Brennan C. McBride
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Brennan C. McBride has a total of 55 co-authors. Here are the top co-authors by number of shared publications:
- Gia Thinh Tran
Department of Chemistry, Colorado State University, Fort Collins, Colorado 80523-1872, United States
5 shared publications - James Richmond Neilson
Department of Chemistry, Colorado State University, Fort Collins, CO 80523, USA
5 shared publications - Kristin Aslaug Persson
University of California Berkeley
4 shared publications - Matthew J. McDermott
Materials Sciences Division, Lawrence Berkeley National Laboratory, Berkeley, California 94720, United States
4 shared publications - Allison Wustrow
Université de Sherbrooke 2500, boulevard de l’Université
3 shared publications - Karena W. Chapman
Stony Brook University
3 shared publications
Latest Publications
- 31 January 2024
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 146 (6) , 4001-4012
Mechanistically Guided Materials Chemistry: Synthesis of Ternary Nitrides, CaZrN2 and CaHfN2
Recent computational studies have predicted many new ternary nitrides, revealing synthetic opportunities in this underexplored phase space. However, synthesizing new ternary nitrides is difficult, in part because intermediate and product phases often have high cohesive energies that inhibit diffusion. Here, we report the synthesis of two new phases, calcium zirconium nitride (CaZrN2) and calcium hafnium nitride (CaHfN2), by solid state metathesis reactions between Ca3N2 and MCl4 (M = Zr, Hf). Although the reaction nominally proceeds to the target phases in a 1:1 ratio of the precursors via Ca3N2 + MCl4 → CaMN2 + 2 CaCl2, reactions prepared this way result in Ca-poor materials (CaxM2-xN2, x < 1). A small excess of Ca3N2 (ca. 20 mol %) is needed to yield stoichiometric CaMN2, as confirmed by high-resolution synchrotron powder X-ray diffraction. In situ synchrotron X-ray diffraction studies reveal that nominally stoichiometric reactions produce Zr3+ intermediates early in the reaction pathway, and the excess Ca3N2 is needed to reoxidize Zr3+ intermediates back to the Zr4+ oxidation state of CaZrN2. Analysis of computationally derived chemical potential diagrams rationalizes this synthetic approach and its contrast from the synthesis of MgZrN2. These findings additionally highlight the utility of in situ diffraction studies and computational thermochemistry to provide mechanistic guidance for synthesis.
- 31 January 2024
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 146 (6) , 4001-4012
Mechanistically Guided Materials Chemistry: Synthesis of Ternary Nitrides, CaZrN2 and CaHfN2
Recent computational studies have predicted many new ternary nitrides, revealing synthetic opportunities in this underexplored phase space. However, synthesizing new ternary nitrides is difficult, in part because intermediate and product phases often have high cohesive energies that inhibit diffusion. Here, we report the synthesis of two new phases, calcium zirconium nitride (CaZrN2) and calcium hafnium nitride (CaHfN2), by solid state metathesis reactions between Ca3N2 and MCl4 (M = Zr, Hf). Although the reaction nominally proceeds to the target phases in a 1:1 ratio of the precursors via Ca3N2 + MCl4 → CaMN2 + 2 CaCl2, reactions prepared this way result in Ca-poor materials (CaxM2-xN2, x < 1). A small excess of Ca3N2 (ca. 20 mol %) is needed to yield stoichiometric CaMN2, as confirmed by high-resolution synchrotron powder X-ray diffraction. In situ synchrotron X-ray diffraction studies reveal that nominally stoichiometric reactions produce Zr3+ intermediates early in the reaction pathway, and the excess Ca3N2 is needed to reoxidize Zr3+ intermediates back to the Zr4+ oxidation state of CaZrN2. Analysis of computationally derived chemical potential diagrams rationalizes this synthetic approach and its contrast from the synthesis of MgZrN2. These findings additionally highlight the utility of in situ diffraction studies and computational thermochemistry to provide mechanistic guidance for synthesis.
- 27 December 2023
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 63 (7) , 3250-3257
Selective Synthesis of Defect-Rich LaMnO3 by Low-Temperature Anion Cometathesis
The synthesis of complex oxides at low temperatures brings forward aspects of chemistry not typically considered. This study focuses on perovskite LaMnO3, which is of interest for its correlated electronic behavior tied to the oxidation state and thus the spin configuration of manganese. Traditional equilibrium synthesis of these materials typically requires synthesis reaction temperatures in excess of 1000 °C, followed by subsequent annealing steps at lower temperatures and different p(O2) conditions to manipulate the oxygen content postsynthesis (e.g., LaMnO3+x). Double-ion exchange (metathesis) reactions have recently been shown to react at much lower temperatures (500-800 °C), highlighting a fundamental knowledge gap for how solids react at lower temperatures. Here, we revisit the metathesis reaction, LiMnO2 + LaOX, where X is a halide or mixture of halides, using in situ synchrotron X-ray diffraction. These experiments reveal low reaction onset temperatures (ca. 450-480 °C). The lowest reaction temperatures are achieved by a mixture of lanthanum oxyhalide precursors: 2 LiMnO2 + LaOCl + LaOBr. In all cases, the resulting products are the expected alkali halide salt and defective La1-ϵMn1-ϵO3, where ϵ = x/(3 + x). We observe a systematic variation in defect concentration, consistent with a rapid stoichiometric local equilibration of the precursors and the subsequent global thermodynamic equilibration with O2 (g), as revealed by computational thermodynamics. Together, these results reveal how the inclusion of additional elements (e.g., Li and a halide) leads to the local equilibrium, particularly at low reaction temperatures for solid-state chemistry.
- 27 December 2023
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 63 (7) , 3250-3257
Selective Synthesis of Defect-Rich LaMnO3 by Low-Temperature Anion Cometathesis
The synthesis of complex oxides at low temperatures brings forward aspects of chemistry not typically considered. This study focuses on perovskite LaMnO3, which is of interest for its correlated electronic behavior tied to the oxidation state and thus the spin configuration of manganese. Traditional equilibrium synthesis of these materials typically requires synthesis reaction temperatures in excess of 1000 °C, followed by subsequent annealing steps at lower temperatures and different p(O2) conditions to manipulate the oxygen content postsynthesis (e.g., LaMnO3+x). Double-ion exchange (metathesis) reactions have recently been shown to react at much lower temperatures (500-800 °C), highlighting a fundamental knowledge gap for how solids react at lower temperatures. Here, we revisit the metathesis reaction, LiMnO2 + LaOX, where X is a halide or mixture of halides, using in situ synchrotron X-ray diffraction. These experiments reveal low reaction onset temperatures (ca. 450-480 °C). The lowest reaction temperatures are achieved by a mixture of lanthanum oxyhalide precursors: 2 LiMnO2 + LaOCl + LaOBr. In all cases, the resulting products are the expected alkali halide salt and defective La1-ϵMn1-ϵO3, where ϵ = x/(3 + x). We observe a systematic variation in defect concentration, consistent with a rapid stoichiometric local equilibration of the precursors and the subsequent global thermodynamic equilibration with O2 (g), as revealed by computational thermodynamics. Together, these results reveal how the inclusion of additional elements (e.g., Li and a halide) leads to the local equilibrium, particularly at low reaction temperatures for solid-state chemistry.
- Open Access
- 16 October 2023
- Published by American Chemical Society (ACS) in ACS Central Science
- Vol. 9 (10) , 1957-1975
Assessing Thermodynamic Selectivity of Solid-State Reactions for the Predictive Synthesis of Inorganic Materials
Synthesis is a major challenge in the discovery of new inorganic materials. Currently, there is limited theoretical guidance for identifying optimal solid-state synthesis procedures. We introduce two selectivity metrics, primary and secondary competition, to assess the favorability of target/impurity phase formation in solid-state reactions. We used these metrics to analyze 3520 solid-state reactions in the literature, ranking existing approaches to popular target materials. Additionally, we implemented these metrics in a data-driven synthesis planning workflow and demonstrated its application in the synthesis of barium titanate (BaTiO3). Using an 18-element chemical reaction network with first-principles thermodynamic data from the Materials Project, we identified 82985 possible BaTiO3 synthesis reactions and selected 9 for experimental testing. Characterization of reaction pathways via synchrotron powder X-ray diffraction reveals that our selectivity metrics correlate with observed target/impurity formation. We discovered two efficient reactions using unconventional precursors (BaS/BaCl2 and Na2TiO3) that produce BaTiO3 faster and with fewer impurities than conventional methods, highlighting the importance of considering complex chemistries with additional elements during precursor selection. Our framework provides a foundation for predictive inorganic synthesis, facilitating the optimization of existing recipes and the discovery of new materials, including those not easily attainable with conventional precursors.
- 16 October 2023
- Published by American Chemical Society (ACS) in ACS Central Science
- Vol. 9 (10) , 1957-1975
Open AccessAssessing Thermodynamic Selectivity of Solid-State Reactions for the Predictive Synthesis of Inorganic Materials
Synthesis is a major challenge in the discovery of new inorganic materials. Currently, there is limited theoretical guidance for identifying optimal solid-state synthesis procedures. We introduce two selectivity metrics, primary and secondary competition, to assess the favorability of target/impurity phase formation in solid-state reactions. We used these metrics to analyze 3520 solid-state reactions in the literature, ranking existing approaches to popular target materials. Additionally, we implemented these metrics in a data-driven synthesis planning workflow and demonstrated its application in the synthesis of barium titanate (BaTiO3). Using an 18-element chemical reaction network with first-principles thermodynamic data from the Materials Project, we identified 82985 possible BaTiO3 synthesis reactions and selected 9 for experimental testing. Characterization of reaction pathways via synchrotron powder X-ray diffraction reveals that our selectivity metrics correlate with observed target/impurity formation. We discovered two efficient reactions using unconventional precursors (BaS/BaCl2 and Na2TiO3) that produce BaTiO3 faster and with fewer impurities than conventional methods, highlighting the importance of considering complex chemistries with additional elements during precursor selection. Our framework provides a foundation for predictive inorganic synthesis, facilitating the optimization of existing recipes and the discovery of new materials, including those not easily attainable with conventional precursors.
- 10 May 2022
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 34 (10) , 4694-4702
Reaction Selectivity in Cometathesis: Yttrium Manganese Oxides
- 10 May 2022
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 34 (10) , 4694-4702
Reaction Selectivity in Cometathesis: Yttrium Manganese Oxides
- Open Access
nmfMapping: a cloud-based web application for non-negative matrix factorization of powder diffraction and pair distribution function datasets
A cloud-hosted web-based software application, nmfMapping, for carrying out a nonnegative matrix factorization of a set of powder diffraction or atomic pair distribution function datasets is described. This app allows structure scientists to rapidly find trends in sets of related data such as from in situ and operando diffraction experiments. The application is easy to use and does not require any programming expertise. It is available at the pdfitc.org website.
Open AccessnmfMapping: a cloud-based web application for non-negative matrix factorization of powder diffraction and pair distribution function datasets
A cloud-hosted web-based software application, nmfMapping, for carrying out a nonnegative matrix factorization of a set of powder diffraction or atomic pair distribution function datasets is described. This app allows structure scientists to rapidly find trends in sets of related data such as from in situ and operando diffraction experiments. The application is easy to use and does not require any programming expertise. It is available at the pdfitc.org website.
- Open Access
- 31 March 2021
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 50 (19) , 6463-6476
Third time's the charm: intricate non-centrosymmetric polymorphism in LnSiP3 (Ln = La and Ce) induced by distortions of phosphorus square layers
Complex polymorphic relationships in the LnSiP3 (Ln = La and Ce) family of compounds are reported.
- 31 March 2021
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 50 (19) , 6463-6476
Open AccessThird time's the charm: intricate non-centrosymmetric polymorphism in LnSiP3 (Ln = La and Ce) induced by distortions of phosphorus square layers
Complex polymorphic relationships in the LnSiP3 (Ln = La and Ce) family of compounds are reported.