Mohammad Nadeem Khan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mohammad Nadeem Khan has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
I. Tlili
Majmaah University, Majmaah, Saudi Arabia
7 shared publications- Ibrahim Mohammed Alarifi
Department of Mechanical and Industrial Engineering, College of Engineering Majmaah University Riyadh Saudi Arabia
3 shared publications - Waqar Ahmed Khanb
Department of Pure and Applied Mathematics, Saveetha School of Engineering, Saveetha Nagar, Thandalam, Chennai-602105, Tamil Nadu, India
3 shared publications Abdulaziz R. Alharbi
Department of Mechanical Engineering, Fahad Bin Sultan University, Tabuk, Tabuk, SAUDI ARABIA
2 shared publicationsM. Osman
Department of Mechanical and Industrial Engineering, Majmaah University, Al Majma'ah, SAUDI ARABIA
2 shared publicationsMohammad Rahimi-Gorji
Faculty of Medicine and Health Science, Ghent University, 9000 Gent, Belgium
2 shared publications
Latest Publications
- 10 June 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 145, 446-459
Machine learning-aided optimal energy management of a Solar-to-X energy system based on hydrogen production/storage and CAES
- 10 June 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 145, 446-459
Machine learning-aided optimal energy management of a Solar-to-X energy system based on hydrogen production/storage and CAES
- 23 June 2022
- Published by Polish Academy of Sciences Chancellery in Archive of Mechanical Engineering
- p. 497-517
Air bottoming combined cycle performance analyses by the combined effect of variable parameters
To meet the continuous demand for energy of industrial as well as commercial sectors, researchers focus on increasing the power generating capacity of gas turbine power plants. In this regard, the combined cycle is a better solution in terms of environmental aspects and power generation as compared to a simple gas turbine power plant. The present study is the thermodynamic investigation of five possible air bottoming combined cycles in which the topping cycle is a simple gas turbine cycle, regenerative gas turbine cycle, inter-cool gas turbine cycle, reheat gas turbine cycle, and intercool-reheat gas turbine cycle. The effect of pressure ratio of the topping cycle, the turbine inlet temperature of topping cycle, and ambient temperature on net power output, thermal efficiency, total exergy destruction, and exergetic efficiency of the combined cycle have been analyzed. The ratio of the net power output of the combined cycle to that of the topping cycle is maximal in the case when the topping cycle is a simple gas turbine cycle. The ratio of net power output and the total exergy destruction of the combined cycle to those of the topping cycle decrease with pressure ratio for all the combinations under study except for the case when the topping cycle is the regenerative gas turbine cycle.
- 23 June 2022
- Published by Polish Academy of Sciences Chancellery in Archive of Mechanical Engineering
- p. 497-517
Air bottoming combined cycle performance analyses by the combined effect of variable parameters
To meet the continuous demand for energy of industrial as well as commercial sectors, researchers focus on increasing the power generating capacity of gas turbine power plants. In this regard, the combined cycle is a better solution in terms of environmental aspects and power generation as compared to a simple gas turbine power plant. The present study is the thermodynamic investigation of five possible air bottoming combined cycles in which the topping cycle is a simple gas turbine cycle, regenerative gas turbine cycle, inter-cool gas turbine cycle, reheat gas turbine cycle, and intercool-reheat gas turbine cycle. The effect of pressure ratio of the topping cycle, the turbine inlet temperature of topping cycle, and ambient temperature on net power output, thermal efficiency, total exergy destruction, and exergetic efficiency of the combined cycle have been analyzed. The ratio of the net power output of the combined cycle to that of the topping cycle is maximal in the case when the topping cycle is a simple gas turbine cycle. The ratio of net power output and the total exergy destruction of the combined cycle to those of the topping cycle decrease with pressure ratio for all the combinations under study except for the case when the topping cycle is the regenerative gas turbine cycle.
- 18 November 2021
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 7 (7) , 1768-1783
Combined effect of variable parameters on the performance of gas turbine cycles
The gas turbine cycle is the key solution for the power generation system from the last decade. several types of research are going to enhance the overall system efficiency of the gas turbine cycle. In the present study, six sets have been investigated parametrically for energy and exergy. Thermodynamic assessments have been effectively achieved for the compressor pressure ratio from 4 to 14, turbine inlet temperature (TIT) from 1000K to 1500K, and ambient temperature 250C to 450C. Results show that for every 100 rises in ambient temperature the maximum decrease in peak output and peak thermal efficiency is 6.2% and 5% respectively at 1000K and 3.6% and 1.9% respectively at 1500K. The exergy loss by exhaust gases of set 4 and set 5 increased by 107% whereas set 6 is decreased by 85.5% as compared to set 1 under the conditions when the exergy loss by exhaust gases of set 1 is minimum at TIT 1000K. The total exergy destruction of set 3, set 4, set 5, and set 6 is increased by 102%, 32.6%, 133.3%, and 102% respectively as compared to set 1 under the conditions when the total exergy destruction of set1 is minimum at TIT 1000K. Regenerative Gas Turbine cycle is the best in terms of the ratio of net output to exergy destruction of the plant as well as initial, operational, and maintenance costs.
- 18 November 2021
- Published by Yildiz Technical University in Journal of Thermal Engineering
- Vol. 7 (7) , 1768-1783
Combined effect of variable parameters on the performance of gas turbine cycles
The gas turbine cycle is the key solution for the power generation system from the last decade. several types of research are going to enhance the overall system efficiency of the gas turbine cycle. In the present study, six sets have been investigated parametrically for energy and exergy. Thermodynamic assessments have been effectively achieved for the compressor pressure ratio from 4 to 14, turbine inlet temperature (TIT) from 1000K to 1500K, and ambient temperature 250C to 450C. Results show that for every 100 rises in ambient temperature the maximum decrease in peak output and peak thermal efficiency is 6.2% and 5% respectively at 1000K and 3.6% and 1.9% respectively at 1500K. The exergy loss by exhaust gases of set 4 and set 5 increased by 107% whereas set 6 is decreased by 85.5% as compared to set 1 under the conditions when the exergy loss by exhaust gases of set 1 is minimum at TIT 1000K. The total exergy destruction of set 3, set 4, set 5, and set 6 is increased by 102%, 32.6%, 133.3%, and 102% respectively as compared to set 1 under the conditions when the total exergy destruction of set1 is minimum at TIT 1000K. Regenerative Gas Turbine cycle is the best in terms of the ratio of net output to exergy destruction of the plant as well as initial, operational, and maintenance costs.
- 10 June 2021
- Published by Kaunas University of Technology (KTU) in Mechanics
- Vol. 27 (3) , 251-258
Energetic and Exergetic Investigation of Regenerative Gas Turbine Air-Bottoming/Steam -Bottoming Combined Cycle
The present study is a thermodynamic analysis of a Regenerative Air-Bottoming combined (RABC) cycle /Steam bottoming combined (RABC) cycle operated by the exhaust gases the topping gas turbine cycle. The fractional mass of exhaust gases passes through the first heat exchanger where it exchanges heat with the compressed air from the air compressor of topping cycle and remaining amount of exhaust gasses passes through a second heat exchanger where it uses to supply heat to RABC cycle or third heat exchanger where it uses to supply heat to RSBC cycle. The energetic and exergetic performance of RABC cycle and RSBC cycle is investigated using turbine inlet temperature (1000 K⩽ TIT⩽1500 K) and mass fraction of exhaust gas (0⩽x⩽1) of the topping cycle as the input variables. The work net output attained its peak value at x=0 which is 22.1 % to 27.3 % for RABC cycle and 22.7 % to 21.5 % for RSBC cycle whereas the maximum thermal efficiency and minimum specific fuel consumption is observed at x=1. Also exergy loss by exhaust gases is minimum at x=0 for both RABC cycle and RSBC cycle. Finally, it is concluded that for the maximum work net output and minimum exergy loss by exhaust gases, RABC cycle is the best option followed by RSBC cycle but for optimum thermal efficiency and minimum specific fuel consumption purely regenerative gas turbine cycle have no comparison with RABC cycle and RSBC cycle.
- 10 June 2021
- Published by Kaunas University of Technology (KTU) in Mechanics
- Vol. 27 (3) , 251-258
Energetic and Exergetic Investigation of Regenerative Gas Turbine Air-Bottoming/Steam -Bottoming Combined Cycle
The present study is a thermodynamic analysis of a Regenerative Air-Bottoming combined (RABC) cycle /Steam bottoming combined (RABC) cycle operated by the exhaust gases the topping gas turbine cycle. The fractional mass of exhaust gases passes through the first heat exchanger where it exchanges heat with the compressed air from the air compressor of topping cycle and remaining amount of exhaust gasses passes through a second heat exchanger where it uses to supply heat to RABC cycle or third heat exchanger where it uses to supply heat to RSBC cycle. The energetic and exergetic performance of RABC cycle and RSBC cycle is investigated using turbine inlet temperature (1000 K⩽ TIT⩽1500 K) and mass fraction of exhaust gas (0⩽x⩽1) of the topping cycle as the input variables. The work net output attained its peak value at x=0 which is 22.1 % to 27.3 % for RABC cycle and 22.7 % to 21.5 % for RSBC cycle whereas the maximum thermal efficiency and minimum specific fuel consumption is observed at x=1. Also exergy loss by exhaust gases is minimum at x=0 for both RABC cycle and RSBC cycle. Finally, it is concluded that for the maximum work net output and minimum exergy loss by exhaust gases, RABC cycle is the best option followed by RSBC cycle but for optimum thermal efficiency and minimum specific fuel consumption purely regenerative gas turbine cycle have no comparison with RABC cycle and RSBC cycle.
- 18 May 2020
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (7) , 5895-5905
Energy and Exergy Analyses of Regenerative Gas Turbine Air-Bottoming Combined Cycle: Optimum Performance
- 18 May 2020
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (7) , 5895-5905
Energy and Exergy Analyses of Regenerative Gas Turbine Air-Bottoming Combined Cycle: Optimum Performance
- 21 March 2020
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 144 (3) , 821-834
Performance enhancement of regenerative gas turbine: air bottoming combined cycle using bypass valve and heat exchanger—energy and exergy analysis
- 21 March 2020
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 144 (3) , 821-834
Performance enhancement of regenerative gas turbine: air bottoming combined cycle using bypass valve and heat exchanger—energy and exergy analysis
- 11 February 2020
- Published by IOP Publishing in Physica Scripta
- Vol. 95 (4) , 045701
Improving the efficiency of gas turbine-air bottoming combined cycle by heat exchangers and bypass control valves
The present study is a comparative energy and exergy analysis of a Proposed gas turbine cycle (PGTC) with a simple gas turbine cycle (SGTC), maintaining the same rate of fuel supply in both cycles. In the PGTC, the air bottoming cycle is operated by exhaust gases from the topping gas turbine cycle by exchanging heat in the heat exchangers (H.E.s) by controlling the path of exhaust gases and compressed air through the bypass control valves. The bypass valve in the topping, as well as the bottoming cycle, direct the combustible product from the combustion chamber to the H.E., in such a way that it optimizes the performance of the proposed combined cycle as compared to SGTC. The results show that the maximum increase in Work net output and thermal efficiency in PGTC compared to SGTC is 65.7% at r p = 4 and turbine inlet temperature (TIT) = 1500 K, whereas the exergy loss by the exhaust gases in the PGTC is much less than the exergy loss by the exhaust gases in the SGTC. The maximum difference in the exergy loss by the exhaust gases in PGTC and SGTC is also observed at r p = 4 and TIT = 1500 K.
- 11 February 2020
- Published by IOP Publishing in Physica Scripta
- Vol. 95 (4) , 045701
Improving the efficiency of gas turbine-air bottoming combined cycle by heat exchangers and bypass control valves
The present study is a comparative energy and exergy analysis of a Proposed gas turbine cycle (PGTC) with a simple gas turbine cycle (SGTC), maintaining the same rate of fuel supply in both cycles. In the PGTC, the air bottoming cycle is operated by exhaust gases from the topping gas turbine cycle by exchanging heat in the heat exchangers (H.E.s) by controlling the path of exhaust gases and compressed air through the bypass control valves. The bypass valve in the topping, as well as the bottoming cycle, direct the combustible product from the combustion chamber to the H.E., in such a way that it optimizes the performance of the proposed combined cycle as compared to SGTC. The results show that the maximum increase in Work net output and thermal efficiency in PGTC compared to SGTC is 65.7% at r p = 4 and turbine inlet temperature (TIT) = 1500 K, whereas the exergy loss by the exhaust gases in the PGTC is much less than the exergy loss by the exhaust gases in the SGTC. The maximum difference in the exergy loss by the exhaust gases in PGTC and SGTC is also observed at r p = 4 and TIT = 1500 K.