LLLeo Gu Li

Leo Gu Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Leo Gu Li has a total of 5 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effects of Pulverized Fuel Ash and Condensed Silica Fume on Heat Generation of Curing Concrete

    by J. J. Chen, H. N. Chen, L. G. Li

    The heat generated during the curing period of concrete may results in early thermal cracking. To avoid or at least alleviate this early thermal cracking problem, replacing part of cement by cementitious materials should be an effective method. Herein, it is proposed to add PFA or CSF as cement replacement to lower the cement content and heat generated from the hydration of cement. To study the effectiveness of adding PFA or CSF in reducing the heat generation of curing concrete, a series of concrete mixes with water/cement ratios ranging from 0.24 to 0.40 and different amounts of PFA or CSF added were tested for their heat generation. The results illustrated that the addition of PFA or CSF as cement replacement could effectively reduce the adiabatic temperature rise and heat generation of curing concrete, while the addition of CSF is much more effectively than addition of PFA in reducing heat generation at the same strength.

  • Packing and film thickness theories for the mix design of high-performance concrete

    by Pui-Lam Ng, Albert Kwok-Hung Kwan, Leo Gu Li

    A high-performance concrete (HPC) is required to have superior performance in various aspects such as workability, strength, durability, dimensional stabil


  • Open Access

    Use of Limestone Fines to Reduce Permeability of Concrete for Durability Improvement

    by J. J. Chen, P. L. Ng, L. G. Li, A. K. H. Kwan

    Traditionally, the use of limestone fines (LF) in concrete is to replace either part of the cement or part of the fine aggregate, notwithstanding this, the authors are advocating that the LF should be better used as cement paste replacement, which is expected to improve the durability and sustainability of concrete at the same time. To verify this new strategy of using LF, 9 nos. concrete mixes of the same powder paste volume ratio and variable LF contents and W/C ratios were produced for permeability and strength measurement. The results proved that the strategy of using LF to partially replace cement paste could effectively decrease the permeability and increase the strength at the same W/C ratio. Furthermore, even when the W/C ratio is allowed to slightly increase while keeping the concrete at the same strength, the permeability can also be significantly reduced for better durability by using LF as cement paste replacement.


  • Wet Packing Method for Blended Aggregate and Concrete Mix

    by Leo Gu Li, Albert K. H. Kwan

    Although it is well known that the packing density of the particles in a concrete mix has great influence on the performance of concrete, the packing density is seldom directly measured and all codified methods for measuring packing density are carried out under dry condition. These dry packing methods do not account for the effects of water and any chemical admixture present and are not really suitable for water-solid mixtures containing cementitious materials and fine aggregate, which tend to form agglomerates under dry condition. To solve these problems, a new method, called the wet packing method, for measuring the packing density of cementitious materials, fine aggregate and mortar under wet condition has been developed. In this study, the wet packing method was extended to measure the packing density of blended fine and coarse aggregate as well as concrete mix. The results revealed that the packing density of blended aggregate and concrete mix is highly dependent on whether the aggregate and concrete mix are dry or wet. Hence, when measuring the packing density of blended aggregate and concrete mix, the wet packing method should always be used.