Yuhui Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Yuhui Chen has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Joseph B. Schlenoff
Department of Chemistry and Biochemistry
6 shared publications - Mo Yang
Department of Chemistry and Biochemistry, The Florida State University, Tallahassee, Florida 32306, United States
3 shared publications - Zachary A. Digby
Department of Chemistry and Biochemistry, The Florida State University, Tallahassee, Florida 32306, United States
3 shared publications - John Akintola
Department of Chemistry
1 shared publication Khalil Akkaoui
Department of Chemistry and Biochemistry The Florida State University, Tallahassee, Florida 32306-4390, United States
1 shared publication- Rachel L. Abbett
Department of Chemistry and Biochemistry, Florida State University, Tallahassee, Florida 32306, United States
1 shared publication
Latest Publications
- 23 October 2023
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (43) , 50058-50068
Antifouling Coatings from Glassy Polyelectrolyte Complex Films
Coatings that prevent or decrease fouling are sought for many applications, including those that inhibit the attachment of organisms in aquatic environments. To date, antifouling coatings have mostly followed design criteria assembled over decades: surfaces should be well/strongly hydrated, possess low net charge, and maintain a hydrophilic character when exposed to the location of use. Thus, polymers based on ethylene glycol or zwitterionic repeat units have been shown to be highly effective. Unfortunately, hydrated materials can be quite soft, limiting their use in some environments. In a major paradigm shift, this work describes glassy antifouling films made from certain complexes of positive and negative polyelectrolytes. The dense network of electrostatic interactions yields tough materials below the glass transition temperature, Tg, in normal use, while the highly ionic character of these polyelectrolyte complexes ensures strong hydration. The proximity of equal numbers of opposite charges within these complexes mimics zwitterionic structures. Films, assembled layer-by-layer from aqueous solutions, contained sulfonated poly(ether ether ketone), SPEEK, a rigid polyelectrolyte that binds strongly to a selection of quaternary ammonium polycations. Layer-by-layer buildup of SPEEK and polycations was linear, indicating strong complexes between polyelectrolytes. Calorimetry also showed that complex formation was exothermic. Surfaces coated with these films in the 100 nm thickness range completely resisted adhesion of the common flagellate green algae, Chlamydomonas reinhardtii, which were removed from surfaces at a minimum applied flow rate of 0.8 cm s-1. The total surface charge density of adsorbed cations, determined with a sensitive radioisotopic label, was very low, around 10% of a monolayer, which minimized adsorption driven by counterion release from the surface. The viscoelastic properties of the complexes, which were stable even in concentrated salt solutions, were explored using rheology of bulk samples. When fully hydrated, their Tg values were observed to be above 75 °C.
- 23 October 2023
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (43) , 50058-50068
Antifouling Coatings from Glassy Polyelectrolyte Complex Films
Coatings that prevent or decrease fouling are sought for many applications, including those that inhibit the attachment of organisms in aquatic environments. To date, antifouling coatings have mostly followed design criteria assembled over decades: surfaces should be well/strongly hydrated, possess low net charge, and maintain a hydrophilic character when exposed to the location of use. Thus, polymers based on ethylene glycol or zwitterionic repeat units have been shown to be highly effective. Unfortunately, hydrated materials can be quite soft, limiting their use in some environments. In a major paradigm shift, this work describes glassy antifouling films made from certain complexes of positive and negative polyelectrolytes. The dense network of electrostatic interactions yields tough materials below the glass transition temperature, Tg, in normal use, while the highly ionic character of these polyelectrolyte complexes ensures strong hydration. The proximity of equal numbers of opposite charges within these complexes mimics zwitterionic structures. Films, assembled layer-by-layer from aqueous solutions, contained sulfonated poly(ether ether ketone), SPEEK, a rigid polyelectrolyte that binds strongly to a selection of quaternary ammonium polycations. Layer-by-layer buildup of SPEEK and polycations was linear, indicating strong complexes between polyelectrolytes. Calorimetry also showed that complex formation was exothermic. Surfaces coated with these films in the 100 nm thickness range completely resisted adhesion of the common flagellate green algae, Chlamydomonas reinhardtii, which were removed from surfaces at a minimum applied flow rate of 0.8 cm s-1. The total surface charge density of adsorbed cations, determined with a sensitive radioisotopic label, was very low, around 10% of a monolayer, which minimized adsorption driven by counterion release from the surface. The viscoelastic properties of the complexes, which were stable even in concentrated salt solutions, were explored using rheology of bulk samples. When fully hydrated, their Tg values were observed to be above 75 °C.
- 8 February 2023
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 24 (3) , 1453-1462
Bulk Biopolyelectrolyte Complexes from Homopolypeptides: Solid “Salt Bridges”
Salt bridges, pairings between oppositely charged amino acids, are dispersed throughout proteins to assist folding and interactions. Biopolyelectrolyte complexes (BioPECs) were made between the homopolypeptides poly-L-arginine (PLR) and poly-L- lysine (PLK) with sodium triphosphate (STPP), as well as from polypeptide-only combinations. Viscoelastic measurements on these high salt bridge density materials showed many were solid, even glassy, in nature. Although the polypeptide-phosphate complexes had similar moduli at room temperature, the PLR-STPP complex displayed an unusual melting event above 70 degrees C not seen in PLK-STPP. This event was supported with differential scanning calorimetry. Infrared spec-troscopy showed the PLK-STPP system contained ,g-sheets, while PLR-STPP did not. Stoichiometric, macroscopic BioPECs of PLR and PLK with poly-L-aspartic acid (PLD) and poly-L-glutamic acid (PLE) were made. PLR-PLD was found to undergo a melting event similar to that in PLR-STPP. ATR-FTIR studies showed that BioPECs made with PLD do not contain ,g-sheets, while those composed of PLE do. This work illustrates an expanded palette of unique properties from these biomaterials, such as strong viscoelastic differences between PECs containing PLE and PLD, even though they differ by only one carbon on the side chain.
- 8 February 2023
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 24 (3) , 1453-1462
Bulk Biopolyelectrolyte Complexes from Homopolypeptides: Solid “Salt Bridges”
Salt bridges, pairings between oppositely charged amino acids, are dispersed throughout proteins to assist folding and interactions. Biopolyelectrolyte complexes (BioPECs) were made between the homopolypeptides poly-L-arginine (PLR) and poly-L- lysine (PLK) with sodium triphosphate (STPP), as well as from polypeptide-only combinations. Viscoelastic measurements on these high salt bridge density materials showed many were solid, even glassy, in nature. Although the polypeptide-phosphate complexes had similar moduli at room temperature, the PLR-STPP complex displayed an unusual melting event above 70 degrees C not seen in PLK-STPP. This event was supported with differential scanning calorimetry. Infrared spec-troscopy showed the PLK-STPP system contained ,g-sheets, while PLR-STPP did not. Stoichiometric, macroscopic BioPECs of PLR and PLK with poly-L-aspartic acid (PLD) and poly-L-glutamic acid (PLE) were made. PLR-PLD was found to undergo a melting event similar to that in PLR-STPP. ATR-FTIR studies showed that BioPECs made with PLD do not contain ,g-sheets, while those composed of PLE do. This work illustrates an expanded palette of unique properties from these biomaterials, such as strong viscoelastic differences between PECs containing PLE and PLD, even though they differ by only one carbon on the side chain.
- Open Access
- 20 May 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (20) , eabm4783
Valence-induced jumps in coacervate properties
Spontaneous phase separation, or coacervation, of oppositely charged macromolecules is a powerful and ubiquitous mechanism for the assembly of natural and synthetic materials. Two critical triggering phenomena in coacervation science and technology are highlighted here. The first is the transition from one (mixed) to two (separated) phases of polyelectrolytes coacervated with small molecules upon the addition of one or two charges per molecule. The second is a large jump in coacervate modulus and viscosity mediated by the addition of just one additional charge to a three-charged system. This previously unknown viscoelastic transition is relevant to those aspects of disease states that are characterized by abnormal mechanical properties and irreversible assembly.
- 20 May 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (20) , eabm4783
Open AccessValence-induced jumps in coacervate properties
Spontaneous phase separation, or coacervation, of oppositely charged macromolecules is a powerful and ubiquitous mechanism for the assembly of natural and synthetic materials. Two critical triggering phenomena in coacervation science and technology are highlighted here. The first is the transition from one (mixed) to two (separated) phases of polyelectrolytes coacervated with small molecules upon the addition of one or two charges per molecule. The second is a large jump in coacervate modulus and viscosity mediated by the addition of just one additional charge to a three-charged system. This previously unknown viscoelastic transition is relevant to those aspects of disease states that are characterized by abnormal mechanical properties and irreversible assembly.
- 13 October 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (20) , 9522-9531
Self-Exchange of Polyelectrolyte in Multilayers: Diffusion as a Function of Salt Concentration and Temperature
- 13 October 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (20) , 9522-9531
Self-Exchange of Polyelectrolyte in Multilayers: Diffusion as a Function of Salt Concentration and Temperature
- 2 September 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (17) , 7890-7899
Influence of Nonstoichiometry on the Viscoelastic Properties of a Polyelectrolyte Complex
- 2 September 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (17) , 7890-7899
Influence of Nonstoichiometry on the Viscoelastic Properties of a Polyelectrolyte Complex
- 7 April 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (8) , 3822-3831
Glass Transitions in Hydrated Polyelectrolyte Complexes
- 7 April 2021
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 54 (8) , 3822-3831
Glass Transitions in Hydrated Polyelectrolyte Complexes