Paavai Era
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Paavai Era has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Ro. Mu. Jauhar
Department of Physics, Saveetha School of Engineering, SIMATS, Chennai, India
4 shared publications V. Siva
Department of Physics, Karpagam Academy of Higher Education, Coimbatore, India
2 shared publicationsA. Raja
CNR-SPIN, University of Salerno, Fisciano, Italy
1 shared publication- Ahmed Nabih Zaki Rashed
Electronics and Electrical Communications Engineering Department, Faculty of Electronic Engineering Menoufia University Menouf Egypt
1 shared publication - Amzad Hossain
Department of Electrical and Electronic Engineering, Jashore University of Science and Technology 2 , Jashore 7408
1 shared publication Fahd Alharethy
Department of Chemistry, College of Science, King Saud University, Riyadh, Saudi Arabia
1 shared publication
Latest Publications
- Open Access
- 20 February 2026
- Published by Elsevier in SSRN Electronic Journal
Scalable Reaction Time-Controlled Ni-BTC MOF as High-Performance Hydrogen Evolution Catalyst
Designing efficient and robust electrocatalysts are essential for advancing sustainable hydrogen production through water electrolysis. Here, a reaction time–controlled, morphology-tailored Ni-BTC metal–organic framework synthesized over 12 hours is reported as an effective electroactive catalyst for the HER. Structural analysis through powder X-ray diffraction confirms the preservation of the coordination between Ni²⁺ centers and the trimesic acid linker. And also ensures the formation of lower crystallite size (minimum 1.4 nm, average 7.5 nm). The mesoporous architecture with a surface area of 204.77 m² g⁻¹ obtained from BET surface analysis ensures the framework integrity along with mesoporous characteristics that enhance electrolyte accessibility and mass transport. Further elemental composition and surface morphology were analysed through the EDS and FESEM. Morphology of the prepared sample was analysed through TEM analysis, and the average particle size of 0.19 nm was assessed through TEM analysis. Electrochemical evaluation reveals that the 9:0.5:0.5 electrode composition achieves a low overpotential and a Tafel slope of 170.6 mV and 120 mV dec⁻¹, respectively, and also exhibits excellent durability. The double-layered capacitance (3.12 × 10⁻³ F) and electrochemically active surface area (78.1 cm²), indicates abundant accessible catalytic sites than the 8:1:1 electrode. These results demonstrate that reaction time-controlled morphological optimization and synergistically tuned electrode composition enhance the HER performance and establish Ni-BTC MOFs as viable candidates for efficient and sustainable hydrogen generation.
- 20 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessScalable Reaction Time-Controlled Ni-BTC MOF as High-Performance Hydrogen Evolution Catalyst
Designing efficient and robust electrocatalysts are essential for advancing sustainable hydrogen production through water electrolysis. Here, a reaction time–controlled, morphology-tailored Ni-BTC metal–organic framework synthesized over 12 hours is reported as an effective electroactive catalyst for the HER. Structural analysis through powder X-ray diffraction confirms the preservation of the coordination between Ni²⁺ centers and the trimesic acid linker. And also ensures the formation of lower crystallite size (minimum 1.4 nm, average 7.5 nm). The mesoporous architecture with a surface area of 204.77 m² g⁻¹ obtained from BET surface analysis ensures the framework integrity along with mesoporous characteristics that enhance electrolyte accessibility and mass transport. Further elemental composition and surface morphology were analysed through the EDS and FESEM. Morphology of the prepared sample was analysed through TEM analysis, and the average particle size of 0.19 nm was assessed through TEM analysis. Electrochemical evaluation reveals that the 9:0.5:0.5 electrode composition achieves a low overpotential and a Tafel slope of 170.6 mV and 120 mV dec⁻¹, respectively, and also exhibits excellent durability. The double-layered capacitance (3.12 × 10⁻³ F) and electrochemically active surface area (78.1 cm²), indicates abundant accessible catalytic sites than the 8:1:1 electrode. These results demonstrate that reaction time-controlled morphological optimization and synergistically tuned electrode composition enhance the HER performance and establish Ni-BTC MOFs as viable candidates for efficient and sustainable hydrogen generation.
- Open Access
- 11 May 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (26) , 15710-15721
The exploration of the crystal nucleation parameters and physico-chemical analysis of a single crystal: 2-amino-4,6-dimethoxypyrimidinium hydrogen (2 R ,3 R )-tartrate 2-amino-4,6-dimethoxypyrimidine
This paper discusses the structural orientations and the physico-chemical properties of a single crystal of 2-amino-4,6-dimethoxypyrimidinium hydrogen (2R,3R)-tartrate 2-amino-4,6-dimethoxypyrimidine (2ADT). The experimental investigation of the properties of the compound improves the potential for the utilization of the crystalline compound in the fabrication of optical limiting and nonlinear optical devices. For the growth process, an organic nonlinear optical crystal of 2ADT is synthesized conventionally at varying molar concentrations to achieve an excellent yield. The structural orientations and refinements of the compound are identified and discussed with reference to a single crystal X-ray diffraction study and its supporting computations. The results of the experimental analysis via UV-vis-NIR spectrometry and a z-scan setup with a laser beam source are used in an in-depth discussion on the linear and nonlinear optical properties of the crystal together with its damage threshold induced by a Nd:YAG laser beam at 1064 nm. With optical transparency of 55% in the entire visible region, a lower cut-off wavelength at 228 nm, and a bandgap at 5.2 eV, the crystal was demonstrated to be suitable for use in optical device fabrication. The thermogravimetrically assessed thermal stability of 2ADT was examined up to 147 °C. In addition, the thermodynamic parameters responsible for activation reactions are also discussed because these give information about the material's thermal behavior. An optical limiting study revealed that the transmitted output power increases linearly with the input power at about 1.89 mW cm−2.
- 11 May 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (26) , 15710-15721
Open AccessThe exploration of the crystal nucleation parameters and physico-chemical analysis of a single crystal: 2-amino-4,6-dimethoxypyrimidinium hydrogen (2 R ,3 R )-tartrate 2-amino-4,6-dimethoxypyrimidine
This paper discusses the structural orientations and the physico-chemical properties of a single crystal of 2-amino-4,6-dimethoxypyrimidinium hydrogen (2R,3R)-tartrate 2-amino-4,6-dimethoxypyrimidine (2ADT). The experimental investigation of the properties of the compound improves the potential for the utilization of the crystalline compound in the fabrication of optical limiting and nonlinear optical devices. For the growth process, an organic nonlinear optical crystal of 2ADT is synthesized conventionally at varying molar concentrations to achieve an excellent yield. The structural orientations and refinements of the compound are identified and discussed with reference to a single crystal X-ray diffraction study and its supporting computations. The results of the experimental analysis via UV-vis-NIR spectrometry and a z-scan setup with a laser beam source are used in an in-depth discussion on the linear and nonlinear optical properties of the crystal together with its damage threshold induced by a Nd:YAG laser beam at 1064 nm. With optical transparency of 55% in the entire visible region, a lower cut-off wavelength at 228 nm, and a bandgap at 5.2 eV, the crystal was demonstrated to be suitable for use in optical device fabrication. The thermogravimetrically assessed thermal stability of 2ADT was examined up to 147 °C. In addition, the thermodynamic parameters responsible for activation reactions are also discussed because these give information about the material's thermal behavior. An optical limiting study revealed that the transmitted output power increases linearly with the input power at about 1.89 mW cm−2.