Mazura Jusoh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mazura Jusoh has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Norshafika Yahya
5 shared publications- Shafirah Samsuri
Chemical Engineering Department, Universiti Teknologi PETRONAS, Seri Iskandar, Malaysia
5 shared publications Nurul Aini Amran
4 shared publicationsNor Zanariah Safiei
3 shared publicationsNorzita Ngadi
3 shared publicationsZaki Yamani Zakaria
Department of Chemical Engineering, Faculty of Chemical and Energy Engineering; Universiti Teknologi Malaysia; Johor
3 shared publications
Latest Publications
- Open Access
- 22 May 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 358 (1) , 012042
Optimization of Progressive Freeze Concentration on Apple Juice via Response Surface Methodology
In this work, a progressive freeze concentration (PFC) system was developed to concentrate apple juice and was optimized by response surface methodology (RSM). The effects of various operating conditions such as coolant temperature, circulation flowrate, circulation time and shaking speed to effective partition constant (K) were investigated. Five different level of central composite design (CCD) was employed to search for optimal concentration of concentrated apple juice. A full quadratic model for K was established by using method of least squares. A coefficient of determination (R2) of this model was found to be 0.7792. The optimum conditions were found to be coolant temperature = -10.59 °C, circulation flowrate = 3030.23 mL/min, circulation time = 67.35 minutes and shaking speed = 30.96 ohm. A validation experiment was performed to evaluate the accuracy of the optimization procedure and the best K value of 0.17 was achieved under the optimized conditions.
- 22 May 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 358 (1) , 012042
Open AccessOptimization of Progressive Freeze Concentration on Apple Juice via Response Surface Methodology
In this work, a progressive freeze concentration (PFC) system was developed to concentrate apple juice and was optimized by response surface methodology (RSM). The effects of various operating conditions such as coolant temperature, circulation flowrate, circulation time and shaking speed to effective partition constant (K) were investigated. Five different level of central composite design (CCD) was employed to search for optimal concentration of concentrated apple juice. A full quadratic model for K was established by using method of least squares. A coefficient of determination (R2) of this model was found to be 0.7792. The optimum conditions were found to be coolant temperature = -10.59 °C, circulation flowrate = 3030.23 mL/min, circulation time = 67.35 minutes and shaking speed = 30.96 ohm. A validation experiment was performed to evaluate the accuracy of the optimization procedure and the best K value of 0.17 was achieved under the optimized conditions.
- 1 May 2018
- Published by Elsevier in Chinese Journal of Chemical Engineering
- Vol. 26 (5) , 970-975
Modelling of heat transfer for progressive freeze concentration process by spiral finned crystallizer
- 1 May 2018
- Published by Elsevier in Chinese Journal of Chemical Engineering
- Vol. 26 (5) , 970-975
Modelling of heat transfer for progressive freeze concentration process by spiral finned crystallizer
- 19 July 2016
- Published by Hindawi Limited in Journal of Food Processing and Preservation
- Vol. 41 (1) , e12910
Grape Juice Concentration by Progressive Freeze Concentrator Sequence System
- 19 July 2016
- Published by Hindawi Limited in Journal of Food Processing and Preservation
- Vol. 41 (1) , e12910
Grape Juice Concentration by Progressive Freeze Concentrator Sequence System
- 18 March 2016
- Published by Institute of Research Engineers and Doctors Pvt Ltd
- p. 37-41
Thermodynamic Analysis of Glycerol Dry Reforming to Hydrogen at Low Pressure
Hydrogen can be produced using several reforming methods from the byproduct of biodiesel which is glycerol. In this investigation, thermodynamic study for glyce
- 18 March 2016
- Published by Institute of Research Engineers and Doctors Pvt Ltd
- p. 37-41
Thermodynamic Analysis of Glycerol Dry Reforming to Hydrogen at Low Pressure
Hydrogen can be produced using several reforming methods from the byproduct of biodiesel which is glycerol. In this investigation, thermodynamic study for glyce
- 4 August 2015
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 203 (7) , 957-975
Review: Parametric Study on the Performance of Progressive Cryoconcentration System
Progressive cryoconcentration (PC) is gaining acceptance in solution concentration process as it could provide an easy separation and ice purification with relatively low energy. In fact, the advantages of PC process as compared to the other concentration methods have led the growth of related studies that aim to provide the best system or condition for the separation process involved. Apart from the provision of appropriate equipment, the PC process should also be conducted at its optimum conditions of operating parameters involved, which could give the highest separation efficiency. Hence, relationship between the parameters, which covers both manipulated and determinant parameters should be studied first. This review summarizes the previous conducted studies on the effect of various operating parameters on the PC performance, which includes effect of coolant temperature, solution flowrate, initial solution concentration, freezing time, ice crystal front growth rate, and stirring rate.
- 4 August 2015
- Published by Taylor & Francis in Chemical Engineering Communications
- Vol. 203 (7) , 957-975
Review: Parametric Study on the Performance of Progressive Cryoconcentration System
Progressive cryoconcentration (PC) is gaining acceptance in solution concentration process as it could provide an easy separation and ice purification with relatively low energy. In fact, the advantages of PC process as compared to the other concentration methods have led the growth of related studies that aim to provide the best system or condition for the separation process involved. Apart from the provision of appropriate equipment, the PC process should also be conducted at its optimum conditions of operating parameters involved, which could give the highest separation efficiency. Hence, relationship between the parameters, which covers both manipulated and determinant parameters should be studied first. This review summarizes the previous conducted studies on the effect of various operating parameters on the PC performance, which includes effect of coolant temperature, solution flowrate, initial solution concentration, freezing time, ice crystal front growth rate, and stirring rate.
- 1 June 2015
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 74 (7)
Effect of Coolant Temperature on Progressive Freeze Concentration of Refined, Bleached and Deodorised Palm Oil based on Process Efficiency and Heat Transfer
In this paper, raw material of refined bleached and deodorised palm oil (RBDPO) was separated into olein and stearin by applying progressive freeze concentration (PFC) as an alternative method to replace the conventional fractionation process using coil crystallizer. Overall heat transfer coefficient (U) was analyzed from the process by varying different coolant temperature values since both of them are closely related each other. In this case, heat transfer efficiency depends strongly on crystal of stearin formed on the inner wall of cooled surface and is explained theoretically from that angle. At optimum flowrate, operation time and initial iodine value (IV), the best results were observed at 28ºC of coolant temperature where high IV of olein and effective partition constant (K) obtained were 55.8 wijs and 0.27 respectively. Meanwhile, the highest U obtained at coolant temperature 28oC same as result for process efficiency at 392.9183 W/m².K and time at 55 min.
- 1 June 2015
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 74 (7)
Effect of Coolant Temperature on Progressive Freeze Concentration of Refined, Bleached and Deodorised Palm Oil based on Process Efficiency and Heat Transfer
In this paper, raw material of refined bleached and deodorised palm oil (RBDPO) was separated into olein and stearin by applying progressive freeze concentration (PFC) as an alternative method to replace the conventional fractionation process using coil crystallizer. Overall heat transfer coefficient (U) was analyzed from the process by varying different coolant temperature values since both of them are closely related each other. In this case, heat transfer efficiency depends strongly on crystal of stearin formed on the inner wall of cooled surface and is explained theoretically from that angle. At optimum flowrate, operation time and initial iodine value (IV), the best results were observed at 28ºC of coolant temperature where high IV of olein and effective partition constant (K) obtained were 55.8 wijs and 0.27 respectively. Meanwhile, the highest U obtained at coolant temperature 28oC same as result for process efficiency at 392.9183 W/m².K and time at 55 min.
- 1 June 2015
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 74 (7)
Fractional Freezing of Ethanol and Water Mixture
Fractional freezing was introduced to separate a mixture that contains a volatile organic compound in this case; ethanol and water. The mixture was separated by using freezing process since both ethanol and water have different freezing points. This method is an alternative method for fractional distillation as it does not consume high amount of energy to supply heat for vaporization purpose. Besides, this method is safer to our environment as it does not liberate any harmful vapor or gases since there is no heating process involved. In this study, the performance of the process in producing high purity ethanol was evaluated based on two parameters which are stirring rate and coolant temperature. It was found that the concentration of ethanol in liquid phase increased as the stirring rate increased. The ethanol concentration has increased by 52.2% when the stirring rate was at the highest rotating speed which is 500 rpm. When the coolant temperature was decreased to -14˚C, the ethanol concentration in liquid phase increased the most by 56.5%. Thus it can be concluded that the concentration of ethanol in liquid phase increased as the coolant temperature decreased.
- 1 June 2015
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 74 (7)
Fractional Freezing of Ethanol and Water Mixture
Fractional freezing was introduced to separate a mixture that contains a volatile organic compound in this case; ethanol and water. The mixture was separated by using freezing process since both ethanol and water have different freezing points. This method is an alternative method for fractional distillation as it does not consume high amount of energy to supply heat for vaporization purpose. Besides, this method is safer to our environment as it does not liberate any harmful vapor or gases since there is no heating process involved. In this study, the performance of the process in producing high purity ethanol was evaluated based on two parameters which are stirring rate and coolant temperature. It was found that the concentration of ethanol in liquid phase increased as the stirring rate increased. The ethanol concentration has increased by 52.2% when the stirring rate was at the highest rotating speed which is 500 rpm. When the coolant temperature was decreased to -14˚C, the ethanol concentration in liquid phase increased the most by 56.5%. Thus it can be concluded that the concentration of ethanol in liquid phase increased as the coolant temperature decreased.
- 31 January 2015
- Published by IWA Publishing in Water Supply
- Vol. 15 (3) , 625-631
Desalination of seawater through progressive freeze concentration using a coil crystallizer
In this century, the shortage of clean water supply is an issue of concern and the problem is expected to become more serious in the future. Consequently, researchers are trying to find the best solution to address this problem by introducing new desalination technologies that are able to accommodate the increasing demand for clean water. One of the new technologies introduced is desalination of seawater through freeze concentration. In this study, progressive freeze concentration (PFC) was implemented to produce pure water in the form of an ice crystal block, leaving behind higher concentration seawater using a coil crystallizer. The effect of operating parameters such as initial concentration and coolant temperature were investigated. Meanwhile, the efficiency of the system was reviewed based on the value of the effective partition constant K which is defined by the ratio of solute in ice and liquid phase. A low value of K indicates when the system is most efficient. In addition, the results for the overall heat transfer coefficient are also presented to observe the heat transfer involved in the system.
- 31 January 2015
- Published by IWA Publishing in Water Supply
- Vol. 15 (3) , 625-631
Desalination of seawater through progressive freeze concentration using a coil crystallizer
In this century, the shortage of clean water supply is an issue of concern and the problem is expected to become more serious in the future. Consequently, researchers are trying to find the best solution to address this problem by introducing new desalination technologies that are able to accommodate the increasing demand for clean water. One of the new technologies introduced is desalination of seawater through freeze concentration. In this study, progressive freeze concentration (PFC) was implemented to produce pure water in the form of an ice crystal block, leaving behind higher concentration seawater using a coil crystallizer. The effect of operating parameters such as initial concentration and coolant temperature were investigated. Meanwhile, the efficiency of the system was reviewed based on the value of the effective partition constant K which is defined by the ratio of solute in ice and liquid phase. A low value of K indicates when the system is most efficient. In addition, the results for the overall heat transfer coefficient are also presented to observe the heat transfer involved in the system.