Ramadan A. Geioushy

Ramadan A. Geioushy

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ramadan A. Geioushy has a total of 116 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A sustainable carbon–silica based adsorption membrane system derived from asphaltene oil-contaminated sand and acrylic fiber waste for water purification

    by Amira M. Mahmoud, Walaa R. Abd-Ellatif, A. A. Ragab, Eman S. Mansor, Ramadan A. Geioushy, Osama A. Fouad

    Asphaltene-contaminated sand poses a significant environmental threat and presents substantial challenges as a waste product. The immediate and serious risks it poses to ecosystems and human health demand urgent action. This study presents an innovative carbon-based SiO 2 composite that is synthesized from crude oil-contaminated sand using a carefully controlled thermal treatment process at 600 °C and 1200 °C, with the temperature difference influencing the material’s properties. The synthesized C@SiO 2 was characterized and evaluated for its ability to effectively remove copper ions (Cu²) from water. We thoroughly examined crucial factors that impact the affinity and efficiency of Cu²⁺ sorption, such as contact time, adsorbent dosage, initial concentration, and competitive adsorption behaviors. It is clearly shown that the maximum adsorption achieved 95.06% after 120 min in the presence of a 2 g/L adsorbent for C@SiO 2 -600, while C@SiO 2 -1200 exhibited a lower initial efficiency of 33.02%, reflecting the temperature effect. The Langmuir isotherm best fits the data, indicating monolayer adsorption with a maximum capacity of ~ 30.67 mg/g using sample prepared at 600 °C, which decreases with sample prepared at 1200 °C due to potential thermal degradation. Kinetic studies favor the pseudo-second-order model (R² = 0.9996) for C@SiO 2 -600, suggesting chemisorption, with a reduced fit with C@SiO 2 -1200 . The C@SiO 2 -600 adsorbent demonstrates excellent reusability, maintaining 90% efficiency over four cycles, whereas C@SiO 2 -1200 loses effectiveness by the third cycle, highlighting the temperature difference’s impact on stability. This study demonstrates an innovative and eco-friendly approach to convert asphaltene-contaminated sand into a valuable resource for water treatment, enhancing waste valorization and improving heavy metal remediation, with C@SiO 2 -600 proving more advantageous than C@SiO 2 -1200. To further enhance water purification efficiency, the synthesized C@SiO 2 was incorporated into an acrylic fiber waste matrix to fabricate ultrafiltration (UF) membranes. The resulting composite membranes exhibited improved hydrophilicity, mechanical strength, and antifouling behavior compared to pristine acrylic membranes. The modified membranes (NCM1 &NCM2), containing C@SiO 2 prepared at 600 & 1200 °C, respectively, achieved a pure water flux of approximately 60 LMH and demonstrated excellent removal performance, rejecting up to 98% of humic acid. These results confirm that the integration of upcycled C@SiO 2 into acrylic fiber-based membranes not only enhances pollutant removal efficiency but also contributes to sustainable waste valorization and advanced water treatment solutions.

  • Copper Aluminum Oxide for enabling Q-switching and mode-locking in erbium-doped fiber lasers

    by Muhammad N.A.H.M. Husaini, Aeriyn D. Ahmad, Masruroh, Osama A. Fouad, Ahmed Mourtada Elseman, Ramadan A. Geioushy, Zulzilawati Jusoh, Sulaiman W. Harun

  • Open Access

    Thyme-synthesized silver nanoparticles mitigate immunosuppression, oxidative damage, and histopathological alterations induced by multidrug-resistant Enterococcus faecalis in Oreochromis niloticus: in vitro and in vivo assays

    by Dalia A. Abdel-Moneam, Hanan S. Khalefa, Maha M. Rashad, Ghada E. Ali, Yasmine H. Ahmed, Eman Ragab, Osama A. Fouad, Ramadan A. Geioushy, Sahr B. Mahmoud

    The escalating prevalence of antibiotic resistance poses a significant challenge to controlling aquatic diseases, underscoring the need for innovative antimicrobial approaches. Therefore, the current study aimed to investigate the effects of thyme-synthesized silver nanoparticles (thyme-AgNPs) on modulating the immunosuppressive, oxidative stress, and histopathological changes induced by multidrug-resistant Enterococcus faecalis (MDR E. faecalis) infection in Oreochromis niloticus (Nile tilapia). The antibiotic susceptibility profiling of the isolated E. faecalis (PQ084785) revealed resistance to multiple antibiotic classes. The in vitro bactericidal efficacy of thyme-AgNPs was confirmed, with minimum bactericidal concentrations (MBC) and minimum inhibitory concentrations (MIC) of 62.5 µg/mL and 31.5 µg/mL, respectively. In vivo, the 96-h median lethal concentration (LC50) of thyme-AgNPs was determined to be 1 mg/L. Meanwhile, eighty O. niloticus (30.00 ± 5.00 g) were categorized into four groups in duplicate: group I was the negative control group, group II was intraperitoneally injected with MDR E. faecalis (0.2 mL of 0.79 × 108 CFU/mL), group III was exposed to the sublethal dose of thyme-AgNPs in water (0.1 mg/L), and group IV was challenged with the E. faecalis and exposed to thyme-AgNPs simultaneously for 15 days. Results outlined that E. faecalis induced clinical abnormalities, reduced immunoglobulin M levels, elevated oxidant indicators (malondialdehyde), decreased antioxidant capacity (reduced glutathione content, catalase, and superoxide dismutase), and significantly upregulated immune gene expression (tumor necrosis factor-α and interleukin-1β) with marked histopathological and histochemical alterations in gill and liver tissues. Interestingly, the thyme-AgNPs intervention resulted in a noticeable improvement in all measured biomarkers as well as histopathological regeneration. Overall, thyme-AgNPs are a recent antibacterial tool against immune-oxidant/antioxidant and histopathological changes triggered by MDR E. faecalis infection.


  • Open Access

    Mechanical characteristics and antibacterial activity against Staphylococcus aureus of sustainable cellulosic paper coated with Ag and Cu modified ZnO nanoparticles

    by Ramadan A. Geioushy, Samya El-Sherbiny, Eslam T. Mohamed, Osama A. Fouad, Marwa Samir

    In this study, zinc oxide (ZnO) nanoparticles were prepared and modified using a wet chemical method with different concentrations of Ag and Cu nanoparticles. The objective was to improve the mechanical, optical, and antibacterial properties of the coated paper by using the prepared pigments. The long-term antimicrobial effects of the coated paper were evaluated over 25 years. The successful synthesis of a hexagonal structure of ZnO nanoparticles decorated with spherical Ag and Cu nanoparticles ranging from 20 to 50 nm was confirmed using X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), and transmission electron microscopy (TEM). By increasing the concentrations of Ag and Cu from 0.01% to 1.0%, the mechanical properties of the coated paper were enhanced. The tensile strength reached a maximum of 6.77 kN/m and 7.03 kN/m, elongation increased to 1.69% and 1.70%, tensile energy absorption improved to approximately 77 and 80 J/m2, and burst strength rose to 218 and 219 kPa, respectively. The use of Ag-modified ZnO maintains the optical properties, while Cu-modified ZnO reduces brightness and whiteness without affecting opacity. The antimicrobial inhibition activity was improved with higher silver (Ag) and copper (Cu) content. The formulations containing 1% Ag/ZnO and 1%Cu/ZnO showed long-lasting antibacterial effects against gram-positive Staphylococcus aureus bacteria. Even after 25 years of aging, they maintained inhibition rates of 92.2% and 62.2%, respectively. The molecular docking and GeneMANIA analysis revealed the potential of ZnO, Ag-modified ZnO, and Cu-modified ZnO nanoparticles to disrupt the S. aureus cell wall biosynthesis pathway by targeting the MurA enzyme and associated cell wall synthesis genes.


  • Open Access

    Cu nanoparticles grafting on the surface of ZnO nanostructures to boost the porosity and surface area for effective removal of manganese ions from aqueous solutions

    by Ramadan A. Geioushy, Eman S. Ali, Ridha Djellabi, Mohamed A. Abdel-Khalek, Osama A. Fouad

    Designing highly adsorptive materials for wastewater treatment via facile approaches is still challenging. To boost the recovery of heavy metals from wastewater, surface and structure modification are considered a successful route. Herein, we report the design of ZnO nanoparticles by a simple thermal decomposition method followed by grafting Cu nanoparticles (Cu NPs) over the ZnO surface. Cu/ZnO was prepared with different Cu ratios, 0.01 and 1%. It was found that incorporating Cu into ZnO improved the porosity and surface area of ZnO. The adsorption ability of Cu/ZnO compared with bare ZnO was studied towards removing manganese ions from wastewater. The effects of several parameters, such as pH, temperature, contact time, and initial ion concentrations, were studied. The maximum removal of manganese was found at pH 2, 20 °C after 60 min in the presence of 1 g/L adsorbent. The role of Cu grafted on the surface of ZnO was discussed. The rates of adsorption were found to follow the pseudo-second-order model. The results showed better fitting to Freundlich isotherm. The thermodynamic study revealed that the sorption process is spontaneous, exothermic, and favorable at low temperatures. The free energy (ΔG°), enthalpy (ΔH°), and entropy (ΔS°) changes were calculated to predict the nature of adsorption. Graphical Abstract


  • Recent Advances in the Development of Metal–Organic Frameworks-based Photocatalysts for Water Splitting and CO2 Reduction

    by Ehiaghe Agbovhimen Elimian, Ayat N. El-Shazly, Mahmoud A. Hamza, Ramadan A. Geioushy, Jafar Ali, Ayman N. Saber, Peidong Su, Osama A. Fouad, Waheed Iqbal, Phuong Nguyen-Trik, et al.

    The rapid increase in the worldwide population and agro-industrial activities have led to substantial environmental pollution and energy crises in recent decades. The scientific community has given dramatic attention to developing green technologies for production processing and environmental remediation by using natural resources to solve such issues and to provide a better future for our planet. Photocatalysis technologies have been proven to be green alternatives for many applications, including environmental remediation and energy production. Indeed, the engineering of photocatalytic materials with enhanced ability has received the most attention from the scientific community. In recent years, many efforts have been made to develop and modify novel materials based on metal–organic frameworks (MOFs), having excellent stability, high porosity and light absorption, as ideal materials for adsorption, catalysis, and photocatalytic processes. This chapter summarizes and critically discusses approaches towards modifying MOFs-based photocatalysts for enhanced photocatalytic activities such as coupling with inorganic semiconductors, carbon materials, and dye-photosensitizers. Recent advances in using MOFs-based photocatalysts for CO2 reduction into different valuable products and H2 generation through photocatalytic and electrophotocatalytic methods are reviewed.


  • Polyvinylpyrrolidone and freeze drying-assisted growth of an α-Ni(OH) 2 /reduced graphene oxide hybrid structure as a superior electrode material for supercapacitors

    by Ramadan A. Geioushy, Sayed Y. Attia, Saad G. Mohamed, Ragab A. A., Osama A. Fouad

    The electrode of 30 wt% α-Ni(OH) 2 /rGO hybrid structure displayed a promising material for supercapacitors. It showed a specific capacitance (capacity) of 1050 F g −1 (580 C g −1 ), and its hybrid device exhibited a high energy density of 60 W h kg −1 .