Yuanheng Yao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yuanheng Yao has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Guangyao Li
3 shared publicationsHao Jiang
2 shared publications- Junjia Cui
State Key Laboratory of Advanced Design and Manufacturing Technology for Vehicle, Hunan University, Changsha 410082, China
2 shared publications - Shaoluo Wang
State Key Laboratory of Advanced Design and Manufacturing for Vehicle Body, Hunan University, Changsha, China
2 shared publications - Alexander F. H. Kaplan
Department of Engineering Sciences and Mathematics, Luleå University of Technology, Lulea, Sweden
1 shared publication Ao Chen
1 shared publication
Latest Publications
- Open Access
- 5 September 2023
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 26, 6146-6161
Mechanical properties and joining mechanisms of magnetic pulse welding joints of additively manufactured 316L and conventional AA5052 aluminum alloy
- 5 September 2023
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 26, 6146-6161
Open AccessMechanical properties and joining mechanisms of magnetic pulse welding joints of additively manufactured 316L and conventional AA5052 aluminum alloy
- 29 December 2022
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 23 (1) , 1-13
Experimental and simulation study on stiffness of basalt fiber-reinforced plastic door interior trimming panel
- 29 December 2022
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 23 (1) , 1-13
Experimental and simulation study on stiffness of basalt fiber-reinforced plastic door interior trimming panel
- 1 November 2006
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 18 (4) , 283-288
Influence of joint geometry and fit-up gaps on hybrid laser-metal active gas (MAG) welding
This article presents the results of an experimental program to investigate the sensitivity of the hybrid laser-MAG welding process to gaps between the work pieces being welded. It was concluded that the minimum throat depth of the welds remained surprisingly stable for fillet welds as long as the metal active gas (MAG) parameters were set high enough to fill the gaps involved (up to a gap size of approximately 3 mm). If the MAG parameters were insufficient then the welding process collapsed with increasing gap widths.
- 1 November 2006
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 18 (4) , 283-288
Influence of joint geometry and fit-up gaps on hybrid laser-metal active gas (MAG) welding
This article presents the results of an experimental program to investigate the sensitivity of the hybrid laser-MAG welding process to gaps between the work pieces being welded. It was concluded that the minimum throat depth of the welds remained surprisingly stable for fillet welds as long as the metal active gas (MAG) parameters were set high enough to fill the gaps involved (up to a gap size of approximately 3 mm). If the MAG parameters were insufficient then the welding process collapsed with increasing gap widths.