ABAndi M. Barbour

Andi M. Barbour

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Andi M. Barbour has a total of 81 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Manipulation of the orbital angular momentum of soft X-ray beams by consecutive diffractive optics

    by Nazir Khan, Rahul Jangid, Taras Stanislavchuk, Aaron Stein, Oleg Chubar, Andi Barbour, Andrei Sirenko, Valery Kiryukhin, Claudio Mazzoli

    Production and manipulation of orbital angular momentum (OAM) of coherent soft X-ray beams is demonstrated utilizing consecutive diffractive optics. OAM addition is observed upon passing the beam through consecutive fork gratings. The OAM of the beam was found to be decoupled from its spin angular momentum (SAM). Practical implementation of angular momentum control by consecutive devices in the X-ray regime opens new experimental opportunities, such as direct measurement of the beam’s OAM without resorting to phase-sensitive techniques, including holography. OAM analyzers utilizing fork gratings can be used to characterize the beams produced by synchrotron and free electron lasers sources; they can also be used in scattering experiments.


  • Enabling room-temperature ferromagnetism in few-layered MoS2 films via strain engineering

    by Kai-Wei Chuang, Aswin Kumar Anbalagan, Yuan-Jhen Wong, Amr Sabbah, Ming-Hsuan Wu, Mayur Chaudhary, Kim Kisslinger, Shu-Chih Haw, Ching-Yu Chiang, Yu-Lun Chueh, et al.

    Strain engineering presents a promising pathway for modulating the physical properties of two-dimensional (2D) transition metal dichalcogenides materials. In this study, we investigate the strain-induced magnetic behavior of diamagnetic MoS2 films prepared by the DC magnetron sputtering technique. By applying +1% tensile strain to few-layered MoS2 films (∼3.5 nm), we observe the emergence of room-temperature ferromagnetism with a magnetization saturation of about ∼130 emu/cm3, in stark contrast to bulk films (∼40 nm), which remain diamagnetic under similar conditions. Raman spectroscopy reveals a pronounced reduction in the intensity and the splitting of the E′ mode in 1% strained few-layered films, indicating a possible bond elongation and symmetry breaking under tensile stress. Additionally, x-ray absorption spectroscopy at the Mo M3 edge further confirms a strain-induced electronic structure modification in few-layered films, with no corresponding shift observed in bulk counterparts. Moreover, the strain-induced magnetic and structural changes are largely reversible upon strain release. We attribute the origin of ferromagnetism in few-layered films to the combined influence of tensile strain and defect-assisted bond weakening, which facilitates crystal field transitions within the Mo 4d orbitals. These findings demonstrate that strain engineering can effectively induce and modulate magnetism in 2D materials, providing opportunities for developing strain-controlled spintronic applications.

  • Open Access

    Revealing the Origin and Nature of the Buried Metal‐Substrate Interface Layer in Ta/Sapphire Superconducting Films

    by Aswin K. Anbalagan, Rebecca Cummings, Chenyu Zhou, Junsik Mun, Vesna Stanic, Jean Jordan‐Sweet, Juntao Yao, Kim Kisslinger, Conan Weiland, Dmytro Nykypanchuk, et al.

    Despite constituting a smaller fraction of the qubit's electromagnetic mode, surfaces and interfaces can exert significant influence as sources of high‐loss tangents, which brings forward the need to reveal properties of these extended defects and identify routes to their control. Here, we examine the structure and composition of the metal‐substrate interfacial layer that exists in Ta/sapphire‐based superconducting films. Synchrotron‐based X‐ray reflectivity measurements of Ta films, commonly used in these qubits, reveal an unexplored interface layer at the metal‐substrate interface. Scanning transmission electron microscopy and core‐level electron energy loss spectroscopy identified an intermixing layer (≈0.65 ± 0.05 nm) at the metal‐substrate interface containing Al, O, and Ta atoms. Density functional theory modeling reveals that the structure and properties of the Ta/sapphire heterojunctions are determined by the oxygen content on the sapphire surface prior to Ta deposition for two atomic terminations of sapphire. Using a multimodal approach, we gained deeper insights into the interface layer between the metal and substrate, which suggests that the orientation of deposited Ta films depend on the surface termination of sapphire. The observed elemental intermixing at the metal‐substrate interface influences the thermodynamic stability and electronic behavior of the film, which may also affect qubit performance.


  • Static and dynamic topological defects in the domain textures in the helical antiferromagnet Ni2CoTeO6

    by Nazir Khan, Andi Barbour, Junjie Yang, Sang-Wook Cheong, Claudio Mazzoli, Valery Kiryukhin


  • Open Access

    Revealing the Origin and Nature of the Buried Metal-Substrate Interface Layer in Ta/Sapphire Superconducting Films

    by Aswin Kumar Anbalagan, Rebecca Cummings, Chenyu Zhou, Junsik Mun, Vesna Stanic, Jean Jordan-Sweet, Juntao Yao, Kim Kisslinger, Conan Weiland, Dmytro Nykypanchuk, et al.

    Despite constituting a smaller fraction of the qubits electromagnetic mode, surfaces and interfaces can exert significant influence as sources of high-loss tangents, which brings forward the need to reveal properties of these extended defects and identify routes to their control. Here, we examine the structure and composition of the metal-substrate interfacial layer that exists in Ta/sapphire-based superconducting films. Synchrotron-based X-ray reflectivity measurements of Ta films, commonly used in these qubits, reveal an unexplored interface layer at the metal-substrate interface. Scanning transmission electron microscopy and core-level electron energy loss spectroscopy identified an approximately 0.65 \ \text{nm} \pm 0.05 \ \text{nm} thick intermixing layer at the metal-substrate interface containing Al, O, and Ta atoms. Density functional theory (DFT) modeling reveals that the structure and properties of the Ta/sapphire heterojunctions are determined by the oxygen content on the sapphire surface prior to Ta deposition, as discussed for the limiting cases of Ta films on the O-rich versus Al-rich Al2O3 (0001) surface. By using a multimodal approach, integrating various material characterization techniques and DFT modeling, we have gained deeper insights into the interface layer between the metal and substrate. This intermixing at the metal-substrate interface influences their thermodynamic stability and electronic behavior, which may affect qubit performance.

  • Open Access

    Machine Learning for analysis of speckle dynamics: quantification and outlier detection

    by Tatiana Konstantinova, Lutz Wiegart, Maksim Rakitin, Anthony M. DeGennaro, Andi M. Barbour

    X-ray photon correlation spectroscopy (XPCS) provides an understanding of complex dynamics in materials that are tied to their synthesis, properties, and behaviors. Analysis of XPCS data for dynamics that are far from equilibrium is labor intense and often can impede the discovery process, especially in experiments with high collection rates. Moreover, binning and averaging, involved in the analysis for alleviating poor signal-to-noise ratio, leads to a loss of temporal resolution and the accumulation of systematic error for the parameters quantifying the dynamics. Here, we integrate a denoising autoencoder model into workflows for the analysis of nonequilibrium two-time intensity-intensity correlation functions. Noise reduction allows for extracting the parameters that characterize the sample's dynamics with the temporal resolution limited only by frame rates. Not only does it improve the quantitative usage of the data, but it also creates the potential for automating the analytical workflow, which is a key to high-throughput or autonomous XPCS experiments. Various approaches for the uncertainty quantification and extension of the model for anomalies' detection are discussed.


  • Open Access

    Imaging mesoscopic antiferromagnetic spin textures in the dilute limit from single-geometry resonant coherent x-ray diffraction

    by Martin Bluschke, Rourav Basak, Andi Barbour, Ashley N. Warner, Katrin Fürsich, Stuart Wilkins, Sujoy Roy, James Lee, Georg Christiani, Gennady Logvenov, et al.

    The detection and manipulation of antiferromagnetic domains and topological antiferromagnetic textures are of central interest to solid-state physics. A fundamental step is identifying tools to probe the mesoscopic texture of an antiferromagnetic order parameter. In this work, we demonstrate that Bragg coherent diffractive imaging can be extended to study the mesoscopic texture of an antiferromagnetic order parameter using resonant magnetic x-ray scattering. We study the onset of the antiferromagnet transition in PrNiO 3 , focusing on a temperature regime in which the antiferromagnetic domains are dilute in the beam spot and the coherent diffraction pattern modulating the antiferromagnetic peak is greatly simplified. We demonstrate that it is possible to extract the arrangements and sizes of these domains from single diffraction patterns and show that the approach could be extended to a time-structured light source to study the motion of dilute domains or the motion of topological defects in an antiferromagnetic spin texture.


  • Open Access

    Real-space observation of fluctuating antiferromagnetic domains

    by Min Gyu Kim, Andi Barbour, Wen Hu, Stuart B. Wilkins, Ian K. Robinson, Mark P. M. Dean, Junjie Yang, Choongjae Won, Sang-Wook Cheong, Claudio Mazzoli, et al.

    Magnetic domains play a fundamental role in physics of magnetism and its technological applications. Dynamics of antiferromagnetic domains is poorly understood, although antiferromagnets are expected to be extensively used in future electronic devices wherein it determines the stability and operational speed. Dynamics of antiferromagnets also features prominently in the studies of topological quantum matter. Real-space imaging of fluctuating antiferromagnetic domains is therefore highly desired but has never been demonstrated. We use coherent x-ray diffraction to obtain videos of fluctuating micrometer-scale antiferromagnetic domains in Ni 2 MnTeO 6 on time scales from 10 −1 to 10 3 s. In the collinear phase, thermally activated domain wall motion is observed in the vicinity of the Néel temperature. Unexpectedly, the fluctuations persist through the full range of the higher-temperature helical phase. These observations illustrate the high potential significance of the dynamic domain imaging in phase transition studies and in magnetic device research.


  • Open Access

    Machine learning enabling high-throughput and remote operations at large-scale user facilities

    by Tatiana Konstantinova, Phillip M. Maffettone, Bruce Ravel, Stuart I. Campbell, Andi M. Barbour, Daniel Olds

    Imaging, scattering, and spectroscopy are fundamental in understanding and discovering new functional materials.


  • Open Access

    Noise Reduction in X-ray Photon Correlation Spectroscopy with Convolutional Neural Networks Encoder-Decoder Models

    by Tatiana Konstantinova, Lutz Wiegart, Maksim Rakitin, Anthony M. DeGennaro, Andi M. Barbour

    Like other experimental techniques, X-ray Photon Correlation Spectroscopy is subject to various kinds of noise. Random and correlated fluctuations and heterogeneities can be present in a two-time correlation function and obscure the information about the intrinsic dynamics of a sample. Simultaneously addressing the disparate origins of noise in the experimental data is challenging. We propose a computational approach for improving the signal-to-noise ratio in two-time correlation functions that is based on Convolutional Neural Network Encoder-Decoder (CNN-ED) models. Such models extract features from an image via convolutional layers, project them to a low dimensional space and then reconstruct a clean image from this reduced representation via transposed convolutional layers. Not only are ED models a general tool for random noise removal, but their application to low signal-to-noise data can enhance the data quantitative usage since they are able to learn the functional form of the signal. We demonstrate that the CNN-ED models trained on real-world experimental data help to effectively extract equilibrium dynamics parameters from two-time correlation functions, containing statistical noise and dynamic heterogeneities. Strategies for optimizing the models performance and their applicability limits are discussed.