Ilda Olivia Santos Mendoza
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ilda Olivia Santos Mendoza has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Arina Nadeina
Laboratoire de Réactivité et Chimie des Solides (LRCS) CNRS UMR 7314 Université de Picardie Jules Verne 33 Rue Saint Leu Amiens Cedex 80039 France
1 shared publication - Carlos Omar Castillo-Araiza
Laboratory of Catalytic Reactor Engineering Applied to Chemical and Biological Systems (LCRE), Departamento de Ingeniería de Procesos e Hidráulica Universidad Autónoma Metropolitana‐Iztapalapa Ciudad de México Mexico
1 shared publication - Dennis Becker
Inorganic Solid State Chemistry, Saarland University, D-66123, Saarbrücken, Germany
1 shared publication G. Ramos-Sánchez
1 shared publicationHector López-Arjona
Universidad del Papaloapan
1 shared publicationI. González
1 shared publication
Latest Publications
- 25 October 2022
- Published by Elsevier in Journal of Power Sources
- Vol. 553
Operando X-ray diffraction in transmission geometry « at home » from tape casted electrodes to all-solid-state battery
- 25 October 2022
- Published by Elsevier in Journal of Power Sources
- Vol. 553
Operando X-ray diffraction in transmission geometry « at home » from tape casted electrodes to all-solid-state battery
- 5 October 2018
- Published by Walter de Gruyter GmbH in International Journal of Chemical Reactor Engineering
- Vol. 17 (6)
Revisiting Electrochemical Techniques to Characterize the Solid-State Diffusion Mechanism in Lithium-Ion Batteries
Lithium-ion batteries (LiBs) have gained a worldwide position as energy storage devices due to their high energy density, power density and cycle life. Nevertheless, these performance parameters are yet insufficient for current and future demands diversifying their range of applications, and competitiveness against other power sources. In line with the materials science, the optimization of LiBs, first, requires an in-depth characterization and understanding of their determining steps regarding transport phenomena and electrode kinetics occurring within these devices. Experimental and theoretical studies have identified the solid-state diffusion of Li+into the composite cathode material as one of the transport mechanisms limiting the performance of LiBs, in particular at high charge and discharge rates (C-rates). Nowadays, there is however ambivalence to characterize this mass transport mechanism using the diffusion coefficient calculated either by electrochemical techniques orab initioquantum chemistry methods. This contribution revisits conventional electrochemical methodologies employed in literature to estimate mass transport diffusivity of LiBs, in particular using LiFePO4in the cathode, and their suitability and reliability are comprehensively discussed. These experimental and theoretical methods include Galvanostatic and Potentiostatic Intermittent Titration Technique (GITT and PITT), Electrochemical Impedance Spectroscopy (EIS), Cyclic Voltammetry (CV) andab initioquantum chemistry methods. On the one hand, experimental methods seem not to isolate the diffusion mechanism in the solid phase; thus, obtaining an unreliable apparent diffusion coefficient (ranging from 10–10to 10–16 cm2 s−1), which only serves as a criterion to discard among a set of LiBs. On the other hand, atomistic approaches based onab initio, density functional theory (DFT), cannot yet capture the complexity of the local environments involved at this scale; in consequence, these approaches have predicted inadequate diffusion coefficients for LiFePO4(ranging from 10–6to 10–7 cm2 s−1) which strongly differ from experimental values. This contribution, at long last, remarks the factors influencing diffusion mechanisms and addresses the uncertainties to characterize this transport mechanism in the cathode, stressing the needs to establish methods to determine the diffusion coefficient accurately, coupling electrochemical techniques,ab initiomethods, and engineering approaches based on modeling.
- 5 October 2018
- Published by Walter de Gruyter GmbH in International Journal of Chemical Reactor Engineering
- Vol. 17 (6)
Revisiting Electrochemical Techniques to Characterize the Solid-State Diffusion Mechanism in Lithium-Ion Batteries
Lithium-ion batteries (LiBs) have gained a worldwide position as energy storage devices due to their high energy density, power density and cycle life. Nevertheless, these performance parameters are yet insufficient for current and future demands diversifying their range of applications, and competitiveness against other power sources. In line with the materials science, the optimization of LiBs, first, requires an in-depth characterization and understanding of their determining steps regarding transport phenomena and electrode kinetics occurring within these devices. Experimental and theoretical studies have identified the solid-state diffusion of Li+into the composite cathode material as one of the transport mechanisms limiting the performance of LiBs, in particular at high charge and discharge rates (C-rates). Nowadays, there is however ambivalence to characterize this mass transport mechanism using the diffusion coefficient calculated either by electrochemical techniques orab initioquantum chemistry methods. This contribution revisits conventional electrochemical methodologies employed in literature to estimate mass transport diffusivity of LiBs, in particular using LiFePO4in the cathode, and their suitability and reliability are comprehensively discussed. These experimental and theoretical methods include Galvanostatic and Potentiostatic Intermittent Titration Technique (GITT and PITT), Electrochemical Impedance Spectroscopy (EIS), Cyclic Voltammetry (CV) andab initioquantum chemistry methods. On the one hand, experimental methods seem not to isolate the diffusion mechanism in the solid phase; thus, obtaining an unreliable apparent diffusion coefficient (ranging from 10–10to 10–16 cm2 s−1), which only serves as a criterion to discard among a set of LiBs. On the other hand, atomistic approaches based onab initio, density functional theory (DFT), cannot yet capture the complexity of the local environments involved at this scale; in consequence, these approaches have predicted inadequate diffusion coefficients for LiFePO4(ranging from 10–6to 10–7 cm2 s−1) which strongly differ from experimental values. This contribution, at long last, remarks the factors influencing diffusion mechanisms and addresses the uncertainties to characterize this transport mechanism in the cathode, stressing the needs to establish methods to determine the diffusion coefficient accurately, coupling electrochemical techniques,ab initiomethods, and engineering approaches based on modeling.
- 29 November 2011
- Published by The Electrochemical Society in ECS Transactions
- Vol. 36 (1) , 503-510
Simulation and Modelling of Atratone Herbicide Extraction at the Immiscible Liquid System Using an Electrochemical Reactor
In the present work a modeling and mathematical simulation of the atratone herbicide extraction at the immiscible electrolyte solutions system was studied. As subject of study, it was considered a biphasic electrochemical reactor (water/organic solvent) with constant concentration of atratone in the water input flow during the extraction process. Using the experimental data obtained by cyclic voltammetry at the interface of two immiscible electrolyte solutions, such as transfer formal potential (Δ a o' φ o i) and the coefficient diffusion, this latter parameter was evaluated for the herbicide in both phases. Then a mathematical model was developed to describe the concentration profiles for this compound near the interface (aqueous and organic) and the total transfer across the interface. The suggested model is able to describe the transport behaviour of the herbicide across the interface and the optimums operation parameters were fixed in the model system allowing the extraction of the compound from water to organic phase.
- 29 November 2011
- Published by The Electrochemical Society in ECS Transactions
- Vol. 36 (1) , 503-510
Simulation and Modelling of Atratone Herbicide Extraction at the Immiscible Liquid System Using an Electrochemical Reactor
In the present work a modeling and mathematical simulation of the atratone herbicide extraction at the immiscible electrolyte solutions system was studied. As subject of study, it was considered a biphasic electrochemical reactor (water/organic solvent) with constant concentration of atratone in the water input flow during the extraction process. Using the experimental data obtained by cyclic voltammetry at the interface of two immiscible electrolyte solutions, such as transfer formal potential (Δ a o' φ o i) and the coefficient diffusion, this latter parameter was evaluated for the herbicide in both phases. Then a mathematical model was developed to describe the concentration profiles for this compound near the interface (aqueous and organic) and the total transfer across the interface. The suggested model is able to describe the transport behaviour of the herbicide across the interface and the optimums operation parameters were fixed in the model system allowing the extraction of the compound from water to organic phase.