Ziwei Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ziwei Liu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Chen Cai
State Key Laboratory of Transducer Technology, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing 100190, China
2 shared publications- Zhi-Mei Qi
State Key Laboratory of Transducer Technology, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing 100190, China
2 shared publications - Bo Yang
State Key Laboratory of Transducer Technology
1 shared publication - Chen Cai
State Key Laboratory of Transducer Technology, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing, China
1 shared publication Chen Chen
State Key Laboratory of Transducer Technology, Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing 100190, China
1 shared publication- Chong Lei
National Key Laboratory of Advanced Micro and Nano Manufacture Technology, Department of Micro-Nano Electronics, School of Electronic Information and Electrical Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
1 shared publication
Latest Publications
- 15 December 2025
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 399
A MEMS fluxgate current sensing chip applicable to DC/AC weak and small current detection
- 15 December 2025
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 399
A MEMS fluxgate current sensing chip applicable to DC/AC weak and small current detection
- Open Access
- 29 October 2022
- Published by Springer Nature in Nature Communications
- Vol. 13 (1) , 1-15
Flexible hyperspectral surface plasmon resonance microscopy
Optical techniques for visualization and quantification of chemical and biological analytes are always highly desirable. Here we show a hyperspectral surface plasmon resonance microscopy (HSPRM) system that uses a hyperspectral microscope to analyze the selected area of SPR image produced by a prism-based spectral SPR sensor. The HSPRM system enables monochromatic and polychromatic SPR imaging and single-pixel spectral SPR sensing, as well as two-dimensional quantification of thin films with the measured resonance-wavelength images. We performed pixel-by-pixel calibration of the incident angle to remove pixel-to-pixel differences in SPR sensitivity, and demonstrated the HSPRM’s capabilities by using it to quantify monolayer graphene thickness distribution, inhomogeneous protein adsorption and single-cell adhesion. The HSPRM system has a wide spectral range from 400 nm to 1000 nm, an optional field of view from 0.884 mm2 to 0.003 mm2 and a high lateral resolution of 1.2 μm, demonstrating an innovative breakthrough in SPR sensor technology.
- 29 October 2022
- Published by Springer Nature in Nature Communications
- Vol. 13 (1) , 1-15
Open AccessFlexible hyperspectral surface plasmon resonance microscopy
Optical techniques for visualization and quantification of chemical and biological analytes are always highly desirable. Here we show a hyperspectral surface plasmon resonance microscopy (HSPRM) system that uses a hyperspectral microscope to analyze the selected area of SPR image produced by a prism-based spectral SPR sensor. The HSPRM system enables monochromatic and polychromatic SPR imaging and single-pixel spectral SPR sensing, as well as two-dimensional quantification of thin films with the measured resonance-wavelength images. We performed pixel-by-pixel calibration of the incident angle to remove pixel-to-pixel differences in SPR sensitivity, and demonstrated the HSPRM’s capabilities by using it to quantify monolayer graphene thickness distribution, inhomogeneous protein adsorption and single-cell adhesion. The HSPRM system has a wide spectral range from 400 nm to 1000 nm, an optional field of view from 0.884 mm2 to 0.003 mm2 and a high lateral resolution of 1.2 μm, demonstrating an innovative breakthrough in SPR sensor technology.
- 31 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (36) , 43186-43196
Spatially Resolved Spectroscopic Characterization of Nanostructured Films by Hyperspectral Dark-Field Microscopy
Nanostructured films have been widely used for preparing various advanced thin-film devices because of their unique electrical, optical, and plasmonic characteristics associated with the nano-size effect. In situ, nondestructive and high-resolution characterization of nanostructured films is essential for optimizing thin-film device performance. In this work, such thin-film characterization was achieved using a hyperspectral dark-field microscope (HSDFM) that was constructed in our laboratory by integrating a hyperspectral imager with a commercial microscope. The HSDFM allows for high-resolution (Δλ = 0.4 nm) spectral analysis of nanostructured samples in the visible-near-infrared region with a spatial resolution as high as 45 nm × 45 nm (corresponding to a single pixel). Four typical samples were investigated with the HSDFM, including the gold nanoplate array, the self-assembled gold nanoparticle (GNP) sub-monolayer, the sol-gel nanoporous titanium dioxide (TiO2) film, and the layer-stacked molybdenum disulfide (MoS2) sheet. According to the experimental results, the plasmon resonance scattering bands for nanoplate clusters are identical with those for individual gold nanoplates, indicating that the gap between adjacent nanoplates is too large to allow plasmonic coupling between them. A different case was observed with the self-assembled GNP sub-monolayer in which the aggregated clusters with the internal plasmonic interaction show a considerable red-shift of the plasmon resonance band relative to the isolated single GNP. In addition, the protein adsorption on the nanoporous TiO2 film was observed to be inhomogeneous on the microscale, and the stepped boundaries of the MoS2 sheet were clearly observed. A quasi-linear dependence of the single-pixel light intensity on the step height was obtained by combining the HSDFM with atomic force microscopy. The minimum thickness detectable by the present HSDFM is 6.5 nm, corresponding to the 10-layer MoS2 film. The work demonstrated the outstanding applicability of the HSDFM for nanostructured film characterization.
- 31 August 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (36) , 43186-43196
Spatially Resolved Spectroscopic Characterization of Nanostructured Films by Hyperspectral Dark-Field Microscopy
Nanostructured films have been widely used for preparing various advanced thin-film devices because of their unique electrical, optical, and plasmonic characteristics associated with the nano-size effect. In situ, nondestructive and high-resolution characterization of nanostructured films is essential for optimizing thin-film device performance. In this work, such thin-film characterization was achieved using a hyperspectral dark-field microscope (HSDFM) that was constructed in our laboratory by integrating a hyperspectral imager with a commercial microscope. The HSDFM allows for high-resolution (Δλ = 0.4 nm) spectral analysis of nanostructured samples in the visible-near-infrared region with a spatial resolution as high as 45 nm × 45 nm (corresponding to a single pixel). Four typical samples were investigated with the HSDFM, including the gold nanoplate array, the self-assembled gold nanoparticle (GNP) sub-monolayer, the sol-gel nanoporous titanium dioxide (TiO2) film, and the layer-stacked molybdenum disulfide (MoS2) sheet. According to the experimental results, the plasmon resonance scattering bands for nanoplate clusters are identical with those for individual gold nanoplates, indicating that the gap between adjacent nanoplates is too large to allow plasmonic coupling between them. A different case was observed with the self-assembled GNP sub-monolayer in which the aggregated clusters with the internal plasmonic interaction show a considerable red-shift of the plasmon resonance band relative to the isolated single GNP. In addition, the protein adsorption on the nanoporous TiO2 film was observed to be inhomogeneous on the microscale, and the stepped boundaries of the MoS2 sheet were clearly observed. A quasi-linear dependence of the single-pixel light intensity on the step height was obtained by combining the HSDFM with atomic force microscopy. The minimum thickness detectable by the present HSDFM is 6.5 nm, corresponding to the 10-layer MoS2 film. The work demonstrated the outstanding applicability of the HSDFM for nanostructured film characterization.
- 21 April 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 9 (21) , 6815-6822
Facile fabrication of nanoporous gold films for surface plasmon resonance (SPR) sensing and SPR-based SERS
NPG films with controllable thickness and smaller pores are prepared by the sputtering-low-temperature dealloying process, and the spatial overlap of the SPP and the adsorbed analyte molecules offers the NPG film significant SERS enhancement.
- 21 April 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 9 (21) , 6815-6822
Facile fabrication of nanoporous gold films for surface plasmon resonance (SPR) sensing and SPR-based SERS
NPG films with controllable thickness and smaller pores are prepared by the sputtering-low-temperature dealloying process, and the spatial overlap of the SPP and the adsorbed analyte molecules offers the NPG film significant SERS enhancement.