which operate at temperatures higher than 1000 K, are more prone to yield harmful pyridinyl radicals via nicotine dissociation, while nicotine in electronic cigarettes and vaporizers, with operating temperatures below 600 K, will be more likely degraded by hydroxyl radicals, resulting in a vapor with a different composition. Although low-temperature nicotine delivery devices have been claimed to be less harmful due to their nonburning operating conditions, the non-Arrhenius kinetics that we observed for the degradation mechanism below 873 K suggests that nicotine degradation may be more rapidly initiated as temperature is reduced, indicating that these devices may be more harmful than it is commonly assumed.