Abdollah Gholami
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abdollah Gholami has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Abbas Haghparast Ghomesheh
Department of Occupational Health and Safety, School of Public Health and Safety, Shahid Beheshti University of Medical Sciences, Tehran, Iran
1 shared publication - Abdoljalil Tazeroudi1 shared publication
- Behzad Fouladi Dehaghi
Professor, Dept. of Occupational Safety and Health Engineering, Faculty of Health, Ahvaz Jundishapur University of Medical Sciences, Ahvaz, Iran
1 shared publication - Davood Eskandari
Department of Occupational Health and Safety, School of Public Health and Safety, Shahid Beheshti University of Medical Sciences, Tehran, Iran
1 shared publication - Farnaz Jahani
Department of Medical Sciences, School of Medicine, Birjand University of Medical Sciences, Birjand, Iran
1 shared publication - Gholamheidar Teimori-Boghsani
Department of Occupational Health Engineering, School of Health, Torbat Heydariyeh University of Medical Sciences, Torbat Heydariyeh, Iran
1 shared publication
Latest Publications
- Open Access
- 1 January 2025
- Published by Wiley in The Scientific World Journal
- Vol. 2025 (1)
Development of a New Index to Assessing the Safety Culture Based on the Edgar Schein Model (Audit Approach)
Introduction: Over the past few decades, particularly following the Chernobyl incident, awareness of the importance of safety culture has increased significantly. Traditionally, safety culture has been assessed using questionnaires, with results often influenced by employees’ psychological states. Therefore, the present study evaluates safety culture through an audit‐based approach, employing performance indicators grounded in Edgar Schein’s model. Materials and Methods: To identify the key factors contributing to the safety culture index, Edgar Schein’s model was applied. Relevant indicators were derived across three levels: artifacts, espoused values, and basic assumptions. The fuzzy analytic hierarchy process (FAHP), combined with expert evaluations, was used to determine the relative importance of these criteria. Finally, the company’s safety culture index was quantitatively assessed using guide tables and the weighted contribution of each factor. Results: Then, 10 indicators were identified across the three levels of Schein’s model: quality of documentation and procedures, employee involvement, management of professional competence, change management, organizational learning, openness and communication, prioritization of safety, managerial knowledge, safety perspectives, and attitudes toward mistakes. According to the FAHP results, prioritization of safety had the highest weight (0.157), while quality of documentation and procedures had the lowest weight (0.026) in the safety culture index. Discussion: An audit‐based approach proves more effective than questionnaire methods for quantitatively assessing safety culture.
- 1 January 2025
- Published by Wiley in The Scientific World Journal
- Vol. 2025 (1)
Open AccessDevelopment of a New Index to Assessing the Safety Culture Based on the Edgar Schein Model (Audit Approach)
Introduction: Over the past few decades, particularly following the Chernobyl incident, awareness of the importance of safety culture has increased significantly. Traditionally, safety culture has been assessed using questionnaires, with results often influenced by employees’ psychological states. Therefore, the present study evaluates safety culture through an audit‐based approach, employing performance indicators grounded in Edgar Schein’s model. Materials and Methods: To identify the key factors contributing to the safety culture index, Edgar Schein’s model was applied. Relevant indicators were derived across three levels: artifacts, espoused values, and basic assumptions. The fuzzy analytic hierarchy process (FAHP), combined with expert evaluations, was used to determine the relative importance of these criteria. Finally, the company’s safety culture index was quantitatively assessed using guide tables and the weighted contribution of each factor. Results: Then, 10 indicators were identified across the three levels of Schein’s model: quality of documentation and procedures, employee involvement, management of professional competence, change management, organizational learning, openness and communication, prioritization of safety, managerial knowledge, safety perspectives, and attitudes toward mistakes. According to the FAHP results, prioritization of safety had the highest weight (0.157), while quality of documentation and procedures had the lowest weight (0.026) in the safety culture index. Discussion: An audit‐based approach proves more effective than questionnaire methods for quantitatively assessing safety culture.
- Open Access
An Investigation of Lead Concentration in the Breathing Air and the Blood of Automobile Welders in Birjand, Iran
Introduction: Lead is known as one of the most dangerous toxic metals in the world and its entry into the body can cause acute and chronic intoxication with a wide range of systemic symptoms. Our goal in the current research is to study the level of lead in the breathing zone and blood of the automobile welders in Birjand. Methods: A cross-sectional, descriptive-analytic study was conducted on 47 automobile welders. The criteria for entering the study included, male gender, having at least 1 year of experience in automobile welding, and at least 8 hours of daily employment in welding. The general information required was collected through a questionnaire. At the beginning of the study, in each working environment air samples were taken in accordance with NIOSH 7082 standards. The analysis of the air lead concentration (ALC) was carried out by a flame atomic absorption spectrophotometer. The blood lead concentration (BLC) was measured by NIOSH 8003 method via graphite furnace atomic absorption spectrophotometer. Results: Based on the data, 12.8% of the workers were smokers and 66% used appropriate personal protective equipment. The average ALC was 0.0458 ± 0.0296 mg/m 3 and the average BLC of automobile welders was 9.89 ± 7.32 μg/dL. Although Pearson correlation coefficient showed a positive correlation between ALCs and BLCs, this correlation was not statistically significant (p = 0.38, r = 0.18). Conclusion: The findings of this study showed that the average BLC in cigarette smokers and those who did not use PPE was higher than other people; besides, it was higher in individuals over the age of 30 than those under this age. The mean BLC in automobile welders and the mean ALC corresponded to the standards of the American Conference of Governmental Industrial Hygienists (ACGIH).
Open AccessAn Investigation of Lead Concentration in the Breathing Air and the Blood of Automobile Welders in Birjand, Iran
Introduction: Lead is known as one of the most dangerous toxic metals in the world and its entry into the body can cause acute and chronic intoxication with a wide range of systemic symptoms. Our goal in the current research is to study the level of lead in the breathing zone and blood of the automobile welders in Birjand. Methods: A cross-sectional, descriptive-analytic study was conducted on 47 automobile welders. The criteria for entering the study included, male gender, having at least 1 year of experience in automobile welding, and at least 8 hours of daily employment in welding. The general information required was collected through a questionnaire. At the beginning of the study, in each working environment air samples were taken in accordance with NIOSH 7082 standards. The analysis of the air lead concentration (ALC) was carried out by a flame atomic absorption spectrophotometer. The blood lead concentration (BLC) was measured by NIOSH 8003 method via graphite furnace atomic absorption spectrophotometer. Results: Based on the data, 12.8% of the workers were smokers and 66% used appropriate personal protective equipment. The average ALC was 0.0458 ± 0.0296 mg/m 3 and the average BLC of automobile welders was 9.89 ± 7.32 μg/dL. Although Pearson correlation coefficient showed a positive correlation between ALCs and BLCs, this correlation was not statistically significant (p = 0.38, r = 0.18). Conclusion: The findings of this study showed that the average BLC in cigarette smokers and those who did not use PPE was higher than other people; besides, it was higher in individuals over the age of 30 than those under this age. The mean BLC in automobile welders and the mean ALC corresponded to the standards of the American Conference of Governmental Industrial Hygienists (ACGIH).
- Open Access
- 30 July 2018
- Published by LLC Science and Innovations in Russian Open Medical Journal
- Vol. 7 (3) , e0306
Lung function and respiratory symptoms among mine workers in the Eastern part of Iran
Introduction In the mineral industry, there are various operations such as extraction of mineral materials, crushing, screening, loading etc., which result in the exposure of workers to high concentrations of inhalable particulates. Exposure to inhalable dust can endanger the safety and health of workers [1]. Silica is the most abundant element in the earth’s crust, which is a toxic substance to the human respiratory system [2].
- 30 July 2018
- Published by LLC Science and Innovations in Russian Open Medical Journal
- Vol. 7 (3) , e0306
Open AccessLung function and respiratory symptoms among mine workers in the Eastern part of Iran
Introduction In the mineral industry, there are various operations such as extraction of mineral materials, crushing, screening, loading etc., which result in the exposure of workers to high concentrations of inhalable particulates. Exposure to inhalable dust can endanger the safety and health of workers [1]. Silica is the most abundant element in the earth’s crust, which is a toxic substance to the human respiratory system [2].