Luke Berny Beardslee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Luke Berny Beardslee has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Ii Timothy Ulrich
Los Alamos National Laboratory (LANL), Los Alamos, NM (United States)
7 shared publications - Marcel Remillieux
Geophys., Los Alamos National Lab., Los Alamos, NM
5 shared publications - Paul Richmond Geimer
Los Alamos National Laboratory (LANL), Los Alamos, NM (United States)
4 shared publications - Andrew A. Delorey
Los Alamos National Laboratory
2 shared publications - Carly M. Donahue
Los Alamos National Laboratory
2 shared publications - Andrew L. Jensen
Stanford University
1 shared publication
Latest Publications
- 20 February 2025
- Published by Seismological Society of America (SSA) in Seismological Research Letters
- Vol. 96 (5) , 2733-2741
Detection of a Space Capsule Entering Earth’s Atmosphere with Distributed Acoustic Sensing (DAS)
On 24 September 2023, the Origins, Spectral Interpretation, Resource Identification, and Security-Regolith Explorer sample return capsule (SRC) entered Earth’s atmosphere after successfully collecting samples from an asteroid. The known trajectory and timing of this return provided a rare opportunity to strategically instrument sites to record geophysical signals produced by the capsule because it travelled at hypersonic speeds through the atmosphere. We deployed two distributed acoustic sensing (DAS) interrogators to sample over 12 km of surface-draped fiber-optic cables, as well as six collocated seismometer-infrasound sensor pairs, spread across two sites near Eureka, Nevada. This campaign-style rapid deployment is the first reported recording of an SRC re-entry with any distributed fiber-optic sensing technology. The DAS interrogators recorded an impulsive arrival with an extended coda which had features that were similar to recordings from both the seismometers and infrasound sensors. While the signal-to-noise ratio of the DAS data was lower than the seismic-infrasound data, the extremely dense spacing of fiber-optic sensors allowed for more phases to be clearly distinguished and the visualization of the continuous transformation of the wavefront as it impacted the ground. Unexpectedly, the DAS recordings contain less low-frequency content than is present in both the seismic and infrasound data. The deployment conditions strongly affected the recorded DAS data; in particular, we observed that fiber selection and placement exert strong controls on data quality.
- 20 February 2025
- Published by Seismological Society of America (SSA) in Seismological Research Letters
- Vol. 96 (5) , 2733-2741
Detection of a Space Capsule Entering Earth’s Atmosphere with Distributed Acoustic Sensing (DAS)
On 24 September 2023, the Origins, Spectral Interpretation, Resource Identification, and Security-Regolith Explorer sample return capsule (SRC) entered Earth’s atmosphere after successfully collecting samples from an asteroid. The known trajectory and timing of this return provided a rare opportunity to strategically instrument sites to record geophysical signals produced by the capsule because it travelled at hypersonic speeds through the atmosphere. We deployed two distributed acoustic sensing (DAS) interrogators to sample over 12 km of surface-draped fiber-optic cables, as well as six collocated seismometer-infrasound sensor pairs, spread across two sites near Eureka, Nevada. This campaign-style rapid deployment is the first reported recording of an SRC re-entry with any distributed fiber-optic sensing technology. The DAS interrogators recorded an impulsive arrival with an extended coda which had features that were similar to recordings from both the seismometers and infrasound sensors. While the signal-to-noise ratio of the DAS data was lower than the seismic-infrasound data, the extremely dense spacing of fiber-optic sensors allowed for more phases to be clearly distinguished and the visualization of the continuous transformation of the wavefront as it impacted the ground. Unexpectedly, the DAS recordings contain less low-frequency content than is present in both the seismic and infrasound data. The deployment conditions strongly affected the recorded DAS data; in particular, we observed that fiber selection and placement exert strong controls on data quality.
- 17 October 2024
- Published by Springer Nature
- p. 97-107
Identification of Bird Species in Large Multi-channel Data Streams Using Distributed Acoustic Sensing
- 17 October 2024
- Published by Springer Nature
- p. 97-107
Identification of Bird Species in Large Multi-channel Data Streams Using Distributed Acoustic Sensing
- Open Access
- 24 November 2023
- Published by Elsevier in NDT & E International
- Vol. 141
Optimal measurement point selection for resonant ultrasound spectroscopy of complex-shaped specimens using principal component analysis
- 24 November 2023
- Published by Elsevier in NDT & E International
- Vol. 141
Open AccessOptimal measurement point selection for resonant ultrasound spectroscopy of complex-shaped specimens using principal component analysis
- Open Access
- 26 June 2023
- Published by Office of Scientific and Technical Information (OSTI)
Demonstration of acoustic monitoring for structural health of microreactors: Through use of neural networks and resonant ultrasound spectroscopy
The U.S. Department of Energy's Office of Scientific and Technical Information
- 26 June 2023
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessDemonstration of acoustic monitoring for structural health of microreactors: Through use of neural networks and resonant ultrasound spectroscopy
The U.S. Department of Energy's Office of Scientific and Technical Information
- Open Access
- 8 March 2023
- Published by Office of Scientific and Technical Information (OSTI)
Instrumentation and Sensors: Acoustics [Slides]
The U.S. Department of Energy's Office of Scientific and Technical Information
- 8 March 2023
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessInstrumentation and Sensors: Acoustics [Slides]
The U.S. Department of Energy's Office of Scientific and Technical Information
- 21 October 2022
- Published by Office of Scientific and Technical Information (OSTI)
Embedded acoustic sensing and monitoring techniques for small modular reactors
The U.S. Department of Energy's Office of Scientific and Technical Information
- 21 October 2022
- Published by Office of Scientific and Technical Information (OSTI)
Embedded acoustic sensing and monitoring techniques for small modular reactors
The U.S. Department of Energy's Office of Scientific and Technical Information
- Open Access
- 1 June 2022
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 151 (6) , 3633-3640
Finite-element-based resonant ultrasound spectroscopy for measurement of multi-material samples
Understanding the elastic properties of materials is critical for their safe incorporation and predictable performance. Current methods of bulk elastic characterization often have notable limitations for in situ structural applications, with usage restricted to simple geometries and material distributions. To address these existing issues, this study sought to expand the capabilities of resonant ultrasound spectroscopy (RUS), an established nondestructive evaluation method, to include the characterization of isotropic multi-material samples. In this work, finite-element-based RUS analysis consisted of numerical simulations and experimental testing of composite samples comprised of material pairs with varying elasticity and density contrasts. Utilizing genetic algorithm inversion and mode matching, our results demonstrate that elastic properties of multi-material samples can be reliably identified within several percent of known or nominal values using a minimum number of identified resonance modes, given sample mass is held consistent. The accurate recovery of material properties for composite samples of varying material similarity and geometry expands the pool of viable samples for RUS and advances the method towards in situ inspection and evaluation.
- 1 June 2022
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 151 (6) , 3633-3640
Open AccessFinite-element-based resonant ultrasound spectroscopy for measurement of multi-material samples
Understanding the elastic properties of materials is critical for their safe incorporation and predictable performance. Current methods of bulk elastic characterization often have notable limitations for in situ structural applications, with usage restricted to simple geometries and material distributions. To address these existing issues, this study sought to expand the capabilities of resonant ultrasound spectroscopy (RUS), an established nondestructive evaluation method, to include the characterization of isotropic multi-material samples. In this work, finite-element-based RUS analysis consisted of numerical simulations and experimental testing of composite samples comprised of material pairs with varying elasticity and density contrasts. Utilizing genetic algorithm inversion and mode matching, our results demonstrate that elastic properties of multi-material samples can be reliably identified within several percent of known or nominal values using a minimum number of identified resonance modes, given sample mass is held consistent. The accurate recovery of material properties for composite samples of varying material similarity and geometry expands the pool of viable samples for RUS and advances the method towards in situ inspection and evaluation.
- 1 October 2021
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 150 (4_Suppleme) , A40
Enhanced resonant ultrasound spectroscopy for multi-material characterization
Resonant ultrasound spectroscopy (RUS) is a non-destructive technique to describe the elastic tensor of a material through inversion of a sample’s measured resonance frequencies. The original RUS approach is limited to simple geometries as it uses a semi-analytical method to simulate the vibrational response. We modified this approach by combining the finite-element method with genetic algorithm. The new approach is applicable to systems with composite materials, complex geometries, and misaligned material and geometry axes. We present recent work focused on the response of a graphite-TZM composite system. We find composite material properties only vary a few percent from results from single-material RUS. Results from varied geometries and materials suggest further optimizations to enhanced RUS.
- 1 October 2021
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 150 (4_Suppleme) , A40
Enhanced resonant ultrasound spectroscopy for multi-material characterization
Resonant ultrasound spectroscopy (RUS) is a non-destructive technique to describe the elastic tensor of a material through inversion of a sample’s measured resonance frequencies. The original RUS approach is limited to simple geometries as it uses a semi-analytical method to simulate the vibrational response. We modified this approach by combining the finite-element method with genetic algorithm. The new approach is applicable to systems with composite materials, complex geometries, and misaligned material and geometry axes. We present recent work focused on the response of a graphite-TZM composite system. We find composite material properties only vary a few percent from results from single-material RUS. Results from varied geometries and materials suggest further optimizations to enhanced RUS.
- 1 October 2021
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 150 (4_Suppleme) , A39
Detection and imaging of stress-corrosion cracking in stainless steel using the linear elastodynamics gradient imaging technique
Linear Elastodynamics Gradient Imaging Technique (LEGIT) is a nondestructive testing technique recently developed to image cracks on the surface of samples. This technique is based on the interaction of an acoustic wave with a crack and the resulting discontinuity in the acoustic wave field such an interaction generates. LEGIT is used to image stress-corrosion cracks in two samples of 304 stainless steel. The first sample is relatively small (50 × 25 × 1.4 mm3) with two mm-size cracks. For this sample, the acoustic source is glued to the sample. The second sample is much larger (180 × 76 × 25.4 mm3), has a curvature, a weld, and multiple cracks running parallel to and across the weld. The imaging of the cracks for this more complex sample is achieved without contact by partial immersion using an underwater acoustic transducer. Imaging data obtained from LEGIT in the two experiments show excellent agreement with a vibro-thermography.
- 1 October 2021
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 150 (4_Suppleme) , A39
Detection and imaging of stress-corrosion cracking in stainless steel using the linear elastodynamics gradient imaging technique
Linear Elastodynamics Gradient Imaging Technique (LEGIT) is a nondestructive testing technique recently developed to image cracks on the surface of samples. This technique is based on the interaction of an acoustic wave with a crack and the resulting discontinuity in the acoustic wave field such an interaction generates. LEGIT is used to image stress-corrosion cracks in two samples of 304 stainless steel. The first sample is relatively small (50 × 25 × 1.4 mm3) with two mm-size cracks. For this sample, the acoustic source is glued to the sample. The second sample is much larger (180 × 76 × 25.4 mm3), has a curvature, a weld, and multiple cracks running parallel to and across the weld. The imaging of the cracks for this more complex sample is achieved without contact by partial immersion using an underwater acoustic transducer. Imaging data obtained from LEGIT in the two experiments show excellent agreement with a vibro-thermography.
- 24 March 2021
- Published by Office of Scientific and Technical Information (OSTI)
Physical Acoustics Characterization For Inspection and Evaluation
The U.S. Department of Energy's Office of Scientific and Technical Information
- 24 March 2021
- Published by Office of Scientific and Technical Information (OSTI)
Physical Acoustics Characterization For Inspection and Evaluation
The U.S. Department of Energy's Office of Scientific and Technical Information