ABAndrii Bulhakov

Andrii Bulhakov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Andrii Bulhakov has a total of 23 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    APPLICATION OF STRAIN GAUGES IN MONITORING LOAD-BEARING ELEMENTS OF BUILDING STRUCTURES

    by Oleksandr Isayev, Svitlana Bondar, Petro Chulanov, Andrii Bulhakov

    The paper addresses the application of strain gauges, classified as strain-based sensors, in structural health monitoring of engineering constructions. Particular attention is given to monitoring the bending behavior of relatively tall columns subjected to variable and increasing loads. It is shown that the use of resistive strain gauges enables continuous measurement of relative strains and the indirect evaluation of stresses within structural elements with high sensitivity and accuracy. This allows for the detection of adverse changes in structural behavior at early stages, including stress redistribution and the initiation of damage. It is emphasized that strain measurements are inherently local, reflecting the state of the material only at specific points where sensors are installed. Therefore, they do not directly provide information about the global displacements of structures, such as deflections, tilts, or planimetric and vertical movements. To assess these parameters, geodetic monitoring methods must be employed using robotic total stations and other high-precision measurement instruments. Based on the analysis, the necessity of an integrated approach combining strain measurement and geodetic monitoring is substantiated. Such an approach enables the simultaneous acquisition of local stress–strain state characteristics and global spatial behavior parameters, significantly improving the reliability of structural assessment and prediction. The paper also discusses practical aspects of monitoring system design, including the selection of locations and mounting techniques for strain gauges, determination of the required number of sensors, and optimization of their layout. Special attention is paid to coordinating the placement of strain gauges with reflective targets used for coordinate measurements by robotic total stations. This ensures the effective integration of heterogeneous data sources and enhances the overall effectiveness of comprehensive structural monitoring.

  • Open Access

    APPLICATION OF DRONES IN LAND INVENTORY

    by Svitlana Bondar, Bohdan Sirenko, Andrii Bulhakov

    Today, the development of digital technologies is very fast. What determines the emergence of new methods of terrain research. One example of a state-of-the-art method for topographic-geodetic and land management works is the use of unmanned aerial vehicles (Drons), which significantly reduces the execution time and allows obtaining detailed data. During the short time the UAV is in the air, it is possible to obtain information for compiling orthophoto plans with centimeter accuracy for a certain object. Which in turn are a good basis for land inventory and land monitoring. In the modern world, the economic side plays an important role. The inventory requires the introduction of more automated technologies that require minimal labor costs and shorten the execution time. Therefore, the method of using unmanned aerial vehicles is ideal for the tasks. In this work, we use the example of carrying out an inventory of communally owned lands, which are provided to citizens for personal agriculture, with the involvement of Drons.

  • SIMULATION OF THE EVACUATION PROCESS OF DAMAGED WEAPONS AND MILITARY EQUIPMENT DURING OPERATIONS (MILITARY ACTIONS)

    by M. Kudrytskyi, A. Bulhakov, V. Yurchenko, I. Safronov, Military Academy (Odesa)

    SIMULATION OF THE EVACUATION PROCESS OF DAMAGED WEAPONS AND MILITARY EQUIPMENT DURING OPERATIONS (MILITARY ACTIONS) The article presents a procedure for modeling the process of evacuating damaged weapons and military equipment during operations (combat actions), which contains 5 stages and allows for the assessment of the effectiveness of the damaged weapons and military equipment evacuation system at the strategic (operational, tactical) level, taking into account the specifics of employing forces and means of the weapons and military equipment restoration system during operations (combat actions). To solve the task of assessing the effectiveness of the evacuation subsystem during operations (combat actions), the use of the following is proposed: a mathematical model for detecting and destroying forces and means of the weapons and military equipment restoration system, namely evacuation and repair systems during operations (combat actions); a mathematical model of the process of evacuating damaged weapons and military equipment, based on a queueing system with waiting; a mathematical model of the process of evacuating damaged weapons and military equipment, based on a queueing system with time-limited waiting; The use of these models during modeling provides the opportunity to conduct more accurate (correct) assessment of the effectiveness of the weapons and military equipment evacuation system functioning, by taking into account: possible changes in the evacuation procedure for damaged weapons and military equipment, related to the possible destruction of weapons and military equipment restoration forces and means during operations (combat actions); possible time limitations for conducting weapons and military equipment evacuation measures, which may be caused by high intensity of combat actions, rapid changes in the operational situation, etc. This approach allows for effective consideration of the interaction between different elements of the technical support system under modern combat conditions.

  • Open Access

    METHODOLOGY FOR COST ESTIMATION OF TOPOGRAPHIC, GEODETIC, AND CARTOGRAPHIC WORKS

    by Oleksandr Korenets, Iryna Pidlisetska, Andrii Bulgakov, Tamara Kurach, Ірина Підлісецька

    B a c k g r o u n d . The issue of economic evaluation of topographic, geodetic, and cartographic works (hereinafter – TG&CW) within Ukraine's defence sector remains insufficiently addressed in current scientific research. In the context of security and defence sector reform, and in light of the growing demand for geospatial support to military operations, there is a pressing need for a scientifically grounded methodology for determining the cost of TG&CW. This methodology should reflect the operational specifics of the Topographic Service of the Armed Forces of Ukraine (TS AFU). The proposed cost estimation model consists of six stages: data preparation, core calculation procedures, determination of direct and indirect expenses, calculation of baseline estimated cost, coordination, and approval of cost estimates. M e t h o d s . The article applies general scientific methods such as analysis, comparison, synthesis, analogy, the systems approach, and structural-graphic modelling. These methods allowed for the systematisation of existing approaches to cost assessment in TG&CW and facilitated the development of a structured graphical model for calculating their cost. R e s u l t s . The developed system of baseline calculation indicators includes labour costs, material expenditures, transportation costs, equipment costs and depreciation, administrative and overhead expenses, as well as allowances for unforeseen expenses and operational risks. There is both a scientific and practical need for an economic-methodological model for assessing TG&CW costs, adapted to the structure and missions of the TS AFU. Such a model would serve as a basis for managerial decision-making in planning, logistics, and resource allocation. C o n c l u s i o n s . The proposed structural-graphic model for cost estimation accounts for the military-specific context of TG&CW, integrating a comprehensive system of cost indicators including labour, material, transportation, administrative, and overhead expenses. A key outcome of this study is the development of a system of baseline calculation indicators, which may be adapted to various types of TG&CW conducted by the TS AFU.

  • Open Access

    ANALYSIS OF THE DEVELOPMENT OF LIDAR TECHNOLOGIES AND THE PROSPECTS OF THEIR USE DURING THE PERFORMANCE OF THE TASKS OF GEOSPATIAL SUPPORT OF ARMIES (FORCES) IN COMBAT CONDITIONS

    by Andrii Bulhakov, Svitlana Bondar, Roman Demyanenko, Yurii Medvedskyi, Oleksandr Kuzmych, Андрій Булгаков, Роман Дем'яненко, Юрій Медведський

    The results of the analysis of the implementation of geospatial support of troops (forces) by military units in the performance of assigned tasks in the course of repelling the large-scale aggression of the Russian Federation against Ukraine revealed serious gaps in the provision of geospatial data to troops (forces) [1]. In particular, given the unsatisfactory state of cartographic materials, remote methods of collecting, creating (updating) geospatial data are used. The use of Earth remote sensing materials with high resolution has become a priority. LiDAR systems (3D laser scanning) are one of the varieties of Earth remote sensing technology. However, in the Armed Forces of Ukraine, this technology in the field of geospatial support of troops (forces), especially in the conditions of hostilities, is rarely used. Therefore, the use of LiDAR systems in this field is relevant and requires a thorough analysis of the current state, prospects for development and application of this technology in the mentioned direction. In this regard, this article is aimed at identifying the prospects of using LiDAR systems to increase the efficiency of the tasks of creating and updating geospatial data in combat conditions. The article presents the results of the analysis of the use of LiDAR systems, reveals the advantages and disadvantages of this technology, discovers the prospects for its development and implementation in the Armed Forces of Ukraine, substantiated practical recommendations for its use in combat conditions. The materials of the article are of practical value for officials of military administrations engaged in planning and implementation of tasks of geospatial support of the Armed Forces of Ukraine during operations, developers and users of geospatial technologies in military affairs, as well as scientists investigating the issue of task transformation in the field of geospatial support of troops (forces).

  • Open Access

    Development of recommendations regarding the composition of forces and equipment for topogeodesic support of the troops of the operational command

    by Andrii Bulhakov

    The object of the research is the forces and devices of topographic support of the operational command troops. The work highlights the recommendations regarding the composition of the forces and devices of topographical support of the operational command troops. The analysis of the nature of the armed struggle of the last decades shows a sharp increase in the need of the troops (forces) for information provision, in particular in the provision of topogeodesic information (geospatial information) of the armed forces, the timeliness and reliability of which affects the course and results of military operations. One of the types of geospatial data that is needed by the military both in peacetime and in a special period are topographic maps, they are the main source of information about the terrain and the objects on it. Nowadays, the state of topographic information on most nomenclature sheets of topographic maps of the territory of Ukraine does not meet the modern requirements of the troops. The successful implementation of the task of updating topographical information is facilitated by the use of the most acceptable and economically justified composition of forces and devices of topographical support of troops. However, the experience of geodetic support during the operational training of troops (forces), the operation of the United Forces in the east of the country and the large-scale armed aggression by the Russian Federation showed that the currently available forces and devices of geodetic support of the troops are not capable of fulfilling the entire scope of the assigned tasks This especially applies to operational commands. Therefore, in order to successfully carry out changes in the system of topographic support regarding the necessary composition of forces and devices of this support, appropriate scientific researches were conducted. This, in turn, will provide an opportunity to improve existing methods and develop recommendations regarding the necessary composition of forces and devices of topographic support for the troops of the operational command. The mentioned recommendations will make it possible to justify the composition of the forces and devices of topographical support of the troops of the operational command by the persons planning the operations of the groups of troops (forces).


  • Open Access

    Рекомендації щодо порядку застосування методичного підходу до воєнно-економічного обґрунтування вибору варіанту розвідувально-ударної системи або комплексу в програмах (планах)

    by Olegh Semenenkо, Artem Remez, Vladimir Musienko, Ivan Motrunych, Andrii Bulhakov, Oleh Tarasov

    Стан вітчизняної економіки та рівень впровадження сучасних технологій на підприємствах оборонно-промислового комплексу роблять проблематичним виконання у встановлені терміни всіх планів переозброєння Збройних Сил України. Тому найбільш прийнятним, як з воєнної, так і з економічної точки зору є підхід щодо ситуаційного інтегрування наявних сил і засобів у цільові системи в єдиному інформаційному просторі шляхом інтеграції засобів розвідки, управління та ураження. Тобто розвідувально-ударна система, побудована з множини підсистем об'єднаних інформаційними відносинами, які функціонують, як одне ціле, на основі єдиних принципів і правил, з погодженими основними вимогами до їх складових дозволить збільшити ефективність бойового застосування військ за рахунок синергетичного ефекту. Але інтегрування різних сил і засобів у цільові системи створює передумови щодо наявності декілька можливих варіантів цих систем, які мають різні оцінки ефективності їх застосування, вартісні показники їх створення, утримання та застосування, а також різні часові інтервали щодо їх створення та приведення у бойову готовність. Тому система показників і критеріїв оцінювання та порівняння різних варіантів розвідувально-ударно систем чи комплексів, а також методичні підходи щодо обґрунтування вибору раціонального варіанту цих систем чи комплексів повинні мати інтегральний критерій вибору пріоритетного варіанту в умовах обстановки, що складається на час оцінювання. Тому авторами в статті запропоновано загальну структуру побудови методичного підходу до воєнно-економічного обґрунтування вибору раціонального варіанту розвідувально-ударної системи або комплексу з урахуванням воєнних, економічних та часових факторів, що вливають на їх створення, утримання та застосування, а також сформовано повну структурно-логічну схему цього підходу. У свою чергу запропонований методичний підхід дозволяє сформувати основні рекомендації щодо порядку його застосування в штабах, службах Збройних Силах України під час формування програм та планів розвитку озброєння та військової техніки Збройних Сил України та Збройних Сил України в цілому.