Hugo Perazzini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hugo Perazzini has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
Maisa Tonon Bitti Perazzini
7 shared publications- Maisa Tonon Bitti Perazzini
Instituto de Recursos Naturais, Universidade Federal de Itajubá, Itajuba, MG, BRAZIL
4 shared publications Ariany Binda Silva Costa
2 shared publications- Caio Camargo Claudio
Federal University of Itajuba
2 shared publications José T. Freire
2 shared publications- Lidja Dahiane Menezes Santos Borél
Department of Engineering Federal University of Lavras (UFLA) Lavras Minas Gerais Brazil
2 shared publications
Latest Publications
- Open Access
- 22 September 2026
- Published by Elsevier in Thermal Science and Engineering Progress
- Vol. 79
Efficiency analysis and evaluation 4E of a hybrid solar photovoltaic-electric dryer for Brewer’s Spent Grain drying
- 22 September 2026
- Published by Elsevier in Thermal Science and Engineering Progress
- Vol. 79
Open AccessEfficiency analysis and evaluation 4E of a hybrid solar photovoltaic-electric dryer for Brewer’s Spent Grain drying
- Open Access
- 30 June 2026
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 151 (13) , 1-15
Moisture-induced variations in effective thermal conductivity, diffusivity, and physical properties of fertilizers: an experimental exploration and artificial neural network analysis
The manufacturing process of phosphate fertilizer demands a substantial amount of thermal energy. Moisture contained in fertilizer particles is a key parameter affecting the performance of the energy transfer systems. For this reason, heat transfer parameters must be precisely known for the process’s characterization, design, and optimization. The conductivity and effective thermal diffusivity of phosphate fertilizers under different moisture contents were determined in this work considering two different approaches: experimental determination by the linear heat probe and Dickerson methods and prediction by a perceptron feed-forward neural network. The results showed that both diffusivity and effective thermal conductivity varied linearly with moisture content within the range of 7.19–8.67 × 10 −8 ± 0.193 m 2 s −1 and 0.172–0.284 ± 0.012 W m −1 K −1 , respectively. The developed neural network demonstrated its ability to accurately predict thermal conductivity, even for conditions outside the training dataset. For a wide range of particle moisture content, the relative deviation was 5.76%. The characterization of the particulate material, based on the size and shape factors of the particles, scanning electron microscopy, specific heat, density, and thermogravimetry, were discussed and reported. The thorough results provided a comprehensive understanding of fertilizers and their behavior in diverse conditions, contributing to the knowledge in this field.
- 30 June 2026
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 151 (13) , 1-15
Open AccessMoisture-induced variations in effective thermal conductivity, diffusivity, and physical properties of fertilizers: an experimental exploration and artificial neural network analysis
The manufacturing process of phosphate fertilizer demands a substantial amount of thermal energy. Moisture contained in fertilizer particles is a key parameter affecting the performance of the energy transfer systems. For this reason, heat transfer parameters must be precisely known for the process’s characterization, design, and optimization. The conductivity and effective thermal diffusivity of phosphate fertilizers under different moisture contents were determined in this work considering two different approaches: experimental determination by the linear heat probe and Dickerson methods and prediction by a perceptron feed-forward neural network. The results showed that both diffusivity and effective thermal conductivity varied linearly with moisture content within the range of 7.19–8.67 × 10 −8 ± 0.193 m 2 s −1 and 0.172–0.284 ± 0.012 W m −1 K −1 , respectively. The developed neural network demonstrated its ability to accurately predict thermal conductivity, even for conditions outside the training dataset. For a wide range of particle moisture content, the relative deviation was 5.76%. The characterization of the particulate material, based on the size and shape factors of the particles, scanning electron microscopy, specific heat, density, and thermogravimetry, were discussed and reported. The thorough results provided a comprehensive understanding of fertilizers and their behavior in diverse conditions, contributing to the knowledge in this field.
- Open Access
- 3 April 2026
- Published by Elsevier in Journal of Food Engineering
- Vol. 417
Infrared and infrared-convective drying of foamed coffee extract for the instant coffee production: Kinetics, energy-environmental performance and modeling study
- 3 April 2026
- Published by Elsevier in Journal of Food Engineering
- Vol. 417
Open AccessInfrared and infrared-convective drying of foamed coffee extract for the instant coffee production: Kinetics, energy-environmental performance and modeling study
- Open Access
- 20 February 2026
- Published by Elsevier in SSRN Electronic Journal
EFFICIENCY ANALYSIS AND EVALUATION 4E OF A HYBRID SOLAR PHOTOVOLTAIC-ELECTRIC DRYER FOR BREWER'S SPENT GRAIN DRYING
Brewer's Spent Grain (BSG) has high initial moisture it represents a significant environmental liability, but when properly dried, it BSG constitutes a biomass with a high heating value that can be used as an energy source. Since drying is one of the most energy-intensive stages in the agro-industrial chain, this work analyzed a hybrid solar dryer that incorporates solar thermal energy and a photovoltaic (PV) system with battery storage, supplying forced convection and auxiliary electric heating. The system’s performance was evaluated using four key indicators – energy, exergy, economic, and environmental (4E) analyses. Results showed that the overall drying efficiency ranged from 9.51 to 13.16%. The process, which involved operating the electric resistance heater at two power levels and during the night period, resulted in the highest specific energy consumption (7.01 kWh kg-1) and the lowest exergy performance (1.0%). In contrast, continuous electric heating increased the outlet exergy (3.08%) and reduced the specific energy consumption (6.61 kWh kg-1). The economic analysis indicated a payback period of approximately 3.72 years, along with a mitigation of up to 2.0 tons of CO2 emissions over a 10-year lifetime. The environmental return was estimated at 6.35 years. The dried BSG from continuous electrical heating processes showed an energy potential exceeding 15.0 MJ kg-1, demonstrating that the use of the hybrid solar PV-electric dryer can generate biomass with high energy content and support a more sustainable economy.
- 20 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEFFICIENCY ANALYSIS AND EVALUATION 4E OF A HYBRID SOLAR PHOTOVOLTAIC-ELECTRIC DRYER FOR BREWER'S SPENT GRAIN DRYING
Brewer's Spent Grain (BSG) has high initial moisture it represents a significant environmental liability, but when properly dried, it BSG constitutes a biomass with a high heating value that can be used as an energy source. Since drying is one of the most energy-intensive stages in the agro-industrial chain, this work analyzed a hybrid solar dryer that incorporates solar thermal energy and a photovoltaic (PV) system with battery storage, supplying forced convection and auxiliary electric heating. The system’s performance was evaluated using four key indicators – energy, exergy, economic, and environmental (4E) analyses. Results showed that the overall drying efficiency ranged from 9.51 to 13.16%. The process, which involved operating the electric resistance heater at two power levels and during the night period, resulted in the highest specific energy consumption (7.01 kWh kg-1) and the lowest exergy performance (1.0%). In contrast, continuous electric heating increased the outlet exergy (3.08%) and reduced the specific energy consumption (6.61 kWh kg-1). The economic analysis indicated a payback period of approximately 3.72 years, along with a mitigation of up to 2.0 tons of CO2 emissions over a 10-year lifetime. The environmental return was estimated at 6.35 years. The dried BSG from continuous electrical heating processes showed an energy potential exceeding 15.0 MJ kg-1, demonstrating that the use of the hybrid solar PV-electric dryer can generate biomass with high energy content and support a more sustainable economy.
- 28 April 2025
- Published by Elsevier in Food and Bioproducts Processing
- Vol. 152, 74-87
Effect of infrared power and intermittency ratio on combined infrared-convective intermittent drying of banana
- 28 April 2025
- Published by Elsevier in Food and Bioproducts Processing
- Vol. 152, 74-87
Effect of infrared power and intermittency ratio on combined infrared-convective intermittent drying of banana
- 9 November 2023
- Published by Elsevier in Renewable Energy
- Vol. 220
Valorization of pure poultry manure for biomass applications: Drying and energy potential characteristics
- 9 November 2023
- Published by Elsevier in Renewable Energy
- Vol. 220
Valorization of pure poultry manure for biomass applications: Drying and energy potential characteristics
- 31 October 2023
- Published by Elsevier in Food and Bioproducts Processing
- Vol. 143, 102-116
Convective drying of black pepper: Experimental measurements and mathematical modeling of the process
- 31 October 2023
- Published by Elsevier in Food and Bioproducts Processing
- Vol. 143, 102-116
Convective drying of black pepper: Experimental measurements and mathematical modeling of the process
- 24 August 2023
- Published by Elsevier in Biosystems Engineering
- Vol. 233, 206-220
Modelling and characterisation of jackfruit seeds drying using the diffusion theory considering shrinkage
- 24 August 2023
- Published by Elsevier in Biosystems Engineering
- Vol. 233, 206-220
Modelling and characterisation of jackfruit seeds drying using the diffusion theory considering shrinkage
- 16 June 2023
- Published by Taylor & Francis
- p. 11-29
Vibrated Bed Drying
Vibrated beds were developed to overcome difficulties in the fluidized bed (FB) technique when dealing with flat, cohesive particles or materials that are heterogeneous in terms of shape, size, and density, which can lead to the unwanted formation of preferential channels, bubbles, and agglomerates. In this context, the vibro-fluidized bed (VFB) improves the movement of particles, thus increasing the heat and mass transfer rates and decreasing the minimum fluidization velocity, which improves the energy performance of the system. It can be said that vibration is widely found in industrial applications. VFBs can be seen in a variety of unit operations such as cooling, heating, classification, separation and particles coating, and finally drying, which has the largest number of applications, mainly in the pharmaceutical, food, chemical, mining, and textile industry. The first studies on VFBs date back to 1938 and, since then, efforts have been focused on understanding transport phenomena and theoretical aspects of vibration, as can be seen in the pioneering works of Pakowski et al. (1984) and Érdesz et al. (1986). Taking as a starting point the established works on VFBs, the objective of this chapter is to show new discoveries found in the literature that impact the efficient operation of the vibrated bed and improve mathematical description for process design and optimization. The chapter also shows examples of current industrial applications of this type of bed.
- 16 June 2023
- Published by Taylor & Francis
- p. 11-29
Vibrated Bed Drying
Vibrated beds were developed to overcome difficulties in the fluidized bed (FB) technique when dealing with flat, cohesive particles or materials that are heterogeneous in terms of shape, size, and density, which can lead to the unwanted formation of preferential channels, bubbles, and agglomerates. In this context, the vibro-fluidized bed (VFB) improves the movement of particles, thus increasing the heat and mass transfer rates and decreasing the minimum fluidization velocity, which improves the energy performance of the system. It can be said that vibration is widely found in industrial applications. VFBs can be seen in a variety of unit operations such as cooling, heating, classification, separation and particles coating, and finally drying, which has the largest number of applications, mainly in the pharmaceutical, food, chemical, mining, and textile industry. The first studies on VFBs date back to 1938 and, since then, efforts have been focused on understanding transport phenomena and theoretical aspects of vibration, as can be seen in the pioneering works of Pakowski et al. (1984) and Érdesz et al. (1986). Taking as a starting point the established works on VFBs, the objective of this chapter is to show new discoveries found in the literature that impact the efficient operation of the vibrated bed and improve mathematical description for process design and optimization. The chapter also shows examples of current industrial applications of this type of bed.