HBHadar Ben-Gida

Hadar Ben-Gida

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hadar Ben-Gida has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Spatio-temporal dynamics of the flow in the flap cove of a high-lift airfoil

    by Marinus Kenechukwu Okoronkwo, Dominic Geneau, Hadar Ben-Gida, Oksana Stalnov, Stephane Moreau, Philippe Lavoie

    This study investigates the flow field in the flap cove of a two-element high-lift airfoil, focusing on mechanisms responsible for noise generation. The main-element trailing-edge wake mixes weakly with the flap-cove shear layer, producing a persistent velocity deficit along the flap suction surface. This contrasts with the slat region, where stronger mixing between the shear layer and slat wake at low angles of attack leads to higher broadband noise levels. Within the flap cove, a turbulent separation bubble (TSB) bounded by a shear layer is identified. Strong correlations between flap leading-edge (LE) pressure fluctuations and cove flow support the use of LE noise models. However, significant correlation near the shear-layer reattachment point indicates additional acoustic scattering from the main element, suggesting that LE noise is not the sole contributor. The shear layer reattaches on the main element approximately three step heights downstream, where the step corresponds to the separation lip at the main-element cusp, and the step height represents the characteristic depth of the cove. This reattachment is driven by high-speed flow through the flap gap, shortening the TSB relative to canonical backward-facing step flows. Spectral analysis of hot-wire and wall-pressure data reveals dominant mid- and low-frequency peaks associated with shear-layer vortex shedding and TSB breathing. The shedding frequency agrees with predictions of an analytical slat-noise model, despite the absence of strong flow–acoustic coupling. Proper orthogonal decomposition shows that low-frequency breathing drives large-scale oscillations of the stagnation line and reattachment location, likely triggered by Görtler-type centrifugal instabilities.

  • Open Access

    On the Absence of Self-Sustained Flow–Acoustic Coupling Between the Slat and Flap Coves of High-Lift Devices

    by Marinus K. Okoronkwo, Reuben W. Haklander, Dominic G. Geneau, Hadar Ben-Gida, Oksana Stalnov, Stéphane Moreau, Philippe Lavoie

    The present study investigates the flow-acoustic interactions within the slat and flap coves of a 30P30N high-lift configuration. Velocity fluctuations in the slat cove exhibit a dominant tonal feature at a Strouhal number based on the slat chord (cs), Sts=fcs/U∞=1.75 (f≈ 1500 Hz), corresponding to the second acoustic mode predicted by the feedback model. Strong coherence between wall-pressure sensors in the slat cove and shear layer velocity fluctuations confirms this coupling. The same tonal signature appears in the flap cove wall-pressure spectra, with high coherence between slat and flap surface-pressure signals, indicating propagation of acoustic waves from the slat to the flap. However, no tonal content is observed in the flap cove velocity spectra, suggesting that while acoustic waves propagate between coves, they do not excite shear-layer unsteadiness within the flap cove.

  • Open Access

    Evolution of velocity gradient tensor invariants in wing-tip vortices

    by Guang C. Deng, Satoshi Baba, Hadar Ben-Gida, Philippe Lavoie, Stéphane Moreau


  • Characterization of noise sources in two- and three-element high-lift airfoil configurations

    by Marinus K. Okoronkwo, Dominic G. Geneau, Jessica M. Eburn, Hadar Ben-Gida, Oksana Stalnov, Stéphane Moreau, Philippe Lavoie


  • Open Access

    Detached Eddy Simulations of Cavity-Store Interactions at Subsonic Turbulent Flow

    by Hadar Ben-Gida

    Weapons bays have gained much attraction in the last decade, mainly in the context of next-generation aircraft. Although internal store carriage provides numerous advantages, aero-mechanical challenges still exist, particularly for safe store separation. Therefore, it is essential to gain fundamental knowledge of the flow field within weapons bays, which can be achieved by studying the flow within a more simplified geometry of a cavity. In this study, detached eddy simulations are performed using the Elastic-Zonal-Navier–Stokes-Solver (EZNSS) to characterize the unsteady turbulent flow within NASA’s benchmark rectangular cavity with a store model located at various positions. Simulations are performed at a Mach number of 0.4 and a Reynolds number of 7 million to form a transitional cavity flow, which is common in jet-fighter weapons bays. The numerical results are validated with experimental data for the empty cavity and cavity-with-store configurations. The effect of the store’s position on the cavity flow characteristics is analyzed and verified, as well as the aerodynamic loads exerted on the store. Results show a complex interaction between the store model and the cavity flow field, manifested by distortion of the wall pressure fluctuations and mean flow structures and large amplitude fluctuations of the loads exerted on the store. The insights reported herein can serve future development efforts of more accurate numerical frameworks for cavity-with-store configurations towards improving their applicability for weapons bays store separation in certification procedures.


  • Open Access

    The role of leading-edge serrations in controlling the flow over owls’ wing

    by Tanner Saussaman, Asif Nafi, David Charland, Hadar Ben-Gida, Roi Gurka

    We studied the effects of leading-edge serrations on the flow dynamics developed over an owl wing model. Owls are predatory birds. Most owl species are nocturnal, with some active during the day. The nocturnal ones feature stealth capabilities that are partially attributed to their wing microfeatures. One of these microfeatures is small rigid combs (i.e. serrations) aligned at an angle with respect to the incoming flow located at the wings’ leading-edge region of the primaries. These serrations are essentially passive flow control devices that enhance some of the owls’ flight characteristics, such as aeroacoustics and, potentially, aerodynamics. We performed a comparative study between serrated and non-serrated owl wing models and investigated how the boundary layer over these wings changes in the presence of serrations over a range of angles of attack. Using particle image velocimetry, we measured the mean and turbulent flow characteristics and analyzed the flow patterns within the boundary layer region. Our experimental study suggests that leading-edge serrations modify the boundary layer over the wing at all angles of attack, but not in a similar manner. At low angles of attack (<20°), the serrations amplified the turbulence activity over the wing planform without causing any significant change in the mean flow. At 20° angle of attack, the serrations act to suppress existing turbulence conditions, presumably by causing an earlier separation closer to the leading-edge region, thus enabling the flow to reattach prior to shedding downstream into the wake. Following the pressure Hessian equation, turbulence suppression reduces the pressure fluctuations gradients. This reduction over the wing would weaken, to some extent, the scattering of aerodynamic noise in the near wake region.


  • The leading-edge vortex over a swift-like high-aspect-ratio wing with nonlinear swept-back geometry

    by Hadar Ben-Gida, Roi Gurka

    The leading-edge vortex (LEV) is a common flow structure that forms over wings at high angles of attack. Over the years, LEVs were exploited for augmenting the lift of man-made slender delta wings aircraft. However, recent observations suggested that natural flyers with high-aspect-ratio (high-AR) wings, such as the common swift (Apus apus), can also generate LEVs while gliding. We hypothesize that the planform shape and nonlinear sweep (increasing towards the wingtip) enable the formation and control of such LEVs. In this paper, we investigate whether a stationary LEV can form over a nonlinear swept-back high-AR wing inspired by the swift’s wing shape and evaluate its characteristics and potential aerodynamic benefit. Particle image velocimetry (PIV) measurements were performed in a water flume on a high-AR swept-back wing inspired by the swift wing. Experiments were performed at four spanwise sections and a range of angles of attack for a chord-based Reynolds number of 20 000 . Stationary LEV structures were identified across the wingspan by utilizing the proper orthogonal decomposition (POD) method for angles of attack of 5∘–15∘. The size and circulation of the stationary LEV were found to grow towards the wingtip in a nonlinear manner due to shear layer feeding and spanwise transport of mass and vorticity within the LEV, thus confirming that nonlinear high-AR swept-back wings can generate stationary LEVs. Our results suggest that the common swift can generate stationary LEVs over its swept-back wings to glide slower and at a higher rate of descent, with the LEVs potentially supporting up to 60% of its weight.


  • Turbulent Wake-Flow Characteristics in the Near Wake of Freely Flying Raptors: A Comparative Analysis Between an Owl and a Hawk

    by Krishnamoorthy Krishnan, Hadar Ben-Gida, Gareth Morgan, Gregory A Kopp, Christopher G Guglielmo, Roi Gurka

    Synopsis: Owl flight has been studied over multiple decades associated with bio-inspiration for silent flight. However, their aerodynamics has been less researched. The aerodynamic noise generated during flight depends on the turbulent state of the flow. In order to document the turbulent characteristics of the owl during flapping flight, we measured the wake flow behind a freely flying great horned owl (Bubo virginianus). For comparison purposes, we chose to fly a similar-sized raptor a Harris’s hawk (Parabuteo unicinctus): one is nocturnal and the other is a diurnal bird of prey. Here, we focus on the wake turbulent aspects and their impact on the birds’ flight performances. The birds were trained to fly inside a large-scale wind tunnel in a perch-to-perch flight mode. The near wake of the freely flying birds was characterized using a long duration time-resolved particle image velocimetry system. The velocity fields in the near wake were acquired simultaneously with the birds’ motion during flight which was sampled using multiple high-speed cameras. The turbulent momentum fluxes, turbulent kinetic energy production, and dissipation profiles are examined in the wake and compared. The near wake of the owl exhibited significantly higher turbulent activity than the hawk in all cases, though both birds are similar in size and followed similar flight behavior. It is suggested that owls modulate the turbulence activity of the near wake in the vicinity of the wing, resulting in rapid decay before radiating into the far-field; thus, suppressing the aerodynamic noise at the far wake.


  • Leading-Edge Vortex as a High-Lift Mechanism for Large-Aspect-Ratio Wings

    by Hadar Ben-Gida, Roi Gurka, Daniel Weihs

    Enabling a leading-edge vortex (LEV) is a possible mechanism to significantly increase the lift on wings. This is well known for slender delta wings, for which various analytical models were developed and show accurate predictions of the lift enhancement. This paper shows that, when suitably designing the wing planform, LEVs can also exist on high-aspect-ratio (high-AR) wings. In this study, a quasi-three-dimensional flow model is presented for solving the stationary LEV phenomenon over a high-AR swept back wing, with sweep increasing toward the wingtip. Our model captures the three-dimensional phenomenon by satisfying conservation of mass and vorticity within the LEV, and using a combination of strip theory and the lifting-line theory. Our model predictions are compared with flow visualization data on a parabolic swept back wing. Results confirm that suitable sweep wing geometry can fix an LEV steadily over the upper wing surface, resulting in significant lift enhancement of up to 70%.