Jonathan Sprinkle
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jonathan Sprinkle has a total of 257 co-authors. Here are the top co-authors by number of shared publications:
- Daniel B. Work
Vanderbilt University, USA
19 shared publications - Benedetto Piccoli
Rutgers University - Camden
16 shared publications Sean Whitsitt
University of Arizona, Tucson, AZ
13 shared publicationsRoman Lysecky
University of Arizona
11 shared publications- Matthew Bunting
Vanderbilt University, USA
10 shared publications - Matthew Nice
Vanderbilt University, USA
10 shared publications
Latest Publications
- Open Access
- 16 October 2026
- Published by Association for Computing Machinery (ACM) in ACM Transactions on Cyber-Physical Systems
Control barrier function supervision of an automated vehicle in live freeway traffic: Field experiments
This work presents testing of a Control Barrier Function (CBF) supervised Automated Vehicle (AV) in live freeway traffic. The CBF is designed and implemented using a common dynamical model for AV longitudinal control and a time-gap based safety property combined with CAN bus injection software/hardware. 1.17 hours of car-following data is collected from driving in congested freeway traffic. We analyze the extent to which the CBF controlled AV satisfied three properties: 1) forward-invariance of the safety property, 2) recovery of the safety property, and 3) collision avoidance. Our main findings are as follows. Forward-invariance was not strictly satisfied across all states. When trajectories begin satisfying the safety property it was violated by a maximum of \(3.4[m]\) , and \(90\%\) of violations were less than \(2[m]\) . Recovery was also not strictly satisfied across all states. For trajectories which begin outside of the safe set due to merge-in events, if the violation to the safety property was by more than \(5[m]\) the AV was recovering back to the safe set in more than \(98\%\) of the time. Finally, the minimum spacing-gap was \(11.7[m]\) . Across the tests the AV remained far from any collisions. We additionally analyze errors between control inputs and achieved outputs and hypothesize that unaccounted for modeling errors may lead to under-braking compared to what the CBF logic specifies, which may contribute to the observed property violations. Using the collected experimental data we consider the role that control input delay may have played as an unmodeled error source. We perform model calibration considering both a traditional goodness of fit metric as well as capacity to model observed safety violations. Finally we propose two new approaches for handling delay in CBF AV control both based on lead vehicle acceleration estimation and compare this to existing approaches. We use collected experimental data to quantify this. We find that our proposed approach requires less added robustness to achieve forward-invariance in safety compared to existing approaches.- 16 October 2026
- Published by Association for Computing Machinery (ACM) in ACM Transactions on Cyber-Physical Systems
Open AccessControl barrier function supervision of an automated vehicle in live freeway traffic: Field experiments
This work presents testing of a Control Barrier Function (CBF) supervised Automated Vehicle (AV) in live freeway traffic. The CBF is designed and implemented using a common dynamical model for AV longitudinal control and a time-gap based safety property combined with CAN bus injection software/hardware. 1.17 hours of car-following data is collected from driving in congested freeway traffic. We analyze the extent to which the CBF controlled AV satisfied three properties: 1) forward-invariance of the safety property, 2) recovery of the safety property, and 3) collision avoidance. Our main findings are as follows. Forward-invariance was not strictly satisfied across all states. When trajectories begin satisfying the safety property it was violated by a maximum of \(3.4[m]\) , and \(90\%\) of violations were less than \(2[m]\) . Recovery was also not strictly satisfied across all states. For trajectories which begin outside of the safe set due to merge-in events, if the violation to the safety property was by more than \(5[m]\) the AV was recovering back to the safe set in more than \(98\%\) of the time. Finally, the minimum spacing-gap was \(11.7[m]\) . Across the tests the AV remained far from any collisions. We additionally analyze errors between control inputs and achieved outputs and hypothesize that unaccounted for modeling errors may lead to under-braking compared to what the CBF logic specifies, which may contribute to the observed property violations. Using the collected experimental data we consider the role that control input delay may have played as an unmodeled error source. We perform model calibration considering both a traditional goodness of fit metric as well as capacity to model observed safety violations. Finally we propose two new approaches for handling delay in CBF AV control both based on lead vehicle acceleration estimation and compare this to existing approaches. We use collected experimental data to quantify this. We find that our proposed approach requires less added robustness to achieve forward-invariance in safety compared to existing approaches. - Open Access
- 9 September 2026
- Published by Elsevier in Transportation Research Part D: Transport and Environment
- Vol. 161
Emission reduction potential of freeway stop-and-go wave smoothing
- 9 September 2026
- Published by Elsevier in Transportation Research Part D: Transport and Environment
- Vol. 161
Open AccessEmission reduction potential of freeway stop-and-go wave smoothing
- Open Access
- 20 November 2025
- Published by Elsevier in Transportation Research Part C: Emerging Technologies
- Vol. 182
Scalable analysis of stop-and-go waves: Representation, measurements and insights
- 20 November 2025
- Published by Elsevier in Transportation Research Part C: Emerging Technologies
- Vol. 182
Open AccessScalable analysis of stop-and-go waves: Representation, measurements and insights
- 9 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Transportation Systems
- Vol. 26 (12) , 22151-22160
A Safety-Driven Interpretable Model for Vehicle Control With Impact on Traffic
This paper proposes the utilization of a multi-mode ACC based on interpretable Finite State Machine (FSM) to address challenges in infrastructure and surrounding condition changes while meeting macroscopic safety and comfort requirements in traffic flow. Specifically, the paper designs and simulates a merge yield control mode, a dynamic speed change mode, and a safety and monitoring mode switching under defined state transitions with the traditional car-following mode. Advanced ACC algorithms have been applied to improve traffic efficiency and have demonstrated energy savings. Yet they have typically been deployed in a single-use case: car-following mode. In this mode, where the Autonomous Vehicle (AV) maintains an appropriate distance or time gap with the preceding vehicle, decelerating when the gap is small and accelerating when it is large, the system may struggle to guarantee safety and comfort in complex and variable driving scenarios. Although there exist mode-switching ACC and merge mode controllers, in which even involving latitude direction control have been proposed, their dynamics when driving alongside other controlled or human-driving vehicles under a Connected and Autonomous Vehicles (CAVs) traffic environment remains unclear. The paper includes results from an implementation that was successfully tested on the open road, and simulation results that show dampened disturbances from the mode-switching approach, compared to single-mode use of an ACC controller in the same scenarios.
- 9 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Transportation Systems
- Vol. 26 (12) , 22151-22160
A Safety-Driven Interpretable Model for Vehicle Control With Impact on Traffic
This paper proposes the utilization of a multi-mode ACC based on interpretable Finite State Machine (FSM) to address challenges in infrastructure and surrounding condition changes while meeting macroscopic safety and comfort requirements in traffic flow. Specifically, the paper designs and simulates a merge yield control mode, a dynamic speed change mode, and a safety and monitoring mode switching under defined state transitions with the traditional car-following mode. Advanced ACC algorithms have been applied to improve traffic efficiency and have demonstrated energy savings. Yet they have typically been deployed in a single-use case: car-following mode. In this mode, where the Autonomous Vehicle (AV) maintains an appropriate distance or time gap with the preceding vehicle, decelerating when the gap is small and accelerating when it is large, the system may struggle to guarantee safety and comfort in complex and variable driving scenarios. Although there exist mode-switching ACC and merge mode controllers, in which even involving latitude direction control have been proposed, their dynamics when driving alongside other controlled or human-driving vehicles under a Connected and Autonomous Vehicles (CAVs) traffic environment remains unclear. The paper includes results from an implementation that was successfully tested on the open road, and simulation results that show dampened disturbances from the mode-switching approach, compared to single-mode use of an ACC controller in the same scenarios.
- Open Access
- 23 September 2025
- Published by Elsevier in Transportation Research Part C: Emerging Technologies
- Vol. 180
Stop-and-go wave super-resolution reconstruction via iterative refinement
- 23 September 2025
- Published by Elsevier in Transportation Research Part C: Emerging Technologies
- Vol. 180
Open AccessStop-and-go wave super-resolution reconstruction via iterative refinement
- Open Access
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-10
Can control barrier functions keep automated vehicles safe in live freeway traffic?
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-10
Open AccessCan control barrier functions keep automated vehicles safe in live freeway traffic?
- Open Access
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-12
Human-In-The-Loop Classification of Adaptive Cruise Control at a Freeway Scale
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-12
Open AccessHuman-In-The-Loop Classification of Adaptive Cruise Control at a Freeway Scale
- Open Access
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-2
High-Level Scenario Management For Parallel Autonomous Vehicle Simulation
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-2
Open AccessHigh-Level Scenario Management For Parallel Autonomous Vehicle Simulation
- Open Access
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-2
V2X-Enabled Communication for Traffic Operations via ROS
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-2
Open AccessV2X-Enabled Communication for Traffic Operations via ROS
- Open Access
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-6
Visual Modeling of ROS Launch Files
- 6 May 2025
- Published by Association for Computing Machinery (ACM)
- p. 1-6
Open AccessVisual Modeling of ROS Launch Files