Minseok Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Minseok Kim has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Jeong-Hwan Oh
4 shared publications- Sooseok Choi
Faculty of Applied Energy System, Jeju National University, Jeju 63243, Republic of Korea
4 shared publications Yong Hee Lee
3 shared publicationsSeung-Hyun Hong
2 shared publicationsTae-Hee Kim
2 shared publications- Tae-Hee Kim
Department of Chemical Engineering, Wonkwang University, Iksan 54538, Republic of Korea
2 shared publications
Latest Publications
- Open Access
- 21 October 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 500
Enhancing the combustion of silicon nanoparticles via plasma-assisted fluorocarbon surface modification
- 21 October 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 500
Open AccessEnhancing the combustion of silicon nanoparticles via plasma-assisted fluorocarbon surface modification
- 24 February 2023
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 11 (2) , 109578
Evaluation of thermal plasma-synthesized cobalt boride nanoparticles as efficient water-splitting catalysts
- 24 February 2023
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 11 (2) , 109578
Evaluation of thermal plasma-synthesized cobalt boride nanoparticles as efficient water-splitting catalysts
- 1 February 2022
- Published by Elsevier in Advanced Powder Technology
- Vol. 33 (2)
Facile synthesis of cubic boron nitride nanoparticles from amorphous boron by triple thermal plasma jets at atmospheric pressure
- 1 February 2022
- Published by Elsevier in Advanced Powder Technology
- Vol. 33 (2)
Facile synthesis of cubic boron nitride nanoparticles from amorphous boron by triple thermal plasma jets at atmospheric pressure
- 1 September 2020
- Published by Elsevier in Chemical Engineering Journal
- Vol. 395
Synthesis of boron nitride nanotubes using triple DC thermal plasma reactor with hydrogen injection
- 1 September 2020
- Published by Elsevier in Chemical Engineering Journal
- Vol. 395
Synthesis of boron nitride nanotubes using triple DC thermal plasma reactor with hydrogen injection
- 14 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 47 (7) , 3366-3373
Thermal Flow Characteristics of the Triple Plasma Torch System for Nanoparticle Synthesis
Triple dc plasma torch system was used for the synthesis of nanoparticles. Three thermal plasma jets are ejected from each plasma torch and they are merged into a strong single plasma plume. Since the feedstock is injected into the jet merging area, this system is suitable for refractory nanoparticle synthesis and enable to high production yield caused by the complete evaporation is possible. In this paper, numerical simulation was carried out to analyze thermal plasma characteristic inside a reactor according to the plasma-forming gas and carrier gas compositions: Ar, Ar-H₂, and Ar-N₂ plasma; Ar, He, and N₂ carrier gas. Then, it was comparatively interpreted with the actually synthesized nanoparticle in order to understand the condensation process of nanoparticles. It was revealed that the thermal environment is able to control readily in the triple torch system by the operating condition depending on the target materials.
- 14 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 47 (7) , 3366-3373
Thermal Flow Characteristics of the Triple Plasma Torch System for Nanoparticle Synthesis
Triple dc plasma torch system was used for the synthesis of nanoparticles. Three thermal plasma jets are ejected from each plasma torch and they are merged into a strong single plasma plume. Since the feedstock is injected into the jet merging area, this system is suitable for refractory nanoparticle synthesis and enable to high production yield caused by the complete evaporation is possible. In this paper, numerical simulation was carried out to analyze thermal plasma characteristic inside a reactor according to the plasma-forming gas and carrier gas compositions: Ar, Ar-H₂, and Ar-N₂ plasma; Ar, He, and N₂ carrier gas. Then, it was comparatively interpreted with the actually synthesized nanoparticle in order to understand the condensation process of nanoparticles. It was revealed that the thermal environment is able to control readily in the triple torch system by the operating condition depending on the target materials.
- Open Access
- 30 January 2018
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 1852
Sewable soft shields for the γ-ray radiation
Soft shields are required to protect the human body during a radioactive accident. However, the modulus of most soft shields, such as HDPE and epoxy, is high, thereby making it difficult to process them in wearable forms like gloves and clothes. We synthesized a soft shield based on a hydrogel that is very compliant, stretchable, and biocompatible. The shields were fabricated by integrating γ-ray-shield particles into hydrogels with an interpenetrating network. The soft shields containing 3.33 M of PbO2 exhibited a high attenuation coefficient (0.284 cm−1) and were stretched to 400% without a rupture. Furthermore, the fabricated soft shield can be sewn without a fabric support due to its high energy-dispersion ability. A wearable arm shield for the γ-ray radiation was demonstrated using a direct sewing of the soft-shield materials.
- 30 January 2018
- Published by Springer Nature in Scientific Reports
- Vol. 8 (1) , 1852
Open AccessSewable soft shields for the γ-ray radiation
Soft shields are required to protect the human body during a radioactive accident. However, the modulus of most soft shields, such as HDPE and epoxy, is high, thereby making it difficult to process them in wearable forms like gloves and clothes. We synthesized a soft shield based on a hydrogel that is very compliant, stretchable, and biocompatible. The shields were fabricated by integrating γ-ray-shield particles into hydrogels with an interpenetrating network. The soft shields containing 3.33 M of PbO2 exhibited a high attenuation coefficient (0.284 cm−1) and were stretched to 400% without a rupture. Furthermore, the fabricated soft shield can be sewn without a fabric support due to its high energy-dispersion ability. A wearable arm shield for the γ-ray radiation was demonstrated using a direct sewing of the soft-shield materials.