Jaroslaw Kurkiewicz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jaroslaw Kurkiewicz has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
Jan Staszak
Kielce University of Technology
3 shared publications- Krzysztof Ludwinek
Faculty of Electrical Engineering, Automatic Control and Computer Science, Kielce University of Technology, Al. Tysiaclecia P. P. 7, 25-314 Kielce, Poland
3 shared publications Tomasz Bekier
Kielce University of Technology
3 shared publicationsZbigniew Gawecki
Kielce University of Technology
3 shared publicationsAndrzej Kuciak
1 shared publicationAnna Majewska
Nuclear Equipment Division HITEC, National Centre for Nuclear Research
1 shared publication
Latest Publications
- Open Access
- 17 March 2020
- Published by Greater Poland Cancer Centre in Letters in Oncology Science
- Vol. 17 (1) , 11-15
Radiation shielding swing door drive control system for linear accelerator bunkers
The paper aims to describe a functional radiation shielding door control system as designed and manufactured by the National Centre for Nuclear Research in Otwock, Poland. Basic principles and normative references as well as a short historical overview of control approaches are described.
- 17 March 2020
- Published by Greater Poland Cancer Centre in Letters in Oncology Science
- Vol. 17 (1) , 11-15
Open AccessRadiation shielding swing door drive control system for linear accelerator bunkers
The paper aims to describe a functional radiation shielding door control system as designed and manufactured by the National Centre for Nuclear Research in Otwock, Poland. Basic principles and normative references as well as a short historical overview of control approaches are described.
- 21 October 2017
- Published by Springer Nature
- p. 219-228
Simulations and Experimental Investigations of an Impulse System for Battery Charging in Electric Bike
- 21 October 2017
- Published by Springer Nature
- p. 219-228
Simulations and Experimental Investigations of an Impulse System for Battery Charging in Electric Bike
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
A simple way of determining induced voltages in the damping bars of salient pole synchronous generator
The article presents a simple way of determining induced voltages in the damping bars of salient pole 5.5 kVA salient pole synchronous generator under no load conditions. Field-circuital model created by coupling FEMM and Matlab environments was used for voltage calculation purposes. The simulation results were verified experimentally in the measurement stand utilizing a purpose built special rotor geometry with additional slip rings connected to individual damping bars.
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
A simple way of determining induced voltages in the damping bars of salient pole synchronous generator
The article presents a simple way of determining induced voltages in the damping bars of salient pole 5.5 kVA salient pole synchronous generator under no load conditions. Field-circuital model created by coupling FEMM and Matlab environments was used for voltage calculation purposes. The simulation results were verified experimentally in the measurement stand utilizing a purpose built special rotor geometry with additional slip rings connected to individual damping bars.
- 1 July 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 170, 342-347
Utilization of permanent magnet synchronous motors in industrial robots
The paper presents results of research concerning the basis of utilization of PMSMs in industrial robots. A mathematical model of PMSM is described. Identification of PMSM's parameters is performed as well as an analysis of simulation and experimental investigation results of transients and steady states of electrical and mechanical quantities is presented.
- 1 July 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 170, 342-347
Utilization of permanent magnet synchronous motors in industrial robots
The paper presents results of research concerning the basis of utilization of PMSMs in industrial robots. A mathematical model of PMSM is described. Identification of PMSM's parameters is performed as well as an analysis of simulation and experimental investigation results of transients and steady states of electrical and mechanical quantities is presented.