Kurniawan Eko Saputro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kurniawan Eko Saputro has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Agnia Vibriani
School of Life Science and Technology, Bandung Institute of Technology, Bandung, Indonesia
1 shared publication - Akmal Zulfi
Research Center for Environmental and Clean Technology, National Research and Innovation Agency (BRIN), Komplek BRIN Cisitu, Bandung 40135, Indonesia
1 shared publication - Alfian Noviyanto
University of Mercu Buana
1 shared publication Ande Fudja Rafryanto
Nano Center Indonesia, Jalan Raya PUSPIPTEK, South Tangerang, Banten 15314, Indonesia
1 shared publication- Arinobu Tojo
Tokyo Medical and Dental University, Tokyo 113-8510, Japan
1 shared publication Bagas Haqi Arrosyid
Nano Center Indonesia, Jalan Raya PUSPIPTEK, South Tangerang, Banten 15314, Indonesia
1 shared publication
Latest Publications
- Open Access
- 22 November 2022
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 12 (52) , 33751-33760
Waste acrylonitrile butadiene styrene (ABS) incorporated with polyvinylpyrrolidone (PVP) for potential water filtration membrane
Acrylonitrile butadiene styrene (ABS) is one of the most common fused-filament feedstocks for 3D printing. The rapid growth of the 3D printing industry has resulted in huge demand for ABS filaments; however, it generates a large amount of waste. This study developed a novel method using waste ABS to fabricate electrospun nanofiber membranes (ENMs) for water filtration. Polyvinylpyrrolidone (PVP) was employed to modify the properties of waste ABS, and the effect of PVP addition in the range of 0–5 wt% was investigated. The results showed that adding PVP increased the viscosity and surface tension but decreased the conductivity of the precursor solution. After electrospinning, PVP could reduce the number of beads, increase the porosity and fiber diameter, and improve the wettability of the fabricated fibers. Moreover, the bilayer of ABS ENMs achieved a high flux value between 2951 and 48 041 L m−2 h−1 and a high rejection rate of 99%. Our study demonstrates a sustainable strategy to convert waste plastics to inexpensive materials for wastewater treatment membranes.
- 22 November 2022
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 12 (52) , 33751-33760
Open AccessWaste acrylonitrile butadiene styrene (ABS) incorporated with polyvinylpyrrolidone (PVP) for potential water filtration membrane
Acrylonitrile butadiene styrene (ABS) is one of the most common fused-filament feedstocks for 3D printing. The rapid growth of the 3D printing industry has resulted in huge demand for ABS filaments; however, it generates a large amount of waste. This study developed a novel method using waste ABS to fabricate electrospun nanofiber membranes (ENMs) for water filtration. Polyvinylpyrrolidone (PVP) was employed to modify the properties of waste ABS, and the effect of PVP addition in the range of 0–5 wt% was investigated. The results showed that adding PVP increased the viscosity and surface tension but decreased the conductivity of the precursor solution. After electrospinning, PVP could reduce the number of beads, increase the porosity and fiber diameter, and improve the wettability of the fabricated fibers. Moreover, the bilayer of ABS ENMs achieved a high flux value between 2951 and 48 041 L m−2 h−1 and a high rejection rate of 99%. Our study demonstrates a sustainable strategy to convert waste plastics to inexpensive materials for wastewater treatment membranes.
- Open Access
- 8 July 2019
- Published by Springer Nature in BMC Research Notes
- Vol. 12 (1) , 1-7
Nanochitosan antimicrobial activity against Streptococcus mutans and Candida albicans dual-species biofilms
Chitosan nanoparticle (nanochitosan) has a broad antimicrobial spectrum against diverse pathogenic microorganisms. However, its effect on dental caries-associated microorganisms, such as Streptococcus mutans and Candida albicans is yet to be explored. These microorganisms are known for causing early childhood caries. Therefore, this study was aimed at investigating nanochitosan inhibition capacity against dual-species biofilms of S. mutans and C. albicans. In this study, nanochitosan antimicrobial activity is reported against mono and dual biofilm species of S. mutans and/or C. albicans at 3 and 18 h incubation time. Nanochitosan inhibition capacity was observed through biofilm mass quantity and cell viability. The present study successfully synthesized nanochitosan with average diameter of approximately 20–30 nm, and also established dual-species biofilms of S. mutans and C. albicans in vitro. With nanochitosan treatment, the cell viability of both microorganisms significantly decreased with the increasing concentration of nanochitosan. There was no significant decrease in biofilm mass both in the dual and single-species biofilms after 3 h of incubation. However, greater inhibition of biofilm was observed at 18 h incubation.
- 8 July 2019
- Published by Springer Nature in BMC Research Notes
- Vol. 12 (1) , 1-7
Open AccessNanochitosan antimicrobial activity against Streptococcus mutans and Candida albicans dual-species biofilms
Chitosan nanoparticle (nanochitosan) has a broad antimicrobial spectrum against diverse pathogenic microorganisms. However, its effect on dental caries-associated microorganisms, such as Streptococcus mutans and Candida albicans is yet to be explored. These microorganisms are known for causing early childhood caries. Therefore, this study was aimed at investigating nanochitosan inhibition capacity against dual-species biofilms of S. mutans and C. albicans. In this study, nanochitosan antimicrobial activity is reported against mono and dual biofilm species of S. mutans and/or C. albicans at 3 and 18 h incubation time. Nanochitosan inhibition capacity was observed through biofilm mass quantity and cell viability. The present study successfully synthesized nanochitosan with average diameter of approximately 20–30 nm, and also established dual-species biofilms of S. mutans and C. albicans in vitro. With nanochitosan treatment, the cell viability of both microorganisms significantly decreased with the increasing concentration of nanochitosan. There was no significant decrease in biofilm mass both in the dual and single-species biofilms after 3 h of incubation. However, greater inhibition of biofilm was observed at 18 h incubation.
- 1 April 2017
- Published by Springer Nature in Microsystem Technologies
- Vol. 24 (1) , 749-755
Recycled carbon black from waste of tire industry: thermal study
- 1 April 2017
- Published by Springer Nature in Microsystem Technologies
- Vol. 24 (1) , 749-755
Recycled carbon black from waste of tire industry: thermal study