Sanghun Pyo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sanghun Pyo has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Jungwon Yoon
Gwangju Institute of Science and Technology
2 shared publications - Amre Eizad
Center for Intelligent and Interactive Robotics, Korea Institute of Science and Technology, Seoul, South Korea
1 shared publication - Hosu Lee
Department of Control and Robot Engineering, Gyeongsang National University, Jinju, Republic of Korea
1 shared publication - Hosu Lee
Integrated Institute of Technology, Gwangju Institute of Science and Technology (GIST), 123 Cheomdan-gwagiro, Buk-gu, Gwangju 61005, Korea
1 shared publication - Min-Kyun Oh
Institute of Medical Science, Gyeongsang National University, Jinju 52727, Republic of Korea
1 shared publication - Sung-Ki Lyu
School of Mechanical and Aerospace Engineering, Gyeongsang National University, Jinju-si 52828, Republic of Korea
1 shared publication
Latest Publications
- Open Access
- 16 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Neural Systems and Rehabilitation Engineering
- Vol. 30 (15344320) , 812-822
Study on the Effects of Different Seat and Leg Support Conditions of a Trunk Rehabilitation Robot
Performance of trunk rehabilitation exercises while sitting on movable surfaces with feet on the ground can increase trunk and leg muscle activations, and constraining the feet to move with the seat isolates control of the trunk. However, there are no detailed studies on the effects of these different leg supports on the trunk and leg muscle activations under unstable and forcefully perturbed seating conditions. We have recently devised a trunk rehabilitation robot that can generate unstable and forcefully perturbed sitting surfaces, and can be used with ground-mounted or seat-connected footrests. In this study, we have evaluated the differences in balance performance, trunk movement and muscle activation (trunk and legs) of fourteen healthy adults caused by the use of these different footrest configurations under the different seating scenarios. The center of pressure and trunk movement results show that the seat-connected footrest may be a more suitable choice for use in a balance recovery focused rehabilitation protocol, while the ground-mounted footrest may be a more suitable choice for a trunk movement focused rehabilitation protocol. Although it is difficult to make a clear selection between footrests due to the mixed trends observed in the muscle activation results, it appears that the seat-connected footrest may be preferable for use with the unstable seat as it causes greater muscle activations. Furthermore, the results provide limited evidence that targeting of a particular muscle group may be possible through careful selection of the seat and footrest conditions. Therefore, it may be possible to utilize the trunk rehabilitation robot to maximize the training outcomes for a wide range of patients through careful selection of training protocols.
- 16 March 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Neural Systems and Rehabilitation Engineering
- Vol. 30 (15344320) , 812-822
Open AccessStudy on the Effects of Different Seat and Leg Support Conditions of a Trunk Rehabilitation Robot
Performance of trunk rehabilitation exercises while sitting on movable surfaces with feet on the ground can increase trunk and leg muscle activations, and constraining the feet to move with the seat isolates control of the trunk. However, there are no detailed studies on the effects of these different leg supports on the trunk and leg muscle activations under unstable and forcefully perturbed seating conditions. We have recently devised a trunk rehabilitation robot that can generate unstable and forcefully perturbed sitting surfaces, and can be used with ground-mounted or seat-connected footrests. In this study, we have evaluated the differences in balance performance, trunk movement and muscle activation (trunk and legs) of fourteen healthy adults caused by the use of these different footrest configurations under the different seating scenarios. The center of pressure and trunk movement results show that the seat-connected footrest may be a more suitable choice for use in a balance recovery focused rehabilitation protocol, while the ground-mounted footrest may be a more suitable choice for a trunk movement focused rehabilitation protocol. Although it is difficult to make a clear selection between footrests due to the mixed trends observed in the muscle activation results, it appears that the seat-connected footrest may be preferable for use with the unstable seat as it causes greater muscle activations. Furthermore, the results provide limited evidence that targeting of a particular muscle group may be possible through careful selection of the seat and footrest conditions. Therefore, it may be possible to utilize the trunk rehabilitation robot to maximize the training outcomes for a wide range of patients through careful selection of training protocols.
- Open Access
- 6 May 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (9) , 4223
Development of a Novel Omnidirectional Treadmill-Based Locomotion Interface Device with Running Capability
To achieve an immersive virtual reality (VR) environment, omnidirectional treadmills (ODTs) allow users to perform locomotion in any direction. However, existing ODTs are heavy and complex, and operate at low speeds. This limits fast user motion and prevents natural interactions in real applications such as military training programs and interactive games. In this paper, we introduce a novel locomotion interface device with running capability, which uses an omnidirectional treadmill with a new power transmission mechanism and a locomotion controller that enables the user to make fast movements. As a result of the improved power transmission performance due to the simple and relatively lightweight structure, the proposed two-dimensional treadmill can generate a maximum speed of 3 m/s, with an acceleration of 3 m/s2. Moreover, through a pilot test with the proposed locomotion interface device, we verified that the fast directional changes during walking and running with the designed speed adaptation controller do not exceed the acceleration performance of the proposed system. Due to its wide range of movement speeds and acceleration capabilities, and lack of any motion constraints, the proposed locomotion interface device with a novel ODT can be used as a representative platform in various VR environments to enhance the immersive experience.
- 6 May 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (9) , 4223
Open AccessDevelopment of a Novel Omnidirectional Treadmill-Based Locomotion Interface Device with Running Capability
To achieve an immersive virtual reality (VR) environment, omnidirectional treadmills (ODTs) allow users to perform locomotion in any direction. However, existing ODTs are heavy and complex, and operate at low speeds. This limits fast user motion and prevents natural interactions in real applications such as military training programs and interactive games. In this paper, we introduce a novel locomotion interface device with running capability, which uses an omnidirectional treadmill with a new power transmission mechanism and a locomotion controller that enables the user to make fast movements. As a result of the improved power transmission performance due to the simple and relatively lightweight structure, the proposed two-dimensional treadmill can generate a maximum speed of 3 m/s, with an acceleration of 3 m/s2. Moreover, through a pilot test with the proposed locomotion interface device, we verified that the fast directional changes during walking and running with the designed speed adaptation controller do not exceed the acceleration performance of the proposed system. Due to its wide range of movement speeds and acceleration capabilities, and lack of any motion constraints, the proposed locomotion interface device with a novel ODT can be used as a representative platform in various VR environments to enhance the immersive experience.