Carlos Hernandez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Carlos Hernandez has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
Allen Robinson
Carnegie Mellon University
1 shared publicationArden Pope
Brigham Young University
1 shared publicationB. Lefer
B Department of Earth and Atmospheric Sciences , University of Houston , Houston , TX , USA
1 shared publication- Basak Karakurt Cevik
Faculty of Engineering, Energy Systems Engineering Department, Yalova University, Yalova, Türkiye
1 shared publication Brian Dinkelacker
Carnegie Mellon University
1 shared publication- Brian Dinkelacker
Department of Chemical Engineering, Carnegie Mellon University, Pittsburgh, PA 15213, USA
1 shared publication
Latest Publications
- Open Access
- 28 July 2026
- Published by Elsevier in SSRN Electronic Journal
An Evaluation of Reduced-Complexity Models of Air Quality Over Historical, Policy-Relevant PM2.5 Concentration Changes
Chronic exposure to fine particulate matter (PM2.5) has been linked to increased mortality rates. Chemical transport models (CTMs) are often used to evaluate PM2.5 regulations in the United States, but are computationally expensive and require significant technical expertise. Reduced-complexity models (RCMs) for PM2.5 are computationally-efficient air quality models designed to estimate ambient PM2.5 concentrations attributable to emissions of PM2.5 and PM2.5-precursors. We evaluate the ability of three widely-used RCMs (AP3, EASIUR, and InMAP) to reproduce changes in PM2.5 concentrations during 1990-2010. Compared to changes in observed, speciated PM2.5 concentrations, RCMs demonstrated strong correlation (R=0.61–0.66) and low mean error (0.84–1.03 μg m-3), performing comparably to a CTM (R=0.72, error=0.74 μg m-3). Most RCM applications assume that concentrations respond linearly to emissions; over the 20-year period investigated, during which most PM2.5 precursor emissions declined ~37–65%, we find only modest evidence of nonlinearities. These findings support the use of RCMs for many policy analysis and other applications for which the slight loss of accuracy compared to CTMs is tolerable, especially given RCM benefits. Common benefits of RCMs include increased computational efficiency and accessibility of air pollution modeling.
- 28 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessAn Evaluation of Reduced-Complexity Models of Air Quality Over Historical, Policy-Relevant PM2.5 Concentration Changes
Chronic exposure to fine particulate matter (PM2.5) has been linked to increased mortality rates. Chemical transport models (CTMs) are often used to evaluate PM2.5 regulations in the United States, but are computationally expensive and require significant technical expertise. Reduced-complexity models (RCMs) for PM2.5 are computationally-efficient air quality models designed to estimate ambient PM2.5 concentrations attributable to emissions of PM2.5 and PM2.5-precursors. We evaluate the ability of three widely-used RCMs (AP3, EASIUR, and InMAP) to reproduce changes in PM2.5 concentrations during 1990-2010. Compared to changes in observed, speciated PM2.5 concentrations, RCMs demonstrated strong correlation (R=0.61–0.66) and low mean error (0.84–1.03 μg m-3), performing comparably to a CTM (R=0.72, error=0.74 μg m-3). Most RCM applications assume that concentrations respond linearly to emissions; over the 20-year period investigated, during which most PM2.5 precursor emissions declined ~37–65%, we find only modest evidence of nonlinearities. These findings support the use of RCMs for many policy analysis and other applications for which the slight loss of accuracy compared to CTMs is tolerable, especially given RCM benefits. Common benefits of RCMs include increased computational efficiency and accessibility of air pollution modeling.
- Open Access
- 1 September 2021
- Published by Cambridge University Press (CUP) in ChemRxiv
Bias corrections for speciated and source-resolved PM2.5 chemical transport model simulations using a geographically weighted regression
The ability to provide speciated and source-resolved PM2.5 estimates make chemical transport models a potentially valuable tool for exposure assessments. However, epidemiological studies often require unbiased estimates, which can be challenging for chemical transport models. We use geographically weighted regression to predict and correct the bias in source-resolved PM2.5 species (elemental carbon, organic aerosol, ammonium, nitrate, and sulfate) across the continental U.S. for 2001 and 2010. The regression models are trained using speciated ground-level monitors from the CSN and IMPROVE networks. A 10-fold cross-validation shows minimal bias across all simulated PM2.5 species (0 – 3%) and improved agreement with ground-level monitors (R2 = 0.53 – 0.97). Corrections also improve the agreement between simulated and observed species mixtures on a fractional basis. The source-resolved exposure estimates developed in this study are suitable for use in health analyses of PM2.5 toxicity.
- 1 September 2021
- Published by Cambridge University Press (CUP) in ChemRxiv
Open AccessBias corrections for speciated and source-resolved PM2.5 chemical transport model simulations using a geographically weighted regression
The ability to provide speciated and source-resolved PM2.5 estimates make chemical transport models a potentially valuable tool for exposure assessments. However, epidemiological studies often require unbiased estimates, which can be challenging for chemical transport models. We use geographically weighted regression to predict and correct the bias in source-resolved PM2.5 species (elemental carbon, organic aerosol, ammonium, nitrate, and sulfate) across the continental U.S. for 2001 and 2010. The regression models are trained using speciated ground-level monitors from the CSN and IMPROVE networks. A 10-fold cross-validation shows minimal bias across all simulated PM2.5 species (0 – 3%) and improved agreement with ground-level monitors (R2 = 0.53 – 0.97). Corrections also improve the agreement between simulated and observed species mixtures on a fractional basis. The source-resolved exposure estimates developed in this study are suitable for use in health analyses of PM2.5 toxicity.
- 16 June 2017
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 67 (8) , 854-872
Overview of surface measurements and spatial characterization of submicrometer particulate matter during the DISCOVER-AQ 2013 campaign in Houston, TX
The sources of submicrometer particulate matter (PM1) remain poorly characterized in the industrialized city of Houston, TX. A mobile sampling approach was used to characterize PM1 composition and concentration across Houston based on high-time-resolution measurements of nonrefractory PM1 and trace gases during the DISCOVER-AQ Texas 2013 campaign. Two pollution zones with marked differences in PM1 levels, character, and dynamics were established based on cluster analysis of organic aerosol mass loadings sampled at 16 sites. The highest PM1 mass concentrations (average 11.6 ± 5.7 µg/m3) were observed to the northwest of Houston (zone 1), dominated by secondary organic aerosol (SOA) mass likely driven by nighttime biogenic organonitrate formation. Zone 2, an industrial/urban area south/east of Houston, exhibited lower concentrations of PM1 (average 4.4 ± 3.3 µg/m3), significant organic aerosol (OA) aging, and evidence of primary sulfate emissions. Diurnal patterns and backward-trajectory analyses enable the classification of airmass clusters characterized by distinct PM sources: biogenic SOA, photochemical aged SOA, and primary sulfate emissions from the Houston Ship Channel. Principal component analysis (PCA) indicates that secondary biogenic organonitrates primarily related with monoterpenes are predominant in zone 1 (accounting for 34% of the variability in the data set). The relevance of photochemical processes and industrial and traffic emission sources in zone 2 also is highlighted by PCA, which identifies three factors related with these processes/sources (~50% of the aerosol/trace gas concentration variability). PCA reveals a relatively minor contribution of isoprene to SOA formation in zone 1 and the absence of isoprene-derived aerosol in zone 2. The relevance of industrial amine emissions and the likely contribution of chloride-displaced sea salt aerosol to the observed variability in pollution levels in zone 2 also are captured by PCA. Implications: This article describes an urban-scale mobile study to characterize spatial variations in submicrometer particulate matter (PM1) in greater Houston. The data set indicates substantial spatial variations in PM1 sources/chemistry and elucidates the importance of photochemistry and nighttime oxidant chemistry in producing secondary PM1. These results emphasize the potential benefits of effective control strategies throughout the region, not only to reduce primary emissions of PM1 from automobiles and industry but also to reduce the emissions of important secondary PM1 precursors, including sulfur oxides, nitrogen oxides, ammonia, and volatile organic compounds. Such efforts also could aid in efforts to reduce mixing ratios of ozone.
- 16 June 2017
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 67 (8) , 854-872
Overview of surface measurements and spatial characterization of submicrometer particulate matter during the DISCOVER-AQ 2013 campaign in Houston, TX
The sources of submicrometer particulate matter (PM1) remain poorly characterized in the industrialized city of Houston, TX. A mobile sampling approach was used to characterize PM1 composition and concentration across Houston based on high-time-resolution measurements of nonrefractory PM1 and trace gases during the DISCOVER-AQ Texas 2013 campaign. Two pollution zones with marked differences in PM1 levels, character, and dynamics were established based on cluster analysis of organic aerosol mass loadings sampled at 16 sites. The highest PM1 mass concentrations (average 11.6 ± 5.7 µg/m3) were observed to the northwest of Houston (zone 1), dominated by secondary organic aerosol (SOA) mass likely driven by nighttime biogenic organonitrate formation. Zone 2, an industrial/urban area south/east of Houston, exhibited lower concentrations of PM1 (average 4.4 ± 3.3 µg/m3), significant organic aerosol (OA) aging, and evidence of primary sulfate emissions. Diurnal patterns and backward-trajectory analyses enable the classification of airmass clusters characterized by distinct PM sources: biogenic SOA, photochemical aged SOA, and primary sulfate emissions from the Houston Ship Channel. Principal component analysis (PCA) indicates that secondary biogenic organonitrates primarily related with monoterpenes are predominant in zone 1 (accounting for 34% of the variability in the data set). The relevance of photochemical processes and industrial and traffic emission sources in zone 2 also is highlighted by PCA, which identifies three factors related with these processes/sources (~50% of the aerosol/trace gas concentration variability). PCA reveals a relatively minor contribution of isoprene to SOA formation in zone 1 and the absence of isoprene-derived aerosol in zone 2. The relevance of industrial amine emissions and the likely contribution of chloride-displaced sea salt aerosol to the observed variability in pollution levels in zone 2 also are captured by PCA. Implications: This article describes an urban-scale mobile study to characterize spatial variations in submicrometer particulate matter (PM1) in greater Houston. The data set indicates substantial spatial variations in PM1 sources/chemistry and elucidates the importance of photochemistry and nighttime oxidant chemistry in producing secondary PM1. These results emphasize the potential benefits of effective control strategies throughout the region, not only to reduce primary emissions of PM1 from automobiles and industry but also to reduce the emissions of important secondary PM1 precursors, including sulfur oxides, nitrogen oxides, ammonia, and volatile organic compounds. Such efforts also could aid in efforts to reduce mixing ratios of ozone.