Xiaopeng Qi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xiaopeng Qi has a total of 84 co-authors. Here are the top co-authors by number of shared publications:
Lixuan Mu
8 shared publicationsGuangwei She
7 shared publicationsWensheng Shi
Key Laboratory of Photochemical Conversion and Optoelectronic Materials, Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing 100190, China
6 shared publications- Wensheng Shi
State Key Laboratory of Cryogenic Science and Technology Technical Institute of Physics and Chemistry Chinese Academy of Sciences Beijing China
4 shared publications - Guangwei She
State Key Laboratory of Cryogenic Science and Technology Technical Institute of Physics and Chemistry Chinese Academy of Sciences Beijing China
3 shared publications - Jiantao Wang
China Automotive Battery Research Institute Co., Ltd. Beijing People's Republic of China
3 shared publications
Latest Publications
- 21 July 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (30) , 14894-14901
Revealing the Heat Generation and Release in a High-Energy-Density Quasi-Solid-State Li-Ion Cell
- 21 July 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (30) , 14894-14901
Revealing the Heat Generation and Release in a High-Energy-Density Quasi-Solid-State Li-Ion Cell
- Open Access
Development of Si-Based Anodes for All-Solid-State Li-Ion Batteries
All-solid-state Li-ion batteries (ASSBs) promise higher safety and energy density than conventional liquid electrolyte-based Li-ion batteries (LIBs). Silicon (Si) is considered one of the most promising anode materials due to its high specific capacity (3590 mAh g−1) but suffers from poor cycling performance because of large volumetric effects leading to particle pulverization, unstable solid electrolyte interphase (SEI), and electric disconnection. In ASSBs, additional issues such as poor solid–solid contacts and interfacial side reactions between Si and solid-state electrolytes (SSEs) are also hindering their practical application. This review first outlines the prospects and recent research achievements of Si-based anodes with special focuses on various Si structures and composite materials, then analyzes the issues of electrochemical–mechanical effects, and finally summarizes key factors and promising strategies for further improving Si-based anodes for high-performance ASSBs.
Open AccessDevelopment of Si-Based Anodes for All-Solid-State Li-Ion Batteries
All-solid-state Li-ion batteries (ASSBs) promise higher safety and energy density than conventional liquid electrolyte-based Li-ion batteries (LIBs). Silicon (Si) is considered one of the most promising anode materials due to its high specific capacity (3590 mAh g−1) but suffers from poor cycling performance because of large volumetric effects leading to particle pulverization, unstable solid electrolyte interphase (SEI), and electric disconnection. In ASSBs, additional issues such as poor solid–solid contacts and interfacial side reactions between Si and solid-state electrolytes (SSEs) are also hindering their practical application. This review first outlines the prospects and recent research achievements of Si-based anodes with special focuses on various Si structures and composite materials, then analyzes the issues of electrochemical–mechanical effects, and finally summarizes key factors and promising strategies for further improving Si-based anodes for high-performance ASSBs.
- Open Access
- 17 May 2023
- Published by Royal Society of Chemistry (RSC) in EES Catalysis
- Vol. 1 (4) , 392-412
Strategies for reducing the overpotential of one-dimensional Si nanostructured photoelectrodes for solar hydrogen production
Strategies to reduce the overpotential of 1D silicon nanostructured photoelectrodes for solar hydrogen generation: co-catalysts to improve the reaction kinetics, hetero- and homo-junctions to improve carrier collection and enhance photovoltage.
- 17 May 2023
- Published by Royal Society of Chemistry (RSC) in EES Catalysis
- Vol. 1 (4) , 392-412
Open AccessStrategies for reducing the overpotential of one-dimensional Si nanostructured photoelectrodes for solar hydrogen production
Strategies to reduce the overpotential of 1D silicon nanostructured photoelectrodes for solar hydrogen generation: co-catalysts to improve the reaction kinetics, hetero- and homo-junctions to improve carrier collection and enhance photovoltage.
- 25 February 2022
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 24 (12) , 7405-7414
Improving the performance of silicon monoxide anodes via tuning a multiple pre-doping system: a first-principles study
Silicon monoxide is a potentially viable anode material for high-performance lithium-ion batteries (LIBs). However, a low initial coulombic efficiency and large volume expansion limit its commercial application. Pre-lithiation is an efficient solution, but is expensive because of limited “pre-lithiation” sources. In this work, we theoretically investigated a novel multiple pre-doping SiO system (Li–NaMg–SiO). By comparing its lithiation behavior to that of the traditional Li-doping system (Li–SiO), we revealed the different doping effects during lithiation. Similar to the traditional Li-doping system, the insertion of Na and Mg disintegrates the Si–O host matrix to form Na–O and Mg–O bonds and active Si clusters. At the end of lithiation, the O–Li coordination number (CN) tends to saturate at CNO–Li ≈ 5 in Li–Na–SiO, Li–Mg–SiO, and Li–NaMg–SiO systems, while the value of CNO–Li in the Li–SiO system is more than 6, which suggests that there are reorganizations between Li, Na, and Mg in the silicate matrix. Doping sources of both Na and Mg can prevent the active Li ions from being trapped by O–Li bonds and increase the initial coulombic efficiency. From the density of states (DOS), we notice that all the different pre-doping systems have similar electronic structures, and they can be expected to undergo the same lithiation process. Furthermore, the higher ion-conductivity and smaller volume expansion during the lithiation process characterized by root mean square deviation (RMSD) and volume analysis prove the advantages of the binary doping system (Li–NaMg–SiO) for the improvement of cycle stability for Si-based materials. These advantages benefit from the loose and amorphous structures of doping systems during lithiation. Our work highlights the doping effects of multiple sources and the promotion of “inert compounds” on the entire lithiation process, which provide valuable insight for high-performance anode design.
- 25 February 2022
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 24 (12) , 7405-7414
Improving the performance of silicon monoxide anodes via tuning a multiple pre-doping system: a first-principles study
Silicon monoxide is a potentially viable anode material for high-performance lithium-ion batteries (LIBs). However, a low initial coulombic efficiency and large volume expansion limit its commercial application. Pre-lithiation is an efficient solution, but is expensive because of limited “pre-lithiation” sources. In this work, we theoretically investigated a novel multiple pre-doping SiO system (Li–NaMg–SiO). By comparing its lithiation behavior to that of the traditional Li-doping system (Li–SiO), we revealed the different doping effects during lithiation. Similar to the traditional Li-doping system, the insertion of Na and Mg disintegrates the Si–O host matrix to form Na–O and Mg–O bonds and active Si clusters. At the end of lithiation, the O–Li coordination number (CN) tends to saturate at CNO–Li ≈ 5 in Li–Na–SiO, Li–Mg–SiO, and Li–NaMg–SiO systems, while the value of CNO–Li in the Li–SiO system is more than 6, which suggests that there are reorganizations between Li, Na, and Mg in the silicate matrix. Doping sources of both Na and Mg can prevent the active Li ions from being trapped by O–Li bonds and increase the initial coulombic efficiency. From the density of states (DOS), we notice that all the different pre-doping systems have similar electronic structures, and they can be expected to undergo the same lithiation process. Furthermore, the higher ion-conductivity and smaller volume expansion during the lithiation process characterized by root mean square deviation (RMSD) and volume analysis prove the advantages of the binary doping system (Li–NaMg–SiO) for the improvement of cycle stability for Si-based materials. These advantages benefit from the loose and amorphous structures of doping systems during lithiation. Our work highlights the doping effects of multiple sources and the promotion of “inert compounds” on the entire lithiation process, which provide valuable insight for high-performance anode design.
- 7 December 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (3) , 1227-1235
Probing heat generation and release in a 57.5 A h high-energy-density Li-ion pouch cell with a nickel-rich cathode and SiO x /graphite anode
This study clarifies the heat generation and release of a 57.5 Ah HED (266.9 W h kg −1 ) Li-ion cell with a nickel-rich cathode and SiO x /graphite anode. Significant heat accumulation and delayed heat release effects in large-format cells are uncovered.
- 7 December 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 10 (3) , 1227-1235
Probing heat generation and release in a 57.5 A h high-energy-density Li-ion pouch cell with a nickel-rich cathode and SiO x /graphite anode
This study clarifies the heat generation and release of a 57.5 Ah HED (266.9 W h kg −1 ) Li-ion cell with a nickel-rich cathode and SiO x /graphite anode. Significant heat accumulation and delayed heat release effects in large-format cells are uncovered.
- 1 January 2020
- Published by Elsevier in Journal of Energy Chemistry
- Vol. 40, 171-179
Preparation of high-purity straight silicon nanowires by molten salt electrolysis
- 1 January 2020
- Published by Elsevier in Journal of Energy Chemistry
- Vol. 40, 171-179
Preparation of high-purity straight silicon nanowires by molten salt electrolysis
- 10 December 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 59 (1) , 1-8
Pilot-Plant Production of High-Performance Silicon Nanowires by Molten Salt Electrolysis of Silica
- 10 December 2019
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 59 (1) , 1-8
Pilot-Plant Production of High-Performance Silicon Nanowires by Molten Salt Electrolysis of Silica
- 1 January 2019
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 124, 312-317
Coating nanoparticle-assembled Si microspheres with carbon for anode material in lithium-ion battery
- 1 January 2019
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 124, 312-317
Coating nanoparticle-assembled Si microspheres with carbon for anode material in lithium-ion battery
- 1 September 2015
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 15 (9) , 7068-7073
Contributions of Ag Nanowires to the Photoelectric Conversion Efficiency Enhancement of TiO2 Dye-Sensitized Solar Cells
Ag nanowires (AgNWs) were employed in mesoporous TiO2 dye-sensitized solar cells (DSSCs) to enhance the photoelectric conversion efficiency (PCE). The possible reasons for PCE improvement, i.e., improvement in electron transport and light harvesting due to light scattering and plasmonic resonance effect of AgNWs are investigated. Electrochemical impedance spectra (EIS) study proved that addition of AgNWs can enhance the conductivity of TiO2 thin film photoanode, which is an important reason for the increase of photocurrent. Furthermore, through the comparison experiments as well as the UV-Vis absorption and IPCE characterization, contributions of the light scattering and plasmonic resonance effect to the enhancement of light harvest, and thus PCE of the DSSCs were demonstrated. It was found that fast electron transport of AgNWs played more important role for the PCE improvement than the light harvest enhancement due to light scattering and plasmonic effect. Based on these investigations, the AgNWs modified TiO2 thin film DSSCs were optimized. After integrating AgNWs into the photoanode, the photocurrent increased significantly and PCE increased ∼50% comparing with the pure TiO2-based DSSCs.
- 1 September 2015
- Published by American Scientific Publishers in Journal of Nanoscience and Nanotechnology
- Vol. 15 (9) , 7068-7073
Contributions of Ag Nanowires to the Photoelectric Conversion Efficiency Enhancement of TiO2 Dye-Sensitized Solar Cells
Ag nanowires (AgNWs) were employed in mesoporous TiO2 dye-sensitized solar cells (DSSCs) to enhance the photoelectric conversion efficiency (PCE). The possible reasons for PCE improvement, i.e., improvement in electron transport and light harvesting due to light scattering and plasmonic resonance effect of AgNWs are investigated. Electrochemical impedance spectra (EIS) study proved that addition of AgNWs can enhance the conductivity of TiO2 thin film photoanode, which is an important reason for the increase of photocurrent. Furthermore, through the comparison experiments as well as the UV-Vis absorption and IPCE characterization, contributions of the light scattering and plasmonic resonance effect to the enhancement of light harvest, and thus PCE of the DSSCs were demonstrated. It was found that fast electron transport of AgNWs played more important role for the PCE improvement than the light harvest enhancement due to light scattering and plasmonic effect. Based on these investigations, the AgNWs modified TiO2 thin film DSSCs were optimized. After integrating AgNWs into the photoanode, the photocurrent increased significantly and PCE increased ∼50% comparing with the pure TiO2-based DSSCs.