Domenico Bonaccini Calia

The Ingot WFS represents an innovative and indispensable class of sensors conceived to overcome some limitations due to the LGSs geometry, which is significantly different from the point-object originated by a NGS. Here we overview the project, aiming at investigating the performance of an ELT-like telescope equipped with the Ingot WFS, facing different aspects of the program: the needs for numerical simulations and laboratory experiments, the prototype and, finally the future plan for the verification on sky.

SPIE Digital Library Proceedings

SPIE Digital Library Proceedings

Laser Guide Star Adaptive Optics (LGS-AO) is becoming routine in several astronomical observatories. The use of powerful lasers generates sensible Raman emissions on the uplink laser beam path, plus secondary Rayleigh scattering from atmospheric molecules and Mie scattering from aerosols. This paper reports the results of a campaign done with the 10.4m Gran Telescopio CANARIAS (GTC); this campaign was undertaken to assess the spectral and photometric contamination coming from a 589 nm laser uplink beam scattering and Raman emission induced on the GTC spectro-imager OSIRIS by laser launched about 1 km off-axis. The photometric contamination is due to primary and secondary scattering of the uplink photons, as well by the Raman inelastic scattering. We have propagated the laser beam creating a mesospheric LGS, then pointed and focused the GTC telescope toward the uplink laser beam, at different heights and up to the LGS, taking into account the observing geometry. In our observations, the Raman emissions for O2 and N2 vibrational lines are visible at 20 km, weakening with altitude and becoming undetectable above 30 km. The scattering of the focused uplink beam is detectable at less than +/-0.2 arcmin from the center of the beam, while for the focused LGS the scattering is narrower, being detectable at less than +/-0.1 arcmin around the plume. Recommendations for Laser Traffic Control Systems (LTCS) are given accordingly.

We numerically study a method to increase the photon return flux of continuous-wave laser guide stars using one-dimensional atomic cooling principles. The method relies on chirping the laser towards higher frequencies following the change in velocity of sodium atoms due to recoil, which raises atomic populations available for laser excitation within the Doppler distribution. The efficiency of this effect grows with the average number of atomic excitations between two atomic collisions in the mesosphere. We find the parameters for maximizing the return flux and evaluate the performance of chirping for operation at La Palma. According to our simulations, the optimal chirp rate lies between 0.8 − 1.0 M H z / µ s , and an increase in the fluorescence of the sodium guide star up to 60% can be achieved with current 20-W-class guide star lasers.

The performance of adaptive optics systems employing sodium laser guide stars can be improved by continuously monitoring the vertical density structure of mesospheric sodium along the line of sight. We demonstrate that sodium density profiles can be retrieved by amplitude modulation of continuous wave (CW) lasers. In an experiment conducted at the Large Zenith Telescope (LZT), ESO’s Wendelstein Raman-fibre laser was amplitude-modulated with a pseudo-random binary sequence and profiles were obtained by cross-correlation of the modulation pattern with the observed return signal from the laser guide star. For comparison, high-resolution profiles were obtained simultaneously using the lidar system of the LZT. The profiles obtained by the two techniques show noise contamination, but were found to agree to within the measurement error. As a further check, a comparison was also made between several lidar profiles and those obtained by simultaneous observations using a remote telescope to image the laser plume from the side. The modulated CW lidar technique could be implemented by diverting a small fraction of the returned laser light to a photon counting detector. Theoretical analysis and numerical simulations indicate that, for 50 per cent modulation strength, the sodium centroid altitude could be retrieved every 5 s from a single laser guide star, with an accuracy which would induce a corresponding wavefront error of 50 nm for the Extremely Large Telescope and less than 30 nm for the Thirty Meter Telescope and Giant Magellan Telescope. If multiple laser guide stars are employed, the required modulation amplitude will be smaller.

The first observations of laser guide-star photons that are Raman-scattered by air molecules above the Very Large Telescope (VLT) were reported in June 2017. The initial detection came from the Multi-Unit Spectroscopic Explorer (MUSE) optical integral field spectrograph, following the installation of the 4 Laser Guide Star Facility (4LGSF) on Unit Telescope 4 (UT4) of the VLT. In this Letter, we delve further into the symbiotic relationship between the 4LGSF laser guide-star system, the UT4 telescope, and MUSE by monitoring the spectral contamination of MUSE observations by Raman photons over a 27-month period. This dataset reveals that dust particles deposited on the primary and tertiary mirrors of UT4, which are responsible for a reflectivity loss of ∼8% at 6000 Å, contribute (60 ± 5)% to the laser line fluxes detected by MUSE. The flux of Raman lines, which contaminates scientific observations that are acquired with optical spectrographs, thus provides a new, non-invasive means to monitor the evolving scatter properties of the mirrors of astronomical telescopes that are equipped with laser guide-star systems.