Jakub Zlámal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jakub Zlámal has a total of 122 co-authors. Here are the top co-authors by number of shared publications:
- Radek Kalousek
CEITEC BUT Brno University of Technology Brno 61200 Czech Republic
8 shared publications Tomáš Šikola
CEITEC BUT, Brno University of Technology, Czech Republic
5 shared publications- Michal Horák
Brno University of Technology, Central European Institute of Technology, Purkyňova 123, Brno 612 00, Czech Republic
4 shared publications - Miroslav Kolíbal
Brno University of Technology, Central European Institute of Technology, Purkyňova 123, 61200 Brno, Czech Republic
4 shared publications T. Šikola
4 shared publicationsB. Lencová
Institute of Physical Engineering, Brno University of Technology, Technická 2, 616 69 Brno, Czech Republic
3 shared publications
Latest Publications
- 12 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
The On-site DC Magnetic Survey of the SXI Telescope for SMILE Project
This paper presents an onsite DC magnetic survey on a space instrument using rotational magnetic measurement to obtain its multiple dipole model. It describes various measures implemented to enhance the reliability of measurement results obtained in an uncontrolled environment. The test, conducted without earth magnetic field compensation, identified a suitable space through initial sniffing and verified the signal-to-noise ratio with a sanity check. The magnetic model was validated with falling off test, showing good agreement with the field level calculated using the derived model. The model's usage is provided with further interpretation.
- 12 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
The On-site DC Magnetic Survey of the SXI Telescope for SMILE Project
This paper presents an onsite DC magnetic survey on a space instrument using rotational magnetic measurement to obtain its multiple dipole model. It describes various measures implemented to enhance the reliability of measurement results obtained in an uncontrolled environment. The test, conducted without earth magnetic field compensation, identified a suitable space through initial sniffing and verified the signal-to-noise ratio with a sanity check. The magnetic model was validated with falling off test, showing good agreement with the field level calculated using the derived model. The model's usage is provided with further interpretation.
- Open Access
- 14 May 2024
- Published by Wiley in Advanced Functional Materials
- Vol. 34 (32)
Accelerating the Laser‐Induced Phase Transition in Nanostructured FeRh via Plasmonic Absorption
By ultrafast x‐ray diffraction (UXRD), it is shown that the laser‐induced magnetostructural phase transition in FeRh nanoislands proceeds faster and more complete than in continuous films. An intrinsic 8 ps timescale is observed for the nucleation of ferromagnetic (FM) domains in the optically excited fraction of both types of samples. For the continuous film, the substrate‐near regions are not directly exposed to light and are only slowly transformed to the FM state after heating above the transition temperature via near‐equilibrium heat transport. Numerical modeling of the absorption in the investigated nanoislands reveals a strong plasmonic contribution near the FeRh/MgO interface. The larger absorption and the optical excitation of the electrons in nearly the entire volume of the nanoislands enables a rapid phase transition throughout the entire volume at the intrinsic nucleation timescale.
- 14 May 2024
- Published by Wiley in Advanced Functional Materials
- Vol. 34 (32)
Open AccessAccelerating the Laser‐Induced Phase Transition in Nanostructured FeRh via Plasmonic Absorption
By ultrafast x‐ray diffraction (UXRD), it is shown that the laser‐induced magnetostructural phase transition in FeRh nanoislands proceeds faster and more complete than in continuous films. An intrinsic 8 ps timescale is observed for the nucleation of ferromagnetic (FM) domains in the optically excited fraction of both types of samples. For the continuous film, the substrate‐near regions are not directly exposed to light and are only slowly transformed to the FM state after heating above the transition temperature via near‐equilibrium heat transport. Numerical modeling of the absorption in the investigated nanoislands reveals a strong plasmonic contribution near the FeRh/MgO interface. The larger absorption and the optical excitation of the electrons in nearly the entire volume of the nanoislands enables a rapid phase transition throughout the entire volume at the intrinsic nucleation timescale.
- 1 August 2023
- Published by Elsevier in Ultramicroscopy
- Vol. 253, 113825
2D calculation of parasitic fields in misaligned multipole electron-optical systems
- 1 August 2023
- Published by Elsevier in Ultramicroscopy
- Vol. 253, 113825
2D calculation of parasitic fields in misaligned multipole electron-optical systems
- 22 March 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 107 (12) , 125144
Strong coupling in an Au plasmonic antenna– layer system: A hybrid-mode analysisA detailed analysis of the optical response of a system accommodating several coupled modes is needed for the complete understanding of the strong coupling effect. In this paper, we report on the analysis of scattering cross-section spectra of Au antennas on a layer on a Si substrate in the IR region. A classical model of coupled oscillators is used for determining the resonant energies, damping rates, and coupling strengths of four phonon polariton modes in the layer coupled to a localized surface plasmon mode in a Au antenna. The calculated Hopfield mixing coefficients then show the contribution of the individual uncoupled modes to the hybrid modes of the coupled system.- 22 March 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 107 (12) , 125144
Strong coupling in an Au plasmonic antenna– layer system: A hybrid-mode analysisA detailed analysis of the optical response of a system accommodating several coupled modes is needed for the complete understanding of the strong coupling effect. In this paper, we report on the analysis of scattering cross-section spectra of Au antennas on a layer on a Si substrate in the IR region. A classical model of coupled oscillators is used for determining the resonant energies, damping rates, and coupling strengths of four phonon polariton modes in the layer coupled to a localized surface plasmon mode in a Au antenna. The calculated Hopfield mixing coefficients then show the contribution of the individual uncoupled modes to the hybrid modes of the coupled system.- Open Access
- 28 November 2022
- Published by Wiley in Advanced Materials Interfaces
- Vol. 10 (2)
Electron Tractor Beam: Deterministic Manipulation of Liquid Droplets on Solid Surfaces
The motion of liquid droplets is studied across many physics subfields and manipulation of nanoscale droplets on demand holds great promise in, e.g., nanotechnology. In this study, AuGe droplets on a germanium substrate are manipulated by an electron beam in a scanning electron microscope. The electron beam exposure creates a local temperature gradient in a substrate and induces a directional thermomigration of droplets nearby. To quantitatively analyse this phenomenon and to reveal the mechanism behind it, experimental observations under different conditions (beam current, sample temperature, scanning strategy) and simulations are combined. The obtained insights suggest that the droplet motion is limited by the dissolution of the substrate below the droplet. In addition, it is shown that the electron tractor beam is not only able to control the droplet motion but can also be used to split the droplets, thus opening new possibilities for droplet manipulation inside an SEM.
- 28 November 2022
- Published by Wiley in Advanced Materials Interfaces
- Vol. 10 (2)
Open AccessElectron Tractor Beam: Deterministic Manipulation of Liquid Droplets on Solid Surfaces
The motion of liquid droplets is studied across many physics subfields and manipulation of nanoscale droplets on demand holds great promise in, e.g., nanotechnology. In this study, AuGe droplets on a germanium substrate are manipulated by an electron beam in a scanning electron microscope. The electron beam exposure creates a local temperature gradient in a substrate and induces a directional thermomigration of droplets nearby. To quantitatively analyse this phenomenon and to reveal the mechanism behind it, experimental observations under different conditions (beam current, sample temperature, scanning strategy) and simulations are combined. The obtained insights suggest that the droplet motion is limited by the dissolution of the substrate below the droplet. In addition, it is shown that the electron tractor beam is not only able to control the droplet motion but can also be used to split the droplets, thus opening new possibilities for droplet manipulation inside an SEM.
- 15 March 2019
- Published by Springer Nature in Ionics
- Vol. 25 (8) , 4013-4029
Co doped YbFeO3: exploring the electrical properties via tuning the doping level
- 15 March 2019
- Published by Springer Nature in Ionics
- Vol. 25 (8) , 4013-4029
Co doped YbFeO3: exploring the electrical properties via tuning the doping level
- 6 July 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10699, 151
Design of the charged particle diverter for the ATHENA mission
The large Halo orbit in L2 of the ATHENA mission will expose the spacecraft (SC) to a significant flux of charged particles which is expected to overlap with the energy range of the instruments. This is a source of measurement background that needs to be minimized as much as possible to achieve the strict requirements of the mission. The need to know and mitigate this type of background has been identified as critical, and has led to a number of technology development activities which are progressing in parallel to the Phase A activities. Particularly, this paper details the status of the on-going activities to develop a set of charged particle diverters whose goal is to reduce the background generated by soft-protons which are focused by the Silicon Pore Optics (SPO) mirror modules towards the instrument detectors. This paper explains the considerations leading to an accommodation of the charged particle diverters close to the instruments in the Science Instrument Module (SIM), and details the analytical approach followed to choose the massoptimal location for the case of a uniform magnetic field Halbach design. The case of graded (non-uniform) magnetic fields is also explained in an effort to further decrease the mass. Preliminary magnetic field maps are presented as a proxy to compare the mass from different options. Finally, the first engineering models, manufacturing and test plans are presented which are the focus of a technology development activity aiming at the validation of the technologies involved up to TRL5.
- 6 July 2018
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10699, 151
Design of the charged particle diverter for the ATHENA mission
The large Halo orbit in L2 of the ATHENA mission will expose the spacecraft (SC) to a significant flux of charged particles which is expected to overlap with the energy range of the instruments. This is a source of measurement background that needs to be minimized as much as possible to achieve the strict requirements of the mission. The need to know and mitigate this type of background has been identified as critical, and has led to a number of technology development activities which are progressing in parallel to the Phase A activities. Particularly, this paper details the status of the on-going activities to develop a set of charged particle diverters whose goal is to reduce the background generated by soft-protons which are focused by the Silicon Pore Optics (SPO) mirror modules towards the instrument detectors. This paper explains the considerations leading to an accommodation of the charged particle diverters close to the instruments in the Science Instrument Module (SIM), and details the analytical approach followed to choose the massoptimal location for the case of a uniform magnetic field Halbach design. The case of graded (non-uniform) magnetic fields is also explained in an effort to further decrease the mass. Preliminary magnetic field maps are presented as a proxy to compare the mass from different options. Finally, the first engineering models, manufacturing and test plans are presented which are the focus of a technology development activity aiming at the validation of the technologies involved up to TRL5.
- 1 June 2018
- Published by Elsevier in Ultramicroscopy
- Vol. 189, 95-101
Accurate interpolation of 3D fields in charged particle optics
- 1 June 2018
- Published by Elsevier in Ultramicroscopy
- Vol. 189, 95-101
Accurate interpolation of 3D fields in charged particle optics
- 17 October 2016
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 37 (3) , 1067-1072
Rapid heating of zirconia nanoparticle-powder compacts by infrared radiation heat transfer
- 17 October 2016
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 37 (3) , 1067-1072
Rapid heating of zirconia nanoparticle-powder compacts by infrared radiation heat transfer
- 1 September 2016
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 36 (12) , 2955-2959
Role of conduction and convection heat transfer during rapid crack-free sintering of bulk ceramic with low thermal conductivity
- 1 September 2016
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 36 (12) , 2955-2959
Role of conduction and convection heat transfer during rapid crack-free sintering of bulk ceramic with low thermal conductivity