Huawei Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Huawei Li has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
Hong Hao
7 shared publications- Wensu Chen
Centre for Infrastructural Monitoring and Protection, School of Civil and Mechanical Engineering, Curtin University, Kent Street, Bentley, WA 6102, Australia
5 shared publications - Duong Tran-Thanh
Curtin University , Bentley
2 shared publications Thong M. Pham
2 shared publications- Bin Li
Qilu University of Technology (Shandong Academy of Sciences)
1 shared publication Boxiang Yan
State Key Laboratory of Silicate Engineering Center, Wuhan University of Technology, Wuhan, China
1 shared publication
Latest Publications
- 19 August 2026
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 219
Counterintuitive phenomenon in impact dynamics: peak reaction force exceeds the applied peak impact force
- 19 August 2026
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 219
Counterintuitive phenomenon in impact dynamics: peak reaction force exceeds the applied peak impact force
- Open Access
- 6 August 2026
- Published by Elsevier in SSRN Electronic Journal
Counterintuitive Phenomenon in Impact Dynamics: Peak Reaction Force Exceeds the Applied Peak Impact Force
This study investigates a counterintuitive phenomenon in structural impact, i.e., the peak reaction force exceeds the peak impact force. While the other three counterintuitive phenomena have been collectively documented and studied, this fourth phenomenon was experimentally observed and has not yet been systematically investigated. Through a combination of experiments, finite element simulations and analytical derivation, this study demonstrates that the phenomenon is real, measurable, and governed by structural dynamics rather than measurement error. The analytical solution shows that the reaction force is primarily influenced by the ratio between the applied impact load duration (td) and the structural fundamental vibration period (T1). For an idealised simply supported linear elastic beam subjected to a linearly decaying triangular pulse, the first-mode solution suggests that the peak reaction exceeds the peak impact force when the td/T1 ratio is greater than a critical threshold of 0.271, and that the maximum amplification under idealised conditions approaches approximately 2.55. Parametric studies further confirm that the amplification factor, namely the ratio of peak reaction force to peak impact force, is influenced by not only by td/T1, but also by structural stiffness, contact-induced pulse characteristics, impact velocity, and impactor mass. This phenomenon occurs only within specific dynamic conditions and is not universal. These findings provide a clear physical explanation of reaction force amplification and highlight the need to consider dynamic interaction effects in the impact assessment and design of structural systems.
- 6 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessCounterintuitive Phenomenon in Impact Dynamics: Peak Reaction Force Exceeds the Applied Peak Impact Force
This study investigates a counterintuitive phenomenon in structural impact, i.e., the peak reaction force exceeds the peak impact force. While the other three counterintuitive phenomena have been collectively documented and studied, this fourth phenomenon was experimentally observed and has not yet been systematically investigated. Through a combination of experiments, finite element simulations and analytical derivation, this study demonstrates that the phenomenon is real, measurable, and governed by structural dynamics rather than measurement error. The analytical solution shows that the reaction force is primarily influenced by the ratio between the applied impact load duration (td) and the structural fundamental vibration period (T1). For an idealised simply supported linear elastic beam subjected to a linearly decaying triangular pulse, the first-mode solution suggests that the peak reaction exceeds the peak impact force when the td/T1 ratio is greater than a critical threshold of 0.271, and that the maximum amplification under idealised conditions approaches approximately 2.55. Parametric studies further confirm that the amplification factor, namely the ratio of peak reaction force to peak impact force, is influenced by not only by td/T1, but also by structural stiffness, contact-induced pulse characteristics, impact velocity, and impactor mass. This phenomenon occurs only within specific dynamic conditions and is not universal. These findings provide a clear physical explanation of reaction force amplification and highlight the need to consider dynamic interaction effects in the impact assessment and design of structural systems.
- 8 November 2025
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 209
Impact force frequency characteristics and their influence on damage modes of reinforced concrete beams
- 8 November 2025
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 209
Impact force frequency characteristics and their influence on damage modes of reinforced concrete beams
- 19 August 2025
- Published by Elsevier in Structures
- Vol. 80
Numerical analysis and prediction of post-impact fire resistance of square-cased square steel tube-reinforced concrete columns
- 19 August 2025
- Published by Elsevier in Structures
- Vol. 80
Numerical analysis and prediction of post-impact fire resistance of square-cased square steel tube-reinforced concrete columns
- 11 May 2025
- Published by SAGE Publications in International Journal of Protective Structures
- Vol. 17 (1) , 219-241
Impact resistance performance of seismic induced pre-damage G-UHPC beams
Engineering structures may be subjected to couple effects of multiple loads under extreme conditions. As a green and high performance concrete, using geopolymer based ultra-high performance concrete (G-UHPC) would reduce CO 2 emissions and improve engineering structure’s safety under extreme conditions. This study investigated the static and pseudo-static behaviors of G-UHPC beams, with a primary focus on the impact resistance characteristics of seismic induced pre-damaged G-UHPC beams. The results indicated that G-UHPC beams pre-damage by 130 kN and below exhibit similar effects on the impact performance, whereas pre-damage by 160 kN has a more significant impact on the impact performance of G-UHPC beams and even change their failure mode. G-UHPC beams with varying levels of pre-damage due to cyclic loading exhibit similar deflection recovery under identical impact loading conditions. With increasing levels of pre-damage from cyclic loading, G-UHPC beams exhibited a slightly stronger energy absorption effect. Finally, an empirical formula has been established to predict the residual deflection of seismic induced pre-damaged G-UHPC beams subjected to impact loading, which exhibits good agreement with experimental data.
- 11 May 2025
- Published by SAGE Publications in International Journal of Protective Structures
- Vol. 17 (1) , 219-241
Impact resistance performance of seismic induced pre-damage G-UHPC beams
Engineering structures may be subjected to couple effects of multiple loads under extreme conditions. As a green and high performance concrete, using geopolymer based ultra-high performance concrete (G-UHPC) would reduce CO 2 emissions and improve engineering structure’s safety under extreme conditions. This study investigated the static and pseudo-static behaviors of G-UHPC beams, with a primary focus on the impact resistance characteristics of seismic induced pre-damaged G-UHPC beams. The results indicated that G-UHPC beams pre-damage by 130 kN and below exhibit similar effects on the impact performance, whereas pre-damage by 160 kN has a more significant impact on the impact performance of G-UHPC beams and even change their failure mode. G-UHPC beams with varying levels of pre-damage due to cyclic loading exhibit similar deflection recovery under identical impact loading conditions. With increasing levels of pre-damage from cyclic loading, G-UHPC beams exhibited a slightly stronger energy absorption effect. Finally, an empirical formula has been established to predict the residual deflection of seismic induced pre-damaged G-UHPC beams subjected to impact loading, which exhibits good agreement with experimental data.
- 23 May 2022
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 167
Influence of various impact scenarios on the dynamic performance of concrete beam-column joints
- 23 May 2022
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 167
Influence of various impact scenarios on the dynamic performance of concrete beam-column joints
- 15 February 2022
- Published by SPIE-Intl Soc Optical Eng
- p. 208
Ship-carried short-wave-infrared imager with intelligent identification of marine vessels
SPIE Digital Library Proceedings
- 15 February 2022
- Published by SPIE-Intl Soc Optical Eng
- p. 208
Ship-carried short-wave-infrared imager with intelligent identification of marine vessels
SPIE Digital Library Proceedings
- 30 June 2020
- Published by Springer Nature in Journal of Wuhan University of Technology-Mater. Sci. Ed.
- Vol. 35 (3) , 605-610
Hot Mixing Behavior and Curing Process of Epoxy Asphalt
- 30 June 2020
- Published by Springer Nature in Journal of Wuhan University of Technology-Mater. Sci. Ed.
- Vol. 35 (3) , 605-610
Hot Mixing Behavior and Curing Process of Epoxy Asphalt
- 4 September 2019
- Published by Springer Nature
- p. 557-568
Numerical Study of Precast Concrete Beam Under Impact Loads
- 4 September 2019
- Published by Springer Nature
- p. 557-568
Numerical Study of Precast Concrete Beam Under Impact Loads
- Top Cited Papers
- 1 September 2019
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 131, 222-237
Influence of drop weight geometry and interlayer on impact behavior of RC beams
- 1 September 2019
- Published by Elsevier in International Journal of Impact Engineering
- Vol. 131, 222-237
Top Cited PapersInfluence of drop weight geometry and interlayer on impact behavior of RC beams