Bohong Chen
Bohong Chen has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Zhong-Jie Jiang
Guangzhou Key Laboratory for Surface Chemistry of Energy Materials, Guangdong Engineering and Technology Research Center for Surface Chemistry of Energy Materials, College of Environment and Energy, South China University of Technology, Guangzhou 510006, P. R. China
8 shared publications Binglu Deng
5 shared publicationsHaibo Rong
New Energy Research Institute, College of Environment and Energy, South China University of Technology, Guangzhou 510006, China
5 shared publicationsSi Cheng
New Energy Research Institute, College of Environment and Energy, South China University of Technology, Guangzhou 510006, China
5 shared publicationsZhongqing Jiang
5 shared publicationsZihao Zhen
Guangzhou Key Laboratory for Surface Chemistry of Energy Materials
5 shared publications
Latest Publications
- 22 July 2024
- Published by Elsevier in Applied Surface Science
- Vol. 672
Surface modification of g-C3N4 for enhanced photocatalytic activity via a simple illumination in pure water
- 22 July 2024
- Published by Elsevier in Applied Surface Science
- Vol. 672
Surface modification of g-C3N4 for enhanced photocatalytic activity via a simple illumination in pure water
- 24 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
A Buried Heterostructure Laser Diode Based on High Thermal Conductivity Silicon Carbide Substrate
A buried-heterostructure laser diode based on a silicon carbide substrate has been proposed and demonstrated. Using quantum well intermixing and wafer bonding technique, an InGaAsP buried-heterostructure waveguide was formed and bonded on SiC substrate, leading to high optical power of CW >4 mW, low transmission loss, and good cooling performance.
- 24 September 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
A Buried Heterostructure Laser Diode Based on High Thermal Conductivity Silicon Carbide Substrate
A buried-heterostructure laser diode based on a silicon carbide substrate has been proposed and demonstrated. Using quantum well intermixing and wafer bonding technique, an InGaAsP buried-heterostructure waveguide was formed and bonded on SiC substrate, leading to high optical power of CW >4 mW, low transmission loss, and good cooling performance.
- 1 June 2018
- Published by Elsevier in Journal of Power Sources
- Vol. 389, 178-187
Electronic coupling induced high performance of N, S-codoped graphene supported CoS2 nanoparticles for catalytic reduction and evolution of oxygen
- 1 June 2018
- Published by Elsevier in Journal of Power Sources
- Vol. 389, 178-187
Electronic coupling induced high performance of N, S-codoped graphene supported CoS2 nanoparticles for catalytic reduction and evolution of oxygen
- 27 April 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (20) , 9517-9527
Cation exchange synthesis of NixCo(3−x)O4(x= 1.25) nanoparticles on aminated carbon nanotubes with high catalytic bifunctionality for the oxygen reduction/evolution reaction toward efficient Zn–air batteries
NixCo(3–x)O4/NH2-CNTs for ORR and OER is successfully synthesized by a cation exchange reaction.
- 27 April 2018
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (20) , 9517-9527
Cation exchange synthesis of NixCo(3−x)O4(x= 1.25) nanoparticles on aminated carbon nanotubes with high catalytic bifunctionality for the oxygen reduction/evolution reaction toward efficient Zn–air batteries
NixCo(3–x)O4/NH2-CNTs for ORR and OER is successfully synthesized by a cation exchange reaction.
- Open Access
- 18 April 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (26) , 14462-14472
Core@shell structured Co–CoO@NC nanoparticles supported on nitrogen doped carbon with high catalytic activity for oxygen reduction reaction
A composite with a hierarchical structure consisting of nitrogen doped carbon nanosheets with the deposition of nitrogen doped carbon coated Co–CoO nanoparticles (Co–CoO@NC/NC) has been synthesized by a simple procedure involving the drying of the reaction mixture containing Co(NO3)2, glucose, and urea and its subsequent calcination. The drying step is found to be necessary to obtain a sample with small and uniformly sized Co–CoO nanoparticles. The calcination temperature has a great effect on the catalytic activity of the final product. Specifically, the sample prepared at the calcination temperature of 800 °C shows better catalytic activity of the oxygen reduction reaction (ORR). Urea in the reaction mixture is crucial to obtain the sample with the uniformly sized Co–CoO nanoparticles and also plays an important role in improving the catalytic activity of the Co–CoO@NC/NC. Additionally, there exists a strong electronic interaction between the Co–CoO nanoparticles and the NC. Most interestingly, the Co–CoO@NC/NC is highly efficient for the ORR and can deliver an ORR onset potential of 0.961 V vs. RHE and a half-wave potential of 0.868 V vs. RHE. Both the onset and half-wave potentials are higher than those of most catalysts reported previously and even close to those of the commercial Pt/C (the ORR onset and half-wave potential of the Pt/C are 0.962 and 0.861 V vs. RHE, respectively). This, together with its high stability, strongly suggests that the Co–CoO@NC/NC could be used as an efficient catalyst for the ORR.
- 18 April 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (26) , 14462-14472
Open AccessCore@shell structured Co–CoO@NC nanoparticles supported on nitrogen doped carbon with high catalytic activity for oxygen reduction reaction
A composite with a hierarchical structure consisting of nitrogen doped carbon nanosheets with the deposition of nitrogen doped carbon coated Co–CoO nanoparticles (Co–CoO@NC/NC) has been synthesized by a simple procedure involving the drying of the reaction mixture containing Co(NO3)2, glucose, and urea and its subsequent calcination. The drying step is found to be necessary to obtain a sample with small and uniformly sized Co–CoO nanoparticles. The calcination temperature has a great effect on the catalytic activity of the final product. Specifically, the sample prepared at the calcination temperature of 800 °C shows better catalytic activity of the oxygen reduction reaction (ORR). Urea in the reaction mixture is crucial to obtain the sample with the uniformly sized Co–CoO nanoparticles and also plays an important role in improving the catalytic activity of the Co–CoO@NC/NC. Additionally, there exists a strong electronic interaction between the Co–CoO nanoparticles and the NC. Most interestingly, the Co–CoO@NC/NC is highly efficient for the ORR and can deliver an ORR onset potential of 0.961 V vs. RHE and a half-wave potential of 0.868 V vs. RHE. Both the onset and half-wave potentials are higher than those of most catalysts reported previously and even close to those of the commercial Pt/C (the ORR onset and half-wave potential of the Pt/C are 0.962 and 0.861 V vs. RHE, respectively). This, together with its high stability, strongly suggests that the Co–CoO@NC/NC could be used as an efficient catalyst for the ORR.
- Open Access
- 27 March 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (30) , 18491-18499
Significantly enhanced electrochemical performance of a ZnCo 2 O 4 anode in a carbonate based electrolyte with fluoroethylene carbonate
A facile inexpensive and effective way to improve the performance of a Li/ZnCo 2 O 4 cell by using fluoroethylene carbonate as an additive to the conventional carbonate-based electrolyte has been reported.
- 27 March 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (30) , 18491-18499
Open AccessSignificantly enhanced electrochemical performance of a ZnCo 2 O 4 anode in a carbonate based electrolyte with fluoroethylene carbonate
A facile inexpensive and effective way to improve the performance of a Li/ZnCo 2 O 4 cell by using fluoroethylene carbonate as an additive to the conventional carbonate-based electrolyte has been reported.
- 1 September 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 679, 231-238
Hierarchical porous ZnMn2O4 microspheres architectured with sub-nanoparticles as a high performance anode for lithium ion batteries
- 1 September 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 679, 231-238
Hierarchical porous ZnMn2O4 microspheres architectured with sub-nanoparticles as a high performance anode for lithium ion batteries
- 24 August 2016
- Published by Springer Nature in Ionics
- Vol. 23 (1) , 77-85
Parallelepipedally shaped ZnCo2O4 particles with a hierarchical porous structure as an anode for lithium-ion batteries
- 24 August 2016
- Published by Springer Nature in Ionics
- Vol. 23 (1) , 77-85
Parallelepipedally shaped ZnCo2O4 particles with a hierarchical porous structure as an anode for lithium-ion batteries
- 17 May 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (55) , 50349-50357
High catalytic activity of Co3O4 nanoparticles encapsulated in a graphene supported carbon matrix for oxygen reduction reaction
A simple method has been adopted for the synthesis of Co3O4 nanoparticles encapsulated in graphene supported carbon matrix, which could exhibit higher catalytic performance for oxygen reduction reaction than the commercial Pt/C.
- 17 May 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (55) , 50349-50357
High catalytic activity of Co3O4 nanoparticles encapsulated in a graphene supported carbon matrix for oxygen reduction reaction
A simple method has been adopted for the synthesis of Co3O4 nanoparticles encapsulated in graphene supported carbon matrix, which could exhibit higher catalytic performance for oxygen reduction reaction than the commercial Pt/C.