Jagan Sivamani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jagan Sivamani has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Karuppasamy Narayanan
Department of Civil Engineering, Sona College of Technology, Salem, India
2 shared publications Neelakantan Thurvas Renganathan
Department of Civil Engineering, Kalasalingam Academy of Research and Education, Krishnankoil, India
2 shared publications- Neelakantan Thurvas Renganathan
Faculty, School of Civil Engineering, SASTRA Deemed University, Thanjavur, India
2 shared publications - Ramalingam Malathy
Department of Civil Engineering, Sona College of Technology, Salem, India
2 shared publications T.R. Neelakantan
2 shared publicationsC. Mugesh Kanna
Kalasalingam Academy of Research and Education
1 shared publication
Latest Publications
- 17 July 2025
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 10 (8) , 1-17
Evaluation of durability characteristics and life cycle behaviour of high-performance concrete
- 17 July 2025
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 10 (8) , 1-17
Evaluation of durability characteristics and life cycle behaviour of high-performance concrete
- 17 January 2025
- Published by Springer Nature in Multiscale and Multidisciplinary Modeling, Experiments and Design
- Vol. 8 (2) , 1-16
Influence of CO2 in treating the recycled fine aggregate in concrete with polypropylene fibres: multiscale investigation on its mechanical, durability and structural properties
- 17 January 2025
- Published by Springer Nature in Multiscale and Multidisciplinary Modeling, Experiments and Design
- Vol. 8 (2) , 1-16
Influence of CO2 in treating the recycled fine aggregate in concrete with polypropylene fibres: multiscale investigation on its mechanical, durability and structural properties
- 11 August 2023
- Published by Springer Nature in Waste Disposal & Sustainable Energy
- Vol. 5 (4) , 451-459
Performance studies on recycled aggregate concrete with treated recycled aggregates
- 11 August 2023
- Published by Springer Nature in Waste Disposal & Sustainable Energy
- Vol. 5 (4) , 451-459
Performance studies on recycled aggregate concrete with treated recycled aggregates
- 1 June 2023
- Published by Springer Nature in Journal of Wuhan University of Technology-Mater. Sci. Ed.
- Vol. 38 (4) , 815-822
Properties of Sustainable High Strength Concrete with Waste Copper Slag
- 1 June 2023
- Published by Springer Nature in Journal of Wuhan University of Technology-Mater. Sci. Ed.
- Vol. 38 (4) , 815-822
Properties of Sustainable High Strength Concrete with Waste Copper Slag
- 1 January 2023
- Published by MIM Research Group in Research on Engineering Structures and Materials
Performance studies on energy efficient paver block with treated recycled aggregate
Performance studies on energy efficient paver block with treated recycled aggregate
- 1 January 2023
- Published by MIM Research Group in Research on Engineering Structures and Materials
Performance studies on energy efficient paver block with treated recycled aggregate
Performance studies on energy efficient paver block with treated recycled aggregate
- 1 January 2023
- Published by International Digital Organization for Scientific Information (IDOSI) in International Journal of Engineering
- Vol. 36 (5) , 904-913
Performance Studies on Glass Fiber Reinforced Recycled Aggregate Concrete
The utilization of fibers in the concrete reduces cracks, increases the energy absorption and concrete strength. The use of fine recycled aggregate (FRA) in concrete overcomes the scarcity of natural aggregates, however its deprived quality affects the concrete properties through development of cracks. This study investigates the effect of glass fiber (GF) utilization in reducing crack propagation using fine recycled aggregate (FRA) in the concreteThe coarse natural aggregate (CNA) was replaced with 10, 30, 50, 70, 90 and 100% of FRA and GF was added 0, 0.25, 0.5, 0.75, 1 and 1.5% by weight. The concrete mixtures with the optimal percentage of FRA and different percentages of GF were prepared by two-stage mixing approach (TSMA) and normal mixing approach (NMA) and tested for their fresh and hardened properties. The optimized mix was observed with 30% of FRA and 1% of GF prepared by TSMA, with a strength improvement of 11.3% compared to the control mix at 28 days. The study further investigated the practical suitability as a paver block for non-traffic and medium volume traffic applications as per IS 15658: 2006 and observed that minimum strength requirement of 40 MPa was achieved under both conditions with the optimized mix with an improvement of 17.4% compared to conventional paver block.
- 1 January 2023
- Published by International Digital Organization for Scientific Information (IDOSI) in International Journal of Engineering
- Vol. 36 (5) , 904-913
Performance Studies on Glass Fiber Reinforced Recycled Aggregate Concrete
The utilization of fibers in the concrete reduces cracks, increases the energy absorption and concrete strength. The use of fine recycled aggregate (FRA) in concrete overcomes the scarcity of natural aggregates, however its deprived quality affects the concrete properties through development of cracks. This study investigates the effect of glass fiber (GF) utilization in reducing crack propagation using fine recycled aggregate (FRA) in the concreteThe coarse natural aggregate (CNA) was replaced with 10, 30, 50, 70, 90 and 100% of FRA and GF was added 0, 0.25, 0.5, 0.75, 1 and 1.5% by weight. The concrete mixtures with the optimal percentage of FRA and different percentages of GF were prepared by two-stage mixing approach (TSMA) and normal mixing approach (NMA) and tested for their fresh and hardened properties. The optimized mix was observed with 30% of FRA and 1% of GF prepared by TSMA, with a strength improvement of 11.3% compared to the control mix at 28 days. The study further investigated the practical suitability as a paver block for non-traffic and medium volume traffic applications as per IS 15658: 2006 and observed that minimum strength requirement of 40 MPa was achieved under both conditions with the optimized mix with an improvement of 17.4% compared to conventional paver block.
- Open Access
- 1 November 2022
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 23 (6) , 233-242
Review on Impact of Construction Waste Landfill on Environment and its Reutilization
In several countries, the use of recycled coarse aggregate in construction materials is recommended; however, the use of organic matter is restricted because it can produce significant changes in compressive strength. In terms of reaching a conclusive viewpoint regarding the research topic,...
- 1 November 2022
- Published by Wydawnictwo Naukowe Gabriel Borowski (WNGB) in Ecological Engineering & Environmental Technology
- Vol. 23 (6) , 233-242
Open AccessReview on Impact of Construction Waste Landfill on Environment and its Reutilization
In several countries, the use of recycled coarse aggregate in construction materials is recommended; however, the use of organic matter is restricted because it can produce significant changes in compressive strength. In terms of reaching a conclusive viewpoint regarding the research topic,...
- Open Access
Experimental Investigation on the Potential Use of Magnetic Water as a Water Reducing Agent in High Strength Concrete
High-strength concrete is designed for a self-weight reduction structure and exhibits higher resistance to compressive loads. This paper proposes a novel technique to enhance concrete’s properties using Magnetic Field Treated Water (MFTW), describing the results of experimental studies to apprehend the fresh, hardened and microstructural behavior of concrete prepared with Magnetic Water (MW) using a permanent magnet with a field intensity of 0.9 Tesla. The novel scheme focuses on utilizing MW as a water-reducing agent instead of SP to improve the workability of fresh concrete with a 0.38 w/c ratio for achieving M40 grade concrete. Results show a 12% improvement in compressive strength and an 8.9% improvement in split tensile strength compared to normal water (NW) with 1% SP. At 30% cement volume reduction, Magnetic Water Concrete (MWC) performs better than Normal Water Concrete (NWC). Microstructure examination shows that a smaller Calcium Hydrate (CH) crystal is formed with MW and its mineral composition is observed through Energy Dispersive X-ray Analysis (EDAX).
Open AccessExperimental Investigation on the Potential Use of Magnetic Water as a Water Reducing Agent in High Strength Concrete
High-strength concrete is designed for a self-weight reduction structure and exhibits higher resistance to compressive loads. This paper proposes a novel technique to enhance concrete’s properties using Magnetic Field Treated Water (MFTW), describing the results of experimental studies to apprehend the fresh, hardened and microstructural behavior of concrete prepared with Magnetic Water (MW) using a permanent magnet with a field intensity of 0.9 Tesla. The novel scheme focuses on utilizing MW as a water-reducing agent instead of SP to improve the workability of fresh concrete with a 0.38 w/c ratio for achieving M40 grade concrete. Results show a 12% improvement in compressive strength and an 8.9% improvement in split tensile strength compared to normal water (NW) with 1% SP. At 30% cement volume reduction, Magnetic Water Concrete (MWC) performs better than Normal Water Concrete (NWC). Microstructure examination shows that a smaller Calcium Hydrate (CH) crystal is formed with MW and its mineral composition is observed through Energy Dispersive X-ray Analysis (EDAX).