AUAdrian L. Usler

Adrian L. Usler

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Adrian L. Usler has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Basic requirements for potential differences across solid–fluid interfaces

    by David Fertig, Adrian L. Usler, Mathijs Janssen

    At model water–vapor and water–solid interfaces, molecular ordering leads to charge oscillations and, thereby, to a spatially varying electrostatic potential. Atomistic simulations indicate that such ordering leads to an electric potential difference χ, the surface potential, of about −0.5 V across the first few molecular layers. Here, we calculate surface potentials at interfaces between simple model fluids and a solid with molecular dynamics simulations. The fluids are made up of either diatomic, dipolar molecules or a single Lennard-Jones particle with a dipole moment. All fluids show some structuring near the interface, but charge oscillations and a non-zero surface potential are present only for asymmetric molecules (unequal diameters of the atoms) or molecules with an off-center dipole. We condense this finding into the criterion that the geometric and dipolar centers of a molecule must differ for the fluid to exhibit a surface potential. Remarkably, while the solid–fluid interaction strength strongly affects the magnitude of charge oscillations, it hardly affects the potential drop χ. Furthermore, our results demonstrate that changing the diameter of the smaller atom can flip the sign of the surface potential, thus highlighting the importance of steric effects.


  • Open Access

    Unexpectedly High Electronic Partial Conductivity of Porous Yttria-Stabilized Zirconia Thin Films

    by Erdogan Celik, Adrian Usler, Miguel Wiche, Andrey Mazilkin, Torsten Brezesinski, Roger A. De Souza, Matthias T. Elm


  • Grain-Boundary Corrosion in UO2+δ from a Defect Chemical Perspective: A Case Study of the Σ5(310)[001] Grain Boundary

    by Matthew J. Wolf, Adrian L. Usler, Roger A. De Souza

    We combine atomistic and continuum simulation methods to study the defect chemistry of a model grain boundary in UO2+δ. Using atomistic methods, we calculate the formation energies of oxygen interstitials, uranium vacancies, and hole polarons (U5+ ions) across the Σ5(310)[001] symmetric tilt grain boundary. This information is then used as input in a continuum model of point-defect concentrations at the grain boundary and in its vicinity, taking into account electrostatic (space-charge) effects. Two scenarios are modeled: one in which oxygen interstitials are the majority ionic defect and one in which uranium vacancies are the majority ionic defect, with bulk charge neutrality being maintained by hole polarons in both cases. Our results indicate that, irrespective of the majority ionic defect, the Σ5(310)[001] grain boundary in UO2+δ is negatively charged, with positively charged adjacent space-charge zones in which the hole-polaron concentration is enhanced. We propose that the enhanced U5+ concentration at the grain boundary and within the space-charge zones renders grain-boundary regions more susceptible to oxidative corrosion, an effect that could be counteracted by acceptor doping.


  • Open Access

    Point-Defect Segregation and Space-Charge Potentials at the Σ5(310)[001] Grain Boundary in Ceria

    by Adrian L. Usler, Henrik J. Heelweg, Roger A. De Souza, Annalena R. Genreith-Schriever

    The atomistic structure and point-defect thermodynamics of the model Σ5(310)[001] grain boundary in CeO2 were explored with atomistic simulations. An interface with a double-diamond-shaped structural repeat unit was found to have the lowest energy. Segregation energies were calculated for oxygen vacancies, electron polarons, gadolinium and scandium acceptor cations, and tantalum donor cations. These energies deviate strongly from their bulk values over the same length scale, thus indicating a structural grain-boundary width of approximately 1.5 nm. However, an analysis revealed no unambiguous correlation between segregation energies and local structural descriptors, such as interatomic distance or coordination number. From the segregation energies, the grain-boundary space-charge potential in Gouy–Chapman and restricted-equilibrium regimes was calculated as a function of temperature for dilute solutions of (i) oxygen vacancies and acceptor cations and (ii) electron polarons and donor cations. For the latter, the space-charge potential is predicted to change from negative to positive in the restricted-equilibrium regime. For the former, the calculation of the space-charge potential from atomistic segregation energies is shown to require the inclusion of the segregation energies for acceptor cations. Nevertheless, the space-charge potential in the restricted-equilibrium regime can be described well with an empirical model employing a single effective oxygen-vacancy segregation energy.


  • Open Access

    How space-charge behaviour at grain boundaries in electroceramic oxides is modified by two restricted equilibria

    by A. L. Usler, F. Ketter, R. A. De Souza

    Through continuum simulations, the fundamental differences in grain-boundary properties in acceptor-doped SrTiO 3 obtained from imaging and electrical measurements are elucidated.


  • Open Access

    A general expression for the statistical error in a diffusion coefficient obtained from a solid‐state molecular‐dynamics simulation

    by Adrian L. Usler, Dennis Kemp, Alexander Bonkowski, Roger A. De Souza

    Analysis of the mean squared displacement of species , , as a function of simulation time constitutes a powerful method for extracting, from a molecular‐dynamics (MD) simulation, the tracer diffusion coefficient, . The statistical error in is seldom considered, and when it is done, the error is generally underestimated. In this study, we examined the statistics of curves generated by solid‐state diffusion by means of kinetic Monte Carlo sampling. Our results indicate that the statistical error in depends, in a strongly interrelated way, on the simulation time, the cell size, and the number of relevant point defects in the simulation cell. Reducing our results to one key quantity—the number of particles that have jumped at least once—we derive a closed‐form expression for the relative uncertainty in . We confirm the accuracy of our expression through comparisons with self‐generated MD diffusion data. With the expression, we formulate a set of simple rules that encourage the efficient use of computational resources for MD simulations.


  • Open Access

    A Critical Examination of the Mott–Schottky Model of Grain-Boundary Space-Charge Layers in Oxide-Ion Conductors

    by Adrian L. Usler, Roger A. De Souza

    The electrical properties of grain boundaries in ionic conductors are studied most frequently and most easily by Electrochemical Impedance Spectroscopy (EIS). The resistance data obtained in this manner are typically analyzed with the Mott–Schottky space-charge model to extract a space-charge potential. In this study, taking CeO2 containing acceptor-dopant cations and oxygen vacancies as our model system, we calculate impedance spectra by solving the drift–diffusion equation for oxygen vacancies for a bicrystal geometry with space-charge layers at the grain boundary. Three different cases are considered for the behavior of the acceptor-dopant cations: a uniform distribution (Mott–Schottky), an equilibrium distribution (Gouy–Chapman), and a distribution frozen-in from a much higher temperature (restricted equilibrium). Analyzing our impedance data for the restricted-equilibrium case with the Mott–Schottky model, we find that the obtained space-charge potentials are substantially underestimated. In view of such a discrepancy not normally being apparent (the true values being unknown), we propose a specific set of EIS experiments that allow the Mott–Schottky model to be discounted.