Shamini Dharmasena
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Shamini Dharmasena has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Arif I. Sarwat
Department of Electrical and Computer Engineering, Florida International University, Miami, FL, USA
2 shared publications - Temitayo Olayemi Olowu
Energy and Environment Science and Technology Directorate, Idaho National Laboratory, Idaho Falls, ID, USA
2 shared publications Arif I. Sarwat
Department of Electrical and Computer Engineering Florida International University Miami Florida USA
1 shared publicationArjuna Madanayake
University of Akron, Akron, 44325, OH
1 shared publication- Jarred Glickstein
Department of Electrical Engineering and Computer Science, Case Western Reserve University, Cleveland, OH 44106, USA
1 shared publication - Jifu Liang
Department of Electrical Engineering and Computer Science, Case Western Reserve University, Cleveland, OH 44106 USA
1 shared publication
Latest Publications
- Open Access
- 24 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 23477-23488
Algorithmic Formulation for Network Resilience Enhancement by Optimal DER Hosting and Placement
This paper proposes an algorithmic formulation for optimal PV hosting and placement of distributed energy resources (DER) for network resiliency enhancement. The algorithm incorporates a unique critical infrastructure (CI) ranking scheme to prioritize the CI nodes for the DER placement while ensuring maximum hosting of the DER. The proposed multi-objective non linear programming formulation is validated on an IEEE 34 bus feeder with different outage scenarios caused by a hurricane event. The simulation has produced 18 Pareto Optimal Solutions showing several options of optimally locating the DERs in order to achieve a maximum DER hosting capacity, improve system’s resiliency and minimize the system’s active power loss while satisfying all network and power flow constraints. The results verify the effectiveness of the proposed algorithmic formulation which distribution planners and designers can apply directly to multitude of their network substations to improve the overall system’s resiliency through grid-scale situation awareness.
- 24 February 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 23477-23488
Open AccessAlgorithmic Formulation for Network Resilience Enhancement by Optimal DER Hosting and Placement
This paper proposes an algorithmic formulation for optimal PV hosting and placement of distributed energy resources (DER) for network resiliency enhancement. The algorithm incorporates a unique critical infrastructure (CI) ranking scheme to prioritize the CI nodes for the DER placement while ensuring maximum hosting of the DER. The proposed multi-objective non linear programming formulation is validated on an IEEE 34 bus feeder with different outage scenarios caused by a hurricane event. The simulation has produced 18 Pareto Optimal Solutions showing several options of optimally locating the DERs in order to achieve a maximum DER hosting capacity, improve system’s resiliency and minimize the system’s active power loss while satisfying all network and power flow constraints. The results verify the effectiveness of the proposed algorithmic formulation which distribution planners and designers can apply directly to multitude of their network substations to improve the overall system’s resiliency through grid-scale situation awareness.
- Open Access
- 26 April 2021
- Published by Institution of Engineering and Technology (IET) in IET Energy Systems Integration
- Vol. 3 (4) , 413-425
A low‐complexity FS‐MPDPC with extended voltage set for grid‐connected converters
The conventional finite control set model predictive control (FS‐MPC) for converter control is a well‐studied area, but performance degradation due to the finite candidate vector set is still limiting its practical applications. Extending the voltage vector set using discrete space vector modulation has been proposed as a solution to overcome the limitations, but the brute‐force search inherent to FS‐MPC increases the computational complexity for a larger voltage set. This paper proposes a technique to alleviate the above issue by avoiding the brute‐force search that is being executed in FS‐MPC. The technique utilises the basics of direct‐power‐control theory to cut down the number of candidate voltage vectors applied in each cycle in the optimization problem. In this work, a design example having a voltage vector set of 37 elements is considered, and the proposed technique narrows down the search to eight optimal vectors. The proposed controller is specifically designed for active–reactive power control of a grid‐connected converter that interlinks an energy storage system to the grid. The system is modelled in MATLAB Simulink environment and simulations are carried out to analyse the performance in all four active–reactive bidirectional power flow modes. Results validate the performance of the controller, both in steady‐state and transient conditions. Further, the reduction in computational complexity due to the proposed algorithm is evaluated. It is observed that the number of computations was reduced approximately by 75 % after applying the proposed algorithm for a system with a 37 voltage vector set.
- 26 April 2021
- Published by Institution of Engineering and Technology (IET) in IET Energy Systems Integration
- Vol. 3 (4) , 413-425
Open AccessA low‐complexity FS‐MPDPC with extended voltage set for grid‐connected converters
The conventional finite control set model predictive control (FS‐MPC) for converter control is a well‐studied area, but performance degradation due to the finite candidate vector set is still limiting its practical applications. Extending the voltage vector set using discrete space vector modulation has been proposed as a solution to overcome the limitations, but the brute‐force search inherent to FS‐MPC increases the computational complexity for a larger voltage set. This paper proposes a technique to alleviate the above issue by avoiding the brute‐force search that is being executed in FS‐MPC. The technique utilises the basics of direct‐power‐control theory to cut down the number of candidate voltage vectors applied in each cycle in the optimization problem. In this work, a design example having a voltage vector set of 37 elements is considered, and the proposed technique narrows down the search to eight optimal vectors. The proposed controller is specifically designed for active–reactive power control of a grid‐connected converter that interlinks an energy storage system to the grid. The system is modelled in MATLAB Simulink environment and simulations are carried out to analyse the performance in all four active–reactive bidirectional power flow modes. Results validate the performance of the controller, both in steady‐state and transient conditions. Further, the reduction in computational complexity due to the proposed algorithm is evaluated. It is observed that the number of computations was reduced approximately by 75 % after applying the proposed algorithm for a system with a 37 voltage vector set.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Bidirectional AC/DC Converter Topologies: A Review
High penetration of renewable energy generation has demanded advancements in grid interfacing technologies. Further, battery energy storage systems, vehicle to grid and grid to vehicle concepts are emerging as solutions to the grid instability due to intermittent nature of renewable sources. Therefore, it is very important to have an advanced bidirectional interface between the grid and the source to maintain the quality of power supply. AC/DC bidirectional power converter is one of the major and an essential component in the bidirectional link. This paper investigates existing AC/DC bidirectional converter topologies, their pros and cons and recent developments to improve the performance.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Bidirectional AC/DC Converter Topologies: A Review
High penetration of renewable energy generation has demanded advancements in grid interfacing technologies. Further, battery energy storage systems, vehicle to grid and grid to vehicle concepts are emerging as solutions to the grid instability due to intermittent nature of renewable sources. Therefore, it is very important to have an advanced bidirectional interface between the grid and the source to maintain the quality of power supply. AC/DC bidirectional power converter is one of the major and an essential component in the bidirectional link. This paper investigates existing AC/DC bidirectional converter topologies, their pros and cons and recent developments to improve the performance.
- 1 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 759-762
Power-Efficient Data Modulation for All-Mechanical ULF/VLF Transmitters
Miniaturized and power-efficient ULF/VLF (0.330 kHz) transmitters are desirable for underground and undersea wireless communications. Transmitters based on rotating permanently-polarized dipoles are promising for such applications. This paper proposes a power-efficient data modulation scheme for such mechanical transmitters based on continuous-frequency FSK (CF-FSK). Theoretical analysis and simulations show that 8-ary CF-FSK is optimal since it minimizes average mechanical torque for a given bit rate. Model predictive control (MPC) of a permanent magnet (PM) motor is proposed for robust implementation of the data modulation scheme. Preliminary results from an experimental prototype are also presented.
- 1 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 759-762
Power-Efficient Data Modulation for All-Mechanical ULF/VLF Transmitters
Miniaturized and power-efficient ULF/VLF (0.330 kHz) transmitters are desirable for underground and undersea wireless communications. Transmitters based on rotating permanently-polarized dipoles are promising for such applications. This paper proposes a power-efficient data modulation scheme for such mechanical transmitters based on continuous-frequency FSK (CF-FSK). Theoretical analysis and simulations show that 8-ary CF-FSK is optimal since it minimizes average mechanical torque for a given bit rate. Model predictive control (MPC) of a permanent magnet (PM) motor is proposed for robust implementation of the data modulation scheme. Preliminary results from an experimental prototype are also presented.